Search NASA⌕ Search

SEARCH · Search NASA

Results for “control of networks”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 235 records · Page 13
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

The spin vector of Venus determined from Magellan data

A control network of the north polar region of Venus has been established by selecting and measuring control points on full-resolution radar strips. The measurements were incorporated into a least-squares adjustment program that improved initial estimates of the coordinates of the control points, pole direction, and rotation rate of Venus. The current dataset contains 4206 measurements of 606 points on 619 radar strips. The accuracy of the determination is driven by spacecraft ephemeris errors. An accurate estimate of the rotation period of Venus was obtained by applying an ephemeris improvement technique. The second cycle closure orbits improved ephemeris solutions for 40 orbits (376-384, 520-528, 588-592, 658-668, 1002-1010, 1408-1412, 1746-1764, and 2166-2170) are included and fixed in the geodetic control computations, thus trying the network to the J2000 coordinate system.

Davies, M. E.↗
NASA NTRS1993

A laboratory system for the investigation of rain fade compensation techniques for Ka-band satellites

The design and performance of a rain fade simulation/counteraction system on a laboratory simulated 30/20 GHz, time division multiple access (TDMA) satellite communications testbed is evaluated. Severe rain attenuation of electromagnetic radiation at 30/20 GHz occurs due to the carrier wavelength approaching the water droplet size. Rain in the downlink path lowers the signal power present at the receiver, resulting in a higher number of bit errors induced in the digital ground terminal. The laboratory simulation performed at NASA Lewis Research Center uses a programmable PIN diode attenuator to simulate 20 GHz satellite downlink geographic rain fade profiles. A computer based network control system monitors the downlink power and informs the network of any power threshold violations, which then prompts the network to issue commands that temporarily increase the gain of the satellite based traveling wave tube (TWT) amplifier. After the rain subsides, the network returns the TWT to the normal energy conserving power mode. Bit error rate (BER) data taken at the receiving ground terminal serves as a measure of the severity of rain degradation, and also evaluates the extent to which the network can improve the faded channel.

Svoboda, James S.↗
DOE OSTI2023

Encrypted model predictive control design for security to cyberattacks

Abstract In recent years, cyber‐security of networked control systems has become crucial, as these systems are vulnerable to targeted cyberattacks that compromise the stability, integrity, and safety of these systems. In this work, secure and private communication links are established between sensor–controller and controller–actuator elements using semi‐homomorphic encryption to ensure cyber‐security in model predictive control (MPC) of nonlinear systems. Specifically, Paillier cryptosystem is implemented for encryption‐decryption operations in the communication links. Cryptosystems, in general, work on a subset of integers. As a direct consequence of this nature of encryption algorithms, quantization errors arise in the closed‐loop MPC of nonlinear systems. Thus, the closed‐loop encrypted MPC is designed with a certain degree of robustness to the quantization errors. Furthermore, the trade‐off between the accuracy of the encrypted MPC and the computational cost is discussed. Finally, two chemical process examples are employed to demonstrate the implementation of the proposed encrypted MPC design.

Suryavanshi, Atharva↗
DOE OSTI2020

OpenSNAPI: Toward a Unified API for SmartNICs

The end of Moore’s Law and Dennard Scaling has produced a renaissance in the field of computer architecture. Unable to continue leveraging silicon-level processor improvements to further enhance performance and scalability, system architects have been forced to explore other options. In this new era of heterogeneous architectures and hardware/software codesign, a new class of devices known as “accelerators” has emerged. Independently designed for optimized execution of distinct workloads, these devices have proven critical to the continued advancement of application performance. SmartNICs, accelerator devices integrated with a network controller, have conventionally been utilized to offload low-level networking functionality. However, newer SmartNIC variants, which incorporate a system-on-chip (SoC) with traditional designs, are challenging this precedent. Leveraging significantly augmented resources, these new devices offer increased versatility and the potential to more effectively complement a given architecture’s CPU. In this talk, we introduce the motivation underlying acceleration, explore the fundamentals of SmartNICs, and discuss traditional use cases. We also detail our initial efforts to investigate the feasibility and benefits of SmartNICs as general-purpose accelerators. We present the OpenSNAPI project created to define a uniform application programming interface (API) for this emerging class of devices. Finally, we provide a brief tutorial regarding development of SmartNIC-accelerated applications on Los Alamos National Laboratory’s SmartNIC-enabled platforms.

97 MATHEMATICS AND COMPUTING↗
NASA NTRS1978

Effect of various features on the life cycle cost of the timing/synchronization subsystem of the DCS digital communications network

The effect on the life cycle cost of the timing subsystem was examined, when these optional features were included in various combinations. The features included mutual control, directed control, double-ended reference links, independence of clock error measurement and correction, phase reference combining, self-organization, smoothing for link and nodal dropouts, unequal reference weightings, and a master in a mutual control network. An overall design of a microprocessor-based timing subsystem was formulated. The microprocessor (8080) implements the digital filter portion of a digital phase locked loop, as well as other control functions such as organization of the network through communication with processors at neighboring nodes.

