Search NASA⌕ Search

SEARCH · Search NASA

Results for “Window”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Precision temperature gradient measurements on window glass

Surface temperature gradients were measured with miniature thermocouples installed in a 58.5 cm (23-inch) square window. Test measurements at 25 locations were made under vacuum and with the window operating in radiant heat transfer mode. The analysis of thermocouple design and installation is presented along with a lead wire routing scheme to allow for both differential and absolute temperature measurements while using a minimum number of signal feedthru paths through the test chamber wall. Typical test data and operational precautions are presented along with the accuracy analysis for installation effects and measurement effects to support differential temperature measurement precision values of + or - 0.06 C RMS + or - 0.1 F RMS).

Mikk, G.↗
NASA NTRS1979

Vibration characteristics of walls and a plate glass window representative of those of a wood-frame house

Mechanical excitation was used, and measurements of acceleration response, natural frequencies, and nodal patterns were performed. Results indicate that the wall sections and the complete wall did not act as a unit in responding to sinusoidal vibration inputs. Calculated frequencies of the components that account for this independent behavior of the studs and face sheets agreed resonably well with experimental frequencies. Experimental vibrations of the plate glass window agreed with the calculated behavior, and responses of the window exposed to airplane flyover noise were readily correlated with the test results.

Carden, H. D.↗
NASA NTRS1979

Acoustic response of thin film windows in the environment of an Atlas-Centaur launch

An exhaustive design development study was performed to correlate the survivability of thin film to various parameters. Film material properties, film thicknesses, unsupported window areas, window aspect ratios, film/frame transitions, film reinforcing techniques, and material grain orientations were all considered. Several thin films were tested to acoustical loads which are expected during an Atlas-Centaur launch of the High Energy Astronomy Observatory Satellites (HEAO)

Mastronardi, R.↗
NASA NTRS1979

Phosphine absorption in the 5-micron window of Jupiter

Since the original suggestion by Gillett et al. (1969) it has generally been assumed that the region of partial transparency near 5 micron in Jupiter's atmosphere (the 5-micron window) is bounded by the nu sub 4 NH3 at 6.1 micron and the nu sub 3 CH4 band at 3.3 micron. New measurements of Jupiter and of laboratory phosphine (PH3) samples show that PH3 is a significant contributor to the continuum opacity in the window and in fact defines its short-wavelength limit. This has important implications for the use of 5-micron observations as a means to probe the deep atmospheric structure of Jupiter. The abundance of PH3 which results from a comparison of Jovian and laboratory spectra is about 3 to 5 cm-am. This is five to eight times less than that found by Larson et al. (1977) in the same spectral region, but is in good agreement with the result of Tokunaga et al. (1979) from 10-micron observations.

Beer, R.↗
NASA NTRS1980

Design windows for low-high-low GaAs IMPATT's

The paper presents a low-high-low GaAs IMPATT model used to define design windows at the frequency of interest. Emphasis is placed on experimental verification confirming both the utility of the model and the design windows obtained therefrom. It is noted that the model can be also useful during fabrication.

Namordi, M. R.↗
NASA NTRS1980

Design and use of a servo-controlled high pressure window bomb in spectroscopic studies of solid propellant combustion

The feasibility of using a high pressure window bomb as a laboratory scale model of actual motor conditions. The design and operation of a modified high pressure window bomb is discussed. An optical servocontrol mechanism has been designed to hold the burning surface of a propellant strand at a fixed position within the bomb chamber. This mechanism permits the recording of visible and infrared emission spectra from various propellants. Preliminary visible emission spectra of a nonmetalized and metalized propellant are compared with spectra recorded using the modified bomb.

