Time resolved measurement of the 1.4 micron absorption band in water during the shock-induced liquid to ice-VII phase transition
Explore the source record for details and available documents.
SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Explore the source record for details and available documents.
CO2 lidars have heretofore been used to measure water vapor concentrations primarily using the 10R(20) line at 10.247 microns, which has a strong overlap with a water vapor absorption line. This paper discusses the use of that line as well as other CO2 laser lines for which the absorption coefficients are weaker. The literature on measurement of water vapor absorption coefficients using CO2 lasers is reviewed, and the results from four laboratories are shown to be generally consistent with each other after they are normalized to the same partial pressure, temperature, and ethylene absorption coefficent for the 10P(14) CO2 laser line; however, the agreement with the Air Force Geophysics Laboratory's HITRAN and FASCOD 2 spectral data tapes is not good either for the water vapor absorption lines or for the water vapor continuum. Demonstration measurements of atmospheric water vapor have been conducted using the Mobile Atmospheric Pollutant Mapping System, a dual CO2 lidar system using heterodyne detection. Results are discussed for measurements using three sets of laser line pairs covering a wide range of water vapor partial pressures.
Absorbing aerosols (AA) have an important impact on the global radiation budget. The composition and properties of AA can vary substantially throughout the atmosphere, depending on the particle source and the influence of chemical aging. Uncertainties associated with the radiative effects of AA remain substantial. A key contributor to this uncertainty is understanding the extent to which water uptake alters absorption by AA particles and how this depends on particle composition. We have used new and existing experimental tools to systematically characterize the relationship(s) between AA chemical and physical characteristics, relative humidity, and mixing of AA with other aerosol components through a combination of laboratory and field measurements. We have developed fundamental understanding through laboratory experiments that will enable interpretation of field observations at DOE ARM sites and facilitate process-based improvements in the simulation of absorption by carbonaceous aerosols in climate models. In the laboratory experiments we have considered a variety of different AA types, including fullerene soot (a surrogate for refractory black carbon, or BC) and nigrosine (a surrogate for partially soluble brown carbon, or BrC). By examining a range of AA types we will develop insight into how the chemical and physical properties of AA particles (e.g. whether they are refractory or soluble) impact the influence of water uptake on absorption. These AA particles will also be mixed—both internally and externally—with compounds having a wide range of hygroscopic properties to establish how the impact of water uptake on absorption will vary with photochemical processing. These laboratory observations have been compared with commonly used theoretical models, enabling development of empirical models that will facilitate improved representation of absorption by AA particles in regional and global climate models. Overall, our study has contributed to the mission of the Atmospheric System Research program by quantifying how interactions between aerosols and radiation depend on relative humidity. Through this, our work will improve understanding and model representation of aerosol processes as they affect the Earth’s radiation budget.
Water vapor has been detected in the Martian atmosphere by multiple orbiting instruments. The Atmospheric Chemistry Suite (ACS) on the ExoMars Trace Gas Orbiter (TGO) observed H2O mixing ratios reaching up to 50 ppmv at altitudes of 100-120 km during global dust storms, while levels remained low (<2 ppmv) during other seasons. The Neutral Gas and Ion Mass Spectrometer (NGIMS) on the Mars Atmosphere and Volatile EvolutioN (MAVEN) spacecraft revealed that water transported to the upper atmosphere is dissociated by ions, producing atomic hydrogen that escapes into space, contributing to Mars’ water loss. This transport is seasonal, peaking in southern summer and intensifying during dust storms. Additionally, the Mars Reconnaissance Orbiter’s (MRO) imaging spectrometer detected hydrated minerals on slopes, suggesting that liquid water may intermittently flow on present-day Mars. However, an observational gap exists between high-altitude water vapor and surface water due to limitations in spatial resolution and a lack of measurements in the lower atmosphere. To address this gap, we propose using an airborne differential absorption lidar (DIAL) to search for water sources. DIAL provides high-resolution measurements both day and night, bridging the observational gap between high-altitude water vapor and surface water, thus enhancing our understanding of water transport and loss on Mars. Absorption lines of water vapor in the 2.7 μm and 1.8 μm bands have been selected in this study. Simulations show that both lines are capable of detecting water vapor sources with reasonable system parameters.
Range-resolved water vapor measurements using the differential-absorption lidar (DIAL) technique is described in detail. The system uses two independently tunable optically pumped lasers operating in the near infrared with laser pulses of less than 100 microseconds separation, to minimize concentration errors caused by atmospheric scattering. Water vapor concentration profiles are calculated for each measurement by a minicomputer, in real time. The work is needed in the study of atmospheric motion and thermodynamics as well as in forestry and agriculture problems.
