Search NASA⌕ Search

SEARCH · Search NASA

Results for “glassy”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14
All sourcesNASA NTRSDOE OSTI
NASA NTRS1985

Melting of Ni40Pd40P20 glass

Upon reheating, most glassy metal alloys crystallize at a temperature not far removed from the glass temperature Tg and far below the liquidus temperature T1. It has been reported by Kui et al. (1984) that the alloy Ni40Pd40P20, which exhibits a scaled glass temperature of about 0.68, has been melt quenched, under a flux of dehydrated B2O3, to a glass at rates as low as 1 deg/s. Here some specimens of this alloy, when similarly fluxed during reheating, have been reheated to temperatures within 50 deg of T1 and 280 deg above Tg at rates of about 2.5 deg/s, and then cooled again to Tg, without crystallization. From this behavior it is inferred that the steady frequency of homogeneous nucleation of crystals in the alloy is less than 0.1/cu cm s.

Kui, H. W.↗
NASA NTRS1986

On the effect of the Fe(2+)/Fe(3+) redox couple on oxidation of carbon in hot H3PO4

Oxidation studies of graphite:glassy carbon composites have been carried out at 1 and 4.7 atm. pressures in conc. H3PO4 in the presence and absence of iron ions. The concentration of the acid was varied over 85-100 wt pct, and of the iron ions over 30-300 ppm; the temperature varied over 190-210 C. Unlike the effect of Fe, which has been observed to increase the corrosion of carbon in sulphuric acid, the corrosion in phosphoric acid was observed to be slightly decreased or not at all affected. This result arises because of the catalytic reduction of the oxidized surface groups of carbon by Fe(2+) ions. The catalytic reduction is possible because under the experimental conditions the redox potential of the Fe(2+)/Fe(3+) couple is lower than the open-circuit voltage of carbon.

Dhar, H. P.↗
NASA NTRS1987

The fading of R Coronae Borealis

Using the International Ultraviolet Explorer (IUE) low-resolution spectra were obtained of R CrB, the prototype of its class of variable stars, shortly after the beginning of its 1983-84 minimum and during its rise to maximum again. The behavior of the spectra during the rise to maximum is similar to the behavior of the spectra of RY Sgr during a similar phase in 1979-80. The extinction data have been analyzed using Mie theory and are consistent with the stellar photosphere being obscured by 20-nm glassy carbon particles. The observations during the decline to minimum show substantial spectral variations which cannot be explained in terms of simple continuum absorption. An interpretation of the observed behavior in terms of a model incorporating an occulting cloud and circumstellar emission is offered.

Holm, A. V.↗
NASA NTRS1986

Slow crack growth in sintered silicon nitride

The strength and crack growth characteristics of a sintered silicon nitride were studied at 1000 C. Fractographic analysis of material failing in dynamic fatigue revealed the presence of slow crack growth (SCG) at stressing rates below 6 ksi/min. This material can sustain a 40-ksi flexural stress at 1000 C for 400 h or more but is susceptible to both SCG and creep deformation at higher stress levels. The crack velocity exponent (N) determined both from dynamic and static fatigue experiments lies in a range from 13 to 22. The subcritical crack growth and creep behavior at 1000 C is primarily controlled by the deformation of an intergranular glassy phase.

Khandelwal, P. K.↗
NASA NTRS1986

Free molecule drag and lift deduced from Shuttle flight experiment

A gas surface interaction experiment was flown on the STS-8 flight of the Space Shuttle in which atomic oxygen was allowed to reflect off a glassy carbon surface. The spatial distribution of the reflected molecules was recorded showing a lobe between the specular and normal directions. Using the Nocilla treatment of the reflected molecules, the speed ratio of the reflected molecules and the angle of the drifting velocity with respect to the surface were determined. This information is used to determine the drag coefficient of a sphere and the drag and lift coefficients of a flat plate.

Karr, Gerald R.↗
NASA NTRS1987

Comparison of the structure of harmonic aqueous glasses and liquid water

Glassy structures of water were generated by rapidly quenching configurations of 64 and 343 molecules of liquid water; and the potential energy was then expanded through quadratic order around local minima generated in this way, and the properties of the resulting harmonic system were calculated. The results obtained were used to test the degree to which the structure of liquid water is similar to that of a harmonic aqueous glass. The radial distribution functions for the glass were found to be remarkably similar to those of the liquid. Translational modes were found to be almost entirely responsible for the broadening of the oxygen-oxygen radial distribution function of the quenched configuration, and also primarily responsible for the broadening of other radial distribution functions.

