SEARCH · Search NASA

Results for “RUDDERS - DEFLECTION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14

All sources NASA NTRS DOE OSTI

NASA NTRS1991

A study of a proposed modified torsional agility metric

A new candidate lateral agility metric, the modified torsional agility parameter, is proposed and tested through generic, nonlinear, non-real-time flight simulation programs of the F-18 and F-5A. The metric is aimed at quantifying high subsonic loaded roll capabilities which might be useful in modern air combat. The metric is considered to be straightforward for testing and measuring based on nonreal-time unmanned flight simulation. The metric is found to be sensitive to pilot input errors of less than full lateral stick to capture bank angle, when tested using unmanned flight simulations. It is suggested that, for redesigned configurations of both aircraft with improved lateral agility, the major benefit would be provided by fast and highly effective rudders, and a high level of pitch, roll, and yaw damping at moderate to high normal load factor levels.

Valasek, John↗

NASA NTRS1991

Tail venting for enhanced yaw damping at spinning conditions

An investigation was conducted in the NASA Langley 20-ft Vertical Spin Tunnel to determine the spin and spin-recovery characteristics of a 1/11-scale model of a low-wing general aviation airplane with a horizontal tail modified with variable-size gaps to allow ventilation of the vertical stabilizer and rudder. Erect spins at symmetric loadings were tested with varying gap sizes on either or both sides of the horizontal tail. The model results indicate that the basic airplane (with no gaps) exhibits a fast, flat spin from which no recoveries can be obtained. The airplane with the modified tail has either a fast, flat spin from which no recoveries or poor recoveries may be made, or a slower, steeper spin from which fair to excellent recoveries may be obtained, depending on the size and orientation of the tail gaps. The major contribution to spin recovery was from the gap on the leeward side of the tail. Gap widths of 15-25 percent of the tail semispan were needed to produce satisfactory recovery from the flat spin.

Stough, H. P., III↗

NASA NTRS1992

Mechanical Backup For Fly-By-Wire Control System

Mechanical device eliminates need for redundant fly-by-wire subsystems. Main components are two linkages. One connected to control column in conventional, reversible control system. Other slides inside first linkage and connected to pilot's control wheel. In addition to aircraft applications, design used in control systems in which computer control desirable but safety backup systems required; for example, in boat rudders, engine controls in boats and automobiles, and controls in construction equipment.

Stewart, Eric C.↗

NASA NTRS1992

An improved lateral control wheel steering law for the Transport Systems Research Vehicle (TSRV)

A lateral control wheel steering law with improved performance was developed for the Transport Systems Research Vehicle (TSRV) simulation and used in the Microwave Landing System research project. The control law converted rotational hand controller inputs into roll rate commands, manipulated ailerons, spoilers, and the rudder to achieve the desired roll rates. The system included automatic turn coordination, track angle hold, and autopilot/autoland modes. The resulting control law produced faster roll rates (15 degrees/sec), quicker response to command reversals, and safer bank angle limits, while using a more concise program code.

Ragsdale, W. A.↗

NASA NTRS1992

A preliminary look at an optimal multivariable design for propulsion-only flight control of jet-transport aircraft

Control of a large jet transport aircraft without the use of conventional control surfaces was studied. Engine commands were used to attempt to recreate the forces and moments typically provided by the elevator, ailerons, and rudder. Necessary conditions for aircraft controllability were developed pertaining to aircraft configuration such as the number of engines and engine placement. An optimal linear quadratic regulator controller was developed for the Boeing 707-720, in particular, for regulation of its natural dynamic modes. The design used a method of assigning relative weights to the natural modes, i.e., phugoid and dutch roll, for a more intuitive selection of the cost function. A prototype pilot command interface was then integrated into the loop based on pseudorate command of both pitch and roll. Closed loop dynamics were evaluated first with a batch linear simulation and then with a real time high fidelity piloted simulation. The NASA research pilots assisted in evaluation of closed loop handling qualities for typical cruise and landing tasks. Recommendations for improvement on this preliminary study of optimal propulsion only flight control are provided.

