Search NASA⌕ Search

SEARCH · Search NASA

Results for “Sensitive”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 271 records · Page 15
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Sensitivity of hot-cathode ionization vacuum gages in several gases

Four hot-cathode ionization vacuum gages were calibrated in 12 gases. The relative sensitivities of these gages were compared to several gas properties. Ionization cross section was the physical property which correlated best with gage sensitivity. The effects of gage accelerating voltage and ionization-cross-section energy level were analyzed. Recommendations for predicting gage sensitivity according to gage type were made.

Holanda, R.↗
NASA NTRS1972

Time-dependent edge notch sensitivity of Inconel 718 sheet in the temperature range 900 to 1400 F (482 to 760 C)

Time-dependent notch sensitivity of Inconel 718 sheet occurred at 900 to 1200 F when notched specimens were loaded below the yield strength, and tests on smooth specimens showed that small amounts of creep consumed large fractions of creep-rupture life. The severity of the notch sensitivity decreased with decreasing solution treatment temperature and increasing time and/or temperature of the aging treatment. Elimination of the notch sensitivity was correlated with a change in the dislocation mechanism from shearing to by-passing precipitate particles.

Wilson, D. J.↗
NASA NTRS1971

Sensitivity of the creep-rupture properties of Waspaloy sheet to sharp-edged notches in the temperature range 1000-1400 deg F.

Time-dependent notch sensitivity of Waspaloy was observed at test temperatures from 1000 to 1300 deg F. Its occurrence in this range was dependent on the heat treatment. ?Overaging' eliminated the notch sensitivity. Optimum combination of smooth and notched specimen strengths for material solution treated at 1975 deg F were obtained by aging 24 hr at 1550 deg F. Necessary conditions for time-dependent notch sensitivity were (1) the notch specimen loads had to be below the approximate 0.2 percent offset yield strength; and (2 ) test data from smooth specimens had to indicate that small amounts of creep used up large fractions of creep-rupture life. No reasons were evident why these criteria will not prove applicable to other alloys.

Wilson, D. J.↗
NASA NTRS1972

Isolation and characterization of ultraviolet light-sensitive mutants of the blue-green alga Anacystis nidulans.

Three independently isolated ultraviolet light sensitive (uvs) mutants of Anacystis nidulans were characterized. Strain uvs-1 showed the highest sensitivity to UV by its greatly reduced photoreactivation capacity following irradiation. Pretreatment with caffeine suppressed the dark-survival curve of strain uvs-1, thus indicating the presence of excision enzymes involved in dark repair. Under 'black' and 'white' illumination, strain uvs-1 shows photorecovery properties comparable with wild-type cultures. Results indicate that strains uvs-1, uvs-35, and uvs-88 are probably genetically distinct UV-sensitive mutants.

Asato, Y.↗
NASA NTRS1972

Terminal context in context-sensitive grammars.

Investigation of the conditions whereunder context-sensitive grammars generate context-free languages. The obtained results indicate that, if every noncontext-free rewriting rule of a context-sensitive grammar has as left context a string of terminal symbols and the left context is at least as long as the right context, then the language generated is context-free. Likewise, if every noncontext-free rewriting rule of a context-sensitive grammar has strings of terminal symbols as left and right contexts, then the language generated is also context-free.

Book, R. V.↗
NASA NTRS1972

Low-sensitivity, frequency-selective amplifier circuits for hybrid and bipolar fabrication.

A network is described which is suitable for realizing a low-sensitivity high-Q second-order frequency-selective amplifier for high-frequency operation. Circuits are obtained from this network which are well suited for realizing monolithic integrated circuits and which do not require any process steps more critical than those used for conventional monolithic operational and video amplifiers. A single chip version using compatible thin-film techniques for the frequency determination elements is then feasible. Center frequency and bandwidth can be set independently by trimming two resistors. The frequency selective circuits have a low sensitivity to the process variables, and the sensitivity of the center frequency and bandwidth to changes in temperature is very low.

Pi, C.↗
NASA NTRS1973

On the design of wave digital filters with low sensitivity properties.