Kimsey, D. B.↗
DOE OSTI2024

Stability-Constrained Learning for Frequency Regulation in Power Grids With Variable Inertia

The increasing penetration of converter-based renewable generation has resulted in faster frequency dynamics, and low and variable inertia. As a result, there is a need for frequency control methods that are able to stabilize a disturbance in the power system at timescales comparable to the fast converter dynamics. This paper proposes a combined linear and neural network controller for inverter-based primary frequency control that is stable at time-varying levels of inertia. We model the time-variance in inertia via a switched affine hybrid system model. We derive stability certificates for the proposed controller via a quadratic candidate Lyapunov function. We test the proposed control on a 12-bus 3-area test network, and compare its performance with a base case linear controller, optimized linear controller, and finite-horizon Linear Quadratic Regulator (LQR). Our proposed controller achieves faster mean settling time and over 50% reduction in average control cost across 100 inertia scenarios compared to the optimized linear controller. Unlike LQR which requires complete knowledge of the inertia trajectories and system dynamics over the entire control time horizon, our proposed controller is real-time tractable, and achieves comparable performance to LQR.

data-driven control↗
NASA NTRS1972

A feedback control model for network flow with multiple pure time delays

A control model describing a network flow hindered by multiple pure time (or transport) delays is formulated. Feedbacks connect each desired output with a single control sector situated at the origin. The dynamic formulation invokes the use of differential difference equations. This causes the characteristic equation of the model to consist of transcendental functions instead of a common algebraic polynomial. A general graphical criterion is developed to evaluate the stability of such a problem. A digital computer simulation confirms the validity of such criterion. An optimal decision making process with multiple delays is presented.

Press, J.↗
NASA NTRS2004

Selected Flight Test Results for Online Learning Neural Network-Based Flight Control System

The NASA F-15 Intelligent Flight Control System project team has developed a series of flight control concepts designed to demonstrate the benefits of a neural network-based adaptive controller. The objective of the team is to develop and flight-test control systems that use neural network technology to optimize the performance of the aircraft under nominal conditions as well as stabilize the aircraft under failure conditions. Failure conditions include locked or failed control surfaces as well as unforeseen damage that might occur to the aircraft in flight. This report presents flight-test results for an adaptive controller using stability and control derivative values from an online learning neural network. A dynamic cell structure neural network is used in conjunction with a real-time parameter identification algorithm to estimate aerodynamic stability and control derivative increments to the baseline aerodynamic derivatives in flight. This set of open-loop flight tests was performed in preparation for a future phase of flights in which the learning neural network and parameter identification algorithm output would provide the flight controller with aerodynamic stability and control derivative updates in near real time. Two flight maneuvers are analyzed a pitch frequency sweep and an automated flight-test maneuver designed to optimally excite the parameter identification algorithm in all axes. Frequency responses generated from flight data are compared to those obtained from nonlinear simulation runs. An examination of flight data shows that addition of the flight-identified aerodynamic derivative increments into the simulation improved the pitch handling qualities of the aircraft.

Williams, Peggy S.↗
NASA NTRS1991

Effect of locus of resource control on operational efficiency in distributed operations

The following topics are presented in view graph form: space network control (SNC) usage in the Advanced Tracking and Data Relay Satellite (ATDRSS) era; an acronym and icon list; demands of the SNC; tightness of resources coupling; sharing information and sharing control; potential ways of distributing control; efficiency problems unrelated to distribution of control; efficiency problems related to distribution of control; and recommendations.

Geoffroy, A. L.↗
NASA NTRS1991

Fuzzy logic applications to expert systems and control

A considerable amount of work on the development of fuzzy logic algorithms and application to space related control problems has been done at the Johnson Space Center (JSC) over the past few years. Particularly, guidance control systems for space vehicles during proximity operations, learning systems utilizing neural networks, control of data processing during rendezvous navigation, collision avoidance algorithms, camera tracking controllers, and tether controllers have been developed utilizing fuzzy logic technology. Several other areas in which fuzzy sets and related concepts are being considered at JSC are diagnostic systems, control of robot arms, pattern recognition, and image processing. It has become evident, based on the commercial applications of fuzzy technology in Japan and China during the last few years, that this technology should be exploited by the government as well as private industry for energy savings.

