Search NASA⌕ Search

SEARCH · Search NASA

Results for “stream processing”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14

Thermal control of ice-stream margins

The thermal balance at the base of an ice sheet near an ice-stream margin was investigated theoretically. Specifically, conditions such that the base of the ice sheet would be frozen in the absence of heat generated by the ice motion were investigated. The base of the ice stream is maintained at melting as a result of high dissipation of heat at the base associated with its fast motion over the bed. Heat dissipation in the inter-ice-stream ridge ice is presumed to be too small to maintain melting conditions on the bed there. Two opposing effects can be identified near the shear margin separating the fast and slow motions. Because the velocity of an ice stream falls off toward its margin, there is a near margin heat deficit zone where the heat generated at the bed is not, by itself, sufficient to maintain melting conditions. Without some counteracting process, the base could freeze inward toward the ice stream and cause it to narrow. The marginal shearing generates heat within the ice above the bed. This heat produces a thermal shielding effect that tends to warm the bed on both sides of the boundary between the fast and slow motion. This shielding effect, if strong enough, could produce a thawed zone beyond the fast/slow boundary. If melting at the bed by itself allows fast motion, then the ice stream would be free to widen. A coupled mass and heat flow model is being developed to examine these competing processes. Preliminary calculations using available information for boundary conditions appropriate for Ice Stream B predict that the shielding effect is most important. This tentative result suggests that thermal conditions are such that the ice stream could widen unstably. Other constraints would be required to stabilize the width. Possible factors could be bed morphology beneath ridges that does not allow fast motion even in thawed conditions, or inward advection of cold ice from the ridges across the margin and into the ice stream, which suppresses the shielding effect. The unknown geothermal heat flow beneath ice streams and inter ice-stream ridges is a major uncertainty in doing these calculations.

Raymond, Charles F.↗

Test Would Quantify Combustion Oxygen From Different Sources

Proposed isotope-enrichment scheme enables determination of contributions of dual sources of oxygen for combustion. Liquid oxygen or other artificial stream enriched with O(18) to about 1 percent by weight. Combustion products analyzed by mass spectrometer to measure relative abundances of H2O(18) and H2O(16). From relative abundances of water products measured, one computes relative contribution of oxygen extracted from stream compared to other source of oxygen in combustion process. Used to determine contributions of natural oxygen in air and liquid oxygen supplied in separate stream mixed with air or sent directly into combustion chamber.

Tapphorn, Ralph M.↗

Characterization of Catalyst Materials for Production of Aerospace Fuels

Due to environmental, economic, and security issues, there is a greater need for cleaner alternative fuels. There will undoubtedly be a shift from crude oil to non-petroleum sources as a feedstock for aviation (and other transportation) fuels. Additionally, efforts are concentrated on reducing costs coupled with fuel production from non-conventional sources. One solution to this issue is Fischer-Tropsch gas-to-liquid technology. Fischer-Tropsch processing of synthesis gas (CO/H2) produces a complex product stream of paraffins, olefins, and oxygenated compounds such as alcohols and aldehydes. The Fisher-Tropsch process can produce a cleaner diesel oil fraction with a high cetane number (typically above 70) without any sulfur or aromatic compounds. This process is most commonly catalyzed by heterogeneous (in this case, silver and platinum) catalysts composed of cobalt supported on alumina or unsupported alloyed iron powders. Physisorption, chemisorptions, scanning electron microscopy (SEM), and energy dispersive spectroscopy (EDS) are described to better understand the potential performance of Fischer-Tropsch cobalt on alumina catalysts promoted with silver and platinum. The overall goal is to preferentially produce C8 to C18 paraffin compounds for use as aerospace fuels. Progress towards this goal will eventually be updated and achieved by a more thorough understanding of the characterization of catalyst materials. This work was supported by NASA s Subsonic Fixed Wing and In-situ Resource Utilization projects.

