Search NASA⌕ Search

SEARCH · Search NASA

Results for “predictive simulation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 271 records · Page 15

Closed coronal structures. V - Gasdynamic models of flaring loops and comparison with SMM observations

A time-dependent one-dimensional code incorporating energy, momentum and mass conservation equations, and taking the entire solar atmospheric structure into account, is used to investigate the hydrodynamic response of confined magnetic structures to strong heating perturbations. Model calculation results are compared with flare observations which include the light curves of spectral lines formed over a wide range of coronal flare temperatures, as well as determinations of Doppler shifts for the high temperature plasma. It is shown that the numerical simulation predictions are in good overall agreement with the observed flare coronal plasma evolution, correctly reproducing the temporal profile of X-ray spectral lines and their relative intensities. The predicted upflow velocities support the interpretation of the blueshifts as due to evaporation of chromospheric material.

Peres, G.↗

Application of identification techniques to remote manipulator system flight data

This paper addresses the application of identification techniques to flight data from the Space Shuttle Remote Manipulator System (RMS). A description of the remote manipulator, including structural and control system characteristics, sensors, and actuators is given. A brief overview of system identification procedures is presented, and the practical aspects of implementing system identification algorithms are discussed. In particular, the problems posed by desampling rate, numerical error, and system nonlinearities are considered. Simulation predictions of damping, frequency, and system order are compared with values identified from flight data to support an evaluation of RMS structural and control system models. Finally, conclusions are drawn regarding the application of identification techniques to flight data obtained from a flexible space structure.

Shepard, G. D.↗

Path discrepancies between great circle and rhumb line

A mathematical model for a comparative analysis of great circle vs. rhumb line navigation in the continental United States has been developed at the Avionics Engineering Center, Ohio University. A FORTRAN simulation of the model has been implemented on the IBM 370 computer. The simulation predicts pertinent navigation information for the two flight paths. The basis for the project, which is a part of an M.S. thesis, is to provide a data base for computing discrepancies between the two flight paths. This document briefly describes the model and discusses the implications of the results obtained.

Kaul, R.↗

Two recent extensions of the vortex method

The vortex method, coupled to an integral boundary-layer solver, is applied to the numerical simulation of high-Reynolds-number, separated flows in two new cases: a bluff body in a wind tunnel and flow in a cascade. In the bluff body case, the blockage effect of the tunnel walls is included approximately, assuming an inviscid boundary condition at the walls. The resulting increase in drag is computed, and compares well with a small-disturbance theory and with experiments. The results for flow in a cascade are compared with results from two finite-difference codes for a single-blade case, and good agreement is found. When a staggered cascade is treated with five independent blades, the simulation predicts rotating stall, depending on the angle of attack, and the essential features of the flow are correct. The sensitivity of this phenomenon to various parameters is studied and the stall boundary is found.

Spalart, P. R.↗

Comparison of simulation results with sea-level experimental data on 10(14) - 10(16) air shower cores

Simulation predictions for the Leeds 35 sq m horizontal discharge chamber array for proton primaries with a approx. E sup 2.7 spectrum extrapolated from balloon data to 10 to the 16th power eV give power law rho (r)-spectra with constant slope approx. -2 consistent with the experimental data up to the point at which they steepen but overshooting them at higher densities, and at high shower sizes predicted cores which are significantly steeper than those observed. Further comparisons with results for heavy nuclei primaries (up to A = 56) point to the inadequacy of changes in primary composition to account for the observed density spectra and core flattening, and the shower size spectrum together, and point, therefore, to the failure of the scaling interaction model at approx. 10 to the 15th power eV primary energy.

Ash, A. G.↗

Characterizing land processes in the biosphere

NASA long-term planning for the satellite remote sensing of land areas is discussed from the perspective of a holistic interdisciplinary approach to the study of the biosphere. The earth is characterized as a biogeochemical system; the impact of human activity on this system is considered; and the primary scientific goals for their study are defined. Remote-sensing programs are seen as essential in gaining an improved understanding of energy budgets, the hydrological cycle, other biogeological cycles, and the coupling between these cycles, with the construction of a global data base and eventually the development of predictive simulation models which can be used to assess the impact of planned human activities. Current sensor development at NASA includes a multilinear array for the visible and IR and the L-band Shuttle Imaging Radar B, both to be flown on Shuttle missions in the near future; for the 1990s, a large essentially permanent man-tended interdisciplinary multisensor platform connected to an advanced data network is being planned.

