Search NASA⌕ Search

SEARCH · Search NASA

Results for “representativeness”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

A high subsonic speed wind tunnel investigation of winglets on a representative second-generation jet transport wing

The effects of winglets on the aerodynamic forces and moments, loads, and crossflow velocities behind the wing tip are discussed. The results of the investigation indicate that winglets significantly reduce the drag coefficient at lifting conditions. The experiments were conducted in an 8-foot transonic pressure tunnel at Mach numbers from 0.70 to 0.83 and over a lift coefficient range up to 0.65. A semispan model was used.

Flechner, S. G.↗
NASA NTRS1976

The effect of winglets on the static aerodynamic stability characteristics of a representative second generation jet transport model

A baseline wing and a version of the same wing fitted with winglets were tested. The longitudinal aerodynamic characteristics were determined through an angle-of-attack range from -1 deg to 10 deg at an angle of sideslip of 0 deg for Mach numbers of 0.750, 0.800, and 0.825. The lateral aerodynamic characteristics were determined through the same angle-of-attack range at fixed sideslip angles of 2.5 deg and 5 deg. Both configurations were investigated at Reynolds numbers of 13,000,000, per meter (4,000,000 per foot) and approximately 20,000,000 per meter (6,000,000 per foot). The winglet configuration showed slight increases over the baseline wing in static longitudinal and lateral aerodynamic stability throughout the test Mach number range for a model design lift coefficient of 0.53. Reynolds number variation had very little effect on stability.

Jacobs, P. F.↗
NASA NTRS1976

On the use of Pade approximants to represent unsteady aerodynamic loads for arbitrarily small motions of wings

The general behavior of unsteady airloads in the frequency domain is explained. Based on this, a systematic procedure is described whereby the airloads, produced by completely arbitrary, small, time-dependent motions of a thin lifting surface in an airstream, can be predicted. This scheme employs as raw materials any of the unsteady linearized theories that have been mechanized for simple harmonic oscillations. Each desired aerodynamic transfer function is approximated by means of an appropriate Pade approximant, that is, a rational function of finite degree polynomials in the Laplace transform variable. Although these approximations have many uses, they are proving especially valuable in the design of automatic control systems intended to modify aeroelastic behavior.

Vepa, R.↗
NASA NTRS1975

Building application of solar energy. Study no. 2: Representative buildings for solar energy performance analysis and market penetration

The following topics are discussed: (1) Assignment of population to microclimatic zones; (2) specifications of the mix of buildings in the SCE territory; (3) specification of four typical buildings for thermal analysis and market penetration studies; (4) identification of the materials and energy conserving characteristics of these typical buildings; (5) specifications of the HVAC functions used in each typical building, and determination of the HVAC systems used in each building; and (6) identification of the type of fuel used in each building.

Hirshberg, A. S.↗
NASA NTRS1977

Solar power satellite. System definition study. Part 1, volume 5: SPS transportation. Representative system descriptions

Both LEO transportation (earth to low earth orbit) and GEO transportation (low earth orbit to geosynchronous orbit) segments were addressed. LEO options include both a 2 stage winged space freighter vehicle and a 2 stage ballistic recoverable vehicle. Both incorporate LO(2)/RP-1/LH(2) engines on the booster and standard SSME's on the upper stage. The orbit transfer vehicle options included chemical for geosynchronous satellite assembly and self powered electric propulsion for low earth orbit satellite assembly. An exhaust products analysis was conducted for the earth to LEO vehicle since atmospheric pollution could be a concern.

Source record↗
NASA NTRS1979

Vibration characteristics of walls and a plate glass window representative of those of a wood-frame house

Mechanical excitation was used, and measurements of acceleration response, natural frequencies, and nodal patterns were performed. Results indicate that the wall sections and the complete wall did not act as a unit in responding to sinusoidal vibration inputs. Calculated frequencies of the components that account for this independent behavior of the studs and face sheets agreed resonably well with experimental frequencies. Experimental vibrations of the plate glass window agreed with the calculated behavior, and responses of the window exposed to airplane flyover noise were readily correlated with the test results.

Carden, H. D.↗
NASA NTRS1982

The Snake River Plain, Idaho - Representative of a new category of volcanism

Studies of the volcanic geology of the Snake River Plain, Idaho, and comparison with other basaltic regions suggest a new category of volcanic activity, termed basaltic plains volcanism. Typified by the Snake River Plain, this style of volcanism is intermediate between basaltic flood (or plateau) eruptions and Hawaiian volcanism. Characteristics that are common to both Hawaiian and plains volcanism are: multiple lava flow units which erupt primarily from point sources, formation of low shields, and frequent emplacement through lava tubes or channels. Characteristics that are common to both flood basalts and plains volcanism are: high volume flows, vents aligned along rift zones, and planar surfaces. The recognition of plains volcanism in other areas provides a means to interpret the style of eruption and volcanic history.

Greeley, R.↗
NASA NTRS1982

Servicing costs for representative service missions

User cost for three satellite services were assessed. The three missions are: advanced X-ray astrophysics facility (AXAF) revisit; upper atmosphere research satellite (UARS) revisit: and solar maximum mission (SMM) Earth return. Service scenarios for the missions to identify service equipment needs and on orbit usage were developed. The AXAF revisit is a service mission involving a contamination sensitive satellite. Following servicing and checkout, the spacecraft is redeployed from the orbiter. The total user charges for revisit missions is from 5 to 10% less than the cost to build and relaunch a replacement satellite. It is indicated that satellite servicing from the Orbiter is cost effective.