Pohorille, Andrew↗
NASA NTRS1988

Autohesive strength development in polysulfone resin and graphite-polysulfone composites

The effects of bonding temperature and contact time on autohesive strength development in thermoplastic polysulfone resin and graphite-polysulfone composites were investigated. Two test methods were examined to measure autohesion in the neat resin samples. These included an interfacial tension test and a compact tension fracture toughness test. Autohesive strength development in fiber-reinforced composites was measured using a double cantilever beam interlaminar fracture toughness test. The results of the tests were compared with current diffusion theories explaining crack healing and welding of glassy polymers. Discrepancies between the results of the present investigation and the diffusion theories are discussed.

Howes, Jeremy C.↗
NASA NTRS1988

Analysis of crack-induced-craze in polymers

In this paper, the viscoelastic boundary element method is used to estimate the opening displacement and the envelope stress on the surface of an isolated crack-induced-craze system. To predict the propagation history of both the crack and the craze in a polymer sheet, the material properties of the glassy polymers are represented by a generalized linear viscoelastic model. Results are compared with the theoretical micromechanics predictions. Good agreements are obtained.

Sun, B. N.↗
NASA NTRS1989

All-Optical Photochromic Spatial Light Modulators

Photochemical transfer of electrons enables fast reading and writing. New concept based on transfer of electrons between donor and acceptor molecules randomly distributed or covalently linked and dispersed in glassy-polymer host material. Transfer causes significant changes in optical-transmission characteristics of material and used to modulate transmission of reading beam of light impinging on material.

Beratan, David N.↗
NASA NTRS1988

Influence of several metal ions on the gelation activation energy of silicon tetraethoxide

The effects of nine metal cations (Li(+), Na(+), Mg(2+), Ca(2+), Sr(2+), Cu(2+), Al(3+), La(3+), and Y(3+) on silica gel formation has been investigated by studying the hydrolysis and polycondensation of silicon tetraethoxide (TEOS) in the presence of metal nitrates. The influence of water: TEOS mole ratio, metal ion concentration, and the reaction temperature has been investigated. The overall activation energy for gel formation has been determined from the temperature dependence of the time of gelation for each system. The activation energy for -Si-O-Si- network formation is found to be 54.5 kJ/mol. The gel formation time as well as the activation energy sharply increase in the presence of Cu(2+), Al(3+), La(3+) and Y(3+). In contrast, the presence of Li(+), Na(+), Mg(2+), Ca(2+), or, Sr(2+) lowers the gelation time, but has no appreciable effect on the activation energy. This difference may be attributed to the participation or nonparticipation of the metal ions in the formation of the three-dimensional polymeric network during the polycondensation step. The concentration of metal ion (Mg(2+), Ca(2+), Y(3+) or the water: TEOS mole ratio had no appreciable effect on the gelation activation energy. A simple test has been proposed to determine whether a metal ion would act as a network intermediate or modifier in silica and other glassy networks.

Bansal, Narottam P.↗
NASA NTRS1988

The glass transition, crystallization and melting in Au-Pb-Sb alloys

The glass transition, crystallization and melting of Au(55)Pb(22.5)Sb(22.5) alloys have been studied by differential scanning calorimetry DSC. Crystallization on heating above the glass transition temperature Tg (45 C) begins at 64 C. Further crystallization events are observed at 172 C and 205 C. These events were found to correspond to the formation of the intermetallic compounds AuSb2, Au2Pb, and possibly AuPb2, respectively. Isothermal DSC scans of the glassy alloy above Tg were used to monitor the kinetics of crystallization. The solidification behavior and heat capacity in the glass-forming composition range were determined with droplet samples. An undercooling level of 0.3T(L) below the liquidus temperature T(L) was achieved, resulting in crystallization of different stable and metastable phases. The heat capacity C(P) of the undercooled liquid was measured over an undercooling range of 145 C.

Lee, M. C.↗
NASA NTRS1988

Relative dating of Hawaiian lava flows using multispectral thermal infrared images - A new tool for geologic mapping of young volcanic terranes

The weathering of Hawaiian basalts in arid and semiarid environments is accompanied by changes in their thermal infrared emittance spectra. The spectral differences can be measured and mapped with multispectral imaging systems. The differences appear to be related to the degree of development, preservation, and alteration of glassy crusts; the oxidation of iron; and the accretion of silica-rich surface veneers. Because the measurements are quantitative and in image format, they are useful for estimating relative ages in geologic mapping of lava flows. In Hawaii this technique is most diagnostic for distinguishing among sparsely vegetated flows less than 1.5 ka in age.

