Search NASA⌕ Search

SEARCH · Search NASA

Results for “STALLING - PREVENTION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14
All sourcesNASA NTRSDOE OSTI
NASA NTRS1987

An examination of gas compressor stability and rotating stall

The principal sources of vibration related reliability problems in high pressure centrifugal gas compressors are the re-excitation of the first critical speed or Resonant Subsynchronous Vibration (RSSV), and the forced vibration due to rotating stall in the vaneless diffusers downstream of the impellers. An example of such field problems is given elsewhere. This paper describes the results of a test program at the author's company, initiated in 1983 and completed during 1985, which studied the RSSV threshold and the rotating stall phenomenon in a high pressure gas compressor.

Fozi, Aziz A.↗
NASA NTRS1987

Propeller swirl effect on single-engine general-aviation aircraft stall-spin tendencies

An investigation is conducted of the effect of a single engine, untapered low wing general aviation aircraft propeller's swirl on the craft's stall pattern. The asymmetrical character of the propeller's swirl can trigger an early stall of one of the wings, aggravating the spin-entry condition. It is shown that the combination of this propeller-induced effect with adverse sideslip can result in large and abrupt changes in the rolling moment, in such conditions as uncoordinated low speed turning maneuvers where the pilot yaws the aircraft with wings level, rather than rolling it.

Katz, Joseph↗
NASA NTRS1987

A natural low frequency oscillation in the wake of an airfoil near stalling conditions

An unusually low frequency oscillation in the flow over an airfoil was explored experimentally. Wind tunnel measurements were carried out with a two dimensional airfoil model at a chord Reynolds number of 100,000. During deep stall the usual bluff-body shedding occurred at a Strouhal number. But at the onset of stall a low frequency periodic oscillation occurred, the corresponding Strouhal number being an order of magnitude lower. The phenomenon occurred in relatively unclean flow when the freestream turbulence was raised to 0.4 percent, but did not in the cleaner flow with turbulence intensity of 0.1 percent. It could also be produced by certain high frequency acoustic excitation. Details of the flow field are compared between a case of low frequency oscillation at alpha = 15 deg and a case of bluff-body shedding at alpha = 22.5 deg. The origin of the low frequency oscillation traces to the upper surface of the airfoil and is seemingly associated with the periodic formation and breakdown of a large separation bubble. The intense flow fluctuations impart significant unsteady forces to the airfoil but diminish rapidly within a distance of one chord from the trailing edge.

Zaman, K. B. M. Q.↗
NASA NTRS1988

A natural low frequency oscillation in the wake of an airfoil near stalling conditions

An unusually low frequency oscillation in the flow over an airfoil was explored experimentally. Wind tunnel measurements were carried out with a two dimensional airfoil model at a chord Reynolds number of 100,000. During deep stall the usual bluff-body shedding occurred at a Strouhal number. But at the onset of stall a low frequency periodic oscillation occurred, the corresponding Strouhal number being an order of magnitude lower. The phenomenon occurred in relatively unclean flow when the freestream turbulence was raised to 0.4 percent, but did not in the cleaner flow with turbulence intensity of 0.1 percent. It could also be produced by certain high frequency acoustic excitation. Details of the flow field are compared between a case of low frequency oscillation at alpha = 15 deg and a case of bluff-body shedding at alpha = 22.5 deg. The origin of the low frequency oscillation traces to the upper surface of the airfoil and is seemingly associated with the periodic formation and breakdown of a large separation bubble. The intense flow fluctuations impart significant unsteady forces to the airfoil but diminish rapidly within a distance of one chord from the trailing edge.

Zaman, K. B. M. Q.↗
NASA NTRS1988

The effects of canard-wing flow-field interactions on longitudinal stability, effective dihedral and potential deep-stall trim

The literature available on high aspect ratio canard configurations shows them to have some unique stability characteristics. Using a generic canard-wing model, the effects of canard-wing flow-field interactions on stability were investigated in the NASA Langley Twelve-Foot Low-Speed Wind Tunnel. Results for the attached flow regime indicate linear interactions shift the neutral point of a canard configuration forward, but the effect of a canard on a wing can change significantly when the flow over the surface begins to separate, even several degrees below stall. The asymmetry of the canard downwash in a sideslip condition can result in an increment in effective dihedral roughly proportional to canard lift coefficient. At very high angles of attack the presence of a wing can cause an incremental normal force on a canard, contributing to the possibility of a deep-stall trim point. This effect is greater for a high canard and less for a low one.

