Plant cell wall profiling by fast maximum likelihood reconstruction (FMLR) and region-of-interest (ROI) segmentation of solution-state 2D 1H–13C NMR spectra
Explore the source record for details and available documents.
SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Explore the source record for details and available documents.
The purpose of this report is to identify the source citations for the RML method and clearly delineate the relevant analysis that is contained within, relate the RML paradigm to inference from radiography and thereby contextualize the source citations as limited justification for an intuitive Monte Carlo technique, and identify a potential pitfall of applying RML as it is presented in the source citations and prescribe a deviation from techniques adopted by the AWE and presented by researchers there.
Abstract not provided.
Quantitative description of measured short term stability of microwave signal sources
A technique for on-board detection and identification of hard failures and leaks of the shuttle orbiter reaction control subsystem jets, during the orbital flight phase, is presented. The method uses gimbal angle and linear accelerometer measurements from the orbiter inertial measurement unit and requires no additional hardware. Extended Kalman filters with residual traps are employed for state estimation, and generalized likelihood ratio tests for jet failure identification. Rigid body simulation results indicate identification times of less than 2 seconds for hard jet failures and less than 70 seconds for jet leaks.
DSN telemetry system performance is analyzed based on convolutionally coded data for the short constraint length 7:1/2 codes at low bit rates, 8 to 2,048 bits per second, obtained from CTA 21 for the S-band configuration. The results indicate that a loss of one or more decibels in the system performance may be expected due to system degradation. Also, burst error lengths up to 100 bits may not be unusual in actual operational situations.
Viterbi decoding tests were carried out at DSS 62, Madrid, Spain. Results of bit error rate, burst statistics, and estimation of signal-to-noise ratio are presented.
The development status of the decoder and the factors which were considered in defining the specific functional requirements are described. The design is discussed to the block diagram level. A description of the detailed design is provided, along with a description of the test software developed and a brief summary of the performance evaluation testing completed so far.
There are several practical problems in using current techniques on 5-degree-of-freedom equations to estimate the stability and control derivatives of oblique wing aircraft from flight data. A technique has been developed to estimate these derivatives by separating the analysis of the longitudinal and lateral-directional motion without neglecting cross-coupling effects. This technique was used on flight data from a remotely piloted oblique wing aircraft. The results demonstrated that the relatively simple approach developed was adequate to obtain high quality estimates of the aerodynamic derivatives of such aircraft.
There are several practical problems in using current techniques with five degree of freedom equations to estimate the stability and control derivatives of oblique wing aircraft from flight data. A technique was developed to estimate these derivatives by separating the analysis of the longitudinal and lateral directional motion without neglecting cross coupling effects. Although previously applied to symmetrical aircraft, the technique was not expected to be adequate for oblique wing vehicles. The application of the technique to flight data from a remotely piloted oblique wing aircraft is described. The aircraft instrumentation and data processing were reviewed, with particular emphasis on the digital filtering of the data. A complete set of flight determined stability and control derivative estimates is presented and compared with predictions. The results demonstrated that the relatively simple approach developed was adequate to obtain high quality estimates of the aerodynamic derivatives of such aircraft.
This paper shows that translational acceleration derivatives, such as pitching moment due to rate of change of angle of attack, can be estimated from flight data with the use of appropriately designed maneuvers. No new development of estimation methodology is necessary to analyze these maneuvers. Flight data from a T-37B airplane were used to verify that rate of change of angle of attack could be estimated from rolling maneuvers.
Discussed in this report is the clustering algorithm CLASSY, including detailed descriptions of its general structure and mathematical background and of the various major subroutines. The report provides a development of the logic and equations used with specific reference to program variables. Some comments on timing and proposed optimization techniques are included.
The information presented is based on the experience in the past 12 years at the NASA Dryden Flight Research Center of estimating stability and control derivatives from over 3500 maneuvers from 32 aircraft. The overall approach to the analysis of dynamic flight test data is outlined. General requirements for data and instrumentation are discussed and several examples of the types of problems that may be encountered are presented.
The flight test performance of an adaptive control system for the F-8 DFBW aircraft is summarized. The adaptive system is based on explicit identification of surface effectiveness parameters which are used for gain scheduling in a command augmentation system. Performance of this control law under various design parameter variations is presented. These include variations in test signal level, sample rate, and identification channel structure. Flight performance closely matches analysis and simulation predictions from previous references.
The general model for the competing failure modes assuming that location parameters for each mode are expressible as linear functions of the stress variables and the failure modes act independently is presented. The general form of the likelihood function and the likelihood equations are derived for the extreme value distributions, and solving these equations using nonlinear least squares techniques provides an estimate of the asymptotic covariance matrix of the estimators. Monte-Carlo results indicate that, under appropriate conditions, the location parameters are nearly unbiased, the scale parameter is slightly biased, and the asymptotic covariances are rapidly approached.
The latest modifications to the CLASSY system and the associate postprocessor MAXLABEL are described. Software and hardware descriptions, control card modifications, and sample executions are given.
There are no author-identified significant results in this report.
Kernel type density estimators calculated by the method of sieves. Proofs are presented for the characterization theorem: Let x(1), x(2),...x(n) be a random sample from a population with density f(0). Let sigma 0 and consider estimators f of f(0) defined by (1).