Kahle, Anne B.↗
NASA NTRS1989

Gas atomization of cobalt ferrite-phosphate melts

XRD, Moessbauer spectroscopy, and EDXS have been used to characterize a rapidly-solidified (Co,Fe)3O4 spinel generated in a cobalt-iron-phosphate glass matrix by gas atomization of melts. Of the two compositions tested, that containing 20 mol pct P2O5 exhibited randomly-oriented ferrite crystallization whose growth appears to have been diffusion-controlled. Unlike the ferrite, in which the iron has both tetrahedral and octahedral coordination, the iron in the glassy matrix was primarily of distorted-octahedral coordination. Calculations indicate that the cooling rates obtained with oxide melts vary strongly with droplet size, but less strongly with melt temperature.

De Guire, Mark R.↗
NASA NTRS1989

Millimeter petrology and kilometer mineralogical exploration of the moon

Coordinated petrologic and spectroscopic analyses were undertaken for a specially prepared 1-cm chip of regolith breccia 60019. The mafic minerals of each large clast were readily identified from spectral reflectance measurements of the same clasts, and mineral abundance was shown to be directly related to absorption strength. Although most clasts of 60019 are noritic in composition, the presence of abundant olivine and/or high-Ca pyroxene in several clasts is easily noted spectroscopically. The origin of an unusual absorption feature near 0.6 micron in an anorthositic clast was determined by petrographic analysis to be due to very fine-grained translucent ilmenite. The 60019 matrix is dark and glassy, and although a variety of clasts occur on all scales, particulate powders of 60019 are all very similar and have spectral properties that indicate a noritic breccia bulk composition.

Pieters, C. M.↗
NASA NTRS1989

Extraterrestrial spherules in glacial sediment from the Transantarctic Mountains, Antarctica - Structure, mineralogy, and chemical composition

The morphological, mineralogical, and chemical characteristics of silicate and glassy spherules from a number of new localities in the Transantarctic Mountains were determined. The results indicate that these Antarctic spherules are of extraterrestrial origin. It is concluded that they, most likely, represent individual micrometeorites that melted during passage through the atmosphere; alternatively, they may be ablation spherules.

Koeberl, Christian↗
NASA NTRS1988

Shock metamorphism of deformed quartz

The effect produced by shock loading (to peak pressures of 12 and 24) on deformed synthetic quartz containing a dislocation and abundant bubbles and small inclusions was investigated, and the relationships between preexisting dislocation density shock lamellae in the target material were examined. The resultant material was found to be inhomogeneously deformed and extremely fractured. Results of TEM examinations indicate that no change in dislocation density was caused by shock loading except in regions containing shock lamellae, where the dislocation density was lowered. The shock-induced defects tend to nucleate on and be controlled by preexisting stress concentrators; shock lamellae, glassy veins, and most curviplanar defects form in tension, presumably during release. An extremely mobile silica fluid is formed and injected into fractures during release, which forcibly removes crystalline fragments from vein walls. It is concluded that shock deformation in quartz is dominated by fracture and melting.

Gratz, Andrew J.↗
NASA NTRS1988

Electrochemical stability of LiMF6 (M = P, As, Sb) in tetrahydrofuran and sulfolane

The electrochemical stability of LiSbF6 and LiPF6 in aprotic organic solvents has been investigated. Electrochemical studies, conductivity measurements, and open-circuit stability tests were conducted on LiSbF6 in tetrahydrofuran and sulfolane. Cyclic voltammetric studies of SbF6(-) were compared with those of AsF6(-) and PF6(-) anions. Sb(V) was reduced to Sb(III), and then to Sb(0). AsF6(-) was reduced to AsF3, while no reduction of PF6(-) was observed. The reduction products of AsF6(-) and SbF6(-) passivated the glassy carbon electrode, presumably due to LiF precipitation. Peak potentials were observed to shift in the positive direction as a function of concentration. This was accounted for on the basis of a follow-up chemical reaction.

Nanjundiah, C.↗
NASA NTRS1990

Cell Model Of A Disordered Solid

Elastic properties predicted from first principles. Paper discusses generalization of cell theory of disordered (non-crystaline) solid to include anisotropic stresses. Study part of continuing effort to understand macroscopic stress-and-strain properties of solid materials in terms of microscopic physical phenomena. Emphasis on derivation, from first principles, of bulk, shear, and Young's moduli of glassy material at zero absolute temperature.

Peng, Steven T. J.↗