SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Flexseal assemblies, TVC actuators, hydraulic supply system, TVC electronic control unit, flight instrumentation system, ordnance system electronics, and hydrotest of SRM case segments are discussed, applied to typical component recertification test procedures.
This paper describes the design, calibration, and operation of a magnetic spectrometer for particle astronomy. The spectrometer consists of a superconducting magnet, optical spark chambers, scintillation detectors, and associated electronics. The instrument has been flown in a balloon gondola to 4.8 g/sq cm residual atmosphere, where it was used to analyze the charge and differential rigidity spectra of primary nuclei from 5 to 100 GeV/c.
An electron spectrometer instrument for the Orbiting Geophysical Observatories program (OGO 6) was built. The data reduction and analysis of the experiment data are discussed.
Specific power output and radiation resistance characteristics developed for thin film silicon solar cells are reported. The technological base for fabricating these high efficiency cells and limitations of cell photovoltage are included. In addition, optical and electronic measurement instrumentation and mathematical analyses aids are included. Antireflection coatings for these cells are discussed.
Recent investigations of the effect of microstructure on the fracture mechanisms and fracture toughness of steels, aluminum alloys, and titanium alloys have used standard fractographic techniques and a sectioning technique on specimens plastically deformed to various strains up to fracture. The specimens are prepared metallographically for observation in both optical and electron beam instruments. This permits observations to be made about the fracture mechanism as it occurs in thick sections and helps remove speculation from the interpretation of fractographic features. This technique may be used in conjunction with other standard techniques such as extraction replicas and microprobe analyses. Care must be taken to make sure that the microstructural features which are observed to play a role in the fracture process using the sectioning technique can be identified with fractography.
The Voyager 1 low-energy charged particle instrument measured electrons and ions with energies below 26 and 40 kiloelectron volts, respectively, in the Saturn magnetosphere. Spectra of all ion species were found to have an energy cutoff at levels greater than 2 million electron volts. In contrast to the magnetospheres of Jupiter and earth, there are no lobe regions essentially devoid of particles in Saturn's nighttime magnetosphere. One novel feature of the Saturn magnetosphere is a pervasive population of energetic molecular hydrogen.
The Experimental Land Observing System (ELOS) is to demonstrate major advances in space-based land observation. Program success will depend upon successful demonstration of both space-segment performance and ground-system capabilities. Increases in data-rate, volume, and processing requirements present substantial challenges to the ground data processing system. ELOS is based on the utilization of the multispectral linear array (MLA) sensor, a solid-state, electronically scanned instrument. Current MLA instrument designs offer a number of capabilities beyond those provided in the Landsat imaging devices. These capabilities include greater resolution, inherent registration, onboard calibration, off-nadir pointing capability, and fore/aft pointing capability. The proposed MLA flight mission scenario will be one of continued growth and will include flights on the Space Transportation System. Attention is also given to ground-to-ground data transport, data capture, and the use of high speed computers.
Three batteries were operated in parallel from a common bus during charge and discharge. SMM utilized NASA Standard 20AH cells and batteries, and LANDSAT-D NASA 50AH cells and batteries of a similar design. Each battery consisted of 22 series connected cells providing the nominal 28V bus. The three batteries were charged in parallel using the voltage limit/current taper mode wherein the voltage limit was temperature compensated. Discharge occurred on the demand of the spacecraft instruments and electronics. Both flights were planned for three to five year missions. The series/parallel configuration of cells and batteries for the 3-5 yr mission required a well controlled product with built-in reliability and uniformity. Examples of how component, cell and battery selection methods affect the uniformity of the series/parallel operation of the batteries both in testing and in flight are given.
The fabrication and operation of membrane switches are discussed. The membrane switch functions as a normally open, momentary contact, low-voltage pressure-sensitive device. Its design is a three-layer sandwich usually constructed of polyester film. Conductive patterns are deposited onto the inner side of top and bottom sheets by silk screening. The center spacer is then placed between the two circuit layers to form a sandwich, generally held together by an adhesive. When pressure is applied to the top layer, it flexes through the punched openings of the spacer to establish electrical contact between conductive pads of the upper and lower sheets, momentarily closing the circuit. Upon release of force the top sheet springs back to its normal open position. The membrane touch switch is being used in a rapidly expanding range of applications, including instrumentation, appliances, electronic games and keyboards. Its board acceptance results from its low cost, durability, ease of manufacture, cosmetic appeal and design flexibility. The principal electronic components in the membrane switch are the conductor and dielectric.
The Giotto spacecraft will carry sensors for investigating the interplanetary magnetic field while en route and the interaction between the solar wind magnetoplasma and Halley's Comet neutral gas outflow during close approach. Giotto will carry an outboard biaxial fluxgate system and inboard electronics. The instrumentation draws 1.2 kW and weighs 1.31 kg. Sampling rates will be 28/sec during close encounter, covering selectable ranges from 16 nT to 65,535 nT. In-flight calibration techniques are under development to ensure magnetic cleanliness will be obtained. Measurements are also planned of the inbound bow shock, the magnetosheath and the cometary ionopause. The data will be collected as close as 1000 km from the comet surface.
