Search NASA⌕ Search

SEARCH · Search NASA

Results for “phase stability”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

Optical properties monitor: Experiment definition phase

The stability of materials used in the space environment will continue to be a limiting technology for space missions. The Optical Properties Monitor (OPM) Experiment provides a comprehensive space research program to study the effects of the space environment-both natural and induced-on optical, thermal and space power materials. The OPM Experiment was selected for definition under the NASA/OAST In-Space Technology Experiment Program. The results of the OPM Definition Phase are presented. The OPM Experiment will expose selected materials to the space environment and measure the effects with in-space optical measurements. In-space measurements include total hemispherical reflectance total integrated scatter and VUV reflectance/transmittance. The in-space measurements will be augmented with extensive pre- and post-flight sample measurements to determine other optical, mechanical, electrical, chemical or surface effects of space exposure. Environmental monitors will provide the amount and time history of the sample exposure to solar irradiation, atomic oxygen and molecular contamination.

Wilkes, Donald R.↗
NASA NTRS1962

STABILITY OF FILM BOILING TWO-PHASE FLOW IN CRYOGENIC SYSTEMS

The stability of film boiling two phase flow is investigated referring in particular to saturated cryogenic liquids. This type of fluid motion is unstable, such that a range of wave numbers will always be present in which disturbances are amplified. Further the mode of operation of the energy supply system may favour temperature fluctuations of large amplitude if the circuit does not provide feed-back compensation. The theoretically predicted stabilization due to capillarity is reduced considerably in liquefied gases with low surface tension, such as hydrogen. This effect causes the transition to turbulent flow to occur at low Reynolds numbers, and increases the heat transport in the turbulent regime. A comparison with experimental data, (horizontal cylinder), shows that the "critical" film Reynolds number ūδ/𝜈, at which instabilities become effective, is lowered from approximately 200, (O2), to about 30, (H2). Similar results have been found with other configurations. Therefore application of laminar film boiling solutions is restricted to small objects, entrance regions, or stagnation points. Turbulent correlations given so far are valid only for a certain group of substances with similar behavior.

LIQUID FLOW↗
NASA NTRS1989

The influence of annealing in the ferrite-plus-austenite phase field on the stability of vanadium carbide precipitates

The effect of rapid excursions into the ferrite-plus-austenite two-phase field on V4C3 precipitates formed by tempering in the ferrite phases was investigated. Heat treatments were first performed to produce a starting microstructure of fine vanadium carbide particles precipitated in a ferrite matrix, and the microstructure was then subjected to various short-time heat treatment cycles that transformed part of the matrix to austenite. TEM was used to determine the effects of the matrix change on the size, morphology, and distribution of the vanadium carbide particles.

Locci, I. E.↗
NASA NTRS2024

Understanding Mercury’s Magmatic History: Geochemical Affinity, Compatibility, & Volatility Changes Due to Reduction

Mercury’s depletion in O and abundance of S substituting in as S2- has fundamental effects on the physicochemical properties of minerals and melts because O2- is the dominant rock-forming anion. These changes exert a first order effect on planetary body evolution, including the initial distribution of elements, crystallization paths, stability of phases, and mineral chemistry. Experimental and empirical data have revealed that most nominally lithophile elements become more chalcophile and/or siderophile at reducing conditions, which can be visualized through a re-interpreted Goldschmidt classification table prepared for McCubbin & Anzures’s Treatises of Geochemistry 3rd edition chapter under review. Additionally, the S bonding environment influences Mercurian phase equilibria by decreasing the stability of forsterite and anorthite while increasing the stability of enstatite, silica, and albite through re-projection of silicate ternaries.

