Search NASA⌕ Search

SEARCH · Search NASA

Results for “AUTOPILOT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 235 records · Page 13
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

Aeroelastic effects on space shuttle dynamics

A simplified analysis procedure for determining static and dynamic aeroelastic loads for the space shuttle and space shuttle configuration is presented. A computer program, originally developed for the Atlas launch vehicle, was modified for simplifying the turbulence response analysis approach. This approach is compared with a more detailed and time consuming approach to space shuttle response to turbulence which was developed earlier. The simplification in going from interference to lumped aerodynamic data was found to give adequate results for preliminary design aeroelastic analysis. Gust loads were found to be approximately 50% of the maximum static aeroelastic loads. The autopilot became unstable when ten elastic modes were included. Elastic effects were found to be less than 3% in the static aeroelastic analysis.

Source record↗
NASA NTRS1973

Separate surfaces for automatic flight controls.

The purpose of this paper is to describe an investigation of separate surface stability augmentation systems for general aviation aircraft. The program objective were twofold: first, a wind tunnel program to determine control effectiveness of separate surfaces in the presence of main surfaces, and hinge moment feedback from separate surfaces via the main surfaces to the pilot; second, a theoretical study to determine the minimum performance of actuators and sensors that can be tolerated, the best slaving gains to be used with separate surfaces, and control authority needed for proper operation under direct pilot control, under autopilot control, and in failure situations. On the basis of the results obtained, it has been concluded that separate surface systems are feasible and advantageous for use in general aviation aircraft.

Roskam, J.↗
NASA NTRS1973

Navigation, guidance, and control systems for V/STOL aircraft.

The development of digital autopilots and integrated avionics systems, applicable to many classes of vehicles and missions, was undertaken by Sperry Flight Systems in the mid-sixties. The first application of the system was planned for automatic flight control in the U.S. supersonic transport; the termination of that program, however, thwarted any flight experience. The second application, which has additional navigation and energy management functions, is an airborne simulator of the space shuttle vehicle. The latter system underwent a series of successful flight tests in a CV-990 aircraft under contract with NASA. The third application, which has new electronic displays, air data computation, and time-constrained guidance (i.e., specified position and altitude at a specified time), is in the DOT/NASA STOLAND test program. The STOLAND system is described specifically in this paper.

Osder, S. S.↗
NASA NTRS1973

Flight director design for a STOL aircraft.

The study described here was intended to explore some ways of giving the pilot the information necessary to perform as well as an autopilot. A fixed-base flight simulator was built to study pilot/director/aircraft performance. Instrument rated pilots used the different director-displays in an approach down to touchdown, including a flare and decrab maneuver. Two well established areas of control theory are combined in the design of the cockpit display. Optimal control theory and the theory of manual control are used to find the feedback gains required to drive the display symbols. Conclusions based on the simulator are presented. The results show that the director display developed in the work provides more than adequate information for simulated landing in highly turbulent conditions.

Seitz, W. R.↗
NASA NTRS1973

A study to determine the applicability of noise abatement approach procedures to McDonnell Douglas Aircraft

Analyses of McDonnell Douglas DC-8, DC-9, and DC-10 jet transports were conducted to investigate the applicability of two segment approach noise abatement procedures to these airplanes. All models had the required glide slope capability at the certified landing flap settings. The DC-8 models would probably be limited to an upper segment glide slope of 5.5 degrees and would probably not be suitable for the two segment procedure in icing conditions. The DC-8 would not be compatible with this procedure at a reduced landing flap setting. The feasibility of installing a two segment approach system in the Douglas-built fleet of commercial jet transports from a hardware viewpoint is discussed. The candidate system consists of a two segment computer plus the necessary peripheral equipment interfaced with the existing autopilot and associated avionics. The required modifications and additions to existing equipment are described and the attendant costs estimated. Potential problems which may be encountered are also discussed.