DeLaRee, Ana B.↗

Characterization of Catalyst Materials for Production of Aerospace Fuels

Due to environmental, economic, and security issues, there is a greater need for cleaner alternative fuels. There will undoubtedly be a shift from crude oil to non-petroleum sources as a feedstock for aviation (and other transportation) fuels. Additionally, efforts are concentrated on reducing costs coupled with fuel production from non-conventional sources. One solution to this issue is Fischer-Tropsch gas-to-liquid technology. Fischer-Tropsch processing of synthesis gas (CO/H2) produces a complex product stream of paraffins, olefins, and oxygenated compounds such as alcohols and aldehydes. The Fisher-Tropsch process can produce a cleaner diesel oil fraction with a high cetane number (typically above 70) without any sulfur or aromatic compounds. This process is most commonly catalyzed by heterogeneous (in this case, silver and platinum) catalysts composed of cobalt supported on alumina or unsupported alloyed iron powders. Physisorption, chemisorptions, scanning electron microscopy (SEM), and energy dispersive spectroscopy (EDS) are described to better understand the potential performance of Fischer-Tropsch cobalt on alumina catalysts promoted with silver and platinum. The overall goal is to preferentially produce C8 to C18 paraffin compounds for use as aerospace fuels. Progress towards this goal will eventually be updated and achieved by a more thorough understanding of the characterization of catalyst materials. This work was supported by NASA s Subsonic Fixed Wing and In-situ Resource Utilization projects.

Best, Lauren M.↗

Definition and fabrication of an airborne scatterometer radar signal processor

A hardware/software system which incorporates a microprocessor design and software for the calculation of normalized radar cross section in real time was developed. Interface is provided to decommutate the NASA ADAS data stream for aircraft parameters used in processing and to provide output in the form of strip chart and pcm compatible data recording.

Source record↗

Some anomalies between wind tunnel and flight transition results

A review of environmental disturbance influence and boundary layer transition measurements on a large collection of reference sharp cone tests in wind tunnels and of recent transonic-supersonic cone flight results have previously demonstrated the dominance of free-stream disturbance level on the transition process from the beginning to end. Variation of the ratio of transition Reynolds number at onset-to-end with Mach number has been shown to be consistently different between flight and wind tunnels. Previous correlations of the end of transition with disturbance level give good results for flight and large number of tunnels, however, anomalies occur for similar correlation based on transition onset. Present cone results with a tunnel sonic throat reduced the disturbance level by an order of magnitude with transition values comparable to flight.

Harvey, W. D.↗

Energetic electrons and plasma waves associated with a solar type III radio burst

Detailed in situ observations from the ISEE 3 spacecraft of energetic electrons, plasma waves, and radio emission for the type II solar radio burst of February 17, 1979, are presented. The reduced, one-dimensional electron distribution function is constructed as a function of time. Since the faster electrons arrive before the slower ones, a bump on tail distribution forms which is unstable to the growth of Langmuir waves. The plasma wave growth computed from the distribution function agrees well with the observed onset of the Langmuir waves, and there is qualitative agreement between variations in the plasma wave levels and in the development of regions of positive slope in the function. The evolution of the function, however, predicts far higher plasma wave levels than those observed. The maximum levels observed are approximately equal to the threshold for nonlinear wave processes, such as oscillation two-stream instability and soliton collapse.

Lin, R. P.↗

The photochemical heating of the cometary atmosphere

A self-consistent solution of the thermodynamic structure of an H2O-dominated multispecies cometary atmosphere at 1 AU is obtained by solving the simultaneous set of differential equations representing conservation of number density, momentum, energy, and the flux of solar UV radiation in the three streams responsible for the major photolytic processes. The relative efficiency of the expansion and infrared cooling by H2O over the photolytic heating by the UV radiation in the inner coma brings about a rapid decrease in the temperature there, reaching a minimum of only about 5.4 K at a nuclear distance of approximately 54 km. Thereafter, the temperature is found to increase to about 810 K at a nuclear distance of 25,000 km, owing to higher efficiency of the photolytic heating over the cooling process. The expansion in the inner coma is seen to be highly supersonic, attaining a maximum Mach number of about 15 at the distance of temperature minimum. After that, the Mach number steadily decreases, reaching a value of about 2.3 at a nuclear distance of 25,000 km.

Marconi, M. L.↗

Executive summary, aerothermal modeling program, phase 1

Submodels used in the combustor analytical models that were successfully used in designing advanced technology combustors were assessed. Specific recommendations for further improvement of model accuracy for combustor design purposes were made. Based upon an exhaustive literature survey, a number of test cases were selected to assess accuracy of submodels of turbulence, turbulence/chemistry interaction, spray combustion, and dilution jet mixing processes within a confined cross-stream. These test cases included simple flows and complex flows with and without swirl. Nonrecirculating and recirculating, and nonreactive and reactive flows were investigated. It was concluded that the current models give qualitative trends for the recirculating secondary flows (as encountered in a gas turbine combustor primary zone), but the predictions are good for the dilution zone.