Mockovciak, J., Jr.↗
NASA NTRS1983

Development of a simplified analytical method for representing material cyclic response

Development of a simplified method for estimating structural inelastic stress and strain response to cyclic thermal loading is presented. The method assumes that high temperature structural response is the sum of time independent plastic and time dependent elastic/creep components. The local structural stress and strain response predicted by linear elastic analysis is modified by the simplified method to predict the inelastic response. The results with simulations by a nonlinear finite element analysis and used time independent plasticity and unified time dependent material model are compared.

Moreno, V.↗
NASA NTRS1983

Phytoxicity study of the products of wet oxidation of a representative biomass (lettuce)

In an attempt to verify the results reported previously concerning the phytotoxicity of wet-oxidation (wet-ox) products, lettuce solids were suspended in water and then heated to 548 K for 3.6 ksec (1 hr) under 4.1x10 to the -7 Pa (400 psig at 294 K) oxygen pressure and 1.52x10 to the 8th (1500 psig at 548 K) total pressure. Such treatment resulted in oxidation of 80% of the initial organic carbon to carbon dioxide. Thirty-three percent of the remaining organic carbon was present in acetic acid. Organic nitrogen in the feed was decreased 90% by the wet-ox treatment. Ammonia and nitrogen gas were the main nitrogen products. Analysis of the liquid product of wet-ox indicated that most of the minerals essential for plant growth were present. However, when tested using a lettuce-root growth-rate assay, the solution was toxic. This toxicity was not due to excessive salt or ammonia or to an improper pH. Analysis of the wet-ox solution revealed the presence of silver and chromium, thus implicating reactor corrosion as the cause of the phytotoxicity. Both cation and anion exchange resins removed the silver and the toxicity of the liquid effluent, indicating silver as the toxic component. Uptake of both silver and chromium by lettuce roots correlated with diminished root growth. Toxicity of the solution from wet-ox was not observed when precautions were taken to minimize contact of the liquid in the reactor with the metal reactor components.

Onisko, B. L.↗
NASA NTRS1984

Reflections on representing non-geometric data

The American National Standard Y14.26M-1981 on Digital Representation for Communication of Product Definition Data includes an introduction, three sections corresponding to IGES (Initial Graphics Exchange Specification) Version 1.0, and Section 5, which is a constructive, relational, language based representation for geometric and topological entitles.

Emnett, R. F.↗
NASA NTRS1984

Aeromechanical stability analysis of a multirotor vehicle model representing a hybrid heavy lift airship (HHLA)

Hybrid Heavy Lift Airship (HHLA) is a proposed candidate vehicle aimed at providing heavy lift capability at low cost. This vehicle consists of a buoyant envelope attached to a supporting structure to which four rotor systems, taken from existing helicopters are attached. Nonlinear equations of motion capable of modelling the dynamics of this coupled multi-rotor/support frame/vehicle system have been developed. Using these equations of motion the aeroelastic and aeromechanical stability analysis is performed aimed at identifying potential instabilities which could occur for this type of vehicle. The coupling between various blade, supporting structure and rigid body modes is identified. Furthermore, the effects of changes in buoyancy ratio (Buoyant lift/total weight) on the dynamic characteristics of the vehicle are studied. The dynamic effects found are of considerable importance for the design of such vehicles. The analytical model developed is also useful for studying the aeromechanical stability of single rotor and tandem rotor coupled rotor/fuselage systems.

Venkatesan, C.↗
NASA NTRS1985

Abrasion behavior of aluminum and composite skin coupons, stiffened skins and stiffened panels representative of transport airplane structures

A three-phase investigation was conducted to compare the friction and wear response of aluminum and graphite-epoxy composite materials when subjected to loading conditions similar to those experienced by the skin panels on the underside of a transport airplane during an emergency belly landing on a runway surface. The first phase involved a laboratory test which used a standard belt sander to provide the sliding abrasive surface. Small skin-coupon test specimens were abraded over a range of pressures and velocities to determine the effects of these variables on the coefficient of friction and wear rate. The second phase involved abrading I-beam stiffened skins on actual runway surface over the same range of pressures and velocities used in the first phase. In the third phase, large stiffened panels which most closely resembled transport fuelage skin construction were abraded on a runway surface. This report presents results from each phase of the investigation and shows comparisons between the friction and wear behavior of the aluminum and graphite-epoxy composite materials.

Jackson, K. E.↗
NASA NTRS1985

The Southern Hemisphere circulation during the FGGE and its representativeness

An analysis of the global redistribution of mass during the FGGE year indicates that the global circulation was highly anomalous in several respects, especially from April to July 1979. For the 56 to year period 1924-1980, sea-level pressures over the northern hemisphere during the FGGE year were second highest in spring and highest in summer. In April and June, the anomalies were 1-in-100-year events. At the same time, sea-level pressure deficits and an exceptionally deep circumpolar trough were recorded over the Southern Hemisphere. Such compensation between the hemispheres, through the constraint of conservation of mass, provides support for the highly typical nature of the circulation analyzed to exist over the Southern Hemisphere throughout the FGGE year. The Southern Hemisphere circulation was characterized by an exceptionally deep circumpolar trough, an increase in westerlies from 40 deg to 70 deg S, and a decrease in westerlies to the north. In winter, the subtropical jet was weaker and the polar jet stronger than normal, so that a pronounced double jet structure prevailed. In summer, the jet was shifted south by 3 deg latitude. A southward shift in storm tracks accompanied these changes year round in a manner consistent with theory.

Trenberth, K. E.↗