This letter reports the detection and resolution of the characteristic X-ray of oxygen at 523 eV and other ultrasoft X-rays (photons energy less than 1 keV) using radiation detectors fabricated from the compound semi-insulator mercuric iodide (HgI2). These detectors are capable of operation at room ambient but in these experiments were slightly cooled using a Peltier element to 0 C. A pulsed light feedback preamplifier with a Peltier element cooled (to -30 deg) first stage field-effect transistor was used to amplify signals from the detector. Overall system noise level was 185 eV (full width at half-maximum) limited by the temperature of the first stage field-effect transistor. With optimal cooling of this element the characteristic X-ray of carbon at 282 eV should be measurable. These results would seem to be important in measurement of biological samples in electron column instruments.
Progress made in the following areas is discussed: low energy ion and electron experiments; instrument design for current experiments; magnetospheric measurement of particles; ion measurement in the earth plasma sheet; abundance measurement; X-ray data acquisition; high energy physics; extragalactic astronomy; compact object astrophysics; planetology; and high energy photon detector technology.
For the period 1978 September to 1983 December, 67 solar particle events have been identified for which the instruments detected electrons above 3 MeV and for which there are soft X-ray observations. The events are divided into two classes impulsive and long-duration - based on their signature in soft X-rays, and it is found that they have different properties. The events originating with impulsive flares are associated with intensed meter-wavelength type III bursts with associated type V continuum. The events associated with long-duration flares can originate anywhere on the solar disk, extend to much higher proton energies, and are well associated with coronal and interplanetary shocks; for about half of the long-duration events, the associated meter-wavelength events do not include type III bursts. The results discovered by Evenson et al. (1984) and by Kahler et al. (1984) are extended.
As Ada solidified in its development, it became evident that it offered advantages for avionics systems because of it support for modern software engineering principles and real time applications. An Ada programming support environment was developed for two major avionics subsystems in the Beech Starship. The two subsystems include electronic flight instrument displays and the flight management computer system. Both of these systems use multiple Intel 80186 microprocessors. The flight management computer provides flight planning, navigation displays, primary flight display of checklists and other pilot advisory information. Together these systems represent nearly 80,000 lines of Ada source code and to date approximately 30 man years of effort. The Beech Starship avionics systems are in flight testing.
Since launch in early 1980 the gamma-ray spectrometer (GRS) on SMM has monitored the sun at gamma-ray energies. In addition to observations of solar flares, cosmic gamma-ray bursts, and precipitating radiation-belt electrons, the instrument has detected a new class of high-energy transient events that cannot be attributed to any of these phenomena. The duration of these transients can range from 1 sec to more than 10 min. The average event rate between 1980 and 1986 was about five per month. However, in February 1987 this rate increased by more than a factor of 25 and continued at this high level until June 1988. These transients can be subdivided into three classes: 511-keV annihilation-line events, particle events, and broad-band photon continuumlike events. It is found that the most likely sources of these events are reactors in earth-orbiting satellites.
High-latitude electric potential and ionospheric conductance patterns are presented and discussed for the Northern Hemisphere during the SUNDIAL period of September 23-26, 1986 using the Assimilative Mapping of Ionospheric Electrodynamics (AMIE) technique of Richmond and Kamide (1988). Data sources used for the model are satellite and ground magnetometers, electron precipitation instruments, incoherent scatter radars, and ionospheric coherent radars. The period was characterized by many substorms, and a wide variety of instantaneous patterns of electrodynamic parameters on a hemispheric scale are derived throughout this period, of which only a few examples are displayed. The entire set of electric potentials and conductances are being made available through the NCAR CEDAR Data Base for further analysis and utilization in simulation models.
The microstructure and composition of taenite particles were examined in two type-6 ordinary chondrites, Kernouve (H6) and Saint Severin (LL6), using reflected light microscopy and a combination of electron optical instruments. It was found that, in both meteorites, the taenite particles consisted of a narrow rim of high-Ni taenite and a central region of cloudy zone similar to those present in iron meteorites. The microstructure of the cloudy zone in Saint Severin was coarser than that in Kernouve , due to the higher Ni content and slower cooling rate of the former. Three microstructural zones were observed in the outer taenite rim of both meteorites, the origin of which is considered likely to be due to the presence of ordered domain boundaries or to the presence of two phases FeNi and FeNi3 in the high-Ni region of the outer taenite rim.
A piloted flight simulator experiment was conducted to evaluate issues related to the display of microburst alerts on electronic cockpit instrumentation. Issues addressed include display clarity, usefulness of multilevel microburst intensity information, and whether information from multiple sensors should be presented separately or 'fused' into combined alerts. Nine active airline pilots of 'glass cockpit' aircraft participated in the study. Microburst alerts presented on a moving map display were found to be visually clear and useful to pilots. Also, multilevel intensity information coded by colors or patterns was found to be important for decision making purposes. Pilot opinion was mixed on whether to 'fuse' data from multiple sensors, and some resulting design tradeoffs were identified. The positional information included in the graphical alert presentation was found useful by the pilots for planning lateral missed approach maneuvers, but may result in deviations which could interfere with normal airport operations. A number of flight crew training issues were also identified.