Search NASA⌕ Search

SEARCH · Search NASA

Results for “wave parameter”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12

On the accuracy of the pseudocompressibility method in solving the incompressible Navier-Stokes equations

The method of pseudocompressibility is tested for its accuracy in solving the incompressible Navier-Stokes equations. An implicit, finite difference computer code is used to solve the equations in a three-dimensional, curvilinear coordinate system. The code employs artificial compressibiity for solving the pressure field, coupled with an implicit, approximate factorization scheme. This coupling is known as the pseudocompressibility method and introduces pressure waves of finite speed into the fluid medium that would otherwise have an infinite sound speed. The waves die out as the solution converges, and the steady state solution approaches a divergence-free condition. These waves, however, limit the time accuracy of the computations. The effects of these waves are analysed and criteria are set for choosing the pseudocompressibility parameter that governs the pressure wave speed; test cases are presented that verify these criteria. The code is tested by computing laminar flow over a two-dimensional, backward-facing step and over a two-dimensional, impulsively started circular cylinder.

Rogers, S. E.↗

Study made to establish parameters and limitations of explosive welding

It is theorized that metal jetting must be present for welding to occur, therefore an explosive weld interface may indicate the relation between the metal jet velocity and shock wave velocity in welding. Parameters for effecting explosive welding in patches of 3 or 4 inches in diameter were established, and found applicable to explosive welding of patches of various sizes.

Polhemus, F. C.↗

Influence of a weak gravitational wave on a bound system of two point-masses

The problem of a weak gravitational wave impinging upon a nonrelativistic bound system of two point masses is considered. The geodesic equation for each mass is expanded in terms of two small parameters, v/c and dimensionless wave amplitude, in a manner similar to the post-Newtonian expansion; the geodesic equations are resolved into orbital and center-of-mass equations of motion. The effect of the wave on the orbit is determined by using Lagrange's planetary equations to calculate the time evolution of the orbital elements. The gauge properties of the solutions and, in particular, the gauge invariance of the secular effects are discussed.

Turner, M. S.↗

Surface generation and detection of coupled fiber-matrix mode acoustic wave propagation in fiber-reinforced composites

A technique is described that makes it possible to transmit and receive bulk ultrasonic waves launched from the same surface of a composite sheet by means of transducers mounted on variable angle blocks. A straightforward approach to measure the velocity and attenuation of this wave is presented. A bulk compressional wave of 930,000 cm/sec velocity was launched and received in this manner in an 8-ply unidirectional T-300-5208 epoxy composite. Preliminary results indicate that parameters associated with this wave might be sensitive to accumulated damage in a composite; thus, the technique has a potential for NDE in structures made from composite materials.

Yost, W. T.↗

Simulation of a Rapid Dropout Event for Highly Relativistic Electrons with the RBE Model

A flux dropout is a sudden and sizable decrease in the energetic electron population of the outer radiation belt on the time scale of a few hours. We simulated a flux dropout of highly relativistic 2.5 MeV electrons using the Radiation Belt Environment model, incorporating the pitch angle diffusion coefficients caused by electromagnetic ion cyclotron (EMIC) waves for the geomagnetic storm events of 23-26 October 2002. This simulation showed a remarkable decrease in the 2.5 MeV electron flux during main phase of the storm, compared to those without EMIC waves. This decrease was independent of magnetopause shadowing or drift loss to the magnetopause. We suggest that the flux decrease was likely to be primarily due to pitch angle scattering to the loss cone by EMIC waves. Furthermore, the 2.5 MeV electron flux calculated with EMIC waves correspond very well with that observed from Solar Anomalous and Magnetospheric Particle EXplorer spacecraft. EMIC wave scattering is therefore likely one of the key mechanisms to understand flux dropouts. We modeled EMIC wave intensities by the Kp index. However, the calculated dropout is a several hours earlier than the observed one. We propose that Kp is not the best parameter to predict EMIC waves.