Painter, J. A.↗
NASA NTRS1973

Trajectory description

The Mariner 9 spacecraft was launched by an Atlas/Centaur launch vehicle (AC-23) on a direct-ascent trajectory from the Air Force Eastern Test Range (AFETR) launch complex 36B on May 30, 1971. Liftoff occurred at 22 h 23 min 04.5 s GMT, slightly more than 6 min after the opening of a 60-min launch window. The vehicle rose vertically for approximately 15 s, during which time, a programmed roll to a launch azimuth of 92.74 deg was performed. After the initial vertical rise, the vehicle, guided by the open-loop Atlas autopilot, began to pitch over into a zero-lift trajectory. The first of three main powered phases was terminated by booster engine cutoff (BECO) at 22 h 25 min 35.5 s. After the Atlas booster engine package was jettisoned 3 s later, the flight continued under the power of the Atlas sustainer engine and guided by the Centaur guidance system operating in a closed-loop mode.

Webb, W. A.↗
NASA NTRS1974

Digital flight control research

The results of studies which were undertaken to contribute to the design of digital flight control systems, particularly for transport aircraft are presented. In addition to the overall design considerations for a digital flight control system, the following topics are discussed in detail: (1) aircraft attitude reference system design, (2) the digital computer configuration, (3) the design of a typical digital autopilot for transport aircraft, and (4) a hybrid flight simulator.

Potter, J. E.↗
NASA NTRS1973

Simulator evaluation of manually flown curved instrument approaches

Pilot performance in flying horizontally curved instrument approaches was analyzed by having nine test subjects fly curved approaches in a fixed-base simulator. Approaches were flown without an autopilot and without a flight director. Evaluations were based on deviation measurements made at a number of points along the curved approach path and on subject questionnaires. Results indicate that pilots can fly curved approaches, though less accurately than straight-in approaches; that a moderate wind does not effect curve flying performance; and that there is no performance difference between 60 deg. and 90 deg. turns. A tradeoff of curve path parameters and a paper analysis of wind compensation were also made.

Sager, D.↗
NASA NTRS1974

Dynamics of multirate sampled data control systems

The effect was investigated of the synthesis approach (single or multirate) on the machine requirements for a digital control system for the space shuttle boost vehicle. The study encompassed four major work areas: synthesis approach trades, machine requirements trades, design analysis requirements and multirate adaptive control techniques. The primary results are two multirate autopilot designs for the low Q and maximum Q flight conditions that exhibits equal or better performance than the analog and single rate system designs. Also, a preferred technique for analyzing and synthesizing multirate digital control systems is included.

Naylor, J. R.↗
NASA NTRS1975

The 4D area navigation system description and flight test results

A 4D area navigation system was designed to guide aircraft along a prespecified flight path (reference path) such that the aircraft would arrive at the approach gate at a time specified by the ATC controller. Key components to achieve this requirement were: (1) stored reference trajectories; (2) a continuously recomputed capture trajectory to a selected waypoint on the reference trajectory so as to achieve the desired time of arrival; (3) electronic situation displays; and (4) a control system to follow the overall trajectory in space and time. The system was implemented in a digital integrated avionics system (STOLAND) installed on a CV-340 airplane. Although the 4D system was designed primarily for automatic operation, it was flight tested in a flight director mode (the pilot follows the flight director commands), because the CV-340 autopilot servos were not tied to the avionics system. The flight test showed that, even in the flight director mode, the pilot did achieve the objectives of path tracking and time of arrival control with only moderate workload. The system also permitted controlled delay of the time of arrival by path stretching, which takes advantage of the continuously changing capture trajectory to predict the time of arrival. Simulations in the automatic and manual modes were used to complement the flight data.

Lee, H. Q.↗
NASA NTRS1974

Digital attitude control of the Skylab and Apollo/Soyuz orbital assemblies

The present work examines some extensions of the digital autopilot (DAP) capability as programmed in the Apollo Command and Service Module (CSM) onboard computer. Design activity undertaken for a thrust vector control DAP to control a proposed main engine deorbit burn of CSM while still docked to the Orbital Workshop is discussed. The design, implementation, and testing of a reaction control system DAP for the docked Skylab configuration are described along with its adaptation to control of the Apollo/Soyuz docked configuration.

