SEARCH · Search NASA

Results for “backscatter”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 235 records · Page 13

All sources NASA NTRS DOE OSTI

NASA NTRS1983

A tunable coherent CO2 lidar for measurements of atmospheric aerosol backscatter and attenuation

A coherent laser radar system using a grating-tunable, injection-locked TEA-CO2 transmitter is being used to measure the altitude dependence of atmospheric aerosol backscatter and attenuation at a variety of CO2 laser wavelengths in the 9-11 micron region. Injection control of the TEA-CO2 laser allows one to obtain Single-Longitudinal-Mode (SLM) pulses which will follow the frequency of the injected radiation if the TEA laser cavity length is adjusted so that a cavity resonance is in proximity with the injected signal frequency, and if various additional conditions are satisfied. Requirements for generation of SLM pulses in this manner from a TEA CO2 laser with an unstable resonator cavity will be discussed. Procedures used for quantitative range-gated measurements of aerosol backscatter and attenuation will also be discussed.

Menzies, R. T.↗

NASA NTRS1983

Observation of El Chichon volcanic aerosols by the solar backscattered ultraviolet (SBUV) experiment

The Solar Backscatter Ultraviolet Experiment (SBUV) aboard the Nimbus-7 satellite identified large amounts of SO2 in the tropical stratosphere on April 15, 1982, 11 days after major eruption of the El Chichon volcano in southern Mexico. It is shown in the present study that the backscattered ultraviolet radiances measured by the SBUV experiment have been strongly affected by the presence of stratospheric volcanic cloud from the El Chichon eruptions. Both SO2 and aerosol amounts present in the volcanic cloud have been mapped on the basis of an analysis of the radiances measured by the SBUV and TOMS (Total Ozone Mapping Spectrometer) experiments. It is estimated that a volcanic cloud of optical depths as small as 0.03 can be detected using SBUV, provided the cloud reaches the middle atmosphere. Lower-altitude clouds have progressively smaller effects on the radiances as well as on the ozone profile derived from them and are therefore harder to detect.

Bhartia, P. K.↗

NASA NTRS1985

Microwave inversion of leaf area and inclination angle distributions from backscattered data

The backscattering coefficient from a slab of thin randomly oriented dielectric disks over a flat lossy ground is used to reconstruct the inclination angle and area distributions of the disks. The disks are employed to model a leafy agricultural crop, such as soybeans, in the L-band microwave region of the spectrum. The distorted Born approximation, along with a thin disk approximation, is used to obtain a relationship between the horizontal-like polarized backscattering coefficient and the joint probability density of disk inclination angle and disk radius. Assuming large skin depth reduces the relationship to a linear Fredholm integral equation of the first kind. Due to the ill-posed nature of this equation, a Phillips-Twomey regularization method with a second difference smoothing condition is used to find the inversion. Results are obtained in the presence of 1 and 10 percent noise for both leaf inclination angle and leaf radius densities.

Lang, R. H.↗

NASA NTRS1985

A study of backscattering and emission from closely packed inhomogeneous media

The effects of close spacing between small scattering spheres were examined by keeping the distance-dependent terms in the expressions for the transverse scattered fields. The phase matrix was then derived from these fields and was used in the radiative transfer formulation to model scattering and emission from a densely populated, inhomogeneous layer. Computed results were compared with those obtained when the phase matrix was specialized to the far-field condition. It was found that the use of the far-zone condition tended to underestimate both the level of the copolarized backscattering and the cross-polarized backscattering. In emission computations, the use of the far-zone condition overestimated the level of the brightness temperature. These effects decreased with a decrease in the volume fraction or an increase in the exploring frequency, as expected. An improvement on the snow parameter (density and crystal size) estimation was shown to be possible when this new phase matrix was used.

Fung, A. K.↗

NASA NTRS1986

Beta Backscatter Measures the Hardness of Rubber

Nondestructive testing method determines hardness, on Shore scale, of room-temperature-vulcanizing silicone rubber. Measures backscattered beta particles; backscattered radiation count directly proportional to Shore hardness. Test set calibrated with specimen, Shore hardness known from mechanical durometer test. Specimen of unknown hardness tested, and radiation count recorded. Count compared with known sample to find Shore hardness of unknown.

