SEARCH · Search NASA

Results for “WINGS, DELTA - CHARACTERISTICS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 271 records · Page 15

All sources NASA NTRS DOE OSTI

NASA NTRS1993

Adaptive computations of flow around a delta wing with vortex breakdown

An adaptive unstructured mesh solution method for the three-dimensional Euler equations was used to simulate the flow around a sharp edged delta wing. Emphasis was on the breakdown of the leading edge vortex at high angle of attack. Large values of entropy, which indicate vortical regions of the flow, specified the region in which adaptation was performed. The aerodynamic normal force coefficients show excellent agreement with wind tunnel data measured by Jarrah, and demonstrate the importance of adaptation in obtaining an accurate solution. The pitching moment coefficient and the location of vortex breakdown are compared with experimental data measured by Hummel and Srinivasan, showing good agreement in cases in which vortex breakdown is located over the wing.

Modiano, David L.↗

NASA NTRS1992

Lift augmentation on a delta wing via leading edge fences and the Gurney flap

Wind tunnel tests were conducted on two devices for the purpose of lift augmentation on a 60 deg delta wing at low speed. Lift, drag, pitching moment, and surface pressures were measured. Detailed flow visualization was also obtained. Both the leading edge fence and the Gurney flap are shown to increase lift. The fences and flap shift the lift curve as much as 5 deg and 10 deg, respectively. The fences aid in trapping vortices on the upper surface, thereby increasing suction. The Gurney flap improves circulation at the trailing edge. The individual influences of both devices are roughly additive, creating high lift gain. However, the lower lift to drag ratio and the precipitation of vortex burst caused by the fences, and the nose down pitching moment created by the flap are also significant factors.

Buchholz, Mark D.↗

NASA NTRS1994

Navier-Stokes prediction of large-amplitude forced and free-to-roll delta-wing oscillations

The three-dimensional Reynolds-averaged, Navier-Stokes (RANS) equations are used to numerically simulate nonsteady vortical flow about a 65 degree sweep delta wing at 30 degrees angle of attack. Two large-amplitude, high-rate, forced-roll motions and a damped free-to-roll motion are presented. The free-to-roll motion is computed by coupling the time-dependent RANS equations to the flight dynamic equation of motion. The computed results are compared with experimental forces, moments, and roll-angle time histories. The overall agreement is good. Vortex breakdown is present in each case, which causes significant time lags in the vortex breakdown motions relative to the body motions. This behavior strongly influences the dynamic forces and moments.

Chaderjian, Neal M.↗

NASA NTRS1996

Numerical Simulation of Forced and Free-to-Roll Delta-Wing Motions

The three-dimensional, Reynolds-averaged, Navier-Stokes (RANS) equations are used to numerically simulate nonsteady vortical flow about a 65-deg sweep delta wing at 30-deg angle of attack. Two large-amplitude, high-rate, forced-roll motions, and a damped free-to-roll motion are presented. The free-to-roll motion is computed by coupling the time-dependent RANS equations to the flight dynamic equation of motion. The computed results are in good agreement with the forces, moments, and roll-angle time histories. Vortex breakdown is present in each case. Significant time lags in the vortex breakdown motions relative to the body motions strongly influence the dynamic forces and moments.

Chaderjian, Neal M.↗

NASA NTRS1989

A streamwise upwind algorithm applied to vortical flow over a delta wing

Improvements were made to a streamwise upwind algorithm so that it can be used for calculating flows with vortices. A calculation is shown of flow over a delta wing at an angle of attack. The laminar, thin layer, Navier-Stokes equations are used for the calculation. The results are compared with another upwind method, a central differencing method, and experimental data. The present method shows improvements in accuracy and convergence properties.

Goorjian, Peter M.↗

NASA NTRS1991

Navier-Stokes solutions for an oscillating double-delta wing

An upwind-biased implicit scheme is used to investigate steady-state and unsteady Navier-Stokes solutions of the vortical flow over a double-delta wing configuration. The governing equations are solved numerically with a fully upwind, implicit, iterative, and factorized numerical scheme. Steady-state solutions for fixed angles of attack and unsteady solutions for a sinusoidal oscillatory motion are obtained. The steady-state solutions on the baseline grid are in agreement with the experiment, and grid refinements show some improvements of the predictions. The higher-order accuracy of the present scheme yields equivalent solutions on smaller grid densities compared to solutions obtained with a second-order accurate method on larger grids. As the angle of attack increases, the grid resolution requirements for adequate resolution of the leeward-side vortical flowfield become very severe. The unsteady solutions are in general agreement with the measurements and show a qualitative correlation with the experiment.

