Search NASA⌕ Search

SEARCH · Search NASA

Results for “WING SECTIONS - THICKNESS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12
All sourcesNASA NTRSDOE OSTI
NASA NTRS1985

An investigation of the effects of the propeller slipstream of a laminar wing boundary layer

A research program is in progress to study the effects of the propeller slipstream on natural laminar flow. Flight and wind tunnel measurements of the wing boundary layer have been made using hot-film velocity sensor probes. The results show the boundary layer, at any given point, to alternate between laminar and turbulent states. This cyclic behavior is due to periodic external flow turbulence originating from the viscous wake of the propeller blades. Analytic studies show the cyclic laminar/turbulent boundary layer to result in a significantly lower wing section drag than a fully turbulent boundary layer. The application of natural laminar flow design philosophy yields drag reduction benefits in the slipstream affected regions of the airframe, as well as the unaffected regions.

Howard, R. M.↗
NASA NTRS1986

Aerodynamic characteristics of two-dimensional wing configurations at angles of attack near -90 deg

Wind tunnel tests were conducted to determine the drag of two-dimensional wing sections operating in a near-vertical flow condition. Various leading- and trialing-edge configurations, including plain flaps of 25, 30, and 35% chord were tested at angles of attack from -75 to -105 deg. Reynolds numbers examined ranged from approximately 0.6 x 10 to the 6th power to 1.4 x 10 to the 6th power. The data were obtained using a wind tunnel force and moment balance system and arrays of chordwise pressure orifices. The results showed that significant reductions in drag, beyond what would be expected by virtue of the decreased frontal area, were obtainable with geometries that delayed flow separation. Rapid changes in drag with angle of attack were noted for many configurations. The results, however, were fairly insensitive to Reynolds number variations. Drag values computed from the pressure data generally agreed with the force data within 2%.

Maisel, Martin↗
NASA NTRS1987

The impact of circulation control on rotary aircraft controls systems

Application of circulation to rotary wing systems is a new development. Efforts to determine the near and far field flow patterns and to analytically predict those flow patterns have been underway for some years. Rotary wing applications present a new set of challenges in circulation control technology. Rotary wing sections must accommodate substantial Mach number, free stream dynamic pressure and section angle of attack variation at each flight condition within the design envelope. They must also be capable of short term circulation blowing modulation to produce control moments and vibration alleviation in addition to a lift augmentation function. Control system design must provide this primary control moment, vibration alleviation and lift augmentation function. To accomplish this, one must simultaneously control the compressed air source and its distribution. The control law algorithm must therefore address the compressor as the air source, the plenum as the air pressure storage and the pneumatic flow gates or valves that distribute and meter the stored pressure to the rotating blades. Also, mechanical collective blade pitch, rotor shaft angle of attack and engine power control must be maintained.

Kingloff, R. F.↗
NASA NTRS1990

Flight-measured streamwise disturbance instabilities in laminar flow

NASA is presently conducting laminar-flow flight research to explore the limits of practical applications of laminar-flow drag reduction technology. An important aspect of this research involves studies of the dominant instability or instabilities responsible for initiating the transition process from laminar to turbulent flow. Recent subsonic flight experiments using an instrumented wing glove on a Lear 28/29 airplane measured the growth of the two-dimensional, viscous Tollmien-Schlichting (T-S) instability. The gloved wing section incorporated closely-spaced, flush-mounted, streamwise-located instrumentation for measuring the instability frequencies, surface temperatures, and pressure distributions. Flight conditions of the experiment includeed Mach numbers from 0.70 to 0.79 and chord Reynolds numbers from 10 to 20 million. An onboard engineer's station allowed for real-time analysis of the instability frequency data. In addition to a sample of results on the streamwise growth of instabilities, details of the glove and sensor installation and the onboard real-time data analysis system are given.