Morrissey, E. T.↗

NASA NTRS1985

Asymptotic high frequency analysis of the electromagnetic backscattering from an inlet model consisting of piecewise linearly tapered sections

Electromagnetic backscattering from an open ended three dimensional inlet model is analyzed and computed patterns are compared with results of experimental measurements. The model is comprised of two sections. The first section consists of a linearly tapered waveguide with a rectangular opening at one end and the other end is connected to the second section which is a uniform rectangular waveguide with a planar perfectly conducting termination. The model is electrically large so that many propagating modes are excited. The method of analysis contains conventional aperture integration and modal techniques combined with high frequency techniques, which employ concepts such as modal rays, geometrical theory of diffraction and equivalent currents. For the cases considered, it is shown that only a few of the many propagating modes contribute appreciably to the backscattered field. These modes are selected according to their modal ray angle directions.

Altintas, A.↗

NASA NTRS1985

Lidar aerosol backscatter measurements - Systematic, modeling, and calibration error considerations

Sources of systematic, modeling, and calibration errors that affect the interpretation and calibration of lidar aerosol backscatter data are discussed. The treatment pertains primarily to ground-based pulsed CO2 lidars that probe the troposphere and are calibrated using hard calibration targets. However, a large part of the analysis is relevant to other types of lidar system such as lidars operating at other wavelengths; CW focused lidars; airborne or earth-orbiting lidars; lidars measuring other regions of the atmosphere; lidars measuring nonaerosol elastic or inelastic backscatter; and lidars employing other calibration techniques.

Kavaya, M. J.↗

NASA NTRS1985

Modelling of backscatter from vegetation layers

A simple way to build up a library of models which may be used to distinguish between the different types of vegetation and ground surfaces by means of their backscatter properties is presented. The curve of constant power received by the antenna (Gamma sphere) is calculated for the given Stokes Scattering Operator, and model parameters are adopted of the most similar library model Gamma sphere. Results calculated for a single scattering model resembling coniferous trees are compared with the Gamma spheres of a model resembling tropical region trees. The polarization which would minimize the effect of either the ground surface or the vegetation layer can be calculated and used to analyze the backscatter from the ground surface/vegetation layer combination, and enhance the power received from the desired part of the combination.

Van Zyl, J. J.↗

NASA NTRS1986

Measurements of the effect of horizontal variability of atmospheric backscatter on dial measurements

The horizontal variability of atmospheric backscatter may have a substantial effect on how Differential Absorption Lidar (DIAL) data must be taken and analyzed. To minimize errors, lidar pulse pairs are taken with time separations which are short compared to the time scales associated with variations in atmospheric backscatter. To assess the atmospheric variability for time scales which are long compared to the lidar pulse repetition rate, the variance of the lidar return signal in a given channel can be computed. The variances of the on-line, off-line, and ration of the on-line to off-line signals at given altitudes obtained with the dual solid-state Alexandrite laser system were calculated. These evaluations were made for both down-looking aircraft and up-looking ground-based lidar data. Data were taken with 200 microsecond separation between on-line and off-line laser pulses, 30 m altitude resolution, 5 Hz repetition rate, and the signal were normalized for outgoing laser energy.

Schwemmer, G. K.↗

NASA NTRS1986

Determination of cloud microphysical properties by laser backscattering and extinction measurements

The extinction and backscattering of 514 nm laser radiation in polydisperse water droplet clouds was studied in the laboratory. Three cloud size distributions with modal diameters of 0.02, 5.0, and 12.0 microns were investigated. The relationships between the cloud optical parameters (attentuation coefficient, sigma and volume backscattering coefficient, Beta (sub pi)) and the cloud water content, C, were measured for each size distribution. It was found that a linear relationship exists between sigma and C and between beta (sub pi) and C for cloud water content values up to 3gm/cubic m. The linear relationships obtained, however, have slopes which depend on the droplet size distribution. For a given water content both sigma and beta (sub pi) increase as the modal diameter decreases. The measured data are compared with existing theoretical analyses and discussed in terms of thie application to lidar measurements of atmospheric clouds. It is concluded that the empirical information obtained can serve as a basis for quantitative lidar measurements.

Dubinsky, R. N.↗

NASA NTRS1986

Effect of backscatter-to-extinction ratio on lidar inversions

One way of deriving the atmospheric extinction coefficient from lidar measurements is to start from the single scattering lidar equation. Simulations of lidar experiments and extinction coefficient calculation were conducted and the resulting errors examined. In order to make the simulation realistic, the volume backscatter coefficients and extinction coefficients used in the simulation were based on measured particle distributions, in this case on the particle size distributions measured in Meppen, Germany in the fall of 1980. In that experiment particle size distributions were measured with a balloon-borne particle spectrometer during balloon descents from about 600 meters above ground to the surface. Each particle spectrum represented a layer of at most a few meter thickness, so an altitude resolved profile of particle size spectra is measured. A Mie code was used to compute linear extinction coefficient and volume backscatter coefficient profiles from the particle size spectra for each balloon sounding.