Kang, S-B.↗

Validation of a Polyimide Foam Model for Use in Transmission Loss Applications

The work described in this paper was focused on the use of a new polyimide foam in a double wall sound transmission loss application. Recall that polyimide foams are functionally attractive, compared to polyurethane foams, for example, owing to their fire resistance. The foam considered here was found to have a flow resistivity that was too high for conventional acoustical applications, and as a result, it was processed by partial crushing to lower the flow resistivity into an acceptable range. Procedures for measuring the flow resistivity and Young s modulus of the material have been described, as was an inverse characterization procedure for estimating the remaining Biot parameters based on standing wave tube measurements of transmission loss and absorption coefficient. The inverse characterization was performed using a finite element model implementation of the Biot poro-elastic material theory. Those parameters were then used to predict the sound transmission loss of a double panel system lined with polyimide foam, and the predictions were compared with full-scale transmission loss measurements. The agreement between the two was reasonable, especially in the high and low frequency limits; however, it was found that the SEA model resulted in an under-prediction of the transmission loss in the mid-frequency range. Nonetheless, it was concluded that the performance of polyimide foam could be predicted using conventional poro-elastic material models and that polyimide foam may offer an attractive alternative to other double wall linings in certain situations: e.g., when fire resistance is a key issue. Future work will concentrate on reducing the density of the foam to values similar to those used in current aircraft sidewall treatments, and developing procedures to improve the performance of the foam in transmission loss applications.

Hong, Kwanwoo↗

Loaded horizontal antenna over an imperfect ground

The effect of loading for antennas over an imperfect ground is analyzed. The Fresnel reflection coefficient technique is used to derive an E-integral equation for the antenna current. An optimization method is employed to determine the critical loading parameter which enforces a traveling wave current on the antenna. Results are given for the critical loading parameters, antenna currents, input impedances, and radiation patterns for various antenna dimensions and ground parameters. Calculations of the time-domain behavior of the current are presented to show the effect of loading on antenna transient response.

Rahmat-Samii, Y.↗

Waves generated during electron beam emissions from the Space Shuttle

Observations from the SEPAC (Space Experiments with Particle Accelerators) experiment on Spacelab 1 Shuttle mission of waves generated during electron beam emissions are presented. The dependence of the wave intensity on the beam parameters and the Shuttle attitude is outlined, and the shape of the wave spectra are discussed. It is found that the noise in the 0.75- to 10 kHz band has a spectral shape that can be characterized by an f exp -n law, and that the VLF signal level depends on the beam angle to the magnetic field, the strongest emissions being observed for parallel beams. These features are found to be consistent with a drift wave instability.

Neubert, T.↗

Parameter Estimation for Compact Binary Coalescence Signals with the First Generation Gravitational-Wave Detector Network

Compact binary systems with neutron stars or black holes are one of the most promising sources for ground-based gravitational-wave detectors. Gravitational radiation encodes rich information about source physics; thus parameter estimation and model selection are crucial analysis steps for any detection candidate events. Detailed models of the anticipated waveforms enable inference on several parameters, such as component masses, spins, sky location and distance, that are essential for new astrophysical studies of these sources. However, accurate measurements of these parameters and discrimination of models describing the underlying physics are complicated by artifacts in the data, uncertainties in the waveform models and in the calibration of the detectors. Here we report such measurements on a selection of simulated signals added either in hardware or software to the data collected by the two LIGO instruments and the Virgo detector during their most recent joint science run, including a blind injection where the signal was not initially revealed to the collaboration. We exemplify the ability to extract information about the source physics on signals that cover the neutron-star and black-hole binary parameter space over the component mass range 1M25M and the full range of spin parameters. The cases reported in this study provide a snapshot of the status of parameter estimation in preparation for the operation of advanced detectors.

Aasi, J.↗

Near-nadir radar backscatter from a well-developed sea

The Kirchhoff approximation for the case of well-developed seas is analyzed. In this peculiar case, the equilibrium range in the wave number spectrum corresponds to a cascade pattern in the surface geometry. Its high wave number cutoff is shown to be a major factor of the radar backscatter. This intrinsic scale is evaluated, and both the geometrical and the physical optics terms are related to major parameters of wind-wave dynamics. The range of validity of the Kirchhoff approximation and the relative importance of the diffraction correction are analyzed. Finally, the radar cross section sigma exp 0 of well-developed seas is compared with that of poorly developed seas. The great qualitative difference shown in the wind speed dependence of sigma exp 0 for these two regimes is pointed out as a source of a considerable error trend recently discovered in satellite altimeter wind measurements.

Glazman, Roman E.↗

Science requirements for LISA

Historically, gravitational wave antennas have been characterized by their detection capability. This is measured in terms of signal-to-noise ratio, and implies a rate of false positives and false negatives. But to do useful astrophysics, one would like to measure - or more properly, estimate - astrophysical parameters of the gravitational wave sources. In the interest of strengthening the connection between science objectives and a specific instrument performance, the LISA community has reformulated the Laser Interferometer Space Antenna (LlSA) science requirements around the anticipated uncertainty in astrophysical parameter estimation. The rationale for this characterization of LlSA and a summary of the astrophysics and fundamental physics that LISA can do will be given. LISA will be able to make precision measurements of sources out to z approximately equal to 10.