Ekaterinaris, John A.↗

NASA NTRS1993

Lift Augmentation on a Delta Wing via Leading Edge Fences and the Gurney Flap

Wind tunnel tests have been conducted on two devices for the purpose of lift augmentation on a 60 deg delta wing at low speed. Lift, drag, pitching moment, and surface pressures were measured. Detailed flow visualization was also obtained. Both the leading edge fence and the Gurney flap are shown to increase lift. The fences and flap shift the lift curve by as much as 5 deg and 10 deg, respectively. The fences aid in trapping vortices on the upper surface, thereby increasing suction. The Gurney flap improves circulation at the trailing edge. The individual influences of both devices are roughly additive, creating high lift gain. However, the lower lift to drag ratio and the precipitation of vortex burst caused by the fences, and the nose down pitching moment created by the flap are also significant factors.

Buchholz, Mark D.↗

NASA NTRS1972

Experimental surface flow patterns and flow-field phenomena of a delta-wing space-shuttle orbiter

Composite photographs of the surface flow and shadowgraphs of the shock wave pattern are presented that depict the hypersonic flow field of a typical delta wing space shuttle orbiter. Results from a wind tunnel test in air are given in side, oblique, and projected plan views for angles of attack from 0 to 60 deg. The tests were conducted at a Mach number of 7.4 and for Reynolds numbers based on body length of 6,000,000 and 9,000,000. The interrelationship is shown for the intersecting bow and wing leading edge waves with the surface flow for angles of attack for which: (1) the leading edge wave is attached, and (2) the leading edge wave is detached.

Cleary, J. W.↗

NASA NTRS1980

Performance improvement of delta wings at subsonic speeds due to vortex flaps

Subsonic wind tunnel tests were conducted to determine performance improvements possible from the use of leading edge vortex flaps (LEVF) on delta wings. Various flap sizes and deflection angles were examined and lift-to-drag ratio improvements of up to 40% were found at moderate angles of attack on 60 deg and 75 deg swept wings. The LEVF is concluded to be effective in moving the wing's leading edge vortex onto the flaps, tilting the vortex-induced force vector forward to produce a thrust or reduce the wing's drag while maintaining attached flow and lift on the wing's upper surface.

Marchman, J. F., III↗

NASA NTRS1990

A streamwise upwind algorithm applied to vortical flow over a delta wing

Improvements have been made to a streamwise upwind algorithm so that it can be used for calculating flows with vortices. A calculation is shown of flow over a delta wing at an angle of attack. The laminar, thin-layer, Navier-Stokes equations are used for the calculation. The results are compared with another upwind method, a central-differencing method, and experimental data. The present method shows improvements in accuracy and convergence properties.

Goorjian, Peter M.↗

NASA NTRS1992

The effects of blowing on delta wing vortices during dynamic pitching at high angles of attack

An experimental investigation was conducted in a water tunnel to identify the effects of apex blowing on two delta-wing models undergoing constant pitch-rate motion. One wing was of 60-degree sweep and the other was of 76-degree sweep. Flow visualization methods were utilized to determine vortex burst locations for a wide range of pitch-up (nose up) and plunge (nose down) rates, apex jet strengths, and blowing directions. Results indicate that blowing along the 60-degree wing vortex core or along the 76-degree wing centerline results in a notable improvement in vortex behavior under both static and dynamic conditions. The results are most dramatic during dynamic plunging (nose down) conditions, where blowing resulted in the reformation of vortices with significant length.

Miller, L. S.↗

NASA NTRS1978

Configuration heating for a hypersonic research airplane concept having a 70 deg swept double-delta wing

The heating on a candidate hypersonic research airplane configuration has been examined experimentally at Mach 6 by the phase-change-paint technique. The configuration has a double-delta wing with tip fins. Phase-change-paint diagrams give heating data for the model top, side, and bottom, with and without deflected elevons for an angle-of-attack range of 0 deg to 24 deg. Nominal Reynolds numbers are on the order of 15,000,000 with supplementary data at length Reynolds number of 4,000,000, which moves the model from the predominantly turbulent into the predominantly laminar regime. Also, intermediate Reynolds numbers were investigated on the lee side for one angle of attack.