Measure, E. M.↗

NASA NTRS1986

Backscatter and extinction measurements in cloud and drizzle at CO2 laser wavelengths

The backscatter and extinction of laboratory generated cloud and drizzle sized water drops were measured at carbon dioxide laser wavelengths (predominately at lambda = 10.591 micrometers). Two distinctly different drop size regimes were studied: one which covers the range normally encompassed by natural cloud droplets and the other representative of mist or drizzle sized drops. The derivation and verification of the relation between extinction and backscatter at carbon dioxide laser wavelengths should allow the determination of large cloud drop and drizzle extinction coefficient solely from a lidar return signal without requiring knowledge of the drop size distribution. This result will also apply to precipitation sized drops so long as they are spherical.

Jennings, S. G.↗

NASA NTRS1986

Wavelength dependence of coherent and incoherent satellite-based lidar measurements of wind velocity and aerosol backscatter

The results are presented of a capability study of Earth orbiting lidar systems, at various wavelengths from 1.06 to 10.6 microns, for the measurement of wind velocity and aerosol backscatter, and for the detection of clouds. Both coherent and incoherent lidar systems were modeled and compared for the aerosol backscatter and cloud detection applications.

Kavaya, M. J.↗

NASA NTRS1986

Electromagnetic backscattering by corner reflectors

The Geometrical Theory of Diffraction (GTD), which supplements Geometric Optics (GO), and the Physical Theory of Diffraction (PTD), which supplements Physical Optics (PO), are used to predict the backscatter cross sections of dihedral corner reflectors which have right, obtuse, or acute included angles. These theories allow individual backscattering mechanisms of the dihedral corner reflectors to be identified and provide good agreement with experimental results in the azimuthal plane. The advantages and disadvantages of the geometrical and physical theories are discussed in terms of their accuracy, usefulness, and complexity. Numerous comparisons of analytical results with experimental data are presented. While physical optics alone is more accurate and more useful than geometrical optics alone, the combination of geometrical optics and geometrical diffraction seems to out perform physical optics and physical diffraction when compared with experimental data, especially for acute angle dihedral corner reflectors.

Balanis, C. A.↗

NASA NTRS1986

Verification results for a two-scale model of microwave backscatter from the sea surface

The backscatter model of Donelan and Pierson (1986) was adjusted to fit Ku-Band at 13.9 GHz. Data from L to Ka-band are used to test the model. In general, there is no power law. When the wind drops below certain threshold speeds there may be no detectable Bragg backscatter. Saturation may occur at high winds. Results from the Seasat-SASS are used to substantiate the predictions of the model. Suggestions for experiments for determining the overall validity of the model are made.

Pierson, W. J., Jr.↗

NASA NTRS1986

Evaluating roughness models of radar backscatter

Three radar backscatter roughness models were assessed using soil moisture data collected by the Space Shuttle flight 41G SIR-B SAR in an intensively farmed area. The SIR-B data swath included a large number of bare, dry fields with a large variety of surface roughnesses. The small perturbation model gives the best results, particularly when fields with a definite periodic row structure were omitted. The standard deviation of surface heights appears to be a good measure of relative roughness conditions, but the correlation length is not a good descriptor of the surface, and does not seem to be related in any way to the measured backscatter.

Engmann, E. T.↗

NASA NTRS1986

Microwave backscattering from an anisotropic soybean canopy

Electromagnetic backscattering from a soybean canopy is modeled in the L band region of the spectrum. Mature soybean plants are taken as an ensemble of leaves and stems which are represented by lossy dielectric disks and rods respectively. Field data indicated that leaves and stems are not distributed uniformly in the azimuth coordinate. The plant has a tendency to grow out into the area between the rows. The effects on backscattered radar waves was computed by the distorted Born approximation. Results for look directions along the rows and perpendicular to the rows show that only a modest difference occurs in the L band frequency range. The use of another nonuniform distribution, different from those observed experimentally, results in a significant effect due to vegetation asymmetry.

Lang, R. H.↗

NASA NTRS1987

The detection and interpretation of long-term atmospheric change: Tasks in association with the shuttle solar backscatter ultraviolet spectral radiometer

The objectives are to develop techniques to detect and remove long-term instrument drifts from the operational Solar Backscatter Ultraviolet (SBUV/2) data base using periodic measurements made by the Shuttle Solar Backscatter Ultraviolet Spectral Radiometer and to evaluate the potential effects of scattering by atmospheric aerosols on our ability to detect trends in ozone using SBUV-class instruments.

Frederick, John E.↗