Search NASA⌕ Search

SEARCH · Search NASA

Results for “CARRIER FREQUENCY”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14
All sourcesNASA NTRSDOE OSTI
NASA NTRS1991

Lightning induced currents in aircraft wiring using low level injection techniques

Various techniques were studied to predict the transient current induced into aircraft wiring bundles as a result of an aircraft lightning strike. A series of aircraft measurements were carried out together with a theoretical analysis using computer modeling. These tests were applied to various aircraft and also to specially constructed cylinders installed within coaxial return conductor systems. Low level swept frequency CW (carrier waves), low level transient and high level transient injection tests were applied to the aircraft and cylinders. Measurements were made to determine the transfer function between the aircraft drive current and the resulting skin currents and currents induced on the internal wiring. The full threat lightning induced transient currents were extrapolated from the low level data using Fourier transform techniques. The aircraft and cylinders used were constructed from both metallic and CFC (carbon fiber composite) materials. The results show the pulse stretching phenomenon which occurs for CFC materials due to the diffusion of the lightning current through carbon fiber materials. Transmission Line Matrix modeling techniques were used to compare theoretical and measured currents.

Stevens, E. G.↗
NASA NTRS1994

Satellite Multicarrier Demodulation System

Proposed onboard signal processing system for communications satellites performs real-time conversion of multiple uplink (received) signals in single-channel-per-carrier, frequency-division-multiple-access (SCPC/FDMA) format to downlink (transmitted) signals in time-division-multiplexed (TDM) format. Conversion approach enhances use of allocated spectrum and reduces required effective isotropic radiated power at both transponder (satellite) and Earth stations. Equipment needed to implement scheme less complex and less expensive than time-division-multiple-access (TDMA) formats. More economical future satellite communication systems made possible through use of many small-capacity multiservice Earth terminals.

Budinger, James↗
NASA NTRS1995

Compensating For Unbalance In Pulse-Code Phase Modulation

Algorithm proposed for use in pulse-code phase-modulation transmitter in which non-return-to-zero (NRZ) or biphase data modulated directly onto radio-frequency residual carrier signal. Devised to compensate somewhat for effect, upon distant receiver, of unbalance in stream of transmitted data. Formulated to compute combinations of modulation index, data rate, and transmitter power compensating for measured unbalance in transmitted data stream.

Nguyen, Tien M.↗
NASA NTRS2000

Clock Technology Development in the Laser Cooling and Atomic Physics (LCAP) Program

This paper presents the Laser Cooling and Atomic Physics (LCAP) program. It focuses on clock technology development. The topics include: 1) Overview of LCAP Flight Projects; 2) Space Clock 101; 3) Physics with Clocks in microgravity; 4) Space Clock Challenges; 5) LCAP Timeline; 6) International Space Station (ISS) Science Platforms; 7) ISS Express Rack; 8) Space Qualification of Components; 9) Laser Configuration; 10) Clock Rate Comparisons: GPS Carrier Phase Frequency Transfer; and 11) ISS Model Views. This paper is presented in viewgraph form.

Seidel, Dave↗
NASA NTRS1999

Transverse Mode Dynamics of VCSELs Through Space-Time Domain Simulation

Modeling and simulation are important to understand laser operation and to optimize and design device functions. Numerical simulation of VCSEL (Vertical Cavity Surface Emitting Lasers) has been largely based on solving time-independent Helmholtz equation or time dependent coupled mode equations. There are various advantages for choosing these approaches. However, the disadvantages are also apparent. The former cannot handle dynamical mode competition seen in VCSELs, while the latter assumes a given type and number of modes a priori. Furthermore, the microscopic physics of heterstructures and electron-hole plasma is very often represented by a few parameters such as linear gain coefficients and the linewidth enhancement factor. These are over simplification of space and frequency (wavelength) dependent gain and refractive index functions. When the space-time dynamical operation of VCSELs becomes important, these simple approximations become questionable. In this paper, we apply a recently developed model for edge-emitting lasers to a gain guided VCSEL for space-time domain simulation. This model takes into account the actual nonlinear dependence of gain and refractive index on frequency and carrier density within the frame work of the effective Bloch equations. The corresponding partial differential equations are solved directly by finite difference methods. Laser behavior with increasing pumping current is investigated in detail. Special attention is paid to the dynamical competition of the transverse modes.

Goorjian, Peter M.↗
NASA NTRS1991

Wide-band analog frequency modulation of optic signals using indirect techniques

The wideband frequency modulation (FM) of an optical carrier by a radio frequency (RF) or microwave signal can be accomplished independent of laser type when indirect modulation is employed. Indirect modulators exploit the integral relation of phase to frequency so that phase modulators can be used to impress frequency modulation on an optical carrier. The use of integrated optics phase modulators, which are highly linear, enables the generation of optical wideband FM signals with very low intermodulation distortion. This modulator can be used as part of an optical wideband FM link for RF and microwave signals. Experimental results from the test of an indirect frequency modulator for an optical carrier are discussed.