Azzano, Christopher P.↗

NASA NTRS1992

Research on the Stability and Control of Soaring Birds

A research effort was undertaken to determine if birds are statically stable in soaring flight and to identify the control method they use for initiating turns. A full-scale radio-controlled glider model of a soaring Raven was successfully developed and flown in a manner which emulates the soaring flight of a bird. It has no vertical stabilizing surfaces and no rudder. The model was air-launched from a 2nd radio-controlled mother ship which allowed consistent and repeatable tests to be performed. Experiments with the model indicate that soaring birds are probably neutrally stable in the pitch axis but seem to soar with positive lateral-directional static stability. The stability source is the spanwise distribution of both dihedral and wing sweep. Simple theoretical equations were developed which roughly predicted the observed Dutch roll period of the model. Experiments also indicate that soaring birds control turns strictly through dihedral effect and the application of a yawing moment to induce sideslip. Successful model flights were completed using up-and-down tail movement for pitch control and tail-tilt for lateral control. The simple baseline Raven model which evolved should provide an excellent starting point for continued research on bird flight.

Flight Testing↗

NASA NTRS1993

Actuated forebody strake controls for the F-18 high alpha research vehicle

A series of ground-based studies have been conducted to develop actuated forebody strake controls for flight test evaluations using the NASA F-18 High-Alpha Research Vehicle. The actuated forebody strake concept has been designed to provide increased levels of yaw control at high angles of attack where conventional rudders become ineffective. Results are presented from tests conducted with the flight-test strake design, including static and dynamic wind-tunnel tests, transonic wind-tunnel tests, full-scale wind-tunnel tests, pressure surveys, and flow visualization tests. Results from these studies show that a pair of conformal actuated forebody strakes applied to the F-18 HARV can provide a powerful and precise yaw control device at high angles of attack. The preparations for flight testing are described, including the fabrication of flight hardware and the development of aircraft flight control laws. The primary objectives of the flight tests are to provide flight validation of the groundbased studies and to evaluate the use of this type of control to enhance fighter aircraft maneuverability.

Murri, Daniel G.↗

NASA NTRS1921

The Factors that Determine the Minimum Speed of an Airplane

The author argues that because of a general misunderstanding of the principles of flight at low speed, there are a large number of airplanes that could be made to fly several miles per hour slower than at present by making slight modifications. In order to show how greatly the wing section affects the minimum speed, curves are plotted against various loadings. The disposition of wings on the airplane slightly affects the lift coefficient, and a few such cases are discussed. Another factor that has an effect on minimum speed is the extra lift exerted by the slip stream on the wings. Also discussed are procedures to be followed by the pilot, especially with regard to stick movements during low speed flight. Also covered are stalling, yaw, rolling moments, lateral control, and the effectiveness of ailerons and rudders.

AIRPLANES - SPEED AND POWER AIRPLANE - SPEED↗

NASA NTRS1933

Effect of stabilizer location upon pitching and yawing moments in spins as shown by tests with the spinning balance

Tests were made with the spinning balance in a 5-foot wind tunnel to study the effect of stabilizer location upon the pitching and yawing moments given by the tail surfaces in spinning attitudes. The tests revealed that the horizontal surfaces, when in a normal location, seriously reduced the effectiveness of the fin and rudder, particularly at angles of attack of 50 degrees or more. The tests also revealed that a more forward or more rearward location gave no consistent or decided improvement; that a lower location greatly increased the shielding so that the yawing moment from the combination was in general less than that given by the bare fuselage; and that a higher location decreased the shielding and gave a favorable interference effect, particularly at the high angles of attack. Additional results regarding the stabilizer and the elevator are given.

Bamber, M J↗

NASA NTRS1949

Lateral and Directional Stability and Control Characteristics of a C-54D Airplane

Data are presented showing compliance of C-54D with Army and Navy lateral and directional stability and control specifications. The airplane met requirements except for the rolling effectiveness pb/2V, the aileron forces in rolling, and the rudder forces in the asymmetric power conditions which were marginal. Also, the results of special tests concerning asymmetric power, asymmetric loading, and pitch due to yaw requested by the Airplane Handling Qualities Subcommittee of the Air Transport Association are presented.

AIRPLANES - SPECIFIC TYPES↗

NASA NTRS1927

Glider construction and design

The endeavor to draw a strict line between gliders and soarers as been recently abandoned and the following classification adopted: 1) gliders controlled by shifting the weight of the body; 2) gliders controlled by rudders; 3) gliders controlled by wings. The different classes are discussed as well as materials and parts used in construction.

