Televised graphic displays for steep approach- to-landing research
Steep approach to landing for jet transport aircraft noise abatement, using ground based equipment and onboard TV display
Elkins, H. C.↗
SEARCH · Search NASA
Results for “JET TRANSPORT”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Control considerations in severe turbulence
Jet transport aircraft stability and controllability under atmospheric turbulence conditions, discussing longitudinal and lateral- directional characteristics with particular attention to unstable spiral mode
Gilbert, W. P.↗
Full-scale wind-tunnel tests of a small unpowered jet aircraft with a T-tail
The aerodynamic characteristics of a full scale executive type jet transport aircraft with a T-tail were investigated in a 40 x 80 ft (12.2 by 24.4 meter) wind tunnel (subsonic). Static, longitudinal, and lateral stability, and control characteristics were determined at angles of attack from -2 deg to +42 deg. The aircraft wing had 13 deg of sweep and an aspect ratio of 5.02. The aircraft was tested power off with various wing leading- and trailing-edge high lift devices. The basic configuration was tested with and without such components as engine nacelles, wing tip tanks, and empannage. Hinge-moment data were obtained and downwash angles in the horizontal-tail plane location were calculated. The data were obtained at Reynolds numbers of 4.1 million and 8.7 million based on mean aerodynamic chord. The model had static longitudinal stability through initial stall. Severe tail buffet occurred near the angle of attack for maximum lift. Above initial stall the aircraft had pronounced pitch-up, characteristic of T-tail configurations. A stable trim point was possible at angles of attack between 30 deg and 40 deg (depending on c.g. location and flap setting). Hinge-moment data showed no regions with adverse effects on stick force. Comparisons of wind-tunnel data and flight-test are presented.
Soderman, P. T.↗
Investigation of an aircraft trailing vortex using a tuft grid
With the increasing capacity of airport terminal areas, and the use of the new large jet transports, it has become important to understand the turbulent wake created by these aircraft. A study of the trailing vortex of a wing has been made using a tuft grid in a 6 foot wind tunnel. The study included an investigation of the use of mass injection at the wing tip as a means of destroying the vortex. Test results show that a fully developed, stable, vortex exists at least a distance of thirty chord lengths downstream of the wing, and that the swirl of the vortex can be reduced or eliminated by mass injection at the wing tip.
Mason, W. H.↗
Riding and handling qualities of light aircraft: A review and analysis
Design procedures and supporting data necessary for configuring light aircraft to obtain desired responses to pilot commands and gusts are presented. The procedures employ specializations of modern military and jet transport practice where these provide an improvement over earlier practice. General criteria for riding and handling qualities are discussed in terms of the airframe dynamics. Methods available in the literature for calculating the coefficients required for a linearized analysis of the airframe dynamics are reviewed in detail. The review also treats the relation of spin and stall to airframe geometry. Root locus analysis is used to indicate the sensitivity of airframe dynamics to variations in individual stability derivatives and to variations in geometric parameters. Computer programs are given for finding the frequencies, damping ratios, and time constants of all rigid body modes and for generating time histories of aircraft motions in response to control inputs. Appendices are included presenting the derivation of the linearized equations of motion; the stability derivatives; the transfer functions; approximate solutions for the frequency, damping ratio, and time constants; an indication of methods to be used when linear analysis is inadequate; sample calculations; and an explanation of the use of root locus diagrams and Bode plots.
Smetana, F. O.↗
An analytical study of airplane-autopilot response to atmospheric turbulence
An analytical study has shown that, with proper selection of feedback gains, an automatic control system can reduce excursions in altitude of a jet transport flying in turbulence without increasing structural loads. The control system uses feedback of attitude-angle and pitch-rate signals to the elevator and uses feedback of altitude and altitude-rate signals to the throttle.
