Search NASA⌕ Search

SEARCH · Search NASA

Results for “Jittered”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 289 records · Page 16
All sourcesNASA NTRSDOE OSTI
NASA NTRS1985

Behavior of the lean methane-air flame at zero-gravity

A special rig was designed and constructed to be compatible with the NASA Lewis Research Center Airborne Research Laboratory to allow the study of the effect of gravity on the behavior of lean limit in a standard 50.4 mm (2 in.) internal diameter tube when the mixtures are ignited at the open end and propagate towards the closed end of the tube. The lean limit at zero gravity was found to be 5.10% methane and the flame was found to extenguish in a manner previously observed for downward propagating flames at one g. It was observed that g-jitter could be maintained at less than + or 0.04 g on most zero g trajectories. All of propagating lean limit flames were found to be sporadically cellularly unstable at zero g. There was no observable correlation between the occurrence of g-jitter and the lean limit, average propagation speed of the flame through the tube or the occurrence of cellular instability.

Noe, K. A.↗
NASA NTRS1985

TM Geometric Performance: Line to Line Displacement Analysis (LLDA)

An early acquired TM data frame (track 23, frame 35 of 22 August 1982) was used to assess the geometric performance of the LANDSAT-4 thematic mapper instrument. The developed method consists in determining the displacements of adjacent lines by locating the maximum of the correlation profile between the two lines. Then the line to line displacement is used to characterize the TM instrument in respect to: scan to scan jitter and image skew, scan profile non-linearity, along scan jitter, detector to detector displacement, and band to band displacement. To verify the quality of the reported performance parameters, some extracted geometric parameters were used to correct the original raw data. Comparison between P-tape data and results of reprocessed data shows no significant differences in an area of 1024 x 1024 pixels.

Fusco, L.↗
NASA NTRS1985

Performance analysis of the DSN baseband assembly (Bba) Real-Time Combiner (RTC)

The operation of the BBA Real Time Combiner (RTC) is discussed and its performance investigated in detail. It is shown that each channel of the RTC can be modelled by a simple block diagram in the z-transform domain from which all pertinent transient and steady state behavioral characteristics can be determined. In particular, the characteristic equation of the tracking loop and its equivalent noise bandwidth are found and used to evaluate the closed loop transient response and steady-state mean squared timing jitter. The impact of the totality of these loop jitter contributions on the combiner output SNR is evaluated and illustrated numerically. These results show that for parameters of interest to various space missions, the RTC is capable of providing significant SNR improvement relative to a single receiving antenna.

Simon, M. K.↗
NASA NTRS1984

Performance analysis of the DSN baseband assembly (Bba) Real-Time Combiner (RTC)

The operation of the BBA Real Time Combiner (RTC) is discussed and its performance investigated in detail. It is shown that each channel of the RTC can be modelled by a simple block diagram in the z-transform domain from which all pertinent transient and steady state behavioral characteristics can be determined. In particular, the characteristic equation of the tracking loop and its equivalent noise bandwidth are found and used to evaluate the closed loop transient response and steady state mean squared timing jitter. The impact of the totality of these loop jitter contributions on the combiner output SNR is evaluated and illustrated numerically. These results show that for parameters of interest to various space missions, the RTC is capable of providing significant SNR improvement relative to a single receiving antenna.

Simon, M. K.↗
NASA NTRS1985

Fast scintillation counter preamplifier for the observation of Linsley effect

A fast preamplifier circuit has been designed and thoroughly tested for the purpose of observing the air shower arrival directions including the Linsley effect. The circuit intends to eliminate the time jitter due to variation of scintillation counter signal amplitudes. It assumes that the output signals from one counter system have the same rise time. On this basis, error arising from time jitter is removed by voltage discrimination at about half signal amplitudes. Detailed description of the circuit is reported.

