Search NASA⌕ Search

SEARCH · Search NASA

Results for “Attitude Operations”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 271 records · Page 15
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

Reference equations of motion for automatic rendezvous and capture

The analysis presented in this paper defines the reference coordinate frames, equations of motion, and control parameters necessary to model the relative motion and attitude of spacecraft in close proximity with another space system during the Automatic Rendezvous and Capture phase of an on-orbit operation. The relative docking port target position vector and the attitude control matrix are defined based upon an arbitrary spacecraft design. These translation and rotation control parameters could be used to drive the error signal input to the vehicle flight control system. Measurements for these control parameters would become the bases for an autopilot or feedback control system (FCS) design for a specific spacecraft.

Henderson, David M.↗
NASA NTRS2002

Navigation Algorithms for the SeaWiFS Mission

The navigation algorithms for the Sea-viewing Wide Field-of-view Sensor (SeaWiFS) were designed to meet the requirement of 1-pixel accuracy-a standard deviation (sigma) of 2. The objective has been to extract the best possible accuracy from the spacecraft telemetry and avoid the need for costly manual renavigation or geometric rectification. The requirement is addressed by postprocessing of both the Global Positioning System (GPS) receiver and Attitude Control System (ACS) data in the spacecraft telemetry stream. The navigation algorithms described are separated into four areas: orbit processing, attitude sensor processing, attitude determination, and final navigation processing. There has been substantial modification during the mission of the attitude determination and attitude sensor processing algorithms. For the former, the basic approach was completely changed during the first year of the mission, from a single-frame deterministic method to a Kalman smoother. This was done for several reasons: a) to improve the overall accuracy of the attitude determination, particularly near the sub-solar point; b) to reduce discontinuities; c) to support the single-ACS-string spacecraft operation that was started after the first mission year, which causes gaps in attitude sensor coverage; and d) to handle data quality problems (which became evident after launch) in the direct-broadcast data. The changes to the attitude sensor processing algorithms primarily involved the development of a model for the Earth horizon height, also needed for single-string operation; the incorporation of improved sensor calibration data; and improved data quality checking and smoothing to handle the data quality issues. The attitude sensor alignments have also been revised multiple times, generally in conjunction with the other changes. The orbit and final navigation processing algorithms have remained largely unchanged during the mission, aside from refinements to data quality checking. Although further improvements are certainly possible, future evolution of the algorithms is expected to be limited to refinements of the methods presented here, and no substantial changes are anticipated.

Hooker, Stanford B.↗
NASA NTRSDate not supplied

Operations Challenges in a Dynamic Environment: A Three-Year Perspective of SAGE III

The Stratospheric Aerosol and Gas Experiment III on the International Space Station (SAGE III/ISS) was delivered to the International Space Station (ISS) on 23 February 2017. The SAGE III/ISS payload was robotically installed external to the ISS and began acquiring science measurements on 17 March 2017. The SAGE III/ISS instrument retrieves vertical profiles of atmospheric ozone, multi-wavelength aerosol extinctions, and other gaseous species. This paper will focus on the improvements made to the operations of the SAGE III/ISS payload. A key focus of the operations team following commissioning was to create robust tools that aid in the operations of the payload. A close collaboration with the SAGE III/ISS ground systems team allowed for the development of web-based tools to continuously monitor the health of the payload. The mission operations team also worked with the SAGE III/ISS science team to gain a better sense of how the instrument works to maximize the quality and quantity of the science data collected. Another unique aspect of the SAGE III/ISS payload, that will be discussed, is the challenges of operating a hosted payload on the ISS; an active platform that has frequent attitude maneuvers, dockings, and EVAs. This active environment increases the need for the SAGE III/ISS operations team command to the payload. Through coordination and teamwork, SAGE III/ISS mission has developed an operations team, tool, and procedures that have successfully managed the payload around ISS activities and recovered from multiple instrument upsets. This has led the SAGE III/ISS payload to successfully surpass the acquisition metrics set forth prior to launch, allowing for the continued contribution to studying the atmospheric composition of the stratosphere and how it plays a role in Earth’s climate.

SAGE III↗
NASA NTRS1978

An orbital service module systems concept

An Orbital Service Module (OSM) system represents a concept for an evolutionary program that will provide utilities services such as electrical power, heat rejection, attitude control, and communications to support payload operations in both Shuttle-tended and untended (free-flyer) modes. The initial program step is a Space Transportation System (STS) power extension package (a solar array system carried by the Orbiter and deployed by the remote manipulator system). The power extension package (PEP) develops the major components of the more sophisticated OSM vehicles. Major objectives of such an approach are (1) the continuous matching of a capability to meet real needs while avoiding the pitfalls usually associated with the uncertainties inherent in long-range prediction of future requirements, and (2) the economies attendant with program continuity and hardware commonality. The initial Orbiter-carried PEP and several later OSM system growth options are discussed.