Investigating water vapor absorption in submillimeter wave region using Michelson interferometer
In the spring of 1992 an optical closure experiment was conducted at Lake Pend Orielle, Idaho. A primary objective of the experiment was to compare techniques for the measurement of the spectral absorption coefficent and other inherent optical properties of natural waters. Daily averages of absorption coefficents measured using six methods are compared at wavelengths of 456, 488, and 532 nm. Overall agreement was within 40% at 456 nm and improved with increasing wavelength to 25% at 532 nm. These absorption measurements were distributed over the final 9 days of the experiement, when bio-optical conditions in Lake Pend Oreille (as indexed by the beam attenuation coefficent c(sub p)(660) and chlorophyll a fluorescence profiles) were representative of those observed throughout the experiment. However, profiles of stimulated chlorophyll a fluorescence and beam transmission showed that bio-optical properties in the lake varied strongly on all time and space scales. Therefore environmental variabilty contributed significantly to deviations between daily mean absorption coefficients measured using the different techniques.
Water vapor absorption spectra in submillimeter wave region, analog-to-digital conversion and recording system, and carbon dioxide laser construction
The solar energy system installed in the building has 2,978 sq ft of single axis tracking, concentrating collectors and provides solar energy for space heating, space cooling and domestic hot water. A 1,200,000 Btu/hour water tube gas boiler provides hot water for space heating. Space cooling is provided by a 100 ton hot water fired absorption chiller. Domestic hot water heating is provided by a 50 gallon natural gas domestic storage water heater. Extracts from the site files, specification references, drawings, installation, operation and maintenance instructions are included.
An evaluation of reflectance spectra of the icy Galilean satellites, taking account of the depth of the 3-micron fundamental water ice absorption feature and the shorter wavelength bands, suggests lower ice abundances for Ganymede and Callistro than previously supposed, provided that the ice is segregated from the nonicy material. Data are consistent with a 50 percent areal coverage of ice on Ganymede and 10 percent on Callistro, the rest of the surface being covered by carbonaceous chondrite-like material with strong 3-micron absorption due to bound water. The analysis indicates a homogeneous icy surface for Europa, and the possible presence on all three objects of small quantities of surface sulfuric acid.
Research is reported on the development of sensors for gas turbine combustor applications that measure real-time gas temperature using near-infrared water vapor absorption and concentration in the combustor exhaust of trace quantities of pollutant NO and CO using mid-infrared absorption. Gas temperature is extracted from the relative absorption strength of two near-infrared transitions of water vapor. From a survey of the water vapor absorption spectrum, two overtone transitions near 1800 nm were selected that can be rapidly scanned in wavelength by injection current tuning a single DFB diode laser. From the ratio of the absorbances on these selected transitions, a path-integrated gas temperature can be extracted in near-real time. Demonstration measurements with this new temperature sensor showed that combustor instabilities could be identified in the power spectrum of the temperature versus time record. These results suggest that this strategy is extremely promising for gas turbine combustor control applications. Measurements of the concentration of NO and CO in the combustor exhaust are demonstrated with mid-infrared transitions using thermo-electrically cooled, quantum cascade lasers operating near 5.26 and 4.62 microns respectively. Measurements of NO are performed in an insulated exhaust duct of a C2H4-air flame at temperatures of approximately 600 K. CO measurements are performed above a rich H2-air flame seeded with CO2 and cooled with excess N2 to 1150 K. Using a balanced ratiometric detection technique a sensitivity of 0.36 ppm-m was achieved for NO and 0.21 ppm-m for CO. Comparisons between measured and predicted water-vapor and CO2 interference are discussed. The mid-infrared laser quantum cascade laser technology is in its infancy; however, these measurements demonstrate the potential for pollutant monitoring in exhaust gases with mid-IR laser absorption.
New near-infrared (0.65-2.5 microns) reflectance spectra of the Galilean satellites are presented. These spectra more precisely define the water ice absorption features previously identified on Europa, Ganymede, and Callisto at 1.55 and 2.0 microns. In addition, previously unreported spectral features due to water ice are seen at 1.25, 1.06, 0.90, and 0.81 microns on Europa, and at 1.25, 1.04, and possibly 0.71 microns on Ganymede. Unreported absorption features in Callisto's spectrum occur at 1.2 microns, probably due to H2O, and a weak, broad band extending from 0.75 to 0.95 microns due possibly to other minerals. The spectrum of Io has only weak absorption features at 1.15 microns and between 0.8 and 1.0 microns. No water absorptions are positively identified in the Io spectra, indicating an upper limit of areal water frost coverage of 2% (leading and trailing sides). It is found for Callisto, Ganymede, and Europa that the water ice absorption features are due to free water and not to water bound or absorbed onto minerals. The areal coverage of water frost is approximately 100% on Europa (trailing side), approximately 65% on Ganymede (leading side), and 20-30% on Callisto (leading side). An upper limit of approximately 5% bound water (in addition to the 20-30% ice) may be present on Callisto, based on the strong 3-micron band seen by other investigators. A summary of spectra of the satellites from 0.325 to about 5 microns to aid in laboratory and interpretation studies is also presented.
