Search NASA⌕ Search

SEARCH · Search NASA

Results for “climbing”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

Operation of small rocket engines in the JPL high-vacuum molecular space simulator (Molsink)

The feasibility of operating small rocket engines in the Molsink facility was demonstrated. A 0.44-N (0.1-lbf) hydrazine engine and a 0.18-N (0.04-lbf) thruster using cold gas from a hydrazine plenum system were operated for both flight duty cycles and off-nominal conditions. The exhaust gases from these thrusters contain NH3, N2, and H2. The chamber was also calibrated for larger bipropellant engines using nitrogen tetroxide/monomethyl hydrazine (NTO/MMH). The exhaust products of these engines contain CO2, CO, H2, H2O, and H2. A mixture of cold gases simulating the engine exhaust was injected through a nozzle under conditions simulating thrust levels up to 26.7-N (6 lbf). Pulsing and continuous operations were investigated. The chamber background pressure traces were compared with the traces obtained for the same thrusters operated with pure nitrogen at approximately equivalent thrust. Satisfactory recuperation times were encountered in all the pulsing modes. Test times greater than 20s were obtained in steady state operation before the vacuum chamber back pressure climbed to prohibitive values.

Chirivella, J. E.↗
NASA NTRS1972

Technology for design of transport aircraft. Lecture notes for MIT courses: Seminar 1.61 freshman seminar in air transportation and graduate course 1.201, transportation systems analysis

The design parameters which determine cruise performance for a conventional subsonic jet transport are discussed. It is assumed that the aircraft burns climb fuel to reach cruising altitude and that aeronautical technology determines the ability to carry a given payload at cruising altitude. It is shown that different sizes of transport aircraft are needed to provide the cost optimal vehicle for different given payload-range objectives.

Simpson, R. W.↗
NASA NTRS1973

Thermal shielding by subliming volume reflectors in convective and intense radiative environments.

The behavior of dielectric materials having densely packed internal scattering centers subject to extreme convective and radiative environments is analyzed. Experiments have shown that these materials act as volume reflectors of incident radiation even when the exposed surface is being eroded by thermochemical ablation. The analysis was applied to interpret experiments of subliming Teflon models exposed to combined radiative and convective fluxes up to 1.7 kW/sq cm for several seconds. Results show that, although the exposed surface receded at an apparently steady rate, the internal temperature climbed continually, due to internal absorption of radiation and would have caused failure internally if the test duration were extended a few seconds. Thus, performance is time-limited by the internal absorption coefficient. Results were obtained for larger configurations and other materials. Typically, Teflon shells may withstand radiant fluxes up to 20 kW/sq cm for about 5 sec and fritted quartz up to 50 kW/sq cm for about 8 sec (corresponding to the Jupiter entry).

Howe, J. T.↗
NASA NTRS1973

Applications of advanced aerodynamic technology to light aircraft.

This paper discusses a project for adapting advanced technology, much of it borrowed from the jet transport, to general aviation design practice. The NASA funded portion of the work began in 1969 at the University of Kansas and resulted in a smaller, experimental wing with spoilers and powerful flap systems for a Cessna Cardinal airplane. Some flight data and research pilot comments are presented. The project was expanded in 1972 to include a light twin-engine airplane. For the twin there was the added incentive of a potential increase in single-engine climb performance. The use of a new high-lift Whitcomb airfoil is planned for both the wing and the propellers. Preliminary data on the characteristics of the new airfoil are discussed. The configuration of an experimental wing for a Piper Seneca PA-34 and estimated airplane performance with this wing are discussed.

Crane, H. L.↗
NASA NTRS1973

Low speed aerodynamic characteristics of a 17 percent thick airfoil section designed for general aviation applications

Wind-tunnel tests have been conducted to determine the low-speed two-dimensional aerodynamic characteristics of a 17-percent-thick airfoil designed for general aviation applications (GA(W)-1). The results were compared with predictions based on a theoretical method for calculating the viscous flow about the airfoil. The tests were conducted over a Mach number range from 0.10 to 0.28. Reynolds numbers based on airfoil chord varied from 2.0 million to 20.0 million. Maximum section lift coefficients greater than 2.0 were obtained and section lift-drag ratio at a lift coefficient of 1.0 (climb condition) varied from about 65 to 85 as the Reynolds number increased from about 2.0 million to 6.0 million.