Craig, J. W.↗
NASA NTRS1982

The Nimbus Satellite System - Remote sensing R&D platform of the 70's

In surveying the Nimbus series, attention is given to the early problems encountered in developing the Attitude Control System and in proving its operational characteristics in a simulated space environment. A table summarizing the experiments carried out with Nimbus satellites is included. Data from the Nimbus satellites are being used in oceanography, hydrology, geology, geomorphology, geography, cartography, agriculture, and meteorology.

Haas, I. S.↗
NASA NTRS1985

White-collar productivity and quality issues; Proceedings of the Symposium on Productivity and Quality: Strategies for Improving Operations in Government and Industry, Washington, DC, September 25, 26, 1984

Techniques for improving the productivity of white-collar workers while maintaining high product quality are examined in reviews and reports. The emphasis is on the application of strategies developed in the private sector to government-agency and aerospace-industry operations. Topics discussed include international competition, organizational attitudes and orientation, management practices, education and training, renewing large organizations, encouraging innovation, national initiatives, employee involvement, management involvement, and applications of new technology.

Gerard, M.↗
NASA NTRS1986

Control/structures interaction study of two 300 KW dual-keel space station concepts

The results of an investigation of the influence of structural stiffness of the space station framework on the controllability of two 300 kw class, solar dynamic powered, dual-keel space station designs are presented. The two design concepts differed only in the truss bay dimensions of the structural framework of the stations. Two control studies were made: (1) A study of the interaction of the framework structural response with the reaction control system used for attitude control during an orbital reboost maneuver; and (2) A study of the stability of the space station attitude control system with sensors influenced by the elastic deformations of the station framework. Although both configurations had acceptable control characteristics, the configuration with the larger truss bay dimension and its increased structural stiffness had more attractive characteristics for pointing control of the solar dynamic system during reboost and for attitude control during normal in-orbit operations.

Young, J. W.↗
NASA NTRS1987

A flight investigation of helicopter low-speed response requirements

A flight experiment has been conducted using the Canadian National Aeronautical Establishment's variable-stability airborne simulator to define the dynamic response requirements for operations at hover and low speeds. Fourteen Attitude Command/Attitude Hold, Rate, and Rate Command/Attitude Hold configurations were evaluated by six pilots using both conventional controls and a four-axis integrated sidestick over a low-speed course consisting of precision hover, landing, sidestep, and dash/quickstop tasks. The results indicate that with conventional controls all three response-types were acceptable as long as their response bandwidth was sufficiently high, and higher bandwidths were required in roll than in pitch. With the four-axis sidestick, there was a preference for the Rate systems. The range of acceptable bandwidths was lower, and the spread in pilot ratings smaller, than were found in a similar ground-based simulation.

Mitchell, David G.↗
NASA NTRS1989

Computational fluid dynamics and aerothermodynamics

The primary objective was the development of nonequilibrium radiation and chemistry models suitable for engineering applications associated with the flow fields about aeroassisted orbital transfer vehicles (AOTVs), the aero-assisted flight experiment vehicle (AFE), and other vehicles operating at superorbital velocities and very high attitudes.

Carlson, Leland A.↗
NASA NTRS1990

Approach to large space structure control system design using traditional tools

This paper illustrates how traditional analysis and design tools can be successfully applied, with insights derived from recent research on control-structure interaction, to preliminary control system design for a large space structure such as the Space Station Freedom. The control system regulates attitude during construction, normal on-orbit operation, reboost, and docking using control-moment gyros and thrusters. The tools include finite-element modeling, model reduction based on modal truncation, single-input/single-output Bode plot design, position and rate feedback, roll-off and phase filter, and simulation. The resulting system is characterized by simple architecture and moderate bandwidth. The large configuration changes during the construction period are handled by gain scheduling.

Chu, P. Y.↗
NASA NTRS1990

Evolutionary Space Station Guidance Navigation and Control (GN/C) study

The guidance, navigation, and control (GN&C) techniques and equipment to support evolutionary space station concepts were analyzed. Simulations of the evolutionary space station configurations and operational concepts were conducted to analyze the attitude control, reboost, and traffic management accommodation requirements. A summary of the mission concepts, space station configurations, simulation results, and the impact on the baseline GN&C systems are presented.