Stebbins, Robin T.↗

Signal Processing Variables for Optimization of Flaw Detection in Composites Using Ultrasonic Guided Wave Scanning

This study analyzes the effect of signal processing variables on the ability of the ultrasonic guided wave scan method at NASA Glenn Research Center to distinguish various flaw conditions in ceramic matrix composites samples. In the ultrasonic guided wave scan method, several time- and frequency-domain parameters are calculated from the ultrasonic guided wave signal at each scan location to form images. The parameters include power spectral density, centroid mean time, total energy (zeroth moment), centroid frequency, and ultrasonic decay rate. A number of signal processing variables are available to the user when calculating these parameters. These signal processing variables include 1) the time portion of the time-domain waveform processed, 2) integration type for the properties requiring integrations, 3) bounded versus unbounded integrations, 4) power spectral density window type, 5) and the number of time segments chosen if using the short-time fourier transform to calculate ultrasonic decay rate. Flaw conditions examined included delamination, cracking, and density variation.

Roth, Don J.↗

Measurement of the speed of sound in ice

The data presented demonstrate the gathering of sound speed measurements in refrigerated ice, using both compressional and shear waves, on the basis of ice thickness and sound wave time-of-travel parameters. Clear and sharp echo reflections were obtained for both compressional and shear waves at the aluminum/ice and ice/aluminum interfaces for ice at -26 C; ice formed at various conditions can have different sound speeds, depending on the density and elastic constants.

Smith, A. C.↗

Techniques for studying gravity waves and turbulence

Gravity waves and their associated breaking into turbulence are very important in producing the overall picture of middle atmosphere global dynamics and associated transport. It is shown in this research that MST radars represent a most powerful technique for obtaining the needed parameters for gravity-wave-induced drag and diffusion effects as well as measuring wave accelerations and diffusion directly. A mathematical solution to this problem is that of radiative equilibrium with a balanced thermal wind.

Geller, M. A.↗

A parametric study of self-similar blast waves.

Comprehensive examination of self-similar blast waves with respect to two parameters, one describing the front velocity and the other the variation of the ambient density immediately ahead of the front. All possible front trajectories are taken into account, including limiting cases of the exponential and logarithmic form. The structure of the waves is analyzed by means of a phase plane defined in terms of two reduced coordinates. Loci of extrema of the integral curves in the phase plane are traced, and loci of singularities are determined on the basis of their intersections. Boundary conditons are introduced for the case where the medium into which the waves propagate is at rest. Representative solutions, pertaining to all the possible cases of blast waves bounded by shock fronts propagating into an atmosphere of uniform density, are obtained by evaluating the integral curves and determining the corresponding profiles of the gasdynamic parameters. Particular examples of integral curves for waves bounded by detonations are given, and all the degenerate solutions corresponding to cases where the integral curve is reduced to a point are delineated.

Oppenheim, A. K.↗

Scatterometer capabilities in remotely sensing geophysical parameters over the ocean: The status and the possibilities

Extensive comparison between surface measurements and satellite Scatt signal and predicted winds show successful wind and weather analysis comparable with conventional weather service analyses. However, in regions often of the most interest, e.g., fronts and local storms, inadequacies in the latter fields leaves an inability to establish the satellite sensor capabilities. Thus, comparisons must be made between wind detecting measurements and other satellite measurements of clouds, moisture, waves or any other parameter which responds to sharp gradients in the wind. At least for the windfields and the derived surface pressure field analysis, occasional surface measurements are required to anchor and monitor the satellite analyses. Their averaging times must be made compatible with the satellite sensor measurement. Careful attention must be paid to the complex fields which contain many scales of turbulence and coherent structures affecting the averaging process. The satellite microwave system is capable of replacing the conventional point observation/numerical analysis for the ocean weather.

Brown, R. A.↗

Measuring Parameters of Massive Black Hole Binaries with Partially-Aligned Spins

It is important to understand how well the gravitational-wave observatory LISA can measure parameters of massive black hole binaries. It has been shown that including spin precession in the waveform breaks degeneracies and produces smaller expected parameter errors than a simpler, precession-free analysis. However, recent work has shown that gas in binaries can partially align the spins with the orbital angular momentum, thus reducing the precession effect. We show how this degrades the earlier results, producing more pessimistic errors in gaseous mergers. However, we then add higher harmonics to the signal model; these also break degeneracies, but they are not affected by the presence of gas. The harmonics often restore the errors in partially-aligned binaries to the same as, or better than/ those that are obtained for fully precessing binaries with no harmonics. Finally, we investigate what LISA measurements of spin alignment can tell us about the nature of gas around a binary,

Lang, Ryan N.↗