SEARCH · Search NASA

Results for “multimode”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14

All sources NASA NTRS DOE OSTI

NASA NTRS1980

Solar Power Satellite (SPS) fiber optic link assessment

A feasibility demonstration of a 980 MHz fiber optic link for the Solar Power Satellite (SPS) phase reference distribution system was accomplished. A dual fiber-optic link suitable for a phase distribution frequency of 980 MHz was built and tested. The major link components include single mode injection laser diodes, avalanche photodiodes, and multimode high bandwidth fibers. Signal throughput was demonstrated to be stable and of high quality in all cases. For a typical SPS link length of 200 meters, the transmitted phase at 980 MHz varies approximately 2.5 degrees for every deg C of fiber temperature change. This rate is acceptable because of the link length compensation feature of the phase control design.

Source record↗

NASA NTRS1980

Higher order mode propagation in nonuniform circular ducts

Higher order mode propagation in a nonuniform circular duct without mean flow was investigated. An approximate wave equation is derived on the assumptions that the duct cross section varies slowly and that mode conversion is negligible. Exact closed form solutions are obtained for a particular class of converging-diverging circular duct which referred to as 'circular cosh duct.' Numerical results are presented in terms of the transmission loss for the various duct shapes and frequencies. The results are applicable to multimodal propagation, single mode propagation, and sound radiation from certain types of contoured inlet ducts, or of sound propagation in a converging-diverging duct of somewhat different shape from a cosh duct.

Cho, Y. C.↗

NASA NTRS1980

Far-field radiation of aft turbofan noise

Approximate expressions were developed for the noise radiation from the aft duct. The results of approximate aft radiation equation compare favorably to more exact Wiener-Hopf radiation results. Refraction as well as convective effects in the multiple flow streams is considered. The peak in the radiation pattern, which occurs nearly at engine sideline, is composed of modes with relatively large cut-off ratios. This implies that aft fan radiation will be inherently more difficult to suppress that the fan inlet noise. The theoretical multimodal radiation pattern is compared to experimental data for the first two harmonics of blade passage frequency for three full scale fans at two speeds. The agreement between theory and experiment is quite good.

Rice, E. J.↗

NASA NTRS1979

Application of a hierarchical structure stochastic learning automation

A hierarchical structure automaton was developed using a two state stochastic learning automato (SLA) in a time shared model. Application of the hierarchical SLA to systems with multidimensional, multimodal performance criteria is described. Results of experiments performed with the hierarchical SLA using a performance index with a superimposed noise component of ? or - delta distributed uniformly over the surface are discussed.

Neville, R. G.↗

NASA NTRS1980

Higher order mode propagation in nonuniform circular ducts

This paper presents an analytical investigation of higher order mode propagation in a nonuniform circular duct without mean flow. An approximate wave equation is derived on the assumptions that the duct cross section varies slowly and that mode conversion is negligible. Exact closed form solutions are obtained for a particular class of converging-diverging circular duct which is here referred to as 'circular cosh duct'. Numerical results are presentd in terms of the transmission loss for the various duct shapes and frequencies. The results are applicable to studies of multimodal propagation as well as single mode propagation. The results are also applicable to studies of sound radiation from certain types of contoured inlet ducts, or of sound propagation in a converging-diverging duct of somewhat different shape from a cosh duct.

Cho, Y. C.↗

NASA NTRS1980

Far-field radiation of AFT turbofan noise

The far-field radiation from the end of an exhaust duct is studied using both approximate and exact methods. Experimental data of narrow-band tone noise from static tests are compared to a multimodal radiation pattern. It is pointed out that possibly the exhaust noise in the far-field is inherently more difficult to attenuate than an inlet noise using duct suppressors.

Rice, E. J.↗

NASA NTRS1980

Gigahertz analog modulation and differential delay of GaAlAs lasers - Temperature and current behavior

Gigahertz analog modulation characteristics of broad-area commercially available GaAlAs lasers have been investigated as a function of temperature and current in the vicinity of the upper frequency limit, where the resonance phenomena occur. The optimum temperature for small-signal amplitude modulation was found to be around -15 C for our particular broad-stripe geometry double-heterostructure laser. The Q was found to increase by a factor of 2 and the bandwidth by about 2%; the external quantum efficiency was maximized in this range. The optimum dc current bias was about 2% above the threshold current. Differential delays have also been measured down to a few picosecond accuracy by a unique phase-angle measurement method using a vector voltmeter. Some of the temperature effects observed may be related to mode changes and multimode and superradiance behavior.