Lee, Cynthia C.↗
NASA NTRS1990

Laminar flow test installation in the Boeing Research Wind Tunnel

This paper describes the initial wind tunnels tests in the 5- by 8-ft Boeing Research Wind Tunnel of a near full-scale (20-foot chord) swept wing section having laminar flow control (LFC) by slot suction over its first 30 percent chord. The model and associated test apparatus were developed for use as a testbed for LFC-related experimentation in support of preliminary design studies done under contract with the National Aeronautics and Space Administration. This paper contains the description of the model and associated test apparatus as well as the results of the initial test series in which the proper functioning of the test installation was demonstrated and new data were obtained on the sensitivity of suction-controlled laminar flow to surface protuberances in the presence of crossflow due to sweep.

George-Falvy, Dezso↗
NASA NTRS1991

Research on inverse methods and optimization in Italy

The research activities in Italy on inverse design and optimization are reviewed. The review is focused on aerodynamic aspects in turbomachinery and wing section design. Inverse design of blade rows and ducts of turbomachinery in subsonic and transonic regime are illustrated by the Politecnico di Torino and turbomachinery industry (FIAT AVIO).

Larocca, Francesco↗
NASA NTRS1993

Development of a large-scale, outdoor, ground-based test capability for evaluating the effect of rain on airfoil lift

A large-scale, outdoor, ground-based test capability for acquiring aerodynamic data in a simulated rain environment was developed at the Langley Aircraft Landing Dynamics Facility (ALDF) to assess the effect of heavy rain on airfoil performance. The ALDF test carriage was modified to transport a 10-ft-chord NACA 64210 wing section along a 3000-ft track at full-scale aircraft approach speeds. An overhead rain simulation system was constructed along a 525-ft section of the track with the capability of producing simulated rain fields of 2, 10, 30, and 40 in/hr. The facility modifications, the aerodynamic testing and rain simulation capability, the design and calibration of the rain simulation system, and the operational procedures developed to minimize the effect of wind on the simulated rain field and aerodynamic data are described in detail. The data acquisition and reduction processes are also presented along with sample force data illustrating the environmental effects on data accuracy and repeatability for the 'rain-off' test condition.

Bezos, Gaudy M.↗
NASA NTRS1993

Two-dimensional computational analysis of a transport high-lift system and a comparison with flight-test results

Two currently available coupled inviscid/viscous multielement computational codes, including a relatively simple panel method and an Euler method, are used to analyze a high-lift system. The results are compared with two-dimensional wind-tunnel test results and then with the three-dimensional flight-test results obtained from the NASA Langley Transport Systems Research Vehicle five-element high-lift wing section. Comparisons were also made between the panel method, the Euler method, and flight data for two high-lift configurations, one representing a take-off configuration and the other an approach configuration. For the take-off configuration, both codes agreed reasonably well with experimental data, but both codes were found to overpredict the flap upper-surface pressures for the approach configuration.

Hardin, Jay D.↗
NASA NTRS1921

The law relating to air currents

Discussed here are the aerodynamics of a subdivided wing section. The emphasis is upon the increase of lift with more acute angles of attack. Also discussed are wind tunnel tests of the relations among wind resistance, lift, angle of attack, and velocity.

Source record↗
NASA NTRS1924

On the distribution of lift along the span of an airfoil with displaced ailerons

The effect of an aileron displacement on the distribution of the lift along the span is computed for an elliptic wing of aspect ratio 6 for three conditions. The lift distribution caused by the aileron displacement is uniform and extends normally beyond the inner end of the ailerons. Hence, the displacement of an aileron with constant chord length may bring about passing the stalling point of the adjacent wing sections, if these were near this point before. Hence, such ailerons can become ineffective at low speeds. Tapering the aileron towards the inside suggests itself as a remedy.

Munk, Max M↗
NASA NTRS1931

Lift and drag characteristics of a cabin monoplane

The results of flight tests conducted by the NACA to determine the lift and drag characteristics of a full-scale airplane are given herein. A Fairchild FC-2W2 cabin monoplane having a Gottingen 387 wing section was used for the tests. The maximum lift coefficient for the airplane is compared with that obtained for the Gottingen 387 airfoil in recent tests in the Variable Density Tunnel. The maximum lift coefficient for the airplane was found to be 1.50 and that for the airfoil 1.56. Although the flight tests were confined chiefly to glides with the propeller locked horizontally, data obtained with the propeller operating at zero thrust for a few angles of attack are also included.