Oehman, W. I.↗
Recent NASA handling qualities research
A comprehensive review of NASA research results documented since the mid-1960's and some recently completed programs on aircraft handling qualities are presented. In addition to handling qualities research pertaining to vehicle stability and control characteristics, investigations related to specialized piloting tasks, cockpit displays, and environmental factors are summarized. The background leading to NASA's handling qualities research activities is discussed, and programs that have received major emphasis are indicated. For general aviation aircraft, the survey includes investigations aimed at improving handling qualities by incorporating increasingly sophisticated stability augmentation and display systems, simplifying the approach and landing task for relatively inexperienced pilots, and establishing the basic effects of turbulence. Research on the specialized piloting problem of steeper instrument approaches for noise abatement and investigations with a representative first generation aircraft are reviewed in the section on subsonic jet transports. Supersonic cruise aircraft programs include a variety of simulation studies related to supersonic transport designs and flight tests with the XB-70 aircraft. Investigations of high angle of attack loss of control problems and a flight study of direct lift control utilization for formation flying and aerial refueling are discussed in the review of tactical military aircraft research.
Wasicko, R. J.↗
Study of aircraft centered navigation, guidance, and traffic situation system concept for terminal area operation
A concept for automating the control of air traffic in the terminal area in which the primary man-machine interface is the cockpit is described. The ground and airborne inputs required for implementing this concept are discussed. Digital data link requirements of 10,000 bits per second are explained. A particular implementation of this concept including a sequencing and separation algorithm which generates flight paths and implements a natural order landing sequence is presented. Onboard computer/display avionics utilizing a traffic situation display is described. A preliminary simulation of this concept has been developed which includes a simple, efficient sequencing algorithm and a complete aircraft dynamics model. This simulated jet transport was flown through automated terminal-area traffic situations by pilots using relatively sophisticated displays, and pilot performance and observations are discussed.
Anderson, W. W.↗
A flight evaluation of methods for predicting vortex wake effects on trailing aircraft
The results of four current analytical methods for predicting wing vortex strength and decay rate are compared with the results of a flight investigation of the wake characteristics of several large jet transport aircraft. An empirical expression defining the strength and decay rate of wake vortices is developed that best represents most of the flight-test data. However, the expression is not applicable to small aircraft that would be immersed in the vortex wake of large aircraft.
Robinson, G. H.↗
Initial flight and simulator evaluation of a head up display for standard and noise abatement visual approaches
A preliminary assessment was made of the adequacy of a simple head up display (HUD) for providing vertical guidance for flying noise abatement and standard visual approaches in a jet transport. The HUD featured gyro-stabilized approach angle scales which display the angle of declination to any point on the ground and a horizontal flight path bar which aids the pilot in his control of the aircraft flight path angle. Thirty-three standard and noise abatement approaches were flown in a Boeing 747 aircraft equipped with a head up display. The HUD was also simulated in a research simulator. The simulator was used to familiarize the pilots with the display and to determine the most suitable way to use the HUD for making high capture noise abatement approaches. Preliminary flight and simulator data are presented and problem areas that require further investigation are identified.
Bourquin, K.↗
Approach path control for powered-lift STOL aircraft
A flight control system concept is defined for approach flightpath control of an augmentor wing (or similar) powered-lift STOL configuration. The proposed STOL control concept produces aircraft transient and steady-state control responses that are familiar to pilots of conventional jet transports, and has potential for good handling qualities ratings in all approach and landing phases. The effects of trailing-edge rate limits, real-engine dynamics, and atmospheric turbulence are considered in the study. A general discussion of STOL handling qualities problems and piloting techniques is included.
Clymer, D. J.↗
Fundamental advancements of the future.
General aviation encompasses all aviation except air carrier and military. This includes a broad spectrum of aircraft types ranging from amateur-built aircraft to jet transports, and includes missions such as transportation of people and freight, firefighting, power line patrol, agricultural, racing, and police patrol. The time span from discovery to broad utilization is such that for the next decade the majority of the innovations that will show up in the general aviation fleet will be derived from today's research efforts. A second area that has high potential is the modification of technology developments for military and transport aircraft to the needs of general aviation requirements of cost, complexity, and reliability.
Winblade, R. L.↗
Applications of advanced aerodynamic technology to light aircraft.
