SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Innovation uses solid-state Hall-effect sensor to turn electrical circuit on or off. Though normally held off by a small bias magnet, Hall device turns on when strong actuating magnet comes into proximity. Drive magnet moves actuating magnet against restraint of detent magnet.
NASA's overall sensing, data acquisition, and instrumentation programs are reviewed. The review shows that the trends in advanced sensor technology involve increased use of solid-state sensors, multiapplication sensors, standardized instrumentation, and miniaturized detectors. Examples are given of several new technologies, showing how improvements in sensor operational capability (such as enhanced sensitivity and spectral range) derived from these advances have resulted in relaxed spacecraft stability requirements, mission time savings, and savings in weight, size, and power. The introduction of multiapplication sensors and standardized instrumentation will result in measurement cost reduction and improved compatibility with standardized spacecraft.
The paper describes the design parameters and development of a synthetic aperture radar for use on the SEASAT spacecraft. This imaging radar is designed to operate at altitudes of 800 km with an orbital inclination of 108 deg, a nominal resolution of 25 m, and a swath width of 100 km. The design evolved from planetary imaging radar studies conducted over many years where an L-band imaging radar was developed and tested on aircraft flights as a prototype system to map the surface of Venus. A solid-state transmitter is used where the pulse repetition frequency is a function of altitude and will be about 2kHz for a 12-m long antenna. The receiver consists of the receiver protector, input filters, the gain control, and the RF amplifier. The ground station uses the standard NASA receiver with a 10-m antenna. The correlator, either optical or digital, must be able to compensate for the pitch and yaw variations of the spacecraft as well as the inherent effective yaw caused by the rotation of the earth, and extract the range curvature and range walk effects.
Greater sensitivity and longer life for future space sensor systems place more stringent demands on cooling system technology. Results are presented for a study designed to determine and evaluate low-temperature thermal control system concepts for various cooling categories in the range 3-200 K and to generate hardware development plans for undeveloped viable system concepts. The study considered Shuttle launched payloads in the 1980-1991 time frame, with 1-5 yr of life. Cooling concepts are categorized as open-cycle (expendable), closed-cycle (mechanical), solid-state, and radiative. Particular attention is given to the concepts of multistage heat pipe radiator, diode heat pipe radiator, and radiator guarded cryostat. Results are given for parametric analyses of the Vuilleumier refrigerator, the rotary reciprocating refrigerator, the solid hydrogen refrigerator, the solid hydrogen/multistage radiator hybrid cooler, and the magneto-Peltier hybrid cooler.
Measurements of heavy energetic heavy ions present in the vicinity of the geostationary orbit of the ATS-6 satellite, taken with the aid of a solid-state detector telescope, are reported and analyzed. Data extracted from a single fairly isolated injection event (June 18, 1974) are examined: ions of Z not below 6 and energy above 4.0 MeV; energization of these heavy ions in the magnetosphere during substorm events; comparison of the heavy ion intensity and proton intensity; ratio of intensity of carbon ions and oxygen ions. The heavy ions are identified with oxygen for the most part. The heavy-ion spectrometer is described.
The Low Energy Charged Particle Experiment will be launched on the Mariner-Jupiter-Saturn spacecraft in August 1977. The experiment has been designed to perform particle measurements in the intense radiation belts of the Jovian and Saturnian environments, and to provide detailed spectral analysis of both solar and galactic particles in interplanetary space. A single instrument uses 23 solid-state detectors configured in two distinct detector subsystems: one optimized for interplanetary and interstellar measurements, the other for specific particle species, energies, and intensities expected near the planets.
Lunar temperature profiles and their dependences on the viscosity of the lunar interior are calculated numerically for models that include finite-amplitude solid-state convective cooling. Cooling by subsolidus creep and the rheological behavior of geologic material are taken into account. It is found that the deep lunar temperature is about 1500 to 1600 K with an effective viscosity of between 10 to the 21st and 10 to the 22nd power sq cm/sec. The results are compared with lunar heat-flux measurements, seismic observations, and electrical-conductivity determinations.