Fitzmartin, D. J.↗
NASA NTRS2004

Radio science receiver support of the Mars Exploration Rover Landings

The low power levels of the communication signals during the Entry Descent and Landing (EDL) sequences of the Mars rovers prevented the transmission of telemetry at X-band signal to inform the mission operations center of the health and progress of the spacecraft. As an altemative, a series of tones were sent to indicate basic spacecraft conditions and execution of critical events. An open-loop receiver designed for Radio Science experiments was used to acquire the signal during this time. The receiver recorded over a 100 Khz bandwidth to identify the presence of the carrier and tones. The data were fed in real-time to a processing unit which detected the carrier and the frequency separation of the tones from the carrier, in order to determine which event has occurred. Up to 256 different tones were possible. During the actual events, all tones were identified, and the carrier was tracked down to the surface, and for the second rover, through the bouncing which followed, and finally, while stopped on the surface, found the carrier and tones which indicated the spacecraft was alive. In order to identify the tones, the ground receivers had to be able to respond to the bevy of events occurring in the relatively short timespan of EDL.

Deep Space Network (DSN)↗
NASA NTRS2013

Sleuthing the MSL EDL Performance from an X Band Carrier Perspective

During the Entry, Descent, and Landing (EDL) of NASA's Mars Science Laboratory (MSL), or Curiosity, rover to Gale Crater on Mars on August 6, 2012 UTC, the rover transmitted an X-band signal composed of carrier and tone frequencies and a UHF signal modulated with an 8kbps data stream. During EDL, the spacecraft's orientation is determined by its guidance and mechanical subsystems to ensure that the vehicle land safely at its destination. Although orientation to maximize telecom performance is not possible, antennas are especially designed and mounted to provide the best possible line of sight to Earth and to the Mars orbiters supporting MSL's landing. The tones and data transmitted over these links are selected carefully to reflect the most essential parameters of the vehicle's state and the performance of the EDL subsystems for post-EDL reconstruction should no further data transmission from the vehicle be possible. This paper addresses the configuration of the X band receive system used at NASA / JPL's Deep Space Network (DSN) to capture the signal spectrum of MSL's X band carrier and tone signal, examines the MSL vehicle state information obtained from the X band carrier signal only and contrasts the Doppler-derived information against the post-EDL known vehicle state. The paper begins with a description of the MSL EDL sequence of events and discusses the impact of the EDL maneuvers such as guided entry, parachute deploy, and powered descent on the frequency observables expected at the DSN. The range of Doppler dynamics possible is derived from extensive 6 Degrees-Of-Freedom (6 DOF) vehicle state calculations performed by MSL's EDL simulation team. The configuration of the DSN's receive system, using the Radio Science Receivers (RSR) to perform open-loop recording for both for nominal and off-nominal EDL scenarios, is detailed. Expected signal carrier power-to-noise levels during EDL are shown and their impact on signal detection is considered. Particular attention is given to the selection of the appropriate RSR processing bandwidths and to its configuration for real-time signal detection. The X-band carrier frequency obtained through post-processing of the open-loop recorded spectrum is given. Detection of spacecraft status and completion of key vehicle events through their Doppler signature is discussed and illustrated. This Doppler-derived information is compared against the very accurate vehicle data obtained post-EDL via MSL's UHF radio subsystem. The paper concludes with a discussion on the advantages and disadvantages of transmitting the X-band carrier and tone signal in the general context of EDL communications and lessons learned for future missions with EDL sequences are given

Mars Science Laboratory (MSL)↗
NASA NTRS1991

Detection of target distance in the presence of an interfering reflection using a frequency-stepped double side-band suppressed carrier microwave radar system

A technique for detecting the distance to a highly reflective target in the presence of an interesting reflection using a frequency-stepped double-sideband suppressed carrier (DSBSC) microwave-millimeter-wave radar system is analytically derived. The main result of the analysis shows that the measured group delays produced by the DSBSC system possess a periodicity inversely proportional to the difference between the time delays to the target and interferer, independent of the signal-to-interference ratio (SIR). Simulation results are presented in the context of electron plasma density range estimation using a block diagram communications CAD tool. A unique and accurate plasma model is introduced. A high-resolution spectral estimation technique based on an autoregressive time series analysis is applied to the measured group delays, and it is shown that accurate target distance estimates may be obtained, independent of SIR.