Penchuk, A.↗
NASA NTRS1974

Simulator evaluation of manually flown curved MLS approaches

Pilot performance in flying horizontally curved instrument approaches was analyzed by having nine test subjects fly curved approaches in a fixed-base simulator. Approaches were flown without an autopilot and without a flight director. Evaluations were based on deviation measurements made at a number of points along the curved approach path and on subject questionnaires. Results indicate that pilots can fly curved approaches, though less accurately than streight-in approaches; that a moderate wind does not seriously affect curve flying performance; and that there is no major performance difference between 60 and 90 deg turns.

Sager, D.↗
NASA NTRS1974

Simulation of 4D RNAV in the terminal area

A terminal area control concept based on 4D RNAV (3D plus time) has been developed to take full advantage of STOL aircrafts' unique performance capabilities. The 4D RNAV concept involves an airborne system, a ground system and a protocol for information exchange between aircraft and ground. The function of the airborne system is to synthesize the curved three dimensional (3D) flight path, to predict and control the landing time (4D) and to generate flight director or autopilot commands. The airborne system assumes the ground system will specify the 3D path and assign a conflict-free landing time. A real time simulation of this concept has been developed to evaluate its effectiveness for terminal areas control of STOL aicraft. Key elements of the simulation are a computer graphics traffic display, a scheduling display and a keyboard language for issuing controller commands to simulated aircraft. Initial results and planned experiments are described.

Tobias, L.↗
NASA NTRS1976

A non-gaussian model of continuous atmospheric turbulence for use in aircraft design

A non-Gaussian model of atmospheric turbulence is presented and analyzed. The model is restricted to the regions of the atmosphere where the turbulence is steady or continuous, and the assumptions of homogeneity and stationarity are justified. Also spatial distribution of turbulence is neglected, so the model consists of three independent, stationary stochastic processes which represent the vertical, lateral, and longitudinal gust components. The non-Gaussian and Gaussian models are compared with experimental data, and it is shown that the Gaussian model underestimates the number of high velocity gusts which occur in the atmosphere, while the non-Gaussian model can be adjusted to match the observed high velocity gusts more satisfactorily. Application of the proposed model to aircraft response is investigated, with particular attention to the response power spectral density, the probability distribution, and the level crossing frequency. A numerical example is presented which illustrates the application of the non-Gaussian model to the study of an aircraft autopilot system. Listings and sample results of a number of computer programs used in working with the model are included.

Reeves, P. M.↗
NASA NTRS1976

NASA advanced control technology: An overview

NASA's current and projected advanced control technology programs for future transport aircraft include the design and verification of full flight envelope autopilots, the development and flight test of all-digital fly by wire systems, the evolution of low cost innovative avionics concepts such as split surface stability augmentation systems, the evaluation of integrated propulsion control and cooperative autopilot/propulsion control systems, the application of active control systems to short haul and long haul transports, and the demonstration of reconfigured active control aircraft. Key technical features and anticipated contributions of these technologies are outlined.

Peter R Kurzhals↗
NASA NTRS1975

Status of a digital integrated propulsion/flight control system for the YF-12 airplane

The NASA Flight Research Center is engaged in a program with the YF-12 airplane to study the control of interactions between the airplane and the propulsion system. The existing analog air data computer, autothrottle, autopilot, and inlet control system are to be converted to digital systems by using a general purpose airborne computer and interface unit. First, the existing control laws will be programmed in the digital computer and flight tested. Then new control laws are to be derived from a dynamic propulsion model and a total force and moment aerodynamic model to integrate the systems. These control laws are to be verified in a real time simulation and flight tested.

Reukauf, P. J.↗
NASA NTRS1976

Near-hover control of a helicopter with a hanging load

Piloting a helicopter with a hanging load is a difficult task, especially when the mass of the load is a significant fraction of the mass of the vehicle and there are gusty winds. An autopilot logic is proposed here for controlling the helicopter in this configuration and for precision hover. It is proposed that the vehicle position be measured using a lightweight cable from the helicopter to a point on the ground near the desired hover point. Simulation with one version of S-61 Sikorsky helicopter shows satisfactory controller performance under both design conditions and for parameter changes from one mission to another. Assuming noise-free measurements for feedback is found to be far too optimistic in predicting performance, the sensor/estimator design is a key element in the controller.

Gupta, N. K.↗