Erickson, J. D.↗

Simulation of rotating stall by the vortex method

The vortex method, coupled to a boundary-layer solver, is applied to the numerical simulation of high Reynolds number incompressible flow in two-dimensional cascades. Periodic conditions are imposed along the plane of the cascade, with several blades per period. Good agreement is found with two finite-difference methods for a single-blade case. When a staggered cascade is treated with five independent blades, the simulation predicts rotating stall, for a range of angles of attack and stagger, and the essential features of the flow are correct. The stall cell steadily propagates along the cascade. The sensitivity of this phenomenon to two parameters is studied, and the stall boundary is found. Quantitative results and visualizations are presented.

Spalart, P. R.↗

A computer simulation of the turbocharged turbo compounded diesel engine system: A description of the thermodynamic and heat transfer models

A computer simulation of the turbocharged turbocompounded direct-injection diesel engine system was developed in order to study the performance characteristics of the total system as major design parameters and materials are varied. Quasi-steady flow models of the compressor, turbines, manifolds, intercooler, and ducting are coupled with a multicylinder reciprocator diesel model, where each cylinder undergoes the same thermodynamic cycle. The master cylinder model describes the reciprocator intake, compression, combustion and exhaust processes in sufficient detail to define the mass and energy transfers in each subsystem of the total engine system. Appropriate thermal loading models relate the heat flow through critical system components to material properties and design details. From this information, the simulation predicts the performance gains, and assesses the system design trade-offs which would result from the introduction of selected heat transfer reduction materials in key system components, over a range of operating conditions.

Assanis, D. N.↗

Numerical simulation of spacecraft charging by impact-induced plasmas during a cometary flyby

A numerical model is developed for the interaction of a cometary probe, such as Giotto, with its environment, i.e., dust particles and gas. The spacecraft was set on a course to pass the comet at a velocity of 69 km/sec, so a chance existed that a potential field would form around the spacecraft and block lower energy particles from reaching the spacecraft instruments. The motion of electrons and ions is traced as a function of time to examine the evolution of the electric field, electric potential and the total space charge distributions on the surface of the spacecraft and its environment. Account is taken of the density of the particles and gas molecules at various distances from the comet, the collision energies involved, and the Giotto geometry. A solution is defined for the Poisson equation to describe the evolution of the plasma around Giotto, including the effects of ion collisions with the Al bumper protecting the spacecraft. The simulation predicts formation of an ion wake behind Giotto and the evolution of a positive potential on the order of 10 V around the spacecraft, i.e., sufficient for a positive potential barrier near the surface of the spacecraft.

Thiemann, H.↗

Effects of thrust reversing in ground proximity

The changes in stability and control characteristics encountered by a thrust reversing aircraft during its final approach, landing, and ground roll are described. These changes include a strong pitch-up accompanied by the loss of horizontal tail and aileron control effectiveness. The magnitude of reverser induced changes in ground effect are much larger than corresponding changes in free air. Some unexpected unsteady motions exhibited in wind tunnel by an aircraft model with reversers operating in ground proximity are also described. The cause of this oscillatory behavior was determined to be an unsteady interaction between the wall jets formed by impingement of reverser jets on the ground and the on-coming free stream. Time histories of rolling moments measured by the wind tunnel balance or support system were removed and frequencies were scaled by Strouhal number to full scale. Corrected time series were used to simulate the motion of a fighter aircraft with thrust reversers in ground effect. The simulation predicted large roll angles and nose down attitude at touchdown. Some phenomena of jet attachment to solid surfaces are discussed and areas for future research are recommended.

Joshi, P. B.↗

Multiparameter radar study of a microburst - Comparison with model results

Radar observations and model results are used to investigate the microphysical evolution of an isolated, intense storm observed on July 20, 1988 during the Microburst and Severe Thunderstorm experiment. The storm grew to a height of 14 km and upon collapsing, produced heavy rain, pea-sized hail, and a microburst at the surface. The radar observations indicate that the initial precipitation development was by collision-coalescence. As the storm intensified, accretional growth became dominant leading to rapid precipitation development. Radar-derived rainfall rates peaked around 150 to 190 mm/h. Each morning during the experiment, a two-dimensional, time-dependent cloud model, initialized with the morning sounding, was run. The model results from the July 20 sounding are compared to the radar observations. Good agreement is shown in some aspects of the storm development, although the numerical simulation predicted a more vigorous storm than actually developed.