Brendan Anthony Anzures↗
NASA NTRS1984

A frequency domain stability analysis of a phase plane control system

A describing function is used to model a phase plane controller which is part of the Space Shuttle on-orbit Reaction Control System autopilot. A frequency domain stability analysis of the closed-loop control system is applied to a study of potential flight control system interaction with the Orbiter and a class of payloads deployed from a tilt table. Phase-gain plot techniques are used to show that expansion of phase plane angular rate limits and stiffening of the tilt table pivot do not always enhance system stability. Instability region approximations are mapped as a function of rate limit, payload geometry, jet used, and natural frequency of the pivot. Comparison of the describing function analysis with simulation results shows excellent correlation.

Hattis, P. D.↗
NASA NTRS1985

Effects of upstream-biased third-order space correction terms on multidimensional Crowley advection schemes

The impact of upstream-biased corrections for third-order spatial truncation error on the stability and phase error of the two-dimensional Crowley combined advective scheme with the cross-space term included is analyzed, putting primary emphasis on phase error reduction. The various versions of the Crowley scheme are formally defined, and their stability and phase error characteristics are intercompared using a linear Fourier component analysis patterned after Fromm (1968, 1969). The performances of the schemes under prototype simulation conditions are tested using time-dependent numerical experiments which advect an initially cone-shaped passive scalar distribution in each of three steady nondivergent flows. One such flow is solid rotation, while the other two are diagonal uniform flow and a strongly deformational vortex.

Schlesinger, R. E.↗
NASA NTRS1992

Glass-Derived Superconductive Ceramic

Critical superconducting-transition temperature of 107.2 K observed in specimen made by annealing glass of composition Bi1.5Pb0.5Sr2Ca2Cu3Ox for 243 h at 840 degrees C. PbO found to lower melting temperature and viscosity of glass, possibly by acting as fluxing agent. Suggested partial substitution of lead into bismuth oxide planes of crystalline phase having Tc of 110 K stabilizes this phase and facilitates formation of it.

Bansal, Narottam P.↗
NASA NTRS1975

Stability characteristics of a single-phase free convection loop

Experiments investigating the stability characteristics of a single-phase free convection loop are reported. Results of the study confirm the contention made by previous workers that instabilities near the thermodynamic critical point can occur for ordinary fluids as well as those with unusual behavior in the near-critical region. Such a claim runs counter to traditional beliefs, but it is supported by the observation of such instabilities for water at atmospheric pressure and moderate temperatures in the present work.

Creveling, H. F.↗
NASA NTRS1984

Stabilizing Fiber-Optic Transmission Lines

Voltage-controlled optical phase shifter is key. Optical phase shifter stabilizes propagation delay of fiber-optic transmission line by compensating for temperature and pressure effects. Applicable to phased array antenna systems and very-long-baseline interferometer distribution systems.

Lutes, G. F.↗
NASA NTRS1991

Stabilization of high Tc phase in bismuth cuprate superconductor by lead doping

It has been widely ascertained that doping of lead in Bi-Sr-Ca-Cu-O systems promotes the growth of high T sub c (110 K) phase, improves critical current density, and lowers processing temperature. A systematic study was undertaken to determine optimum lead content and processing conditions to achieve these properties. A large number of samples with cationic compositions of Bi(2-x)Pb(x)Sr2Ca2Cu3 (x = 0.2 to 2.0) were prepared by conventional solid state reaction technique. Samples of all compositions were annealed together at a temperature and characterized through resistance temperature (R-T) measurements and x ray diffraction to determine the zero resistance temperature, T sub c(0) and to identify presence of phases, respectively. The annealing temperature was varied between 790 and 880 C to optimize processing parameters. Results are given. In brief, an optimum process is reported along with composition of leaded bismuth cuprate superconductor which yields nearly a high T sub c single phase with highly stable superconducting properties.

