Search NASA⌕ Search

SEARCH · Search NASA

Results for “DELTA WINGS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 289 records · Page 16
All sourcesNASA NTRSDOE OSTI
NASA NTRS2009

Experimental Investigation of the Flow about a 65 deg Delta Wing in the NASA Langley National Transonic Facility

An experimental investigation for the flow about a 65 deg. delta wing has been conducted in the NASA Langley National Transonic Facility (NTF). The tests were conducted at Reynolds numbers, based on the mean aerodynamic chord, ranging from 6 million to 120 million and at Mach numbers ranging from 0.4 to 0.9. The model incorporated four different leading-edge bluntness values. The data include detailed static surfacepressure distributions as well as normal-force and pitching-moment coefficients. The test program was designed to quantify the effects of Mach number, Reynolds number, and leading-edge bluntness on the onset and progression of leading-edge vortex separation.

Luckring, James M.↗
NASA NTRS1986

Calculation of asymmetric vortex separation on slender delta wings with a vortex-sheet model

An inviscid vortex-sheet model based on the slender wing theory is developed to examine asymmetric vortex separation at zero sideslip on delta wings. It is found that multiple asymmetric vortex configurations exist at a given angle of attack. Available data on rolling moment measurements and flow visualization are used for correlation to prove the concept.

Lan, C. E.↗
NASA NTRS1990

Effect of leading edge roundness on a delta wing in wing-rock motion

The effect of wing leading-edge roundness on wing rock was investigated using flow visualization in a water tunnel. Eighty degree delta wing models were tested on free-to-roll and forced oscillation rigs. The onset of wing rock was delayed by increasing the roundness of the leading edges. The wing rock amplitude and frequency results suggested that damping was increased at lower angles of attack but reduced at higher angles of attack. Vortex lift-off and vortex breakdown, especially during dynamic situations, were strongly affected by the leading edge roundness. Different forms of wing rock motion could be sustained by combinations of vortex breakdown and vortex lift-off. Behaviors of the wing and vortex motions were explained by the influence of leading edge roundness on the separation location, vortex trajectory, and vortex breakdown.

Ng, T. Terry↗
NASA NTRS1976

Static force tests of a sharp leading edge delta-wing model at ambient and cryogenic temperatures with a description of the apparatus employed

A sharp leading edge delta-wing model was tested through an angle-of-attack range at Mach numbers of 0.75, 0.80, and 0.85 at both ambient and cryogenic temperatures in the Langley 1/3-meter transonic cryogenic tunnel. Total pressure was varied with total temperature in order to hold test Reynolds number constant at a given Mach number. Agreement between the aerodynamic data obtained at ambient and cryogenic temperatures indicates that flows with leading-edge vortex effects are duplicated properly at cryogenic temperatures. The test results demonstrate that accurate aerodynamic data can be obtained by using conventional force-testing techniques if suitable measures are taken to minimize temperature gradients across the balance and to keep the balance at ambient (warm) temperatures during cryogenic operation of the tunnel.

Kilgore, R. A.↗
NASA NTRS1975

Hypersonic incipient separation on delta wing with trailing-edge flap

The paper reviews the experimental data on the incipient separation characteristics of planar delta wings of 75 degree sharp leading edges, with full-span trailing edge flap deflected into the windward flow. The local Reynolds number range for these investigations covered laminar, transitional and turbulent conditions. It is shown that, while turbulent boundary layer data correlates with two dimensional results, in the laminar and transitional cases, there is a nearly parallel shift to higher flap angles for incipient separation.

Rao, D. M.↗
NASA NTRS1980

Lee side flow for slender delta wings of finite thickness

An experimental and theoretical investigation carried out to determine the lee side flow field over delta wings at supersonic speeds is presented. A theoretical method to described the flow field is described, where boundary conditions as a result of the experimental study are needed. The computed flow field with shock induced separation is satisfactory.

