Search NASA⌕ Search

SEARCH · Search NASA

Results for “Curve fitting”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

Development of a global model for atmospheric backscatter at CO2 wavelengths

The effect of gravitational sedimentation on the atmospheric aerosol size distribution has been simulated using a one layer numerical model. A nonlinear curve fitting program is being developed to study aerosol size parameters. The Sage/Sam 2 data establishing the geographical and temporal variations of aerosol concentration in the troposphere are being studied. The basic version of the Sam 2 program and the alternative version of the Sage 2 program are operational. Above 6 km, latitudinal differences are more important in determining aerosol concentration than surface conditions.

Source record↗
NASA NTRS1983

Stratospheric temperature profile from balloon-borne measurements of the 10.4-micron band of CO2

The technique of nonlinear least squares spectral curve fitting has been used to derive the stratospheric vertical temperature profile from balloon-borne measurements of the 10.4 micron band of CO2. The spectral data were obtained at sunset with the approximately 0.02 per cm resolution University of Denver interferometer system from a float altitude of 33.5 km near Alamogordo, New Mexico, on 23 March 1981. The r.m.s. deviation between the retrieved temperature profile and correlative radiosonde measurements is 2.2 K.

Rinsland, C. P.↗
NASA NTRS1984

Non-nulling seven-hole probes for high angle flow measurement

This paper illustrates a method for calibrating seven-hole probes to measure local total and static pressures and relative flow angles of up to 70 degrees in subsonic compressible flows. The method of Latin Squares was used to statistically sample a large and otherwise unmanageable data set, thereby reducing to a minimum the number of data points required to construct a polynomial curve fit to the data. Calibration produces three-variable third order polynomials which permit all of the desired flow properties to be found explicitly from probe measured pressures. This method determines the flow angles to within 2 degrees and Mach number to within 0.04 with 95 percent certainty.

Gerner, A. A.↗
NASA NTRS1984

Method for calculating multidimensional electric fields in photovoltaic modules

A finite element method for evaluating the electrical isolation characteristics of photovoltaic modules was developed; its accuracy was verified by comparison with an exact solution for a geometry similar to that of solar cells. Tests on a square test coupon, employed in electrical isolation tests, and a group of disc-shaped solar cells illustrated the finite element method's usefulness in evaluating module encapsulation designs. Finite element models had to avoid adjacent large and small elements and elements with large aspect ratios, and the NASTRAN output had to be curve fitted to calculate the maximum field. Geometric limits were indicated: cells with very sharp edges, and cells much thinner or thicker than the dielectric pottant layer.

Kallis, J. M.↗
NASA NTRS1984

Numerical solution of Space Shuttle Orbiter flow field including real gas effects

The hypersonic, laminar flow around the Space Shuttle Orbiter has been computed for both an ideal gas (gamma = 1.2) and equilibrium air using a real-gas, parabolized Navier-Stokes code. This code employs a generalized coordinate transformation; hence, it places no restrictions on the orientation of the solution surfaces. The initial solution in the nose region was computed using a 3-D, real-gas, time-dependent Navier-Stokes code. The thermodynamic and transport properties of equilibrium air were obtained from either approximate curve fits or a table look-up procedure. Numerical results are presented for flight conditions corresponding to the STS-3 trajectory. The computed surface pressures and convective heating rates are compared with data from the STS-3 flight.

Prabhu, D. K.↗
NASA NTRS1984

The relationship of rain-induced cross-polarization discrimination to attenuation for 10 to 30 GHz earth-space radio links

Rain depolarization is quantified through the cross-polarization discrimination (XPD) versus attenuation relationship. Such a relationship is derived by curve fitting to a rigorous theoretical model (the multiple scattering model) to determine the variation of the parameters involved. This simple isolation model (SIM) is compared to data from several earth-space link experiments and to three other models.

Stutzman, W. L.↗
NASA NTRS1984

Estimating sunspot number

An empirical method is developed to predict certain parameters of future solar activity cycles. Sunspot cycle statistics are examined, and curve fitting and linear regression analysis techniques are utilized.

Wilson, R. M.↗
NASA NTRS1985

Models of the upper atmosphere

Several computer models of the thermosphere are discussed. J70MM, the Jacchia 1970 model with matrix and matrix mean output, and J703X, the Jacchia 1970, 1971, and 1977 models, are of primary interest. The subroutines in these programs were studied in detail, and several mistakes were found and corrected. It is proposed that a weighted average of the three-hour geomagnetic index be used in the models rather than a single index value. The densities (for a given date and time) generated by the J703X program (all three models), using both a single value of the index and weighted averages for three different lag times, are tabulated and discussed. Most of the equations used in the models are the results of empirical curve fits. An attempt was made to generate a theoretical prediction of the thermospheric temperature profile based on a simple physical model of atmospheric heat conduction in a spherically-symmetric shell. The exponential heating theory and the temperature dependence of k are discussed.

