Search NASA⌕ Search

SEARCH · Search NASA

Results for “Optical filters”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 271 records · Page 15

Very heavy solar cosmic rays: Energy spectrum and implications for lunar erosion

Particle tracks were investigated in the glass plate of a neutral density (clear flint) optical filter housed in the Surveyor 3 TV camera but exposed directly to space. The track density vs depth curve was determined and descends sharply from approximately 2.6 million tracks/sq cm at a depth of 3.6 mg/sq cm to about 35/sq cm at 700 mg/sq cm. Several tracks were of V-shapes characteristic of high energy induced fission. The erosion rate on the moon due to solar wind ions was determined from the energy spectrum, and was found to be low (0 to 2 x 10 to the minus 8th power cm/yr).

Fleischer, R. L.↗

Spectrofluorometer techniques applicable to sample surfaces

Methods for correcting fluorescence spectra to remove instrumental artifacts are described, including computational and graphical procedures for rapid manual correction by nomographs and similar techniques. Expedient methods for the selection and use of optical filters, the evaluation of filter effectiveness, and the selection of optimum wavelength settings in spectrofluorometry are outlined.

Stoertz, G. E.↗

The ferrioxalate actinometry system of the microbial response to space environment experiment (M191)

The fluid actinometry portion of the Microbial Response to Space Environment Experiment (M191) was designed for measurement of the solar energy that penetrates certain optical filter systems during exposure in space. Potassium ferrioxalate was used to measure energy at peak wavelengths of 254, 280, and 300 nanometers because of its high degree of sensitivity and its linear response to the middle ultraviolet regions.

Parson, M.↗

Doppler shift system

A system is described for measuring velocities of radiating particles based on Doppler shift. Light from the particles is directed through a narrow band optical filter to a Fabry-Perot interferometer initially tuned to a selected center line corresponding to zero particle Doppler shift. The movable mirror of the interferometer is made to sweep about the center line by the output of a modulation oscillator. The fringe pattern output is imaged onto a pin hole through which light is directed to a photomultiplier. The output of the photomultiplier is supplied to a phase sensitive detector with the oscillator output as a reference signal and which operates in the quadrature mode. The detector's output is gain controlled and is combined with the oscillator's output to adjust the interferometer's movable mirror to acquire the line center.

Aisenberg, S.↗

Study for identification of beneficial uses of Space, phase 1. Volume 2, book 2: Technical report: results, conclusions and recommendations

A variety of technologies were investigated to determine the benefits to be derived from space activities. The subjects accepted for product development are: (1) eutectics for cold cathodes, (2) higher putiry fiber optics, (3) fluidic wafers, (4) large germanium wafers for gamma ray camera, (5) improved batteries and capacitors, (6) optical filters, (7) corrosion resistant electrodes, (8) high strength carbon-based filaments for plastic reinforcement, and (9) new antibiotics. In addition, three ideas for services, involving disposal of radioactive wastes, blood analysis, and enhanced solar insolation were proposed.

Source record↗

Wide-field birefringent elements

Birefrigent array consists of two plates with retardation properties nearly independent of direction of incident light over unlimited range of wavelengths. Array can be used as birefrigent color filter. Optical properties of plates may also be changed electro-optically rather than thermally.

Miller, A.↗

Broadband spectral photography of the James River

On May 28, 1974, a photographic mission from 5.3 kilometers altitude was flown over the James River from Norfolk to Hopewell. During the mission 252 photographs were exposed over the river. The photographs are divided into four simultaneously exposed groups with each group exposed through a different broadband optical filter. The four filters isolated blue-green, green, yellow, and near-infrared radiation from the water body. The document summarizes the mission photography in relation to flight altitude, sunglint, and photographic exposure.

Bressette, W. E.↗

Planetary investigation utilizing an imaging spectrometer system based upon charge injection technology

An intrinsic silicon charge injection device (CID) television sensor array has been used in conjunction with a CaMoO4 colinear tunable acousto optic filter, a 61 inch reflector, a sophisticated computer system, and a digital color TV scan converter/computer to produce near IR images of Saturn and Jupiter with 10A spectral resolution and approximately 3 inch spatial resolution. The CID camera has successfully obtained digitized 100 x 100 array images with 5 minutes of exposure time, and slow-scanned readout to a computer. Details of the equipment setup, innovations, problems, experience, data and final equipment performance limits are given.