Gupta, Ram. P.↗
NASA NTRS1987

Slip casting and extruding shapes of rhemium with metal oxide additives. Part 2: Development of grain stabilized rhenium parts for resistojets

The adaptation of the powdered particle process used for pure metal oxides to the coprocessing of rhenium oxides suitable to produce pure miniature resistojet hardware has been successful. Both slip casting and extrusion processes were used. The metal oxide ZrO2 was stabilized into the cubic phase with Y2O3, for use as a potentially grain stabilizing additive to rhenium. Straight meter long tubing in two sizes are reported. Tubing suitable for resistojet ohmic heater use of fully fired dimensions of nominally 3.8 mm o.d. x 2.2 mm i.d.. and 1.26 mm o.d. x .45 mm i.d. with 0, 0.5, 1.0 and 5.0% zirconia additives were produced for further study. Photomicrographs of these are discussed. The addition of the metal oxide zirconia to rhenium resulted in more dense and less porous parts. The additions of phase stabilized zirconia most likely act as a sintering aid. Tubes of varying diameter were slip cast which were representative of miniature pressure cases.

Barr, Francis A.↗
NASA NTRS1989

Multipurpose exciter with low phase noise

Results of an effort to develop a lower-cost exciter with high stability, low phase noise, and controllable phase and frequency for use in Deep Space Network and Goldstone Solar System Radar applications are discussed. Included is a discussion of the basic concept, test results, plans, and concerns.

Conroy, B.↗
NASA NTRS1991

Thermochemical analysis of the silicon carbide-alumina reaction with reference to liquid-phase sintering of silicon carbide

The stabilities of different phases in the Si-Al-C-O system are calculated from thermodynamic considerations with the objective of identifying the liquid phases formed during sintering of SiC in the presence of Al2O3. It is shown that a liquid phase can form at the sintering temperatures by the reaction of SiC with Al2O3. Depending on the carbon activity, the liquid can be either of the following: Al2O3 + Al4C3, SiC + Al4C3, or molten aluminum. The stability of the aluminosilicate melts that can form by the reaction of Al2O3 with the surface silica layer on SiC powders is also evaluated. Several factors that influence liquid-phase sintering, such as the solubility of SiC in the melts and the generation of gases during sintering, are discussed. The results of the thermodynamic analysis are compared with the observed sintering behavior for SiC.

Misra, Ajay K.↗
NASA NTRS1984

A low noise synthesizer for autotuning and performance testing of hydrogen masers

A low noise synthesizer has been developed for use in hydrogen maser autotuning and performance evaluation. This synthesizer replaces the frequency offset maser normally used for this purpose and allows the user to maintain all masers in the ensemble at the same frequency. The synthesizer design utilizes a quartz oscillator with a BVA resonator. The oscillator has a frequency offset of 5 X 10 to the minus 8 power. The BVA oscillator is phase-locked to a hydrogen maser by means of a high gain, high stability phase-locked loop, employing low noise multipliers as phase error amplifiers. A functional block diagram of the synthesizer and performance data will be presented.

Cloeren, J. M.↗
NASA NTRS1981

Stability analysis of automobile driver steering control

In steering an automobile, the driver must basically control the direction of the car's trajectory (heading angle) and the lateral deviation of the car relative to a delineated pathway. A previously published linear control model of driver steering behavior which is analyzed from a stability point of view is considered. A simple approximate expression for a stability parameter, phase margin, is derived in terms of various driver and vehicle control parameters, and boundaries for stability are discussed. A field test study is reviewed that includes the measurement of driver steering control parameters. Phase margins derived for a range of vehicle characteristics are found to be generally consistent with known adaptive properties of the human operator. The implications of these results are discussed in terms of driver adaptive behavior.

Allen, R. W.↗
NASA NTRS1990

Phase-Compensating System For Fiber-Optic Holography

Phase-compensating system controls relative phase of laser light emitted from two optical fibers. Stabilized for conventional holographic applications, or stepped through sequence of 90 degree phase shifts for phase-stepping holographic interferometry. Closed-loop system compensates for phase fluctuations caused by mechanical stresses and temperature changes in fibers, providing long-term phase stability and phase steps accurate to within 0.02 degrees. Controls environmental fluctuations in phases of light emitted by output fibers.

Mercer, Carolyn R.↗