Muchmore, C. B., Jr.↗
NASA NTRS1989

A natural low-frequency oscillation of the flow over an airfoil near stalling conditions

An experimental and computational study of the low-frequency oscillation observed in the flow over an airfoil at the onset of static stall is presented. Wind-tunnel results obtained with two-dimensional airfoil models show that this phenomena takes place only with a transitional state of the separating boundary layer. It is noted that the flowfield does not involve a Karman vortex street. The experimental results agree well with the results of a two-dimensional Navier-Stokes code. The present study demonstrates that the low-frequency oscillations produce intense flow fluctuations which impart much larger unsteady forces to the airfoil than experienced by bluff-body shedding and which may represent the primary aerodynamics of stall flutter of blades and wings.

Zaman, K. B. M. Q.↗
NASA NTRS1990

Amplitude effects on dynamic stall of an oscillating airfoil

Amplitude effects on dynamic stall of an oscillating airfoil in locally transonic flow were studied using stroboscopic schlieren flow visualization. The dynamic stall vortex was photographed for various conditions and its properties were documented. Results show a pronounced effect of the amplitude of oscillation. The airfoil flow can sustain the larger amplitudes with the vortex retained on the surface and thus, produce dynamic lift to higher angles of attack at higher amplitudes. A possible explanation for this is offered in terms of the vorticity generation due to surface acceleration and local streamwise pressure gradient. Also, for the first time a shock has been photographed on the airfoil upper surface and some of its characteristics are discussed.

Chandrasekhara, M. S.↗
NASA NTRS1989

Design and development of a facility for compressible dynamic stall studies of a rapidly pitching airfoil

A facility for the study of dynamic stall of an airfoil undergoing a transient ramp-type pitching motion is described. The facility can produce pitch rates of 3600 deg/sec to an angle of attack of 60 deg by using a specially designed hydraulic drive with feedback control. The ramp motion generator can also generate arbitrary motion of the airfoil and thus can simulate an arbitrary aircraft maneuver. A unique airfoil support system allows unobstructed flow visualization including the complete airfoil contour, thus permitting the use of nonintrusive optical diagnostic methods for flow measurement close to the surface as well as simultaneous far-field measurements. Schlieren pictures obtained during the study reveal the instantaneous density gradients associated with dynamic stall, even under conditions of very low Mach numbers.

Chandrasekhara, M. S.↗
NASA NTRS1990

Helicopter trim with flap-lag-torsion and stall by an optimized controller

An autopilot is applied to helicopter rotor flap-lag-torsion equations to obtain the control settings for a trimmed flight condition. The rotor aerodynamic description includes a stage-space dynamic stall model for lift and for pitching moments. Thus, the rotor is trimmed for flight conditions in which significant stall and torsional deformations are present. The autopilot is extended to Q-bladed rotors by a series of time-delay terms. As a result, the optimum gains and time constants depend upon the number of blades as well as upon the torsional stiffness.

Peters, David A.↗
NASA NTRS1991

Active unsteady aerodynamic suppression of rotating stall in an incompressible flow centrifugal compressor with vaned diffuser

A mathematical model is developed to analyze the suppression of rotating stall in an incompressible flow centrifugal compressor with a vaned diffuser, thereby addressing the important need for centrifugal compressor rotating stall and surge control. In this model, the precursor to to instability is a weak rotating potential velocity perturbation in the inlet flow field that eventually develops into a finite disturbance. To suppress the growth of this potential disturbance, a rotating control vortical velocity disturbance is introduced into the impeller inlet flow. The effectiveness of this control is analyzed by matching the perturbation pressure in the compressor inlet and exit flow fields with a model for the unsteady behavior of the compressor. To demonstrate instability control, this model is then used to predict the control effectiveness for centrifugal compressor geometries based on a low speed research centrifugal compressor. These results indicate that reductions of 10 to 15 percent in the mean inlet flow coefficient at instability are possible with control waveforms of half the magnitude of the total disturbance at the inlet.

Lawless, Patrick B.↗
NASA NTRS1991

Laser velocimetry measurements of oscillating airfoil dynamic stall flow field

Ensemble-averaged two-component velocity measurements over an airfoil experiencing oscillatory dynamic stall under compressibility conditions were obtained. The measurements show the formation of a separation bubble over the airfoil that persists till angles of attack close to when the dynamic stall vortex forms and convects. The fluid attains mean velocities as large as 1.6 times the free stream velocity with instantaneous values of 1.8 times the free stream velocity. The airfoil motion induces these large velocities in regions that are far removed from the surface.

