Search NASA⌕ Search

SEARCH · Search NASA

Results for “electron density”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

Solar cycle variations of the electron densities near the ionospheric peak of Venus

Photochemical equilibrium calculations of electron and ion densities, appropriate for altitudes below about 180 km, were carried out for the Venus dayside ionosphere corresponding to solar cycle maximum and minimum conditions. The results were compared with data from radio occultation measurements. The agreement between the calculations and measurements was, in general, quite good. These comparisons indicate that the most commonly used neutral atmosphere model of Venus (Hedin et al., 1983) predicts densities which are somewhat low near the electron density peak for solar cycle maximum, but provides surprisingly good predictions for solar cycle minimum conditions.

Kim, J.↗
NASA NTRS1992

An ISEE/Whistler model of equatorial electron density in the magnetosphere

Attention is given to an empirical model of equatorial electron density in the magnetosphere covering the L range 2.25-8. Although the model is primarily intended for application to the local time interval 00-15 MLT, a way to extend the model to the 15-24-MLT period is presented. The model describes, in piecewise fashion, the 'saturated' plasmasphere, the region of steep plasmapause gradients, and the plasma trough. Within the plasmasphere the model profile can be expressed as logne - Sigma-xi, where x1 = -0.3145L + 3.9043 is the principal or 'reference' term, and additional terms account for: a solar cycle variation with a peak at solar maximum; an annual variation with a December maximum; and a semiannual variation with equinoctial maxima.

Carpenter, D. L.↗
DOE OSTI2025

Effect of resistivity on poloidal asymmetries in electron density in the edge and scrape off layer in 3D full-F gyro-fluid simulations with FELTOR

In this contribution, we analyze the poloidal asymmetries in electron density in the edge and scrape-off layer (SOL) in a COMPASS-sized, diverted tokamak with the 3D full-F, isothermal, electromagnetic, and gyro-fluid model FELTOR. The study is performed for different simulations that span over 2 orders of magnitude in resistivity. The poloidal asymmetries of density are evaluated in the edge and the SOL relative to the outer midplane (OMP), where the highest densities are usually found. In the closed magnetic surfaces, the relative poloidal asymmetry with respect to the OMP is not larger than 20% independently of the plasma resistivity. For the open field lines in the SOL, the relative density asymmetry can range from 55% for the highest resistivity to around 40% for the lowest. The lowest densities inside the separatrix are found between the inner midplane and the top of the magnetic configuration, away from the X-point. In the SOL it is usually close to the X-point in the high field side. The observations in the closed field lines are consistent with ballooning transport but in the SOL oppose experimental evidence for high-density plasmas. In conclusion, this indicates the necessity for more complex physics to reproduce the experimental observations in the SOL for higher density plasmas, such as neutral-plasma dynamics and realistic divertor conditions.

3D full-f gyrofluid↗
NASA NTRS1986

Rocket experiments for spectral estimation of electron density fine structure in the auroral and equatorial ionosphere and preliminary results

Sounding rockets equipped to monitor electron density and its fine structure were launched into the auroral and equatorial ionosphere in 1980 and 1983, respectively. The measurement electronics are based on the Langmuir probe and are described in detail. An approach to the spectral analysis of the density irregularities is addressed and a software algorithm implementing the approach is given. Preliminary results of the analysis are presented.

Tomei, B. A.↗
NASA NTRS1971

High density electronic packaging module with improved cooling assembly

Cold plate increases heat transfer within high density electronic module. Tapered pins improve heat transfer process by providing larger surface pressure with increased planar area. Cooling technique increases thermal contact where planar area is limited, interface pressure increases the heat transfer coefficient.

Martin, J. H.↗
NASA NTRS1972

Measurement of electron density and temperature in plasmas

Application of two laser wavelengths passing through plasma measures electron density and temperature. Function depends on determining absorption of light at two wavelengths. Nature of reaction is explained and schematic diagram of equipment is included.

Billman, K. W.↗
NASA NTRS1972

The inversion of VLF-LF sounder data to obtain D-region electron-density distributions

The direct problem is to compute reflection coefficients for an assumed electron-density profile, using a full-wave solution. The inverse problem is treated numerically, using derivatives of the reflection matrix with respect to model parameters. A technique for the rapid computation of the derivatives is described. An algorithm for determining resolution in the profile is discussed.