Mcghee, R. J.↗
NASA NTRS1973

Takeoff and landing performance and noise measurements of a deflected slipstream STOL airplane with interconnected propellers and rotating cylinder flaps

A YOV-10A aircraft was modified to incorporate rotating cylinder flaps and interconnected propellers with Lycoming T-53-L11 engines. Flight tests were made to evaluate the low speed handling qualities and performance characteristics. The flight test results indicated that landings could be made with approach speeds of 55 to 65 knots (CL = 4.5) and descent angles of 6 deg to 8 deg for total flap angles of 60 deg to 75 deg. At higher flap angles, deterioration of stability and control characteristics precluded attempts at landing. The noise level on the ground under an 8 deg landing approach path was below 86 PNdB at distances beyond 1 nautical mile from touchdown. Takeoffs were made with 30 deg to 45 deg flaps at lift off speeds of 75 to 80 knots and climb angles of 4 deg to 8 deg. Noise levels were below 83 PNdB at 3.5 nautical miles from the start of ground roll.

Weiberg, J. A.↗
NASA NTRS1974

Preliminary results of flight tests of vortex attenuating splines

Flight tests have been conducted to evaluate the effectiveness of a wingtip vortex attenuating device, referred to as a spline. Vortex penetrations were made with a PA-28 behind a C-54 aircraft with and without wingtip splines attached and the resultant rolling acceleration was measured and related to the roll acceleration capability of the PA-28. Tests were conducted over a range of separation distances from about 5 nautical miles (n. mi.) to less than 1 n. mi. Preliminary results indicate that, with the splines installed, there was a significant reduction in the vortex induced roll acceleration experienced by the PA-28 probe aircraft, and the distance at which the PA-28 roll control became ineffective was reduced from 2.5 n. mi. to 0.6 n. mi., or less. There was a slight increase in approach noise (approximately 4 db) with the splines installed due primarily to the higher engine power used during approach. Although splines significantly reduced the C-54 rate of climb, the rates available with four engines were acceptable for this test program. Splines did not introduce any noticeable change in the handling qualities of the C-54.

Hastings, E. C., Jr.↗
NASA NTRS1974

Computer programs for estimating aircraft takeoff performance in three dimensional space

A set of computer programs has been developed to estimate the takeoff and initial climb-out maneuver of a given aircraft in three-dimensional space. The program is applicable to conventional, vectored lift and power-lift concept aircraft. The aircraft is treated as a point mass flying over a flat earth with no side slip, and the rotational dynamics have been neglected. The required input is described and a sample case presented.

Bowles, J. V.↗
NASA NTRS1974

Performance evaluation of a second-generation elastic loop mobility system

Tests were conducted to evaluate the mobility performance of a second-generation Elastic Loop Mobility System (ELMS II). Performance on level test lanes and slopes of lunar soil simulant (LSS) and obstacle-surmounting and crevasse-crossing capabilities were investigated. In addition, internal losses and contact pressure distributions were evaluated. To evaluate the soft-soil performance, two basic soil conditions were tested: loose (LSS1) and dense (LSS5). These conditions embrace the spectrum of soil strengths tested during recent studies for NASA related to the mobility performance of the LRV. Data indicated that for the tested range of the various performance parameters, performance was independent of unit load (contact pressure) and ELMS II drum angular velocity, but was influenced by soil strength and ELMS pitch mode. Power requirements were smaller at a given system output for dense soil than for loose soil. The total system output in terms of pull developed or slope-climbing capability was larger for the ELMS II operating in restrained-pitch mode than in free-pitch mode.

Melzer, K. J.↗
NASA NTRS1974

Results of full-scale vortex attenuation flight experiments

Flight tests have been conducted to evaluate the effectiveness of a wing-tip vortex attenuating device, referred to as a spline. Vortex penetrations were made with a PA-28 behind a C-54 aircraft with and without wing-tip splines attached, and the resultant rolling acceleration was measured and related to the roll acceleration capability of the PA-28. Tests were conducted over a range of separation distances from about 5 n mi to less than 1 n mi. Preliminary results indicate that, with the splines installed, there was a significant reduction in the vortex-induced roll acceleration experienced by the PA-28 probe aircraft, and the distance at which the PA-28 roll control became ineffective was reduced from 2.5 n mi to less than 1 n mi. Although splines significantly reduced the C-54 rate of climb, the rates available with four engines were acceptable for this test program.

Hastings, E. C., Jr.↗
NASA NTRS1973

The effect of communications and traffic situation displays on pilots awareness of traffic in the terminal area

The Air Traffic Control (ATC) system is evolving under a general plan specified by the Federal Aviation Administration. Among the developments being considered is the Discrete Address Beacon System (DABS). The use of this system, although relieving congestion on the communications frequencies, would eliminate information about other aircraft because the party line communications now in use would be lost. One alternative to restore this lost information is an Airborne Traffic Situation Display (TSD). Experienced airline and military pilots participated in a factorial design to evaluate two types of communication (discrete address, party line) and two types of displays (TSD, no TSD). A stop-action quiz was used to evaluate their knowledge of other aircrafts' position, altitude, speed, heading, rate of climb, identity, and landing sequence number. Significant differences between conditions were detected, primarily in the position variables. Workload, as measured by a spare capacity side-task, showed a main effect of displays and a significant interaction between displays and communications. The data are summarized by plotting each display/communication condition configuration in the plane defined by information and workload index. A limited number of blunders by other aircraft were included in the simulations with a significant, but not entirely satisfactory, improvement in blunder detection attributed to the TSD.

