SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
A literature search was conducted in an effort to collect and compile as many references on the phase-locked loop as possible. Although not all inclusive, a comprehensive listing of approximately 800 references covering the past two decades of work reported throughout the world are presented. The compilation is given in two parts: first by categories, and then alphabetically by authors.
Design, modeling, analysis, and simulation of a phase-locked loop (PLL) with a digital loop filter are presented in this article. A TMS320C25 digital signal processor (DSP) is used to implement this digital loop filter. In order to keep the compatibility, the main design goal was to replace the analog PLL (APLL) of the Deep-Space Transponder (DST) receiver breadboard's loop filter with a digital loop filter without changing anything else. This replacement results in a hybrid digital PLL (HDPLL). Both the original APLL and the designed HDPLL are Type I second-order systems. The real-time performance of the HDPLL and the receiver is provided and evaluated.
This paper presents the simulation experiments that successfully demonstrate FM co-channel voice separation via cross coupled phase locked loops (CCPLL).
Spatiospectral and spatiotemporal characteristics of flared waveguide Y-coupled laser arrays are studied for the cases of both CW and pulsed operation. Regular sustained self-pulsations were observed for both operation modes. It is suggested that the pulsations are due to the destabilization of phase locking which is caused by amplitude phase coupling.
An optical digital communication system requires that an accurate clock signal be available at the receiver for proper synchronization with the transmitted signal. Phase synchronization is especially critical in M-ary pulse position modulation (PPM) systems where the optimum decision scheme is an energy detector which compares the energy in each of M time slots to decide which of M possible words was sent. Timing errors cause energy spillover into adjacent time slots (a form of intersymbol interference) so that only a portion of the signal energy may be attributed to the correct time slot. This effect decreases the effective signal, increases the effective noise, and increases the probability of error. A timing subsystem for a satellite-to-satellite optical PPM communication link is simulated. The receiver employs direct photodetection, preprocessing of the detected signal, and a phase-locked loop for timing synchronization. The variance of the relative phase error is examined under varying signal strength conditions as an indication of loop performance, and simulation results are compared to theoretical calculations.
We solve numerically the time-dependent Schroedinger equation to study the behavior of a molecule interacting with two phase-locked ultrashort laser pulses. The 2D model used in the calculations mimics the properties of the CH3ONO molecule. The two pulses are identical except for their relative phase and are tuned to excite an upper electronic state of the molecule. After excitation the molecule predissociates, and we calculate the dependence of the NO yield and of the NO vibrational population on the delay time between the pulses.
Receiver timing synchronization of an optical Pulse-Position Modulation (PPM) communication system can be achieved using a phased-locked loop (PLL), provided the photodetector output is suitably processed. The magnitude of the PLL phase error is a good indicator of the timing error at the receiver decoder. The statistics of the phase error are investigated while varying several key system parameters such as PPM order, signal and background strengths, and PPL bandwidth. A practical optical communication system utilizing a laser diode transmitter and an avalanche photodiode in the receiver is described, and the sampled phase error data are presented. A linear regression analysis is applied to the data to obtain estimates of the relational constants involving the phase error variance and incident signal power.
Simulation results of the swept-acquisition performance of residual carrier phase-locked loops (PLLs) are reported. The loops investigated are sampled data counterparts of the continuous time type II and III loops currently in use in Deep Space Network receivers. It was found that sweep rates of 0.2 B(sub L)(2) to 0.4 B(sub L)(2) Hz/s can be used, depending on the loop parameters and loop signal-to-noise ratio (SNR), where B(sub L) is the one-sided loop noise bandwidth. Type III loops are shown to be not as reliable as type II loops for acquisition using this technique, especially at low SNRs.
Angle modulated carrier acquisition and demodulation, developing baseband model for behavior of output signal from phase lock loop
Subsystem facilities flexible data acquisition by combining hardware and software processing. Device controls complex signal acquisition sequence and assists in precise phase locking to received signal. Key features include software system and code-generator initialization routines, executive routine, utility subroutines, control sequence routines for each receiver acquisition state, control-command decoding routine, and look-up tables for code-generator configuration versus code-set number. Steps can be added to extend input signal dynamic range.
System employs synchronous motor driven by deflection waveform of TV and connected directly to color filter wheel to phase lock wheel to deflection unit. Innovation stabilizes color response of small TV cameras and allows for small, lightweight installations. Problems associated with motor phase changes are cited.
A diode-pumped single-mode monolithic Nd:YAG ring-laser oscillator has been built which can be tuned piezoelectrically over several tens of MHz in a few microsecs. Frequency stability over 1 msec is better than 500 Hz. Two lasers have been electronically phase locked for periods of minutes with a phase noise of 29 mrad rms.
Performance tailored more flexibly and directly to satisfy design requirements. Controlled-root approach improved method for analysis and design of digital phase-locked loops (DPLLs). Developed rigorously from first principles for fully digital loops, making DPLL theory and design simpler and more straightforward (particularly for third- or fourth-order DPLL) and controlling performance more accurately in case of high gain.
Theoretical analysis is formulated for a solid state laser based optical phase-locked loop (OPLL) disturbed by shot noise, amplitude modulated noise, and frequency noise.
Portable battery operated LORAN-C receivers were fabricated to evaluate simple envelope detector methods with hybrid analog to digital phase locked loop sensor processors. The receivers are used to evaluate LORAN-C in general aviation applications. Complete circuit details are given for the experimental sensor and readout system.
Receiver timing synchronization of an optical pulse position modulation (PPM) communication system can be achieved using a phase locked loop (PLL) if the photodetector output is properly processed. The synchronization performance is shown to improve with increasing signal power and decreasing loop bandwidth. Bit error rate (BER) of the PLL synchronized PPM system is analyzed and compared to that for the perfectly synchronized system. It is shown that the increase in signal power needed to compensate for the imperfect synchronization is small (less than 0.1 dB) for loop bandwidths less than 0.1% of the slot frequency.
A strain sensor uses optical fibers including strain insensitive portions and a strain sensitive portion. The optical fibers form a sensitive arm of an optical phase locked loop (OPLL). The use of the OPLL allows for multimode optical fiber to be used in a strain insensitive configuration. Only strain information for the strain sensitive portion is monitored rather than the integrated strain measurements commonly made with optical fiber sensors.
Improved diversity receiving system automatically utilizes the combined output from its two independent receiving channels /with cross- polarized receiving antennas/ to increase the reliability of maintaining the requisite phase lock for optimum signal reception. It is adapted for use with AM, PM, or narrow band FM signals.