Davis, T. M.↗
NASA NTRS1985

Ignition of mixtures of SiH sub 4, CH sub 4, O sub 2, and Ar or N sub 2 behind reflected shock waves

Ignition delay times in mixtures of methane, silane, and oxygen diluted with argon and nitrogen were measured behind reflected shock waves generated in the chemical kinetic shock tube at Langley Research Center. The delay times were inferred from the rapid increase in pressure that occurs at ignition, and the ignition of methane was verified from the emission of infrared radiation from carbon dioxide. Pressures of 1.25 atm and temperatures from 1100 K to 1300 K were generated behind the reflected shocks; these levels are representative of those occurring within a supersonic Ramjet combustor. Expressions for the ignition delay time as a function of temperature were obtained from least squares curve fits to the data for overall equivalence ratios of 0.7 and 1.0. The ignition delay times with argon as the diluent were longer than those with nitrogen as the diluent. The infrared wavelength observations at 4.38 microns for carbon dioxide indicated that silane and methane ignited simultaneously (i.e., within the time resolution of the measurement). A combined chemical kinetic mechanism for mixtures of silane, methane, oxygen, and argon or nitrogen was assembled from one mechanism that accurately predicted the ignition of methane and a second mechanism that accurately predicted silane hydrogen ignition. Comparisons between this combined mechanism and experiment indicated that additional reactions, possibly between silyl and methyl fragments, are needed to develop a good silane methane mechanism.

Mclain, A. G.↗
NASA NTRS1985

Calculation of secondary-electron escape currents from inclined-spacecraft surfaces in a magnetic field

In low Earth orbit, the geomagnetic field B(vector) is strong enough that secondary electrons emitted from spacecraft surfaces have an average gyroradius much smaller than typical dimensions of large spacecraft. This implies that escape of secondaries will be strongly inhibited on surfaces which are nearly parallel to B(vector), even if a repelling electric field exists outside them. This effect is likely to make an important contribution to the current balance and hence the equilibrium potential of such surfaces, making high voltage charging of them more likely. Numerically calculated escaping secondary electron fluxes are presented for these conditions. For use in numerical spacecraft charging simulations, an analytic curve fit to these results is given which is accurate to within 3% of the emitted current.

Laframboise, J. G.↗
NASA NTRS1985

Measurement of damping of graphite epoxy materials

The design of an experiment to measure the damping of a cylindrical graphite-epoxy specimen with a three point support and a knife edge support is described as well as equipment used in tests conducted to determine the influence of the support at the two ends of the specimen and to simulate an idealized free-free boundary condition at the two edges. A curve fitting technique is being used to process the frequency response data obtained. Experiments conducted on the thin plate specimen also reveal the influence of the end support condition on the damping ratio of the specimen. The damping ratio values measured for both specimens appear to be strongly influenced by the shape of the specimen and appear to depend on length and fiber orientation as well as the presence of discontinuities such as sharp bends, corners, and notches.

Crocker, M. J.↗
NASA NTRS1985

Propagation and secondary production of low energy antiprotons in the atmosphere

Current theories, in which the observed antiproton component is attributed strictly to secondary production in high energy inelastic collisions of protons with the interstellar medium or the atmosphere, apparently fail to explain the relatively high p vertical intensities measured at mountain and balloon altitudes. Therefore, a more careful calculation of the theoretical secondary intensity spectra is required before more exotic sources for these excess p's can be explored. A one dimensional diffusion equation is used to calculate the expected vertical intensity of p's due only to secondary production in the atmosphere; any assumed primary p spectrum is also included. Two adjustable parameters, the inelasticity and charge exchange in nucleon-nucleus collisions, were included in the algorithm. In order to obtain an independent estimate of their values the proton vertical intensities in the atmosphere were calculated, adjusting the parameters until the curves fit the experimental proton data, and then assumed that these values were identical in antinucleon-nucleus collisions.

Bowen, T.↗
NASA NTRS1984

Absolute intensities of spectral lines in carbon dioxide bands near 2050/cm

The absolute intensities of individual lines of eleven relatively weak bands of (C-12)(O-16)2, (C-13)(O-16)2, (O-16)(C-12)(O-18), and (O-16)(C-12)(O-17) near 2050/cm were measured and recorded at room temperature and 0.01/cm resolution with the Fourier transform spectrometer located in the McMath solar telescope complex located at the National Solar Observatory on Kitt Peak. Each spectrum was obtained with an integration time of one hour, the temperature and pressure were monitored during this time, and the signal-to-rms noise in the 5 micron region was approximately 4000 for all scans. The intensities were determined from analysis of 1-2/cm segments of spectra using nonlinear least-squares spectral curve fitting, and analyzed to determine the vibrational band intensity and F-factor coefficients for each of the bands. The results are pertinent to a wide variety of problems in atmospheric physics and for the analysis of remote-sensing data.