The wave digital filter patterned after doubly terminated maximum available power (MAP) networks by means of the Richard's transformation has been shown to have low-coefficient-sensitivity properties. This paper examines the exact nature of the relationship between the wave-digital-filter structure and the MAP networks and how the sensitivity property arises, which permits implementation of the digital structure with a lower coefficient word length than that possible with the conventional structures. The proper design procedure is specified and the nature of the unique complementary outputs is discussed. Finally, an example is considered which illustrates the design, the conversion techniques, and the low sensitivity properties.

Renner, K.↗
NASA NTRS1971

Relationship of mechanical characteristics and microstructural features to the time-dependent edge notch sensitivity of inconel 718 sheet

Time-dependent notch sensitivity of Inconel 718 sheet was observed at 900 F to 1200 F (482 - 649 C). It occurred when edge-notched specimens were loaded below the yield strength and smooth specimen tests showed that small amounts of creep consumed large rupture life fractions. The severity of the notch sensitivity was reduced by decreasing the solution temperature, increasing the time and/or temperature of aging and increasing the test temperature to 1400 F (760 C). Elimination of time-dependent notch sensitivity correlated with a change in dislocation motion mechanism from shearing to by-passing precipitate particles.

Wilson, D. J.↗
NASA NTRS1973

On the structure of context-sensitive grammars

Consideration of the problem of explaining the use of context in generating noncontext-free languages. A number of existing results regarding the constraints placed on the form of the rules (i.e., on the context) of context-sensitive grammars are reviewed and interpreted. Three types of constraints are considered - namely, constraints which do not restrict the weak generative capacity of the class of grammars (i.e., all the context-sensitive languages are generated by grammars with these constraints), constraints which restrict the weak generative capacity to the extent that all context-sensitive languages are not generated but some noncontext-free languages are generated, and constraints which restrict the weak generative capacity to such an extent that only context-free languages are generated.

Book, R. V.↗
NASA NTRS1974

A design method for minimizing sensitivity to plant parameter variations

A method is described for minimizing the sensitivity of multivariable systems to parameter variations. The variable parameters are considered as random variables and their effect is included in a quadratic performance index. The performance index is a weighted sum of the state and control covariances that stem from both the random system disturbances and the parameter uncertainties. The numerical solution of the problem is described and application of the method to several initially sensitive tracking systems is discussed. The sensitivity factor of reduction was typically 2 or 3 over a system based on random system noise only, and yet resulted in state RMS increases of only about a factor of two.

Hadass, Z.↗
NASA NTRS1974

Sensitivity and fatigue of LiTaO3 for holographic recording

The sensitivity of LiTaO3 crystals to hologram formation has been observed to vary with impurity concentration. For a writing wavelength of 488.0 nm and power density of 1.1 W/sq cm, the sensitivity varied from a value comparable to the most sensitive doped LiNbO3 for an impure crystal to a value more than 5 orders of magnitude smaller for a purer crystal. Fatigue effects were observed upon write-erase cycling. These effects were dependent upon writing and erasure polarization and power density and could be minimized by proper choice of optical parameters.

Spinhirne, J. M.↗
NASA NTRS1976

High pressure liquid and gaseous oxygen impact sensitivity evaluation of materials for use at Kennedy Space Center

The sensitivity of materials in contact with gaseous oxygen (GOX) or liquid oxygen (LOX) was examined. Specifically, the reactivity of materials when in contact with GOX or LOX if subjected to such stimuli as mechanical impact, adiabatic compression (pneumatic impact), or an electrical discharge in the form of a spark were examined. Generally, materials are more sensitive in gaseous oxygen than in liquid oxygen and impact sensitivity is known to increase with increasing pressure. Materials presently being used or considered for use in oxygen systems at KSC were evaluated. Results are given in tabular form.

Bryan, C. J.↗
NASA NTRS1975

Space shuttle SRM plume expansion sensitivity analysis

The exhaust plumes of the space shuttle solid rocket motors can have a significant effect on the base pressure and base drag of the shuttle vehicle. A parametric analysis was conducted to assess the sensitivity of the initial plume expansion angle of analytical solid rocket motor flow fields to various analytical input parameters and operating conditions. The results of the analysis are presented and conclusions reached regarding the sensitivity of the initial plume expansion angle to each parameter investigated. Operating conditions parametrically varied were chamber pressure, nozzle inlet angle, nozzle throat radius of curvature ratio and propellant particle loading. Empirical particle parameters investigated were mean size, local drag coefficient and local heat transfer coefficient. Sensitivity of the initial plume expansion angle to gas thermochemistry model and local drag coefficient model assumptions were determined.