This paper discusses a project for adapting advanced technology, much of it borrowed from the jet transport, to general aviation design practice. The NASA funded portion of the work began in 1969 at the University of Kansas and resulted in a smaller, experimental wing with spoilers and powerful flap systems for a Cessna Cardinal airplane. Some flight data and research pilot comments are presented. The project was expanded in 1972 to include a light twin-engine airplane. For the twin there was the added incentive of a potential increase in single-engine climb performance. The use of a new high-lift Whitcomb airfoil is planned for both the wing and the propellers. Preliminary data on the characteristics of the new airfoil are discussed. The configuration of an experimental wing for a Piper Seneca PA-34 and estimated airplane performance with this wing are discussed.
Crane, H. L.↗
Determination of critical nondimensional parameters in aircraft dynamic response to random input
The critical parameters of subsonic jet aircraft response in a random atmospheric environment are determined. Equations of motion are presented for semirigid aircraft with a flexible primary airfoil. However, the analysis is easily extendable to include additional appendage flexibility. The analysis establishes the mechanical admittance values for pitching, plunging, and the first mode effects from wing elastic bending and torsion. Nondimensional parameters are established which allow the representation of all subsonic jet transport aircraft with one nondimensional model. The critical parameters for random forcing are found to be aircraft relative mass, reduced natural and forcing frequencies, and Mach number. Turbulence scale lengths are found to be directly related to the critical values of reduced forcing frequency. Results are given for subsonic craft traveling at constant altitude. Specific values of admittance functions are tabulated at Mach numbers of 0.2, 0.5, and 0.7. The relative mass range covers all aircraft currently in operation.
Hillard, S. E.↗
Applicability of NASA (ARC) two-segment approach procedures to Boeing Aircraft
An engineering study to determine the feasibility of applying the NASA (ARC) two-segment approach procedures and avionics to the Boeing fleet of commercial jet transports is presented. This feasibility study is concerned with the speed/path control and systems compability aspects of the procedures. Path performance data are provided for representative Boeing 707/727/737/747 passenger models. Thrust margin requirements for speed/path control are analyzed for still air and shearing tailwind conditions. Certification of the two-segment equipment and possible effects on existing airplane certification are discussed. Operational restrictions on use of the procedures with current autothrottles and in icing or reported tailwind conditions are recommended. Using the NASA/UAL 727 procedures as a baseline, maximum upper glide slopes for representative 707/727/737/747 models are defined as a starting point for further study and/or flight evaluation programs.
Allison, R. L.↗
Progress in Aircraft Design Since 1903
The progress of aircraft design technology, described in this booklet in words and pictures, is illustrated in a wall display in the Visitors' Center of the Langley Research Center, National Aeronautics and Space Administration, Hampton, Virginia. The display presents, in miniature but highly detailed and accurate models, a broad panorama of aeronautical development. It begins with the Wright brothers' "Flyer" of 1903 and ends with the current generation of jet transports. In model form, and to a common scale, the aircraft described in this booklet take on added dimension and emphasis. Many of the models in the Langley display were built and contributed by members of the Tidewater Branch of the International Plastic Modelers Society, an international group of scale-model enthusiasts. Certain of the models, for which no commercial kits existed, had to be fabricated completely; that work was done by several talented individuals in the Langley Research Center. A few of the models were donated specifically for the display by the manufacturers of the full-scale aircraft.
David A Anderton↗
Non-engine aerodynamic noise investigation of a large aircraft
A series of flyover noise measurements have been accomplished utilizing a large jet transport aircraft with engine power reduced to flight idle. It was determined that the aerodynamic (nonengine) noise levels did occur in the general range that had been predicted by using small aircraft (up to 17,690 kg gross weight) prediction techniques. The test procedures used are presented along with discussions of the effects of aerodynamic configuration on the radiated noise, identification of noise sources, and predicted aerodynamic noise as compared with measurements.
Gibson, J. S.↗
New airfoil sections for general aviation aircraft
A program has been undertaken to develop new airfoil sections suitable for general aviation aircraft, utilizing theoretical and experimental advanced technology developed in recent years primarily for subsonic jet transport and military aircraft. The airfoil development program is one component of the Advanced Technology Light Twin program sponsored by NASA Langley Research Center. Two-dimensional tests of a new airfoil have demonstrated high cruising performance over a fairly wide C sub 1 range, and a C sub 1 max value of 3.69 with Fowler flap and no leading-edge devices. Experimental and theoretical development of additional configurations is under way.
Wentz, W. H., Jr.↗