Melanson, D.↗
NASA NTRS1975

High-lift aerodynamics: Trends, trades, and options

The trend toward the utilization of higher maximum lift coefficient with increased aircraft size and cruise velocities is discussed. The impact of this trend on the need for tradeoffs between cruise performance and takeoff, climb, and landing performance is examined. Theoretical methods for the analysis of the two-dimensional characteristics of flap systems are described and compared with experimental data. Four powered-lift concepts are described to outline some of the options currently being developed. Two jet-flap theories are described which provide analytical methods for estimation of the three-dimensional aerodynamic high-lift performance characteristics of powered lift systems.

Margason, R. J.↗
NASA NTRS1975

Optimum flight profiles for short haul missions

An algorithm, based on the energy-state method, is derived for calculating optimum trajectories with a range constraint. The basis of the algorithm is the assumption that optimum trajectories consist of, at most, three segments: an increasing energy segment (climb); a constant energy segment (cruise); and a decreasing energy segment (descent). The algorithm is used to compute minimum fuel, minimum time, and minimum direct-operating-cost trajectories, with range as a parameter, for an in-service CTOL aircraft and for an advanced STOL aircraft. Use of a simplified trajectory increases the fuel consumption of the total descent trajectory by about 10 percent and the time to fly the descent by about 19 percent compared to the optimum.

Erzberger, H.↗
NASA NTRS1975

Current status of silicon solar cell technology

In quest of higher efficiency, major progress has occurred in solar cell technology. Cell efficiency has climbed about 50 percent. Technical approaches leading to increased output include back surface fields, shallow junctions, improved antireflection coatings, surface texturizing, and fine grid patterns on the cell surface. The status of current solar cell technology and its incorporation into cell production is discussed. Research and development leading to improved performance and reduced cost are also described.

Brandhorst, H. W., Jr.↗
NASA NTRS1975

An application of the Ogee tip

Wind tunnel tests show that the aerodynamic performance of a rectangular 3-D wing is increased by changing its tip to an ogee shape. Potential gains in both cruise and climb performances for a modified Beech Baron aircraft indicate that incremental changes in performance are on the order of the data scatter associated with applied flight test techniques.

Vogel, J. M.↗
NASA NTRS1975

Simulation and flight studies of an approach profile indicator for VTOL aircraft

Simulation and flight investigations were conducted by using a method of providing supplementary information to the pilot in conjunction with a closed-circuit-television display during a VTOL instrument final approach including deceleration and hover. The supplementary information included range, cross range, ground speed, altitude, and rate-of-climb error and was displayed on an instrument called an approach profile indicator. The display was arranged to provide both quasi-command and situation information. Pilot comments indicated that the approach-profile-indicator display concept in conjunction with the closed-circuit television resulted in a decreased pilot workload and an increase in pilot confidence. Also, the results indicated that the approach profile repeatability was significantly improved because of the ground-speed and altitude information provided on the approach profile indicator.

Moen, G. C.↗
NASA NTRS1975

Development and flight tests of vortex-attenuating splines

The ground tests and full-scale flight tests conducted during development of the vortex-attenuating spline are described. The flight tests were conducted using a vortex generating aircraft with and without splines; a second aircraft was used to probe the vortices generated in both cases. The results showed that splines significantly reduced the vortex effects, but resulted in some noise and climb performance penalties on the generating aircraft.

Hastings, E. C., Jr.↗
NASA NTRS1975

DC-9 Flight Demonstration Program with Refanned JT8D Engines: Performance and Analysis - Volume 3

The JT8D-109 engine has a sea level static, standard day bare engine takeoff thrust of 73,840 N. At sea level standard day conditions the additional thrust of the JT8D-109 results in 2,040 kg additional takeoff gross weight capability for a given field length. Range loss of the DC-9 Refan airplane for long range cruise was determined. The Refan airplane demonstrated stall, static longitudinal stability, longitudinal control, longitudinal trim, minimum control speeds, and directional control characteristics similar to the DC-9-30 production airplane and complied with airworthiness requirements. Cruise, climb, and thrust reverser performance were evaluated. Structural and dynamic ground test, flight test and analytical results substantiate Refan Program requirements that the nacelle, thrust reverser hardware, and the airplane structural modifications are flightworthy and certifiable and that the airplane meets flutter speed margins. Estimated unit cost of a DC-9 Refan retrofit program is 1.338 million in mid-1975 dollars with about an equal split in cost between airframe and engine.

Source record↗