Thompson, F L↗
NASA NTRS1933

Effect of aileron displacement on wing characteristics

The effect of aileron displacement on wing characteristics has been investigated for the Clark Y and the U.S.A. 27 wing sections equipped with rectangular ailerons. The airfoils, rectangular in plan, and having a 10 inch chord and 60 inch span, were mounted on a model fuselage.

Heald, R H↗
NASA NTRS1923

Speed limits of aircraft

This paper is restricted to the question of attainable speed limits and attacks the problem from different angles. Theoretical limits due to air resistance are presented along with design factors which may affect speed such as wing loads, wing areas, wing section shifting, landing speeds, drag-lift ratios, and power coefficients.

Everling, E↗
NASA NTRS1949

General Theory of Aerodynamic Instability and the Mechanism of Flutter

The aerodynamic forces on an oscillating airfoil or airfoil-aileron combination of three independent degrees of freedom have been determined. The problem resolves itself into the solution of certain definite integrals, which have been identified as Bessel functions of the first and second kind and of zero and first order. The theory, being based on potential flow and the Kutta condition, is fundamentally equivalent to the conventional wing-section theory relating to the steady case. The air forces being known, the mechanism of aerodynamic instability has been analyzed in detail. An exact solution, involving potential flow and the adoption of the Kutta condition, has been analyzed in detail. An exact solution, involving potential flow and the adoption of the Kutta condition, has been arrived at. The solution is of a simple form and is expressed by means of an auxiliary parameter K.

Theodorsen, Theodore↗
NASA NTRS1923

The tail plane

This report deals with the calculation of the equilibrium, statistical stability, and damping of the tail plane. The author has simplified the present theory of longitudinal stability for the particular purpose of obtaining one definite coefficient characteristics of the effect of the tail plane. This coefficient is obtained by substituting certain aerodynamic characteristics and some dimensions of the airplane in a comparatively simple mathematical expression. Care has been taken to confine all aerodynamical information necessary for the calculation of the coefficient to the well-known curves representing the qualities of the wing section. This is done by making use of the present results of modern aerodynamics. All formulas and relations necessary for the calculation are contained in the paper. They give in some cases only an approximation of the real values. An example of calculation is added in order to illustrate the application of the method. The coefficient indicates not only whether the effect of the tail plane is great enough, but also whether it is not too great. It appears that the designer has to avoid a certain critical length of the fuselage, which inevitably gives rise to periodical oscillations of the airplane. The discussion also shows the way and in what direction to carry out experimental work.

Munk, Max M↗
NASA NTRS1950

The gas kinetics of very high flight speeds

The aerodynamic forces on bodies of arbitrary shape were investigated under conditions such that the mean free path of the air molecule is greater than the dimensions of the body. Air pressures and friction forces were calculated from gas kinetic theory for surfaces facing both toward and away from the air stream at any angle. Air forces for an atmosphere of definite composition (molecular hydrogen) were calculated as a function of the flight velocity. The results indicate that the friction stresses between the air and the body surface are of the same magnitude as the dynamic pressure and as the air pressures normal to the surface. The application of the general method to the specific cases such as thin airfoils and projectiles leads to high drag coefficients and poor glide ratios even for the theoretically best wing sections.

AIR FLOW VELOCITY - MOLECULAR ENERGIES↗
NASA NTRS1939

Experiments on a Slotted Wing

The results of pressure distribution measurements that were made on a model wing section of a Fieseler F 5 R type airplane are presented. Comparison of those model tests with the corresponding flight tests indicates the limitations and also the advantages of wind tunnel investigations, the advantages being particularly that through the variety of measuring methods employed the more complicated flow conditions may also be clarified. A fact brought out in these tests is that even in the case of "well rounded" slots it is possible for a vortex to be set up at the slot entrance and this vortex is responsible for certain irregularities in the pressure distribution and in the efficiency of the slot.

Ruden, P↗