Srinivasan, R.↗

Tip vortices of wings in subsonic and transonic flow: A numerical simulation

Thin layer Navier-Stokes and Euler equations are numerically solved using a multi-block zonal approach to simulate the formation and roll up of tip vortices of wings in subsonic and transonic flows. Several wing planforms were considered to examine the influence of tip-cap shape, planform geometry and free stream Mach number on the formation process. A good definition of the formation and qualitative roll up of tip vortices was achieved.

Srinivasan, G. R.↗

Double layers and plasma-wave resistivity in extragalactic jets: Cavity formation and radio-wave emission

For estimated values of the currents carried by extragalactic jets, current-driven electrostatic-wave- and electromagnetic-wave-produced resistivities do not occur. Strong plasma double layers, however, may exist within self-maintained density cavities, the relativistic double-layer-emitted electron, and ion beams driving plasma-wave resistivities in the low- and high-potential plasma adjacent to the double layers. The double-layer-emitted electron beams may also emit polarized radio waves via a collective bremsstrahlung process mediated by electrostatic two-stream instabilities.

Borovsky, Joseph E.↗

Velocity measurements in the plume of an arcjet engine

A nonintrusive technique has been used to conduct a radial survey in the flow field of an arcjet engine plume. The technique measures the Doppler shift of an optically thin line resulting from recombination and relaxation processes in the high Mach number stream, in order to determine flow velocities. Atom temperature can also be calculated from the same Doppler-broadened line widths, when these shifts are measured with a scanning Fabry-Perot spectrometer whose design is presented in detail.

Pivirotto, T. J.↗

Double layers and plasma-wave resistivity in extragalactic jets - Cavity formation and radio-wave emission

Current driven electrostatic-wave- and electromagnetic-wave-produced resistivities do not occur in extragalactic jets for estimated values of the carried currents. Strong plasma double layers, however, may exist within self-maintained density cavities. The relativistic double-layer-emitted electron and ion beams drive plasma-wave resistivities in the low- and high-potential plasma adjacent to the double layers. The double-layer-emitted electron beams may also emit polarized radio waves via a collective bremsstrahlung process mediated by electrostatic two-stream instabilities.

Borovsky, Joseph E.↗

Powder-Metallurgy Process And Product

Rapid-solidification processing yields alloys with improved properties. Study undertaken to extend favorable property combinations of I/M 2XXX alloys through recently developed technique of rapid-solidification processing using powder metallurgy(P/M). Rapid-solidification processing involves impingement of molten metal stream onto rapidly-spinning chill block or through gas medium using gas atomization technique.

Paris, Henry G.↗

Wind and waves in the middle atmosphere observed with the MU radar

The VHF band MU radar at Shigaraki, Japan, has been in full operation successfully since April 1985. Dynamical features found primarily in the data obtained by the radar during a one year period from December 1985 to November 1986 are examined. These include: basic wind observations, quasi-monochromatic gravity waves generated by the jet stream or through a geostrophic adjustment process, seasonal variation of the mesoscale wind variability, the momentum flux due to gravity wave motions, and saturated gravity wave spectrum. A short discussion is added to the relationship between turbulent layers and ambient wind field in the mesosphere.

Fukao, S.↗

Fast Vector-Quantizing Data Compressor

Proposed encoding digital electronic data-processing system compresses 7-Mb/s input stream of data into 1-Mb/s output stream. Intended to reduce flow of data from orbiting synthetic-aperture-radar (SAR) system to rate low enough for transmission to ground. Features include reliability, light weight, and low power. Proves advantageous in such terrestrial applications as compression of speech and of video signals.

Chang, Chi-Yung↗

Advanced technologies to support earth orbiting systems

Within NASA, the Office of Aeronautics and Space Technology (OAST) is conducting a major, ongoing engineering research and technology program directed toward the support of future programs, with a major focus on technology for future space science missions. OAST is conducting a substantial effort to identify the technologies required to support the evolution of Mission to Planet Earth. The effort consists of studies, workshops, and technology research programs to explore: (1) new concepts for multisatellite, earth-observing instrumentation and sensor sets; (2) information system advances for continuous and reliable processing of terabit per day data streams; and (3) infrastructure development, including spacecraft bus technology and operations for substantial performance, cost, and reliabiltiy gains. This paper discusses the technological needs of future earth science systems, reviews current and planned activities, and highlights significant achievements in the research and technology program.

Rosen, Robert↗