Wattson, R. B.↗

Effects of solar ultraviolet radiations on Bacillus subtilis spores and T-7 bacteriophage

Spores of Bacillus subtilis HA 101 and the DNA polymerase I-defective mutant HA 101 (59)F were exposed to selected wavelengths of solar ultraviolet light and space vacuum during the return of Apollo 16. In addition, coliphage T-7 suspensions were exposed to solar ultraviolet radiation as part of the Microbial Response to Space Environment Experiment. Optical filters were employed to provide different energy levels at wavelengths 254 nm and 280 nm. Dose-response curves for lethal and mutagenic effects were compared with ground-based data. A close parallel was observed between the results of solar radiation and ground tests with spores of the two strains. However, significantly greater inactivation of T-7 bacteriophage was observed after exposure to solar ultraviolet radiation.

Spizizen, J.↗

Space calibration of standard solar cells using high altitude sounding rockets

Four photovoltaic cells were space calibrated and successfully recovered from a NASA Aerobee rocket launched on Sept. 18, 1974, which reached a peak altitude of 251 km. The experiment was comprised of four 2 ohm-cm n/p cells, two of which are optically filtered with 0.6 to 0.9 micron bandpass filters. The short-circuit current agreed to within 4% of the laboratory calibration. The variation of cell output due to atmospheric attenuation between the altitude range 80 and 251 km was 0.4% for the unfiltered cells.

Thomas, N. L.↗

High altitude calibration of solar cells using rockets

The use of sounding rockets for calibrating solar cells offers two principal advantages: there is no effect due to the terrestrial atmosphere and the cells are recoverable immediately after calibration. Four n/p photovoltaic cells were calibrated in space and successfully recovered from a NASA Aerobee rocket that reached a peak altitude of 251 km. Two of the cells were optically filtered with 0.6 to 0.9-micron bandpass filters. The short-circuit current agreed to within 4% of the laboratory calibration; variation of cell output due to atmospheric attenuation in the altitude range of 80 to 251 km was 0.4% for the unfiltered cells.

Thomas, N. L.↗

Use of satellite pictures for determining major shield fractures relevant for ore prospecting, northern Finland

The author has identified the following significant results. A combined analysis of LANDSAT 1 imagery, aeromagnetic and other maps, and aerial photos has revealed a dense network of bedrock fractures in northern Finland. They form several fracturing zones, which obviously represent surficial manifestations of major fractures. The fractures follow, in general, the eight main trends of crustal shear characteristics of the Baltic Shield, but show distinct deviations from them in detail. The major fracture zones divide the bedrock into a mosaic of polygonal blocks, which in many cases coincide with the main rock units of the area and are characterized by different patterns of internal fracturing. Known mineralizations show a tendency to concentrate along the fracture zones. Optical filtering of original LANDSAT images might provide a rapid tool for the analysis of major structural trends in extensive areas such as shields or entire continents.

Tuominen, H. V.↗

A white-light amplitude interferometer with 180-degree rotational shear

The paper reports on the fabrication, alignment, and test techniques of an equal-path, wave-front, folding amplitude interferometer with 180-degree rotational shear. The device may be used for measuring atmospheric phase-perturbing properties and designing optical filters used in processing spatial information. The instrument has been used to photograph the Michelson Stellar interferometer fringes.

Breckinridge, J. B.↗

Viewing electron-beam welds in progress

With aid of optical filter, operator of electron-beam welding machine can view TV image of joint that is being welded and can make corrections as necessary. Operator can see when weld bead gets out of alinement, for example, and compensate for deflection of electron beam caused by changes in magnetic field.

Armenoff, C. T.↗

Acoustically-tuned optical spectrometer

Lens arrangement corrects for aberrations and gives resolution of 0.7 seconds of arc. In spectrometer, light from telescope is relayed by doublet lens to acoustically tuned optical filter. Selected wavelengths are relayed by triplet lens to charge coupled device camera. Intervening cylindrical lens, tilted at 12 degree angle, corrects for astigmatism and coma introduced by two element birefringent crystal in filter.

Sklar, E.↗

Simultaneous measurement of three atmospheric pollutants

Method enables simultaneous concentration monitoring of atmospheric SO2, NO, and NO2. Fluorescing pollutant gases in sample are excited by visible output of dye laser and its second-harmonic ultraviolet frequencies. Three photomultipliers, each with suitable optical filters, view fluorescence. Method tests ambient air, stack emissions, and highway automotive exhausts.

Sinha, M. P.↗

Programs for high-speed Fourier, Mellin and Fourier-Bessel transforms

Several FORTRAN program modules for performing one-dimensional and two-dimensional discrete Fourier transforms, Mellin, and Fourier-Bessel transforms are described along with programs that realize the algebra of high speed Fourier transforms on a computer. The programs can perform numerical harmonic analysis of functions, synthesize complex optical filters on a computer, and model holographic image processing methods.

Ikhabisimov, D. K.↗