Eng, S. T.↗

NASA NTRS1980

Predicted and measured effects of pressure and crossflow velocity on composite propellant burning rate

A theoretical model for prediction of burning rates of composite (ammonium perchlorate oxidizer) solid propellants as a function of pressure and crossflow velocity was developed. Included in this model is the capability for treatment of multimodal oxidizer particle sizes and metalized formulations. In addition, an experimental device for measuring the effects of crossflow velocity on propellant burning rate was developed and used to characterize a series of AP/HTPB propellants with systematically varied formulation parameters. Model predictions of zero-crossflow burning rate versus pressure characteristics were found to be in agreement with data, while the agreement between erosive burning predictions and data is, in general, good. The experimental data indicate that the dominant factor influencing the sensitivity of composite propellant burning rate to crossflow is the base (no-crossflow) burning rate versus pressure characteristics of the propellant (lower base burning rate leading to increased crossflow sensitivity). Finally, the model was used to examine the effects of motor scaling on erosive burning: erosive burning is predicted to diminish with increasing motor size, in agreement with experience.

King, M. K.↗

NASA NTRS1980

Supersonic cruise vehicle research/business jet

A comparison study of a GE-21 variable propulsion system with a Multimode Integrated Propulsion System (MMIPS) was conducted while installed in small M = 2.7 supersonic cruise vehicles with military and business jet possibilities. The 1984 state of the art vehicles were sized to the same transatlantic range, takeoff distance, and sideline noise. The results indicate the MMIPS would result in a heavier vehicle with better subsonic cruise performance. The MMIPS arrangement with one fan engine and two satellite turbojet engines would not be appropriate for a small supersonic business jet because of design integration penalties and lack of redundancy.

Kelly, R. J.↗

NASA NTRS1981

Propagation path length variations due to bending of optical fibers

The geometric effect and material stress effects are included. Calculations are shown that put an upper limit on the expected phase shift in single mode fibers. The fractional change in propagation constant is presented. Moding effects in multimode fibers cause extraneous phase shifts of unusually high magnitude. This does not occur in single mode fibers, rendering them very insensitive to bending with a theoretical limit given by the above relation.

Lau, K. Y.↗

NASA NTRS1979

Performance, operational limits, of an Electronic Switching Spherical Array (ESSA) antenna

The development of a microprocessor controller which provides multimode operational capability for the Electronic Switching Spherical Array (ESSA) Antenna is described. The best set of operating conditions were determined and the performance of an ESSA antenna was demonstrated in the following modes: (1) omni; (2) acquisition/track; (3) directive; and (4) multibeam. The control algorithms, software flow diagrams, and electronic circuitry were developed. The microprocessor and control electronics were built and interfaced with the antenna to carry out performance testing. The acquisition/track mode for users in the Tracking and Data Relay Satellite System is emphasized.

Stockton, R.↗

NASA NTRS1981

Optical fibers for the distribution of frequency and timing references

An optical fiber communications link was installed for the purpose of evaluating the applicability of optical fiber technology to the distribution of frequency and timing reference signals. It incorporated a 1.5km length of optical fiber cable containing two multimode optical fibers. The two fibers were welded together at one end of the cable to attain a path length of 3km. Preliminary measurements made on this link, including Allan variance and power spectral density of phase noise are reported.

Lutes, G. F.↗

NASA NTRS1981

Characterization of aerosols from eruptions of Mount St. Helens

Measurements of mass concentration and size distribution of aerosols from eruptions of Mount St. Helens as well as morphological and elemental analyses were obtained between 7 April and 7 August 1980. In situ measurements were made in early phreatic and later, minor phreatomagmatic eruption clouds near the vent of the volcano and in plumes injected into the stratosphere from the major eruptions of 18 and 25 May. The phreatic aerosol was characterized by an essentially monomodal size distribution dominated by silicate particles larger than 10 micrometers in diameter. The phreatomagmatic eruption cloud was multimodal; the large size mode consisted of silicate particles and the small size modes were made up of mixtures of sulfuric acid and silicate particles. The stratospheric aerosol from the main eruption exhibited a characteristic narrow single mode with particles less than 1 micrometer in diameter and nearly all of the mass made up of sulfuric acid droplets.