Goetz, F.↗
NASA NTRS1983

Low-level water vapor fields from the VAS split-window channels at 11 and 12 microns

Originally, the VAS split window channels were designed to use the differential water vapor absorption between 11 and 12 microns to estimate sea surface temperature by correcting for the radiometric losses caused by atmospheric moisture. It is shown that it is possible to reverse the procedure in order to estimate the vertically integrated low level moisture content with the background surface (skin) temperature removed, even over the bright, complex background of the land. Because the lower troposphere's water vapor content is an important factor in convective instability, the derived fields are of considerable value to mesoscale meteorology. Moisture patterns are available as quantitative fields (centimeters of precipitable water) at full VAS resolution (as fine as 7 kilometers horizontal resolution every 15 minutes), and are readily converted to image format for false color movies. The technique, demonstrated with GOES-5, uses a sequence of split window radiances taken once every 3 hours from dawn to dusk over the Eastern and Central United States. The algorithm is calibrated with the morning radiosonde sites embedded within the first VAS radiance field; then, entire moisture fields are calculated at all five observation times. Cloud contamination is removed by rejecting any pixel having a radiance less than the atmospheric brightness determined at the radiosonde sites.

Chesters, D.↗
NASA NTRS1984

Field repair of AH-16 helicopter window cutting assemblies

The U.S. Army uses explosively actuated window cutting assemblies to provide emergency crew ground egress. Gaps between the system's explosive cords and acrylic windows caused a concern about functional reliability for a fleet of several hundred aircraft. A field repair method, using room temperature vulcanizing silicone compound (RTV), was developed and demonstrated to fill gaps as large as 0.250 inch.

Bement, L. J.↗
NASA NTRS1984

Cockpit Window Edge Proximity Effects on Judgements of Horizon Vertical Displacement

To quantify the influence of a spatially fixed edge on vertical displacement threshold, twenty-four males (12 pilots, 12 non-pilots) were presented a series of forced choice, paired comparison trials in which a 32 deg arc wide, thin, luminous horizontal stimulus line moved smoothly downward through five angles from a common starting position within a three second-long period. The five angles were 1.4, 1.7, 2, 2.3, and 2.6 deg. Each angle was presented paired with itself and the other four angles in all combinations in random order. For each pair of trials the observer had to choose which trial possessed the largest displacement. A confidence response also was made. The independent variable was the angular separation between the lower edge of a stable 'window' aperture through which the stimulus was seen to move and the lowest position attained by the stimulus. It was found that vertical displacement accuracy is inversely related to the angle separating the stimulus and the fixed window edge (p = .05). In addition, there is a strong tendency for pilot confidence to be lower than that of non-pilots for each of the three angular separations. These results are discussed in erms of selected cockpit features and as they relate to how pilots judge changes in aircraft pitch attitude.

Haines, R. F.↗
NASA NTRS1985

Incident beam polarization for laser Doppler velocimetry employing a sapphire cylindrical window

For laser Doppler velocimetry studies employing sapphire windows as optical access ports, the birefringency of sapphire produces an extra beam intersection volume which serves to effectively smear the acquired velocity flow field data. It is shown that for a cylindrical window geometry, the extra beam intersection volume may be eliminated with minimal decrease in the fringe visibility of the remaining intersection volume by suitably orienting the polarizations of the initial laser beams. For horizontally incident beams, these polarizations were measured at three intersection locations within the cylinder. It was found that the measured polarization angles agreed with the theoretical predictions.

Lock, J. A.↗
NASA NTRS1985

Incident beam polarization for laser Doppler velocimetry employing a sapphire cylindrical window

For laser Doppler velocimetry studies employing sapphire windows as optical access ports, the birefringency of sapphire produces an extra beam intersection volume which serves to effectively smear the acquired velocity flow field data. It is shown that for a cylindrical window geometry, the extra beam intersection volume may be eliminated with minimal decrease in the fringe visibility of the remaining intersection volume by suitably orienting the polarizations of the initial laser beams. For horizontally incident beams, these polarizations were measured at three intersection locations within the cylinder. It was found that the measured polarization angles agreed with the theoretical predictions.

Lock, J. A.↗
NASA NTRS1984

The window controller

The window controller developed for the computer animation system (TAN) of the human-body modeling and positioning system TEMPUS (Badler et al., 1983) is characterized, and its operation is illustrated with diagrams. The controller is associated with a screen viewport and comprises five nested squares related to five modifications of the window, including zooming in and out, translation, locking plus translation, and extension of extremes plus translation. The variations of the controller and its limitations are considered, and its advantages over the use of a miniworld in a separate viewport are indicated.