Szodruch, J. G.↗
NASA NTRS1986

Summary of a high subsonic force/pressure experiment for 58 deg cambered/twisted thick delta wings

This paper summarizes the results of a force, moment, and pressure experiment involving six thick, cambered and twisted, delta wings with 58 deg leading-edge sweep. This experiment was conducted in the NASA Langley 7- by 10-foot High-Speed Tunnel at Mach numbers of 0.75, 0.80, and 0.83. The design goal was a configuration which was self-trimming at a lift coefficient of 0.25 and Mach number of 0.80. Although the design goal was not met, the configuration which came closest and which had the best overall performance was selected for further study. Wing surface pressure data and limited surface oil flow data for this configuration are presented to show the extent of attached flow at the design point. For selected cases, inviscid solutions from vortex lattice method/suction analogy, PAN AIR, FLO-28, and FLO-57 are compared with the experimental force, moment, and pressure data.

Chu, J.↗
NASA NTRS1987

Investigation of the vortex flap concept on a 75-deg sweep delta wing at supersonic speeds

An experimental investigation of the aerodynamic performance of vortex flaps on a 75-deg sweep delta wing has been conducted in the NASA Langley Unitary Plan Wind Tunnel at Mach numbers from 1.7 to 2.8. The sharp leading edge vortex flaps consisted of the outboard 30 percent of the local wing semispan. Flap deflections of 0, 5, 10, and 15 deg were investigated, for both a wing-alone and a wing-body configuration. The flaps were effective in reducing the drag across the lift-coefficient range. Integration of the upper surface pressure distributions showed that the suction pressures induced by the vortex on the flap were responsible for the drag reductions. At some lift conditions, the minimum drag condition permitted hinge line separation or vortex migration inboard of the hinge line. This result is in contrast to subsonic results, where optimum conditions call for no hinge line separation. The magnitude of the drag reduction due to flap deflection generally decreased as Mach number increased. The effect of a cylindrical forebody on the drag reduction due to flap deflection was minimal.

Covell, Peter F.↗
NASA NTRS1990

Investigation of vortex breakdown on a delta wing using Euler and Navier-Stokes equations

A numerical investigation of leading-edge vortex breakdown on a delta wing at high angles of attack is presented. The analysis has been restricted to low speed flows on a flat plate wing with sharp leading edges. Both Euler and Navier-Stokes (assuming fully laminar and fully turbulent flows) equations have been used in this study and the results are compared against experimental data. Predictions of vortex breakdown progression with angle of attack with both Euler and Navier-Stokes equations are shown to be consistent with the experimental data. However, the Navier-Stokes predictions show significant improvements in breakdown location at angles of attack where the vortex breakdown approaches the wing apex. The location of the primary vortex and the level of vorticity in the pre-breakdown regions in these flowfield solutions are affected very little by the viscous effects, even though the Navier-Stokes solutions exhibit viscous phenomena such as secondary and tertiary vortices which are not present in the Euler solutions. In the post-breakdown regions, however, the levels of vorticity in the primary vortex have increased differences between the Euler and Navier-Stokes solutions at comparable locations. Navier-Stokes indicates the presence of a secondary vortex even after the primary vortex is burst. The predicted trajectories of the primary vortex are in very good agreement with the test data, the laminar solutions providing the overall best comparison. The Euler shows a small displacement of the primary vortex, relative to experiment, due to the lack of secondary vortices. The turbulent Navier-Stokes, in general, fall between the Euler and laminar solutions. These findings are based on solutions from meshes that are not usually considered fine enough for resolving vortical flows. To further understand the vortex breakdown phenomenon and the fine details of the vortical flow structure, further calculations with the finer meshes and improved turbulence models are necessary.

S. Agrawal↗
NASA NTRS2004

Reynolds Number, Compressibility, and Leading-Edge Bluntness Effects on Delta-Wing Aerodynamics

An overview of Reynolds number, compressibility, and leading edge bluntness effects is presented for a 65 degree delta wing. The results of this study address both attached and vortex-flow aerodynamics and are based upon a unique data set obtained in the NASA-Langley National Transonic Facility (NTF) for i) Reynolds numbers ranging from conventional wind-tunnel to flight values, ii) Mach numbers ranging from subsonic to transonic speeds, and iii) leading-edge bluntness values that span practical slender wing applications. The data were obtained so as to isolate the subject effects and they present many challenges for Computational Fluid Dynamics (CFD) studies.