Tuttle, John D.↗

Advanced modulation technology development for earth station demodulator applications. Coded modulation system development

A jointly optimized coded modulation system is described which was designed, built, and tested by COMSAT Laboratories for NASA LeRC which provides a bandwidth efficiency of 2 bits/s/Hz at an information rate of 160 Mbit/s. A high speed rate 8/9 encoder with a Viterbi decoder and an Octal PSK modem are used to achieve this. The BER performance is approximately 1 dB from the theoretically calculated value for this system at a BER of 5 E-7 under nominal conditions. The system operates in burst mode for downlink applications and tests have demonstrated very little degradation in performance with frequency and level offset. Unique word miss rate measurements were conducted which demonstrate reliable acquisition at low values of Eb/No. Codec self tests have verified the performance of this subsystem in a stand alone mode. The codec is capable of operation at a 200 Mbit/s information rate as demonstrated using a codec test set which introduces noise digitally. The measured performance is within 0.2 dB of the computer simulated predictions. A gate array implementation of the most time critical element of the high speed Viterbi decoder was completed. This gate array add-compare-select chip significantly reduces the power consumption and improves the manufacturability of the decoder. This chip has general application in the implementation of high speed Viterbi decoders.

Miller, Susan P.↗

Application of renormalization group theory to the large-eddy simulation of transitional boundary layers

An eddy viscosity model based on the renormalization group theory of Yakhot and Orszag (1986) is applied to the large-eddy simulation of transition in a flat-plate boundary layer. The simulation predicts with satisfactory accuracy the mean velocity and Reynolds stress profiles, as well as the development of the important scales of motion. The evolution of the structures characteristic of the nonlinear stages of transition is also predicted reasonably well.

Piomelli, Ugo↗

Technical evaluation report, AGARD Fluid Dynamics Panel Symposium on Effects of Adverse Weather on Aerodynamics

The purpose of the meeting on Effects of Adverse Weather on Aerodynamics was to provide an update of the stae-of-the-art with respect to the prediction, simulation, and measurement of the effects of icing, anti-icing fluids, and various precipitation on the aerodynamic characteristics of flight vehicles. Sessions were devoted to introductory and survey papers and icing certification issues, to analytical and experimental simulation of ice frost contamination and its effects of aerodynamics, and to the effects of heavy rain and deicing/anti-icing fluids.

Reinmann, J. J.↗

Effects of Adverse Weather on Aerodynamics

This meeting was organized to provide a timely review of the progress being made in advancing the state of the art in predicting, simulating, and measuring the effects of icing, anti-icing fluids, and various forms of precipitation on the aerodynamic characteristics of flight vehicles. Topics included results from both theoretical and experimental programs and material related to procedures and regulations for certification and operation. International participation for the meeting included authors from eight nations and representatives from most of the 16 NATO nations.

Source record↗

NASCAP/LEO simulations of Shuttle Orbiter charging during the SAMPIE experiment

The electrostatic charging of the Space Shuttle Orbiter during the operation of the Solar Array Module Plasma Interaction Experiment (SAMPIE) was modeled using the NASA Charging Analyzer Program/ low Earth orbit (NASCAP/LEO) computer code. The SAMPIE experiment consists of an array of various solar cells representing the present technologies. The objectives of the experiment are to investigate the arcing and current collection characteristics of these cells when biased to high potentials in a LEO plasma. NASCAP/LEO is a 3-D code designed to simulate the electrostatic charging of a spacecraft exposed to a plasma at LEO or ground test conditions. At its most extreme configuration, with the largest array segment of the SAMPIE experiment biased + 600 V with respect to the orbiter and facing the ram direction, the computer simulations predict that the orbiter's potential will be approximately -20 V with respect to the plasma.

Chock, Ricaurte↗

Altimetry and lidar using AlGaAs lasers modulated with pseudo-random codes

We have demonstrated a prototype laser altimeter and lidar which uses a low power AlGaAs laser modulated with a pseudorandom noise (PN) code, a 20 cm diameter telescope, and a photon counting receiver. Measurements to tree canopies over a 400 m horizontal path show strong signals with 5.3 mW average power and a 6.4 msec averaging time. Computer simulations predict lidar performance for various types of scattering performance.

Abshire, James B.↗

Conical detonation waves - A comparison of theoretical and numerical results

A predictive capability for conical oblique detonation waves (ODWs) is discussed with particular attention given to the special case of an axisymmetric conical projectile, which yields necessary conditions for attached waves. A multidimensional numerical model was used to study the influence of a finite Damkoehler number (Da) and viscosity on the formation of a conical ODW. The ODW is predicted for Da on the order of 10, and is found to be important in the ODW formation. For a Da of 1, shock induced combustion is predicted. Simulations of the experimental geometry showed general agreement with experimental flow features, but underpredicted the shock angle. It is suggested that this difference may be caused by inadequate boundary layer resolution, lack of grid orthogonality at the cone surface, and an inappropriate chemical mechanism.

Fort, James A.↗