Ybarra, Gary A.↗
NASA NTRS2010

SEU/SET Tolerant Phase-Locked Loops

The phase-locked loop (PLL) is an old and widely used circuit for frequency and phase demodulation, carrier and clock recovery, and frequency synthesis [1]. Its implementations range from discrete components to fully integrated circuits and even to firmware or software. Often the PLL is a highly critical component of a system, as for example when it is used to derive the on-chip clock, but as of this writing no definitive single-event upset (SET)/single-event transient (SET) tolerant PLL circuit has been described. This chapter hopes to rectify that situation, at least in regard to PLLs that are used to generate clocks. Older literature on fault-tolerant PLLs deals with detection of a hard failure, which is recovered by replacement, repair, or manual restart of discrete component systems. Several patents exist along these lines (6349391, 6272647, and 7089442). A newer approach is to harden the parts of a PLL system, to one degree or another, such as by using a voltage-based charge pump or a triple modular redundant (TMR) voted voltage-controlled oscillator (VCO). A more comprehensive approach is to harden by triplication and voting (TMR) all the digital pieces (primarily the divider) of a frequency synthesis PLL, but this still leaves room for errors in the VCO and the loop filter. Instead of hardening or voting pieces of a system, such as a frequency synthesis system (i.e., clock multiplier), we will show how the entire system can be voted. There are two main ways of doing this, each with advantages and drawbacks. We will show how each has advantages in certain areas, depending on the lock acquisition and tracking characteristics of the PLL. Because of this dependency on PLL characteristics, we will briefly revisit the theory of PLLs. But first we will describe the characteristics of voters and their correct application, as some literature does not follow the voting procedure that guarantees elimination of errors. Additionally, we will find that voting clocks is a bit trickier than voting data where an infallible clock is assumed. It is our job here to produce (or recover) that assumed infallible clock!

Shuler, Robert L., Jr.↗
NASA NTRS1992

Acquisition performance of various QPSK carrier tracking loops

The frequency and phase acquisition performance of three quadrature phase shift keying (QPSK) carrier tracking loops, the MAP estimation loop, the Costas crossover loop, and the generalized Costas loop, is described. Acquisition time and probability of acquisition as a function of both loop signal-to-noise ratio and frequency offset to loop bandwidth ratio are obtained via computer simulations for type II and III loops. It is shown that the MAP loop, which results in the smallest squaring loss for all signal-to-noise ratios, is sometimes outperformed by the other two loops in terms of acquisition time and acquisition probability.

Hinedi, S.↗
NASA NTRS1989

Practical constraints on network architecture and signalling in the MSAT system

Telesat Mobile Inc. plans to provide mobile satellite communications services in Canada in 1993/4, in close cooperation with the American Mobile Satellite Consortium Inc., which will be providing services in the U.S.A. L-band frequencies will be used in multiple beams for communication with mobile terminals. Ku-band frequencies will be used for the feeder-links to fixed stations. The system will support voice and data communications. The baseline Canadian system will support approximately 450 assignable voice channels, some fraction of which will be the equivalent in data channels. The method of multiple access will be Frequency Division Multiple Access/Single Channel Per Carrier. The availability of frequencies, the availability of technology and the time scale for implementation all constrain the network architecture for the system. Further, it is important to have an open specification to encourage multiple equipment vendors. The interplay of these constraints is discussed.

Davies, N. George↗
NASA NTRS1985

High-amplitude VLF transmitter signals and associated sidebands observed near the magnetic equatorial plane on the ISEE 1 satellite

New high-altitude ISEE 1 satellite observations of high-amplitude nonducted signals from the Omega navigation transmitter in North Dakota are reported. The amplitude of the signal was approximately 16-26 dB higher than that of similar signals observed at comparable locations on other days. Over the range L = 3.3-3.7, the transmitter pulses at 13.1 and 13.6 kHz were associated with sideband signals spaced in frequency roughly symmetrically about the carrier and generally reduced in amplitude by about 5 dB with respect to the carrier. The strongest sidebands were generally offset in frequency from the carrier by about + or - 55 Hz. Reasons are discussed for believing that the unusually high amplitude of the signals was due to wave amplification through the whistler-mode instability.

Bell, T. F.↗
NASA NTRS1991

Coherent optical modulation for antenna remoting

A coherent fiber optic link employing wideband frequency modulation (FM) of the optical carrier is used to transfer radio frequency (RF) or microwave signals. This system is used to link a remotely located antenna to a conveniently located electronics processing site. The advantages of coherent analog fiber optic systems over non-coherent intensity modulated fiber optic analog transmission systems are described. An optical FM link employing an indirect transmitter to frequency modulate the optical carrier and a microwave delay line discriminator receiver is described. Measured performance data for a video signal centered at 60 MHz is presented showing the use of wideband FM in the link.

Fitzmartin, D. J.↗
NASA NTRS1991

Emergency locating transmitter

A transmitter generates three signals for sequential transmission. These signal are an unmodulated r.f. carrier, a r.f. carrier amplitude modulated by a first audio frequency waveform and a r.f. carrier amplitude modulated by a second audio frequency waveform which is distinguishable from the first and which may be employed as a means for identifying a particular transmitter. The composite, sequentially transmitted signal may be varied in terms of the individual signal transmission sequence, the duration of the individual signals, overall composite signal repetition rate and the frequency of the second audio waveform. Various combinations of signal variations may be employed to transmit different information.

Wren, Paul E.↗