Luckring, James M.↗
NASA NTRS1973

Unsteady aerodynamic analysis of space shuttle vehicles. Part 2: Steady and unsteady aerodynamics of sharp-edged delta wings

An analysis of the steady and unsteady aerodynamics of sharp-edged slender wings has been performed. The results show that slender wing theory can be modified to give the potential flow static and dynamic characteristics in incompressible flow. A semiempirical approximation is developed for the vortex-induced loads, and it is shown that the analytic approximation for sharp-edged slender wings gives good prediction of experimentally determined steady and unsteady aerodynamics at M = 0 and M = 1. The predictions are good not only for delta wings but also for so-called arrow and diamond wings. The results indicate that the effects of delta planform lifting surfaces can be included in a simple manner when determining elastic launch vehicle dynamic characteristics. For Part 1 see (N73-32763).

Ericsson, L. E.↗
NASA NTRS1972

Lee-side flow phenomena on space shuttle configurations at hypersonic speeds. Part 1: Flow separation and flow field viscous phenomena of a delta-wing shuttle orbiter configuration

Results of a pitot pressure investigation of the flow field on the lee side of a delta wing shuttle orbiter are presented. The results delineate the extent of the lee side separated flow and give a tentative cross sectional definition to the shock wave structure for angles of attack of 15 deg and 30 deg. It is shown that while, in general, the effects of Reynolds number on the flow field are not large, detailed effects are observed that may have significant bearing on the heating estimate. Two examples are cited for an angle of attack of 15 deg; these are: (1) The scope of the vertical tail exposed to the unseparated flow increases with increasing Reynolds number and (2) the depth of the separated flow adjacent ot where the bow wave crosses the wing appears to decrease with increasing Reynolds number. In addition, it is shown that at a spanwise station outboard of the wing-fuselage juncture, increasing Reynolds number decreased the pitot pressure in the unseparated flow. This defect of pitot pressure appears associated with the flow over the wing-fillet-fuselage juncture.

Cleary, J. W.↗
NASA NTRS1972

Space shuttle: Aerodynamic characteristics of a double delta wing space shuttle orbiter (M equals 0.6 - 5.0)

This test program was the first wind tunnel investigation of a double delta wing space shuttle orbiter. The 0.004 scale model used for this test was the first model constructed of this configuration and as such lacked certain refinements incorporated in later models, the principal differences being that the wing is located 0.1 inches model scale further forward than later models and that the nose contours are slightly different.

Ellis, R. R.↗
NASA NTRS1981

Subsonic balance and pressure investigation of a 60-deg delta wing with leading-edge devices (data report)

The drag reduction potential of leading edge devices on a 60 degree delta wing at high lift was examined. Geometric variations of fences, chordwise slots, pylon type vortex generators, leading edge vortex flaps, and sharp leading edge extensions were tested individually and in specific combinations to improve high-alpha drag performance with a minimum of low-alpha drag penalty. The force, moment, and surface static pressure data for angles of attack up to 23 degrees, at Mach and Reynolds numbers of 0.16 and 3.85 x 10 to the 6th power per meter are documented.

Rao, D. M.↗
NASA NTRS1986

Analytical observations on the aerodynamics of a delta wing with leading edge flaps

The effect of a leading edge flap on the aerodynamics of a low aspect ratio delta wing is studied analytically. The separated flow field about the wing is represented by a simple vortex model composed of a conical straight vortex sheet and a concentrated vortex. The analysis is carried out in the cross flow plane by mapping the wing trace, by means of the Schwarz-Christoffel transformation into the real axis of the transformed plane. Particular attention is given to the influence of the angle of attack and flap deflection angle on lift and drag forces. Both lift and drag decrease with flap deflection, while the lift-to-drag ratioe increases. A simple coordinate transformation is used to obtain a closed form expression for the lift-to-drag ratio as a function of flap deflection. The main effect of leading edge flap deflection is a partial suppression of the separated flow on the leeside of the wing. Qualitative comparison with experiments is presented, showing agreement in the general trends.

Oh, S.↗