OECD MCCI Project: Small-Scale Water Ingression and Crust Strength Tests (SSWICS) (SSWICS 11 Design Report)
During the course of the first MCCI program (MCCI-1), seven small-scale water ingression tests were performed with 75 kg corium melts made up of UO 2 and varying amounts of either siliceous or limestone common sand concrete. The concrete contents varied from a low of 4 wt% to a high of 23 wt%. These tests demonstrated that melt cooling can be enhanced by water ingression made possible by thermal stress-induced cracking, and that the role of water ingression increases with decreasing concrete content. The dependence of the water ingression cooling rate on concrete content is strongest for melts containing less than 14% concrete. For melts with 14% or more concrete, little evidence of water ingression cooling was discernible. It was also found that melts with siliceous concrete cooled at about the same rate as melts with a similar amount of limestone common sand concrete. One aim of the current MCCI program (MCCI-2) is to investigate the role of gas sparging on the corium cooling rate. The gases are a byproduct of the decomposition of concrete, which occurs when the material overheats. Gases generated near the corium/concrete interaction zone at the bottom of the melt are propelled up through the corium by buoyancy forces and the resultant gas flow has the potential to create melt porosity. This porosity is expected to supplement the fissures induced by thermal stress cracking. It is thought that these extra pathways could enhance the amount of water ingression cooling and quench the melt more rapidly than the case without sparging gases. This report describes the gas injection system to be used for SSWICS-11 along with test conditions and a summary of the test procedure. The report first revisits much of the design rationale for the gas sparging system that was detailed in the SSWICS-8 report. The reason for including the material again here is that, assuming this test is successful, there will be little inclination to refer to the earlier report for design background since that test was effectively one without gas sparging. Therefore all potentially pertinent material will be included in this single report. The next section describes the gas sparging system for SSWICS-11 by beginning with the design rationale for the system used in SSWICS-8.