Smith, S. D.↗
NASA NTRS1978

Variation of solar cell sensitivity and solar radiation on tilted surfaces

The validity is studied that one of various insolation models used to compute solar radiation incident on tilted surfaces from global data measured on horizontal surfaces. The variation of solar cell sensitivity to solar radiation is determined over a wide range of atmospheric condition. A new model was formulated that reduced the deviations between measured and predicted insolation to less than 3 percent. Evaluation of solar cell sensitivity data indicates small change (2-3 percent) in sensitivity from winter to summer for tilted cells. The feasibility of using such global data as a means for calibrating terrestrial solar cells is discussed.

Klucher, T. M.↗
NASA NTRS1978

Acceleration sensitivity compensation in high performance crystal oscillators

Two approaches to achieving reduced acceleration sensitivity of crystal oscillators are discussed. The first involves electronic compensation within the frequency control loop. The second utilizes two resonators of comparable acceleration sensitivity to compensate each other. Problems encountered in matching and tuning the resonators are discussed, as well as orientation symmetry of the frequency deviation patterns. Results on frequency stability which reflect an improved static sensitivity are presented.

Emmons, D. A.↗
NASA NTRS1979

Sensitivity study for a remotely piloted microwave-powered sailplane used as a high-altitude observation

The sensitivity of several performance characteristics of a proposed design for a microwave-powered, remotely piloted, high-altitude sailplane to changes in independently varied design parameters was investigated. Results were expressed as variations from baseline values of range, final climb altitude and onboard storage of radiated energy. Calculated range decreased with increases in either gross weight or parasite drag coefficient; it also decreased with decreases in lift coefficient, propeller efficiency, or microwave beam density. The sensitivity trends for range and final climb altitude were very similar. The sensitivity trends for stored energy were reversed from those for range, except for decreasing microwave beam density. Some study results for single parameter variations were combined to estimate the effect of the simultaneous variation of several parameters: for two parameters, this appeared to give reasonably accurate results.

Turriziani, R. V.↗
NASA NTRS1979

A one-dimensional model describing aerosol formation and evolution in the stratosphere. I - Physical processes and mathematical analogs. II - Sensitivity studies and comparison with observations

A new time-dependent one-dimensional model of the stratospheric sulfate aerosol layer is developed. The model treats atmospheric photochemistry and aerosol physics in detail and includes the interaction between gases and particles explicitly. It is shown that the numerical algorithms used in the model are quite precise. Sensitivity studies and comparison with observations are made. The simulated aerosol physics generates a particle layer with most of the observed properties. The sensitivity of the calculated properties to changes in a large number of aeronomic aerosol parameters is discussed in some detail. The sensitivity analysis reveals areas where the aerosol model is most uncertain. New observations are suggested that might help resolve important questions about the origin of the stratospheric aerosol layer.

Turco, R. P.↗
NASA NTRS1978

Variation of solar cell sensitivity and solar radiation on tilted surfaces

An empirical study was performed (1) to evaluate the validity of various insolation models used to compute solar radiation incident on tilted surfaces from global data measured on horizontal surfaces and (2) to determine the variation of solar cell sensitivity to solar radiation over a wide range of atmospheric condition. Evaluation of the insolation data indicates that the isotropic sky model of Liu and Jordan underestimates the amount of solar radiation falling on tilted surfaces by as much as 10%. An anisotropic-clear-sky model proposed by Temps and Coulson was also evaluated and found to be deficient under cloudy conditions. A new model, formulated herein, reduced the deviations between measured and predicted insolation to less than 3%. Evaluation of solar cell sensitivity data indicates small change (2-3%) in sensitivity from winter to summer for tilted cells. The feasibility of using such global data as a means for calibrating terrestrial solar cells as done by Treble is discussed.

Klucher, T. M.↗