Chuan, R. L.↗

NASA NTRS1980

Application of the cubic polynomial strength criterion to the failure analysis of composite materials

A comparative failure analysis is presented based on the application of quadratic and cubic forms of the tensor polynomial lamina strength criterion to various composite structural configurations in a plane stress state. Failure loads have been predicted for off-angle laminates under simple loading conditions and for symmetric-balanced laminates subject to varying degrees of biaxial tension, including configurations subject to multimode failures. Some experimental data are also provided to support these calculations. From these results, the necessity of employing a cubic strength criterion to accurately predict the failure of composite laminae is demonstrated.

Tennyson, R. C.↗

NASA NTRS1980

Rotor blade aeroelastic stability and response in forward flight

The aeroelastic stability and response problem of the coupled flap-lag-torsional dynamics of a hingeless rotor blade in forward flight is treated in a comprehensive manner. The spatial dependence of the partial differential, nonlinear, equations of motion is discretized using a multimodal Galerkin method. The aeroelastic problem is coupled with the trim state of the helicopter obtained from improved, representative, trim procedures. The nonlinear time dependent equilibrium position, or response, about which the equations are linearized is obtained by solving a sequence of linear periodic response problems, using quasi-linearization. Numerous results illustrating blade behavior in forward flight are presented.

Friedmann, P. P.↗

NASA NTRS1981

An improved model for the combustion of AP composite propellants

This paper presents several improvements to the BDP model of steady-state burning of AP composite solid propellants. The Price-Boggs-Derr model of AP monopropellant burning is incorporated to represent the AP. A separate energy equation is written for the binder to permit a different surface temperature from the AP; this includes an analysis of the sharing of primary diffusion flame energy, and correction of a BDP model inconsistency in treating the binder regression rate. A method for assembling component contributions to calculate the burning rates of multimodal propellants is also presented. Results are shown in the form of representative burning rate curves, comparisons with data, and calculated internal details of interest. Ideas for future work are discussed in an Appendix.

Cohen, N. S.↗

NASA NTRS1981

Turbomachinery noise studies of the AiResearch QCGAT engine with inflow control

The AiResearch Quiet Clean General Aviation Turbofan engine was tested on a vertical lift fan facility to measure the acoustic performance of two inflow control devices (ICD) of similar design, and three inlet lips of different external shape. Far-field directivity patterns calculated by existing analyses were compared with the measured fan fundamental blade passing frequency (BPF/F/) and broadband data. Installing an ICD on an engine with hardwall ducts reduced the BPF(F) tone everywhere in the far-field. When the ICD was installed on an engine with active acoustic panels, tone reduction in the forward quadrant was comparable to that in the hardwall tests; in the aft quadrant, however, tone noise was attenuated by the large acoustic panels in the bypass duct to such a degree that the ICD had little effect. Tests to compare performance of ICDs with hardwall inlet ducts showed only minor differences in the BPF(F) directivity patterns, while broadband noise was the same for both. Forward-quadrant BPF(F) and broadband directivity patterns were found to be similar for the inlet lips tested with a hardwall inlet duct. At high fan speeds, however, the shape of the analytical multimodal tone pattern from the exhaust nozzle was flatter than the measured patterns. The sources of lobes from several propagating single modes found in the forward-quadrant BPF(F) data were attributed to rotor/strut interaction and the rotor-alone pressure field.

Mcardle, J. G.↗

NASA NTRS1982

Circumferentially segmented duct lines optimized for axisymmetric and standing wave sources

Optimum and off-optimum properties of circumferentially segmented duct liners are compared with those of uniform liners to identify any potential benefits of circumferentially segmented liners. High- and low-order spinning-mode sources are considered in the study. The solution for the segmented liner is obtained by a multimodal expansion of the segmented-liner eigenmodes in terms of a series of hardwall duct models. The coefficients in the hard-wall series are obtained by using Galerkin's method. Results show that for some frequencies and duct lengths, circumferentially segmented liners scatter energy equally between a higher and lower order circumferential wave number. Studies for higher order spinning-mode sources show that an optimized segmented liner with a hard-wall/soft-wal admittance variation representing an optimum configuration gives better performance than an optimized uniform liner. Overall, the greatest benefit of the segmented liner over the uniform liner occurs under off-optimum conditions. The optimized segmented liner gives more effective broadband performance than the optimized uniform liner.

Watson, W. R.↗