GLIDERS↗

NASA NTRS1929

Device for the Automatic Control of Airplanes

This report provides a description of an automatic control mechanism that consists of an automatic elevator control, aileron control, and a rudder control. Each automatic control can be independently switched on or off.

RECORD↗

NASA NTRS1934

A flight investigation of the spinning of the NY-1 airplane with varied mass distribution and other modifications, and an analysis based on wind-tunnel tests

This report presents the results of an investigation of the spinning characteristics of NY-1 naval training biplane. The results of flight tests and an analysis based on wind-tunnel test data are given and compared. The primary purpose of the investigation was the determination in flight of the effect of changes in mass distribution along the longitudinal axis, without change of mass quantity or centroid. Other effects were also investigated, such as those due to wing loading, center-of-gravity position, dihedral of wings, control setting, and the removal of a large portion of the fabric from the fin and rudder. The wind tunnel test results used in the numerical analysis were obtained in the 7 by 10 foot wind tunnel through an angle-of-attack.

Scudder, Nathan F↗

NASA NTRS1942

Determination of optimum plan forms for control surfaces

Solutions found for a range of airfoil plan forms indicate that, regardless of the characteristics of the tail surface, the chord of the rudder or of the elevator should be very nearly constant over its span. The optimum ailerons are also of a characteristic shape, varying little with the plan form of the wing.

Jones, Robert T↗

NASA NTRS1951

A study of the use of experimental stability derivatives in the calculation of the lateral disturbed motions of a swept-wing airplane and comparison with flight results

An investigation was made to determine the accuracy with which the lateral flight motions of a swept-wing airplane could be predicted from experimental stability derivatives, determined in the 6-foot-diameter rolling-flow test section and 6 by 6-foot curved-flow test section of the Langley stability tunnel. In addition, determination of the significance of including the nonlinear aerodynamic effects of sideslip in the calculations of the motions was desired. All experimental aerodynamic data necessary for prediction of the lateral flight motions are presented along with a number of comparisons between flight and calculated motions caused by rudder and aileron disturbances.

Bird, John D↗

NASA NTRS1957

Experimental and Predicted Longitudinal and Lateral-Directional Response Characteristics of a Large Flexible 35 Degree Swept-Wing Airplane at an Altitude of 35,000 Feet

Measured and predicted dynamic response characteristics of a large flexible swept-wing airplane to control surface inputs are presented for flight conditions of 0.6 to 0.85 Mach number at an altitude of 35,000 feet. The report is divided into two parts. The first part deals with the response of the airplane to elevator control inputs with principal responses contained in a band of frequencies including the longitudinal short-period mode and several symmetrical structural modes. The second part deals with the response of the airplane to aileron and rudder control inputs with principal responses contained in a band of frequencies including the dutch roll mode, the rolling mode, and three antisymmetrical structural modes.

Cole, Henry A , Jr↗

NASA NTRS1944

Measurements in Flight of the Lateral-Control Characteristics of an Airplane Equipped with Full-Span Zap Flaps and Simple Circular-Arc-Type Ailerons

Flight tests were conducted on the OS2U-2 seaplane with simple circular-arc-type ailerons directly connected to the actuating torque tube. Two aileron test installations were made, differing only in the inclination of the projecting surface with the wing's upper surface. The lateral-control characteristics of the airplane were determined from data obtained in stalls and rudder-fixed aileron rolls. The revised ailerons were deficient in maximum rolling effectiveness, but were capable of controlling the rolling tendencies of the airplane near the stall.

AILERON CONTROLS - VOUGHT OS2U-2↗

NASA NTRS1944

Wind-Tunnel Investigation of Shielded Horn Balances and Tabs on a 0.7-Scale Model of XF6F Vertical Tail Surface

Results of subject tests indicate the difficulty of obtaining closely balanced rudder surfaces for most tail assemblies with shielded horns and maintaining a near zero rate-of-change of hinge-moment coefficient without an additional balancing device. A comparison is made between shielded and unshielded horn test results. Pressure distribution and tuft tests of flow over different shaped horns showed higher critical speed for medium-taper nosed horn. The trim tab nose shape had little effect on tab test results.

CONTROL SURFACES, BALANCED-HORN↗