Lawing, P. L.↗

NASA NTRS1978

Calculation of supersonic viscous flow over delta wings with sharp subsonic leading edges

Two complementary procedures were developed to calculate the viscous supersonic flow over conical shapes at large angles of attack, with application to cones and delta wings. In the first approach the flow is assumed to be conical and the governing equations are solved at a given Reynolds number with a time-marching explicit finite-difference algorithm. In the second method the parabolized Navier-Stokes equations are solved with a space-marching implicit noniterative finite-difference algorithm. This latter approach is not restricted to conical shapes and provides a large improvement in computational efficiency over published methods. Results from the two procedures agree very well with each other and with available experimental data.

Vigneron, Y. C.↗

NASA NTRS1983

Vortex flap flow reattachment line and subsonic longitudinal aerodynamic data on 50 deg to 74 deg Delta wings on common fuselage

Positions of the primary vortex flow reattachment line and longitudinal aerodynamic data were obtained at Mach number 0.3 for a systematic series of vortex flaps on delta wing body configurations with leading edge sweeps of 50, 58, 66, and 74 deg. The investigation was performed to study the parametric effects of wing sweep, vortex flap geometry and deflection, canards, and trailing edge flaps on the location of the primary vortex reattachment line relative to the flap hinge line. The vortex reattachment line was located via surface oil flow photographs taken at selected angles of attack. Force and moment measurements were taken over an angle of attack range of -1 deg to 22 deg at zero sideslip angle for many configurations to further establish the data base and to assess the aforementioned parametric effects on longitudinal aerodynamics. Both the flow reattachment and aerodynamic data are presented.

Frink, N. T.↗

NASA NTRS1978

Calculation of supersonic viscous flow over delta wings with sharp subsonic leading edges

Two complementary procedures have been developed to calculate the viscous supersonic flow over conical shapes at large angles of attack, with application to cones and delta wings. In the first approach the flow is assumed to be conical and the governing equations are solved at a given Reynolds number with a time-marching explicit finite-difference algorithm. In the second method the parabolized Navier-Stokes equations are solved with a space-marching implicit noniterative finite-difference algorithm. This latter approach is not restricted to conical shapes and provides a large improvement in computational efficiency over published methods. Results from the two procedures agree very well with each other and with available experimental data.

Vigneron, Y. C.↗

NASA NTRS1971

An experimental study of the hypersonic aerodynamics of delta wings.

Results of aerodynamic balance and pressure measurements carried out in a hypersonic gun tunnel (at a free-stream Mach number of 8.2 and a Reynolds number of 800,000) on delta wings having sharp leading edges swept at 70 and 76 deg. The experimental force and pressure coefficients and shock angles are discussed in relation to simple prediction methods. Some transition data are also included.

Rao, D. M.↗

NASA NTRS1989

A flow visualization and aerodynamic force data evaluation of spanwise blowing on full and half span delta wings

A wind-tunnel investigation has been performed to quantify the effects of a jet on the leading-edge vortices generated by a 70-deg-sweep sharp-edged delta wing at low Reynolds numbers. Efforts were made ot optimize the jet nozzle position with respect to maximum lift increments. Both half-span force-balance testing and half- and full-span flow visualization tests were conducted. Two angles of attack were investigated, 30 and 35 deg, at Reynolds numbers of 150,000 and 200,000. Aerodynamic enhancement, including lift and drag gains of about 20 and 17 percent respectively, were measured. Results indicate an optimum jet nozzle location to be close to the leading edge, tangent to the upper wing surface, and in a direction aligned parallel to the leading edge. Nozzle interference effects, especially near the apex, were not negligible.

Visser, K. D.↗

NASA NTRS1949

A Preliminary Analysis of the Flying Qualities of the Consolidated Vultee MX-813 Delta-Wing Airplane Configuration at Transonic and Low Supersonic Speeds as Determined from Flights of Rocket-Powered Models

A preliminary analysis of the flying qualities of the Consolidated Vultee MX-813 delta-wing airplane configuration has been made based on the results obtained from the first two 1/8 scale models flown at the NACA Pilotless Aircraft Research Station, Wallop's Island, VA. The Mach number range covered in the tests was from 0.9 to 1.2. The analysis indicates adequate elevator control for trim in level flight over the speed range investigated. Through the transonic range there is a mild trim change with a slight tucking-under tendency. The elevator control effectiveness in the supersonic range is reduced to about one-half the subsonic value although sufficient control for maneuvering is available as indicated by the fact that 10 deg elevator deflection produced 5g acceleration at Mach number of 1.2 at 40,000 feet.The elevator control forces are high and indicate the power required of the boost system. The damping. of the short-period oscillation is adequate at sea-level but is reduced at 40,000 feet. The directional stability appears adequate for the speed range and angles of attack covered.

Mitcham, Grady L.↗