Rinsland, C. P.↗
NASA NTRS1984

Fast numerical calculations of EHD sliding traction forces Application to rolling bearings

Based on analytical calculations assuming isothermal elastohydrodynamic (EHD) lubrication conditions, and on curve-fitting of a thermal correction factor, a new formula is proposed to calculate the sliding traction force developed in a concentrated contact, assuming a nonlinear, viscoelastic lubricant and undirectional sliding. When sliding occurs in the rolling and transverse directions (bidimensional sliding), a simplified numerical method is outlined by which the components of the local shear stress are quickly calculated. The latter method is applied to the calculation of the shear stress and temperature distribution in the ball-raceway contacts of an angular-contact ball bearing. Because of the viscoelastic behavior of the lubricant, a nonzero lateral traction force is obtained.

Houpert, L.↗
NASA NTRS1985

N2(+) bound quartet and sextet state potential energy curves

The N2(+) potential energies have been determined from a complete active space self-consistent field calculation with active 2s and 2p electrons. A (6s 4p 3d 1f) Gaussian basis set was used together with additional higher angular momentum and diffuse functions. The calculated potential energy curves for the states 4Sigma(mu)(+), 4Pi(g), and 6Sigma(g)(+), for which there are no spectroscopic observations, are presented. The corresponding spectroscopic constants have been determined from a polynomial curve fit to the computed energies near the well minima and are shown. The 6Sigma(g)(+) state is found to be significantly bound, with a minimum at 1.72 A.

Partridge, H.↗
NASA NTRS1985

Development and testing of tip devices for horizontal axis wind turbines

A theoretical and field experimental program has been carried out to investigate the use of tip devices on horizontal axis wind turbine rotors. The objective was to improve performance by the reduction of tip losses. While power output can always be increased by a simple radial tip extension, such a modification also results in an increased gale load both because of the extra projected area and longer moment arm. Tip devices have the potential to increase power output without such a structural penalty. A vortex lattice computer model was used to optimize three basic tip configuration types for a 25 kW stall limited commercial wind turbine. The types were a change in tip planform, and a single-element and double-element nonplanar tip extension (winglets). A complete data acquisition system was developed which recorded three wind speed components, ambient pressure, temperature, and turbine output. The system operated unattended and could perform real-time processing of the data, displaying the measured power curve as data accumulated in either a bin sort mode or polynomial curve fit. Approximately 270 hr of perormance data were collected over a three-month period. The sampling interval was 2.4 sec; thrus over 400,000 raw data points were logged. Results for each of the three new tip devices, compared with the original tip, showed a small decrease (of the order of 1 kW) in power output over the measured range of wind speeds from cut-in at about 4 m/s to over 20 m/s, well into the stall limiting region. Changes in orientation and angle-of-attack of the winglets were not made. For aircraft wing tip devices, favorable tip shapes have been reported and it is likely that the tip devices tested in this program did not improve rotor performance because they were not optimally adjusted.

Gyatt, G. W.↗
NASA NTRS1986

Simulation and study of small numbers of random events

Random events were simulated by computer and subjected to various statistical methods to extract important parameters. Various forms of curve fitting were explored, such as least squares, least distance from a line, maximum likelihood. Problems considered were dead time, exponential decay, and spectrum extraction from cosmic ray data using binned data and data from individual events. Computer programs, mostly of an iterative nature, were developed to do these simulations and extractions and are partially listed as appendices. The mathematical basis for the compuer programs is given.

Shelton, R. D.↗
NASA NTRS1986

Compensation in epitaxial cubic SiC films

Hall measurements on four n-type cubic SiC films epitaxially grown by chemical vapor deposition on SiC substrates are reported. The temperature dependent carrier concentrations indicate that the samples are highly compensated. Donor ionization energies, E sub D, are less than one half the values previously reported. The values for E sub D and the donor concentration N sub D, combined with results for small bulk platelets with nitrogen donors, suggest the relation E sub D (N sub D) = E sub D(O) - alpha N sub N sup 1/3 for cubic SiC. A curve fit gives alpha is approx 2.6x10/5 meV cm and E sub D (O) approx 48 meV, which is the generally accepted value of E sub D(O) for nitrogen donors in cubic SiC.

Segall, B.↗