Lea, Robert N.↗
NASA NTRS1983

Testing and error analysis of a real-time controller

Inexpensive ways to organize and conduct system testing that were used on a real-time satellite network control system are outlined. This system contains roughly 50,000 lines of executable source code developed by a team of eight people. For a small investment of staff, the system was thoroughly tested, including automated regression testing, before field release. Detailed records were kept for fourteen months, during which several versions of the system were written. A separate testing group was not established, but testing itself was structured apart from the development process. The errors found during testing are examined by frequency per subsystem by size and complexity as well as by type. The code was released to the user in March, 1983. To date, only a few minor problems found with the system during its pre-service testing and user acceptance has been good.

Savolaine, C. G.↗
DOE OSTI2025

Real time heat load calculation software based on EPICS for Fermilab PIP-II CM tests

Fermilab has a project to improve the proton beam energy which is called PIP-II (the 2nd Proton Improvement Plan). There is a superconducting linear accelerator, LINAC, to improve the proton beam power and the LINAC consists of 5 types of cryomodules (CM), 1 HWR CM, 2 SSR1 CM, 4 SSR2 CM, LB650 CM, and HB650 CM. The prototypes of these cryomodules are being tested at Fermilab’s CryoModule Test Facility (CMTF). Heat load measurements are an important part of the prototype CM testing. The CMTF cryogenic control system was developed based on the ACNET (Accelerator Control NETwork) for CM testing for other projects, but the PIP-II cryogenic control system will be implemented using the Experimental Physics and Industrial Control System (EPICS). As part of the prototype CM testing campaign an EPICS based control system has been implemented at CMTF. This EPICS cryogenic control system includes real time heat load calculation software utilizing the Fortran implementation of Hepak. This paper details the real time heat load calculation software developed for the prototype CM testing including the first results from the HB 650 CM.

Yoon, S. [Fermilab]↗
NASA NTRS1986

Optical processing for future computer networks

In the development of future data management systems, such as the NASA Space Station, a major problem represents the design and implementation of a high performance communication network which is self-correcting and repairing, flexible, and evolvable. To obtain the goal of designing such a network, it will be essential to incorporate distributed adaptive network control techniques. The present paper provides an outline of the functional and communication network requirements for the Space Station data management system. Attention is given to the mathematical representation of the operations being carried out to provide the required functionality at each layer of communication protocol on the model. The possible implementation of specific communication functions in optics is also considered.

Husain, A.↗
NASA NTRS2010

The Deep Space Network Advanced Systems Program

The deep space network (DSN)--with its three complexes in Goldstone, California, Madrid, Spain, and Canberra, Australia--provides the resources to track and communicate with planetary and deep space missions. Each complex consists of an array of capabilities for tracking probes almost anywhere in the solar system. A number of innovative hardware, software and procedural tools are used for day-to-day operations at DSN complexes as well as at the network control at the Jet Propulsion Laboratory (JPL). Systems and technologies employed by the network include large-aperture antennas (34-m and 70-m), cryogenically cooled receivers, high-power transmitters, stable frequency and timing distribution assemblies, modulation and coding schemes, spacecraft transponders, radiometric tracking techniques, etc. The DSN operates at multiple frequencies, including the 2-GHz band, the 7/8-GHz band, and the 32/34-GHz band.

tracking↗
DOE OSTI2026

Real time heat load calculation software based on EPICS for Fermilab PIP-II CM tests

Fermilab has a project to improve the proton beam energy which is called PIP-II (the 2nd Proton Improvement Plan). There is a superconducting linear accelerator, LINAC, to improve the proton beam power and the LINAC consists of 5 types of cryomodules (CM), 1 HWR CM, 2 SSR1 CM, 4 SSR2 CM, LB650 CM, and HB650 CM. The prototypes of these cryomodules are being tested at Fermilab’s CryoModule Test Facility (CMTF). Heat load measurements are an important part of the prototype CM testing. The CMTF cryogenic control system was developed based on the ACNET (Accelerator Control NETwork) for CM testing for other projects, but the PIP-II cryogenic control system will be implemented using the Experimental Physics and Industrial Control System (EPICS). As part of the prototype CM testing campaign, an EPICS based control system has been implemented at CMTF. This EPICS cryogenic control system includes real-time heat load calculation software utilizing the Fortran implementation of Hepak. This paper details the real time heat load calculation software developed for the prototype CM testing including the first results from the HB650 CM.

Yoon, S. [Fermilab]↗
DOE OSTI2025

Quantum Wrapper Networking for Entanglement Management and Control in Transparent Optical Quantum Networks

The overarching goal of this three-year project was to design and experimentally demonstrate a quantum wrapper networking (QWN) protocol and architecture for entanglement management and control in coexisted classical-quantum networks, facilitating a global quantum Internet. In QWN, the quantum payload (qubits) is wrapped with classical bits as a header. The classical bits facilitate end-to-end transport of the quantum payload without having to read or alter the quantum data payload at intermediate switches and routers.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