Badler, N. I.↗
NASA NTRS1985

On orbit mission planning using the shuttle trajectory and launch window expert system

With the Space Transportation System (STS) entering the operational era, the need for standardized, automated, mission planning computer tools has become apparent. In order to support an increased flight rate without an increase in manpower, quicker and more efficient methods are needed to perform standard tasks. The Shuttle Trajectory and Launch Window Expert System (STALEX) was developed to automate many aspects of early mission planning for space shuttle missions carrying geosynchronous communications satellites. Most of the commercial Shuttle missions planned for the next 3 years will carry at least one of this type of satellite. The applications of STALEX include payload deployment scheduling, launch window analysis, orbital trajectory determination, and landing opportunity selection.

Ahlf, P. R.↗
NASA NTRS1987

Bonding Lexan and sapphire to form high-pressure, flame-resistant window

Flammable materials have been studied in normal gravity and microgravity for many years. Photography plays a major role in the study of the combustion process giving a permanent visual record that can be analyzed. When these studies are extended to manned spacecraft, safety becomes a primary concern. The need for a high-pressure, flame-resistant, shatter-resistant window permitting photographic recording of combustion experiments in manned spacecraft prompted the development of a method for bonding Lexan and sapphire. Materials that resist shattering (e.g., Lexan) are not compatible with combustion experiments; the material loses strength at combustion temperatures. Sapphire is compatible with combustion temperatures in oxygen-enriched atmospheres but is subject to shattering. Combining the two materials results in a shatter-resistant, flame-resistant window. Combustion in microgravity produces a low-visibility flame; however, flame propagation and flame characteristics are readily visible as long as there is no deterioration of the image. Since an air gap between the Lexan and the sapphire would reduce transmission, a method was developed for bonding these unlike materials to minimize light loss.

Richardson, William R.↗
NASA NTRS1986

Windows in direct dissociative recombination cross sections

Model potential curves are used to show that large windows are present in direct dissociative-recombination cross sections from excited molecular-ion vibrational levels. The windows are due to the overlap of vibrational wave functions of the repulsive neutral states with the nodes of the ion vibrational wave function.

Guberman, Steven L.↗
NASA NTRS1987

A FORTRAN code for the calculation of probe volume geometry changes in a laser anemometry system caused by window refraction

A computer code was written which utilizes ray tracing techniques to predict the changes in position and geometry of a laser Doppler velocimeter probe volume resulting from refraction effects. The code predicts the position change, changes in beam crossing angle, and the amount of uncrossing that occur when the beams traverse a region with a changed index of refraction, such as a glass window. The code calculates the changes for flat plate, cylinder, general axisymmetric and general surface windows and is currently operational on a VAX 8600 computer system.

Owen, Albert K.↗
NASA NTRS1987

The windows of SETI - Frequency and time in the search for extraterrestrial intelligence

Since interstellar travel is not economically possible on the time scale of a human lifetime, communication with extraterrestrials can be achieved only by sending some form of energy or matter across space; photons (electromagnetic waves) are best. Of particular interest to SETI is the region from about 1,000-60,000 MHz known as the free-space microwave window. During the course of NASA's Cyclops program, it was pointed out that the hydrogen and hydroxyl lines bounded a band in which there were no other known lines. The threatened loss of the microwave window to earth-based services is discussed.

Oliver, Bernard M.↗
NASA NTRS1988

Temperature dependence in the ultraviolet transmission of cooled fused silica windows

Transmission losses noted in cooled UV-quality synthetic fused silica windows were investigated. A deuterium lamp was employed as a source of continuum emission over the 400-190-nm range considered. Even slight cooling was found to produce a significant transmission change at wavelengths shorter than about 320 nm. Attempts to clean the windows produced little change in the results, indicating that surface contamination was not responsible for the effect.

Erdman, Peter, W.↗