Chandrasekhara, M. S.↗
NASA NTRS1989

Use of an optimized controller and a finite-state stall model to find trimmed helicopter flight controls

An auto-pilot is applied to helicopter rotor flap-lag-torsion equations in order to obtain the control settings for a trimmed flight condition. The rotor aerodynamic description includes a state-space dynamic stall model for lift and for pitching moments. Thus, an attempt is made to trim the rotor for flight conditions in which significant stall and torsional deformations are present. The auto-pilot is extended to Q-bladed rotors by a series of time-delay terms. As a result, the optimum gains and time constants depend upon the number of blades as well as upon the torsional stiffness.

Peters, David A.↗
NASA NTRS1992

Stall-Departure-Resistance Enhancer

Stall-departure-resistance enhancer imposes lesser drag penalty than nortex generators of older types. Increases lift by as much as 30 percent at angles of attack otherwise in poststall region. Device is flat plate wedge with 60 degree sweep angle and attached so it protrudes from leading edge of wing. Tip is sharp point, and edges made thin and sharp to induce good vortical flow. Applications include those intended to increase safety for broad range of aircraft, including trainers, fighters, general-aviation aircraft, and commercial transport aircraft. Nonaerospace applications where flow stall is problem under certain conditions, such as in control of separation in flow diffusers. Other applications in fluid machinery and fluid flow.

Ross, Holly M.↗
NASA NTRS1992

Exploratory investigation of a spanwise blowing concept for tip-stall control on cranked-arrow wings

A novel blowing concept aimed at controlling the tip-panel stall of 'cranked-arrow' type wings was experimentally investigated. A spanwise-directed jet sheet tangential to the upper surface, blown from a chordwise slot located at the crank, interacts obliquely with the external flow to generate a powerful and highly controllable vortex, substantially covering the tip panel. The incremental suction due to this jet vortex, coupled with its flow stabilization effect improves the tip-panel maximum lift and stall characteristics, leading to pitch-up alleviation and lateral control augmentation. Low-speed wind tunnel flow visualizations, pressure measurements and force/moment results are presented validating the flow-control concept and illustrating its potential on a generic crank-arrow wing model.

Rao, Dhanvada M.↗
NASA NTRS1991

Turbulence and stall in plane diffusers - Computational study

The effect of free-stream turbulence level on stall conditions in plane diffusers is investigated with a finite-volume numerical method which utilizes a k-epsilon turbulence model or a differential Reynolds stress model for closure. Computed results show qualitative agreement with measured data. The ability to eliminate stall and thereby increase pressure recovery in diffusers at large included angles by utilizing high free-stream turbulence is correctly predicted.

Demuren, A. O.↗
NASA NTRS1992

Two leading-edge droop modifications for tailoring stall characteristics of a general aviation trainer configuration

The high-angle-of-attack testing intended to develop leading-edge modifications for tailoring the stall characteristics of model is described. Two different leading-edge modifications are considered: a small profile leading-edge droop on the outboard 24 percent of the wing and a large profile leading-edge droop on the outboard 50 percent of the wing. Results indicate that the longitudinal stability for the unmodified and both modified configurations was good for low angle of attack, but the modified configurations exhibited neutral longitudinal stability just prior to stall. The unmodified and both modified configurations demonstrated good lateral stability characteristics for low angles of attack, but all configurations were directionally unstable for high angles of attack.

Ross, Holly M.↗
NASA NTRS1938

Some aspects of the stalling of modern low-lying monoplanes

The factors affecting the stalling characteristics of modern airplanes are briefly discussed. The effect of present-day design trends is shown and means for improving the stalling characteristics of future airplanes are indicated.

Soule, Hartley A↗
NASA NTRS1939

A comparison of several tapered wings designed to avoid tip stalling

Optimum proportions of tapered wings were investigated by a method that involved a comparison of wings designed to be aerodynamically equal. The conditions of aerodynamic equality were equality in stalling speed, in induced drag at a low speed, and in the total drag at cruising speed. After the wings were adjusted to aerodynamic equivalence, the weights of the wings were calculated as a convenient method of indicating the optimum wing. The aerodynamic characteristics were calculated from wing theory and test data for the airfoil sections. Various combinations of washout, camber increase in the airfoil sections from the center to the tips, and sharp leading edges at the center were used to bring about the desired equivalence of maximum lift and center-stalling characteristics. In the calculation of the weights of the wings, a simple type of spar structure was assumed that permitted an integration across the span to determine the web and the flange weights. The covering and the remaining weight were taken in proportion to the wing area. The total weights showed the wings with camber and washout to have the lowest weights and indicated the minimum for wings with a taper ratio between 1/2 and 1/3.

Anderson, Raymond F↗