Shellman, C. H.↗
NASA NTRS2023

Optimal Estimation Inversion of Ionospheric Electron Density from GNSS-POD Limb Measurements: Part I-Algorithm and Morphology

GNSS-LEO radio links from Precise Orbital Determination (POD) and Radio Occultation (RO) antennas have been used increasingly in characterizing the global 3D distribution and variability of ionospheric electron density (N e ). In this study, we developed an optimal estimation (OE) method to retrieve N e profiles from the slant total electron content (hTEC) measurements acquired by the GNSS-POD links at negative elevation angles (ε < 0°). Although both OE and onion-peeling (OP) methods use the Abel weighting function in the N e inversion, they are significantly different in terms of performance in the lower ionosphere. The new OE results can overcome the large N e oscillations, sometimes negative values, seen in the OP retrievals in the E-region ionosphere. In the companion paper in this Special Issue, the HmF2 and NmF2 from the OE retrieval are validated against ground-based ionosondes and radar observations, showing generally good agreements in NmF2 from all sites. Nighttime hmF2 measurements tend to agree better than the daytime when the ionosonde heights tend to be slightly lower. The OE algorithm has been applied to all GNSS-POD data acquired from the COSMIC-1 (2006–2019), COSMIC-2 (2019–present), and Spire (2019–present) constellations, showing a consistent ionospheric N e morphology. The unprecedented spatiotemporal sampling of the ionosphere from these constellations now allows a detailed analysis of the frequency–wavenumber spectra for the N e variability at different heights. In the lower ionosphere (~150 km), we found significant spectral power in DE1, DW6, DW4, SW5, and SE4 wave components, in addition to well-known DW1, SW2, and DE3 waves. In the upper ionosphere (~450 km), additional wave components are still present, including DE4, DW4, DW6, SE4, and SW4. The co-existence of eastward- and westward-propagating wave4 components implies the presence of a stationary wave4 (SPW4), as suggested by other earlier studies. Further improvements to the OE method are proposed, including a tomographic inversion technique that leverages the asymmetric sampling about the tangent point associated with GNSS-LEO links.

GNSS constellation↗
DOE OSTI2025

Electronic density of states as the descriptor of elastic bond strength, ductility, and local lattice distortion in BCC refractory alloys

Although electronic density of states (DOS) is fundamental to materials properties, its general relationship to mechanical properties of alloys is not well established. In this paper, using density functional theory (DFT) calculations, we show that the electronic occupancy at the Fermi level, N(E f ), obtained from DOS is a key descriptor of alloy strength and ductility. Our comprehensive analysis of numerous body centered cubic (BCC) refractory high entropy alloys (RHEAs) shows an overwhelming correlation that low N(E f ) indicates strong bonds that have high stiffness resulting in high elastic constants. High bond stiffness indicates presence of covalent nature of bonds that are directional in nature resulting in resistance to deformation leading to high bulk (B) and shear (G) moduli. Consequently, N(E f ) provides a direct correlation to the tendency of alloy ductility evidenced in the Pugh ratio (G/B). As stiffer bonds result in lower local lattice distortion (LLD), N(E f ) are LLD are also found to be corelated which opens up a correlation to solid solution strengthening and yield strength. Thus, this work unveils fundamental correlations between N(E f ) and (1) elastic bond strength, (2) ductility, and (3) LLD. These correlations open opportunities for the design of high strength high ductile RHEAs.

36 MATERIALS SCIENCE↗
NASA NTRS1976

Line-of-sight electron density gradients as deduced from an empirical ionospheric model

A topside ionospheric model (Bent Ionospheric Model) was developed for an accurate prediction of integrated total electron content (TEC), from a global data acquired for the years 1962 to 1969. In this paper the effects of line-of-sight electron density gradients on ground to satellite measurements are discussed. The results of analyses show that in the presence of increasing density gradients, deduced values of vertical electron content or slab thicknesses will be too large, while for decreasing gradients these values will be smaller than they should be.

Nesterczuk, G.↗
NASA NTRS1972

Quasi-linear theory of electron density and temperature fluctuations with application to MHD generators and MPD arc thrusters

Fluctuations in electron density and temperature coupled through Ohm's law are studied for an ionizable medium. The nonlinear effects are considered in the limit of a third order quasi-linear treatment. Equations are derived for the amplitude of the fluctuation. Conditions under which a steady state can exist in the presence of the fluctuation are examined and effective transport properties are determined. A comparison is made to previously considered second order theory. The effect of third order terms indicates the possibility of fluctuations existing in regions predicted stable by previous analysis.

Smith, M.↗