Kennedy, Jerry↗
NASA NTRS1995

Numerical studies of surface tensions

Liquid-vapor (bubble) interface disturbances caused by various types of accelerations, including centrifugal, lateral and axial impulses, gravity gradient and g-jitter accelerations associated with spinning and slew motion in microgravity, are reviewed. Understanding of bubble deformations and fluctuations is important in the development of spacecraft orbital and attitude control techniques to secure its normal operation. This review discusses bubble deformations and oscillations driven by various forces in the microgravity environment. The corresponding bubble mass center fluctuations and slosh reaction forces and torques due to bubble deformations are also reviewed.

Hung, R. J.↗
NASA NTRS2002

On-Orbit Testing of the EO-1 Pulsed Plasma Thruster

The Pulsed Plasma Thruster (PPT) Experiment on the Earth Observing 1 (EO-1) spacecraft has demonstrated the capability of a new generation PPT to perform spacecraft attitude control. The PPT is a small, self-contained pulsed electromagnetic propulsion system capable of delivering high specific impulse (900-1200 s) and very small impulse bits (10-1000 microN-s) at low average power (4 to 100 W). EO-1 has a single PPT that can produce torque in the positive or negative pitch direction and replace the function of the spacecraft s pitch reaction wheel. The flight validation experiment was designed to demonstrate the ability of the PPT to provide precision pointing accuracy, response and stability, and to confirm that the thruster plume and EMI effects on the spacecraft and instruments were benign. The PPT has been successfully used for pitch attitude control accumulating over 26 hours of operational time with over 96,000 pulses. Thruster performance has been nominal and all spacecraft subsystems and instruments continue to show no detrimental effects from PPT operation.

Zakrzwski, Charles↗
NASA NTRS2010

IRVE-II Post-Flight Trajectory Reconstruction

NASA s Inflatable Re-entry Vehicle Experiment (IRVE) II successfully demonstrated an inflatable aerodynamic decelerator after being launched aboard a sounding rocket from Wallops Flight Facility (WFF). Preliminary day of flight data compared well with pre-flight Monte Carlo analysis, and a more complete trajectory reconstruction performed with an Extended Kalman Filter (EKF) approach followed. The reconstructed trajectory and comparisons to an attitude solution provided by NASA Sounding Rocket Operations Contract (NSROC) personnel at WFF are presented. Additional comparisons are made between the reconstructed trajectory and pre and post-flight Monte Carlo trajectory predictions. Alternative observations of the trajectory are summarized which leverage flight accelerometer measurements, the pre-flight aerodynamic database, and on-board flight video. Finally, analysis of the payload separation and aeroshell deployment events are presented. The flight trajectory is reconstructed to fidelity sufficient to assess overall project objectives related to flight dynamics and overall, IRVE-II flight dynamics are in line with expectations

O'Keefe, Stephen A.↗
NASA NTRS2014

Bi-Axial Solar Array Drive Mechanism: Design, Build and Environmental Testing

The development of the Bi-Axial Solar Array Drive Mechanism (BSADM) presented in this paper is a demonstration of SSTL's unique space manufacturing approach that enables performing rapid development cycles for cost-effective products that meet ever-challenging mission requirements: The BSADM is designed to orient a solar array wing towards the sun, using its first rotation axis to track the sun, and its second rotation axis to compensate for the satellite orbit and attitude changes needed for a successful payload operation. The tight development schedule, with manufacture of 7 Flight Models within 1.5 year after kick-off, is offset by the risk-reduction of using qualified key component-families from other proven SSTL mechanisms. This allowed focusing the BSADM design activities on the mechanism features that are unique to the BSADM, and having an Engineering Qualification Model (EQM) built 8 months after kick-off. The EQM is currently undergoing a full environmental qualification test campaign. This paper presents the BSADM design approach that enabled meeting such a challenging schedule, its design particularities, and the ongoing verification activities.

Scheidegger, Noemy↗
NASA NTRS2016

Launch and Commissioning of the Deep Space Climate Observatory

The Deep Space Climate Observatory (DSCOVR), formerly known as Triana, successfully launched on February 11th, 2015. To date, each of the five space-craft attitude control system (ACS) modes have been operating as expected and meeting all guidance, navigation, and control (GN&C) requirements, although since launch, several anomalies were encountered. While unplanned, these anomalies have proven to be invaluable in developing a deeper understanding of the ACS, and drove the design of three alterations to the ACS task of the flight software (FSW). An overview of the GN&C subsystem hardware, including re-furbishment, and ACS architecture are introduced, followed by a chronological discussion of key events, flight performance, as well as anomalies encountered by the GN&C team.

DSCOVR↗