Search NASA⌕ Search

SEARCH · Search NASA

Results for “wing aerodynamics”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14
All sourcesNASA NTRSDOE OSTI
NASA NTRS1980

Leading-edge 'Vortex Flaps' for enhanced subsonic aerodynamics of slender wings

The 'Vortex Flap' is a novel concept aimed at reducing the lift-dependent drag due to leading-edge flow separation on highly swept, slender wings at high angles of attack. The suction effect of coiled vortices generated via controlled separation over leading-edge flap surfaces is utilized to produce an aerodynamic thrust component. This principle was verified through wind-tunnel experiments on 74-deg and 60-deg delta wings and a supersonic-cruise slender wing aircraft configuration. Adaptation of the vortex-flap for augmentation of roll-control on the 74-deg delta at high angles of attack also was demonstrated. Selected results are presented in this paper to indicate the potential of the vortex flap concept to enhance the low-speed performance, stability and control of slender wing aircraft.

Rao, D. M.↗
NASA NTRS1934

The aerodynamic analysis of the gyroplane rotating-wing system

An aerodynamic analysis of the gyroplane rotating-wing system is presented herein. This system consists of a freely rotating rotor in which opposite blades are rigidly connected and allowed to rotate or feather freely about their span axis. Equations have been derived for the lift, the lift-drag ratio, the angle of attack, the feathering angles, and the rolling and pitching moments of a gyroplane rotor in terms of its basic parameters. Curves of lift-drag ratio against lift coefficient have been calculated for a typical case, showing the effect of varying the pitch angle, the solidarity, and the average blade-section drag coefficient. The analysis expresses satisfactorily the qualitative relations between the rotor characteristics and the rotor parameters. As disclosed by this investigation, the aerodynamic principles of the gyroplane are sound, and further research on this wing system is justified.

Wheatley, John B↗
NASA NTRS2015

NASA,FAA,ONERA Swept-Wing Icing and Aerodynamics: Summary of Research and Current Status

NASA, FAA, ONERA, and other partner organizations have embarked on a significant, collaborative research effort to address the technical challenges associated with icing on large scale, three-dimensional swept wings. These are extremely complex phenomena important to the design, certification and safe operation of small and large transport aircraft. There is increasing demand to balance trade-offs in aircraft efficiency, cost and noise that tend to compete directly with allowable performance degradations over an increasing range of icing conditions. Computational fluid dynamics codes have reached a level of maturity that they are being proposed by manufacturers for use in certification of aircraft for flight in icing. However, sufficient high-quality data to evaluate their performance on iced swept wings are not currently available in the public domain and significant knowledge gaps remain.

Aircraft Icing↗
NASA NTRS1979

Powered low-aspect-ratio Wing In Ground effect (WIG) aerodynamic characteristics

A wing-in-ground effect configuration was investigated. The configuration used large diameter, low pressure ratio fans mounted about 0.76 wing chord ahead of the wing leading edge to achieve a power augmented ram wing during operation in ground effect. Tests of both in and out of ground effect aerodynamic transition characteristics from very low speeds to cruise speeds are described. The investigation provided a number of conclusions concerning the aerodynamic/propulsive performance interaction. While power augmented lift is required for low speed flight, there is a thrust loss when the efflux is trapped under the wing which reduced the effective thrust to weight available for acceleration by about a third of the installed thrust to weight ratio.

Thomas, J. L.↗
NASA NTRS1976

Aerodynamic Characteristics of an A-4B Aircraft with Simulated and Actual Gunfire Damage to One Wing

The aerodynamic characteristics of a damaged McDonnell Douglas A-4B aircraft were studied in the Ames Research Center's 40- by 80-Foot Wind Tunnel. A standard fuselage and three different wings were used. The first wing tested was an undamaged one in which holes had been cut and detachable cover plates installed. Removal of one or more cover plates gave one of fourteen different simulated damage cases. The other two wings tested were damaged by actual gunfire at an Air Force range.

Betzina, M. D.↗
NASA NTRS1934

The effects of full-span and partial-span split flaps on the aerodynamic characteristics of a tapered wing

The investigation was made to determine the effects of full-span and of partial-span split flaps on the aerodynamic characteristics of a tapered wing. Aerodynamic force tests were made in the N.A.C.A. 7 by 10 foot wind tunnel on a highly tapered Clark Y wing equipped with various split flaps. Two sizes of tapered-chord flaps were tested as full-span flaps, and a narrow tapered-chord flap was tested as a partial-span flap by cutting off portions first from the tip and then from the center. The investigation showed that with full-span split flaps the lift and drag characteristics of the tapered wing up to the stall are similar to those of a rectangular wing with flaps of comparable size, but that the stall of the tapered wing with full-span flaps occurs at progressively lower angles of attack with increasing flap deflection up to that for maximum lift. For partial-span tapered split flaps on a tapered wing it was found that the maximum lift is greater, and the lift-drag ratio at maximum lift is less, when the partial-span flap is located at the center of the wing than when it is located at the tip portion.