Determinations of the abundances of iron and related elements in the photosphere, chromosphere, and corona of the sun as well as in solar and galactic cosmic rays are reviewed and compared with abundances derived from meteoritic data. Observed solar system abundances are found to be in accord with predictions of nucleosynthesis under either hydrostatic or explosive conditions but cannot yet be used to define these processes uniquely. The distribution of iron among planets and meteorites can probably be adequately modelled by condensation and fragmentation under equilibrium conditions above about 700 K, but below that temperature it is likely that inhibited solid-state diffusion perturbed attainment of equilibrium. Pertinent factors which are presently unknown include the mechanism responsible for metal-silicate fractionation, the grain size achieved by metallic iron in the nebula, and whether iron-bearing silicate formed prior to accretion.
The discovery of rings surrounding Uranus has prompted reexamination of telescopic observations made a year ago with a solid-state area detector called a charge-coupling device (CCD). The extreme narrowness of the rings apparently caused them to be hidden in glare from the planet, the reflectivity of which is very high in the blue and green regions of the spectrum. However, Uranus appears as a much darker image in the near-infrared spectral regions detected by the CCD. Although no direct evidence of the rings is obtainable from the CCD images, some simplifying assumptions permit the deduction from the CCD data that average reflectivity of individual particles composing the rings is at most a few percent, much closer to that of carbonaceous chondritic material than to that of the ice-coated particles in Saturn's rings.
Solid-state sensing unit developed for use with NASA's Water-Quality Monitoring System can detect small velocity changes in slow moving fluid. Nonprotruding sensor is applicable to numerous other uses requiring sensitive measurement of slow flows.
The Voyager mission cosmic ray detector system, consisting entirely of solid-state charged-particle detectors, is designed to measure the energy spectrum of electrons in the range 3 to 110 MeV and the energy spectra and elemental composition of cosmic ray nuclei from hydrogen through iron in the range 1 to 500 MeV/nuc; for isotopes of hydrogen through sulfur the range is approximately 2 to 75 MeV/nuc. The cosmic ray investigation deals with the energy content, origin and acceleration process, and dynamics of cosmic rays in the galaxy, with particular attention given to low-energy phenomena in interstellar space and the outer solar system. The precise measurement of three-dimensional stream patterns of nuclei from H to Fe, as well as electrons over a wide energy range, is the data acquisition program emphasized.
The suitability of existing terrestrial extractive metallurgical processes for the production of Al, Ti, Fe, Mg, and O2 from nonterrestrial resources is examined from both thermodynamic and kinetic points of view. Carbochlorination of lunar anorthite concentrate in conjunction with Alcoa electrolysis process for Al; carbochlorination of lunar ilmenite concentrate followed by Ca reduction of TiO2; and subsequent reduction of Fe2O3 by H2 for Ti and Fe, respectively, are suggested. Silicothermic reduction of olivine concentrate was found to be attractive for the extraction of Mg becaue of the technological knowhow of the process. Aluminothermic reduction of olivine is the other possible alternative for the production of magnesium. The large quantities of carbon monoxide generated in the metal extraction processes can be used to recover carbon and oxygen by a combination of the following methods: (1) simple disproportionation of CO,(2) methanation of CO and electrolysis of H2O, and (3) solid-state electrolysis of gas mixtures containing CO, CO2, and H2O. The research needed for the adoption of earth-based extraction processes for lunar and asteroidal minerals is outlined.
Consideration is given to the data processing algorithm used in synthetic aperture radar (SAR) systems. Examples are presented of radar imagery obtained with the ERIM X-band SAR system and processed with a precision optical processor. An optical recording of the data is the input to the coherent optical processing channel. The encoding technique, spatial format, and quality of the stored data are discussed. Several optical processor configurations are outlined, noting particularly the tilted-plane system. A scanning photodetector serves to convert the optical processor output image data into an electronic signal stream. Solid-state two-dimensional photodetector arrays may provide this function at increased speeds and with greater accuracy.