A scheme is presented, for the heating of clear and cloudy air by solar and infrared radiation transfer, designed for use in tropospheric general circulation models with coarse vertical resolution. A bulk transmission function is defined for the infrared transfer. The interpolation factors, required for computing the bulk transmission function, are parameterized as functions of such physical parameters as the thickness of the layer, the pressure, and the mixing ratio at a reference level. The computation procedure for solar radiation is significantly simplified by the introduction of two basic concepts. The first is that the solar radiation spectrum can be divided into a scattered part, for which Rayleigh scattering is significant but absorption by water vapor is negligible, and an absorbed part for which absorption by water vapor is significant but Rayleigh scattering is negligible. The second concept is that of an equivalent cloud water vapor amount which absorbs the same amount of radiation as the cloud.
The Conical Scanning Submillimeter-wave Imaging Radiometer (CoSSIR) has been developed to study the application of submillimeter-wave radiometry for remote sensing of cirrus clouds and humidity sounding. Measurements of the global distribution of ice cloud mass and particle size are important for understanding the Earth s energy budget and for evaluating global climate models. The spatial variability and the wide variety of cloud particle shapes and sizes make ice clouds particularly difficult to measure. Ice clouds are essentially undetectable at microwave frequencies due to the low dielectric of ice and small size of the particles relative to wavelength. However, submillimeter wavelengths demonstrate significant response to the presence of ice clouds thus this frequency regime is applicable to measuring ice clouds. Another potentially viable application for submillimeter-wave radiometry is humidity and temperature sounding. The principle of sounding at submillimeter wavelengths is similar to that at microwavelengths. Submillimeter-wave radiometry has the advantage of achieving finer spatial resolution using a smaller antenna aperture which is an important consideration for spaceborne observatories. Submillimeter-wave radiometry also offers the potential of sounding over land and as a surrogate measurement for precipitation. CoSSIR is a new instrument to explore these applications. The CoSSIR is designed to fly aboard the ER-2 aircraft and its modest size (approximately 100 kg) permits it to be configured for other aircraft. A dual-axes gimbals mechanism provides conical, across-track, and along-track scanning capability. In its present configuration CoSSIR has fifteen channels between 183 GHz and 640 GHz. Three channels are centered about the 183 GHz water vapor absorption line, four channels are centered about the 380 GHz water vapor absorption line, and three dual-polarized channels are centered about the 487 GHz oxygen absorption line. Two channels are located in atmospheric windows at 220 GHz and 640 GHz. All channels are single-linear polarized with the exception of those near 487 GHz. Calibration is achieved by periodically observing two blackbody radiators; one blackbody is heated to approximately 325 K and the other is approximately 250 K during flight. Details of the instrument design as well as measurements from the Cirrus Regional Study of Tropical Anvils and Cirrus Layers - Florida Area Cirrus Experiment will be presented.
The method is based upon molecular line parameters and makes use of a far wing scaling approximation and k distribution approach previously applied to the computation of the infrared cooling rate due to water vapor. Taking into account the wave number dependence of the incident solar flux, the solar heating rate is computed for the entire water vapor spectrum and for individual absorption bands. The accuracy of the method is tested against line by line calculations. The method introduces a maximum error of 0.06 C/day. The method has the additional advantage over previous methods in that it can be applied to any portion of the spectral region containing the water vapor bands. The integrated absorptances and line intensities computed from the molecular line parameters were compared with laboratory measurements. The comparison reveals that, among the three different sources, absorptance is the largest for the laboratory measurements.
Differential absorption lidar and Raman lidar have been applied to the range-resolved measurements of water vapor density for more than 20 years. Results have been obtained using both lidar techniques that have led to improved understanding of water vapor distributions in the atmosphere. This paper reviews the theory of the measurements, including the sources of systematic and random error; the progress in lidar technology and techniques during that period, including a brief look at some of the lidar systems in development or proposed; and the steps being taken to improve such lidar systems.
Ground based radiometer measurements at 20.6, 31.65, and 90.0 GHz were analyzed to provide attenuation statistics, thus extending the data base of previous NAPEX studies. Using data from colocated radiosondes, comparisons of measurements and calculations of brightness temperatures are presented. The oxygen absorption model of Rosenkranz and the water vapor absorption models of Liebe and of Waters are used. Data from July 1987 at San Nicolas Island, California and from December 1987, August and November 1988 at Denver, Colorado, are included. Joint attenuation statistics at 20.6 and 31.65 GHz are presented for two locations of the Colorado Research Network for December 1987 and August 1988.
Absorption of solar radiation by atmospheric water vapor, carbon dioxide and molecular oxygen