Wenzinger, Carl J↗
NASA NTRS1975

Computer programs for calculating the static longitudinal aerodynamic characteristics of wing-body-tail configurations

Four computer programs developed to calculate the longitudinal aerodynamic characteristics of wing-body and wing-body-tail combinations are presented. The R1307 program is based on a linear method and is limited to the small range of angles of attack for which the lift and moment characteristics of wings and bodies are linear with angle of attack. The CRSFLW program is based on a crossflow method of predicting the forces and moments on bodies alone or wing-body combinations over a large angle of attack range. The SUBSON program predicts the longitudinal aerodynamic characteristics of wing-body-tail combinations at subsonic speeds and at angles of attack for which symmetrical pairs of vortices are shed from the body nose and the leading and side edges of the lifting surfaces. Program SUPSON predicts the longitudinal aerodynamic characteristics of wing-body-tail combinations at supersonic speeds in the same angle-of-attack range. A description of the use of each program, instructions for preparation of input, a description of the output, program listings, and sample cases for each program are included.

Mendenhall, M. R.↗
NASA NTRS1989

The DELTA MONSTER: An RPV designed to investigate the aerodynamics of a delta wing platform

The mission requirements for the performance of aerodynamic tests on a delta wind planform posed some problems, these include aerodynamic interference; structural support; data acquisition and transmission instrumentation; aircraft stability and control; and propulsion implementation. To eliminate the problems of wall interference, free stream turbulence, and the difficulty of achieving dynamic similarity between the test and actual flight aircraft that are associated with aerodynamic testing in wind tunnels, the concept of the remotely piloted vehicle which can perform a basic aerodynamic study on a delta wing was the main objective for the Green Mission - the Delta Monster. The basic aerodynamic studies were performed on a delta wing with a sweep angle greater than 45 degrees. These tests were performed at various angles of attack and Reynolds numbers. The delta wing was instrumented to determine the primary leading edge vortex formation and location, using pressure measurements and/or flow visualization. A data acquisition system was provided to collect all necessary data.

Connolly, Kristen↗
NASA NTRS1959

Transonic Aerodynamic Characteristics of a 45 deg Swept Wing Fuselage Model with a Finned and Unfinned Body Pylon Mounted Beneath the Fuselage or Wing, Including Measurements of Body Loads

An investigation of a model of a standard size body in combination with a representative 45 deg swept-wing-fuselage model has been conducted in the Langley 8-foot transonic pressure tunnel over a Mach number range from 0.80 to 1.43. The body, with a fineness ratio of 8.5, was tested with and without fins, and was pylon-mounted beneath the fuselage or wing. Force measurements were obtained on the wing-fuselage model with and without the body, for an angle-of-attack range from -2 deg to approximately 12 deg and an angle-of-sideslip range from -8 deg to 8 deg. In addition, body loads were measured over the same angle-of-attack and angle-of-sideslip range. The Reynolds number for the investigation, based on the wing mean aerodynamic chord, varied from 1.85 x 10(exp 6) to 2.85 x 10(exp 6). The addition of the body beneath the fuselage or the wing increased the drag coefficient of the complete model over the Mach number range tested. On the basis of the drag increase per body, the under-fuselage position was the more favorable. Furthermore, the bodies tended to increase the lateral stability of the complete model. The variation of body loads with angle of attack for the unfinned bodies was generally small and linear over the Mach number range tested with the addition of fins causing large increases in the rates of change of normal-force coefficient and nose-down pitching-moment coefficient. The variation of body side-force coefficient with sideslip for the unfinned body beneath the fuselage was at least twice as large as the variation of this load for the unfinned body beneath the wing. The addition of fins to the body beneath either the fuselage or the wing approximately doubled the rate of change of body side-force coefficient with sideslip. Furthermore, the variation of body side-force coefficient with sideslip for the body beneath the wing was at least twice as large as the variation of this load with angle of attack.

Wornom, Dewey E.↗
NASA NTRS1972

Analysis of the effect of engine characteristics on the external aerodynamics of STOL wing propulsion systems

The effects of engine presssure ratio, engine size, and engine location on the pressure distribution, lift coefficient, and flow field of a STOL wing propulsion system are presented. The flow variables of the engines are included in the two-dimensional potential flow analysis by considering the effects of mass flow coefficient at the engine inlet and thrust coefficient at the engine exit. A functional relation between these coefficients and engine pressure ratio is given. The results of this study indicate that the effect of engine pressure ratio on the external aerodynamics is a function of engine location. For engines located on the bottom of the wing, the highest pressure ratio engine resulted in the highest lift coefficient. For engines located on the top of the wing, the lowest pressure ratio engine resulted in the highest lift coefficient.

Albers, J. A.↗
NASA NTRS1974

Effects of wing trailing-edge truncation on aerodynamic characteristics of a NASA supercritical-wing research airplane model

The Langley 8-foot transonic pressure tunnel was used at Mach numbers from 0.80 to 1.00 to determine the effects of wing trailing-edge truncation on the aerodynamic characteristics of a 0.0625-scale model of a NASA TF-8A supercritical-wing research airplane. The effects of trailing-edge truncations of 1, 2, and 3 percent of the local streamwise chord on the longitudinal aerodynamic characteristics and the wing section characteristics are presented.

Bartlett, D. W.↗
NASA NTRS1977

Airframe, wing, and tail aerodynamic characteristics of a 1/6-scale model of the rotor systems research aircraft with the rotors removed

A wind-tunnel investigation was conducted to determine the aerodynamic characteristics of the rotor systems research aircraft (RSRA) as the helicopter and the compound helicopter with the rotors removed. Data were obtained over ranges of angle of attack and angle of sideslip. Results are presented for the total loads on the airframe as well as the loads on the wing and the tail. The results indicate that the RSRA with the rotors removed has stable static longitidinal and directional characteristics and has stable effective dihedral.

Mineck, R. E.↗