A lighting system originally developed for NASA's Apollo and Skylab manned spacecraft resulted in a industrial spinoff and creation of a whole new company to produce and market the product line. The company is UDEC Corp., Waltham, Mass. UDEC's "Multi-Mode" electronic lighting systems are designed for plant emergency and supplemental use, such as night lighting, "always-on" stairwell lights and illuminated exit signs. Their advantages stem from the qualities demanded for spacecraft installation: extremely high fight output with very low energy drain, compactness, light weight, and high reliability. The Multi-Mode system includes long-life fluorescent lamps operated by electronic circuitry, a sealed battery that needs no maintenance for 10 years, and a solid-state battery charger. A typical emergency installation consists of a master module with battery and an eight watt lamp, together with four remote "Satellight" modules powered by the master's battery. As a night lighting system for maintenance or I security, UDEC fixtures can bypass the battery and 1 operate on normal current at a fraction of the energy 1 demand of conventional night lighting. Industrial customers have realized savings of better than ninety percent with UDEC night lights. UDEC started as a basement industry in 1972 but the company has already sold more than 1,000 lighting systems to building operators.
In the sixties, Chrysler was NASA's prime contractor for the Saturn I and IB test launch vehicles. The company installed and operated at Huntsville what was known as the Saturn I/IB Development Breadboard Facility. "Breadboard," means an array of electrical and electronic equipment for performing a variety of development and test functions. This work gave Chrysler a broad capability in computerized testing to assure quality control in development of solid-state electronic systems. Today that division is manufacturing many products not destined for NASA, most of them being associated with the company's automotive line. A major project is production and quality-control testing of the "lean-burn" engine, one that has a built-in Computer to control emission timing, and allow the engine to run on a leaner mixture of fuel and air. Other environment-related products include vehicle emission analyzers. The newest of the line is an accurate, portable solid state instrument for testing auto exhaust gases. The exhaust analyzers, now being produced for company dealers and for service
Disclosed is a multiple output DC-to-DC converter. The DC input power is filtered and passed through a chopper preregulator. The chopper output is then passed through a current source inverter controlled by a squarewave generator. The resultant AC is passed through the primary winding of a transformer, with high voltages induced in a plurality of secondary windings. The high voltage secondary outputs are each solid-state rectified for passage to individual output loads. Multiple feedback loops control the operation of the chopper preregulator, one being responsive to the current through the primary winding and another responsive to the DC voltage level at a selected output.
Many recent studies of solid-state phenomena, particularly in the area of crystal imperfections, have involved the use of melt-grown NaCl single crystals. Quite often trace impurities in these materials have had a prominent effect on these phenomena. Trace amounts of hydroxide ion have been found in melt-grown NaCl crystals. This paper describes a nondestructive method of neutralizing the hydroxide ion in such crystals. Crystals of similar hydroxide content are maintained at an elevated temperature below the melting point of NaCl in a flowing atmosphere containing. dry hydrogen chloride. Heat treatment is continued until an analysis of the test specimens shows no excess hydroxide ion. A colorimetric method previously described4 is used for this analysis.
Thermochemical stability of ytterbium silicon oxyapatite Ca 2 Yb 8 (SiO 4 ) 6 O 2 (CYbS) in the presence of molten calcium-magnesium aluminosilicate (CMAS) has been investigated at elevated temperatures for consideration as a thermal and environmental barrier coating (T/EBC) material. CYbS apatite powder was synthesized from the constituent oxides via a solid-state reaction method. Hot-pressed apatite substrates were exposed to molten CMAS at 1200, 1300, and 1400 °C for 1, 10, and 50 h. Development of phases in the interaction region of the heat-treated specimens was monitored using scanning electron microscopy, transmission electron microscopy, high-angle annular dark-field imaging, selected area electron diffraction, and energy dispersive x-ray spectroscopy. Monoclinic cyclosilicate Ca 3 Yb 2 (Si 3 O 9 ) 2 formed from interaction of CYbS apatite with CaO in the CMAS melt at the apatite-CMAS reaction front and continued to nucleate and grow within the residual CMAS in diffusion couples annealed for 1 to 50 h at 1200 °C as well as in those heat treated at 1300 °C for 1 h. Residual CMAS was depleted of Ca when cyclosilicate was present. Dendritic wollastonite (CaSiO3) was observed within the residual CMAS in couples annealed at 1200 and 1300 °C. Ingress of molten CMAS, because of its exponential decrease in viscosity, occurred through open pores and along the grain boundaries of the apatite substrates without any detectable chemical reaction at 1300 and 1400 °C. Results of this study indicate that Ca 2 Yb 8 (SiO 4 ) 6 O 2 apatite has the potential to mitigate the CMAS corrosion up to about 1200 °C but not at higher temperatures.