Ng, L. K.↗
NASA NTRS1986

Real-time combiner loss

Telemetry signals from several channels are aligned in time and combined by the Real-Time Combiner (RTC) in order to increase the strength of the total signal. In this article, the impact of the timing jitter in the RTC on the bit/symbol error rate is investigated. Equations are derived for the timing jitter loss associated with the coded and uncoded channels. Included are curves that depict the bit-symbol error rate vs. E sub b/N sub 0 and E sub s/N sub 0 for some typical telemetry conditions. The losses are typically below 0.1 dB.

Simon, M. K.↗
NASA NTRS1987

Passive isolation/damping system for the Hubble space telescope reaction wheels

NASA's Hubble Space Telescope contain large, diffraction limited optics with extraordinary resolution and performance for surpassing existing observatories. The need to reduce structural borne vibration and resultant optical jitter from critical Pointing Control System components, Reaction Wheels, prompted the feasibility investigation and eventual development of a passive isolation system. Alternative design concepts considered were required to meet a host of stringent specifications and pass rigid tests to be successfully verified and integrated into the already built flight vehicle. The final design employs multiple arrays of fluid damped springs that attenuate over a wide spectrum, while confining newly introduced resonances to benign regions of vehicle dynamic response. Overall jitter improvement of roughly a factor of 2 to 3 is attained with this system. The basis, evolution, and performance of the isolation system, specifically discussing design concepts considered, optimization studies, development lessons learned, innovative features, and analytical and ground test verified results are presented.

Hasha, Martin D.↗
NASA NTRS1986

Line-of-sight performance improvement with reaction-wheel isolation

Design techniques used to isolate and damp vibrations from the reaction control wheels assembly (RCA) from the structural dynamics of the Hubble Space Telescope are described. The four RCAs can generate sufficient torque for large maneuvers and precision control during fine pointing. The RCAs are to operate continuously during observations and thereby pose the potential of inducing jitter. The image stability must be constrained to less than 0.007 arcsec rms per 24 hr and pointing accuracy must be 0.01 arcsec for 100 hr. Vibration-producing characteristics of the RCAs are identified, and test results are provided from measurements of the magnitudes of the associated disturbances. Design features and test results for the vibration isolators employed with the RCAs to effect viscous damping of RCA axial perturbations are presented. The dampers are expected to reduce jitter effects of RCA operation by a half.

Rodden, J. J.↗
NASA NTRS1987

Acquisition, tracking, and pointing; Proceedings of the Meeting, Orlando, FL, Apr. 3, 4, 1986

The present conference discusses the effect of target signatures on active tracking, the high resolution obtainable with a two-degrees-of-freedom angle sensor having a high update rate, solar object tracking for the Hubble Space Telescope, scaled experiments for the assessment of precise active tracking, and large aperture high-accuracy satellite laser tracking. Also discussed are laboratory test results for the Spaceborne Geodynamic Ranging System's high speed optical tracking system, jitter stabilization for precise optical pointing, scan stabilization and jitter control for an airborne telescope, a simulation of the Solar Optical Telescope's pointing performance, a microprocessor-based dual-speed angle converter, and image localization for alignment by means of adaptive preprocessing.

Auelmann, Richard R.↗
NASA NTRS1986

Space Telescope Antenna Pointing System analysis and test

The Space Telescope (ST), carrying five astronomy instruments, is a long-life spacecraft designed to achieve and maintain ultrafine stabilization jitter performance. The rms jitter specification for pointing performance is 7 marcsec (1sigma) during periods of scientific observation. Spacecraft attitude control is achieved by onboard computer processing of attitude and rate sensor data to generate reaction-wheel torque commands. The ST Antenna Pointing System is used to position a high-gain antenna for relaying science and engineering data from the spacecraft to the ground station.

Dodder, R.↗
NASA NTRS1989

Doppler-corrected differential detection of MPSK

An open-loop technique is presented for estimating and correcting Doppler frequency shift in an M-ary differential phase-shift-keyed (MDPSK) receiver. The novelty of the scheme is based on the observation that whereas the change in phase of the received signal over a full symbol contains the sum of the data (phase) and the Doppler-induced phase shift, the same change in phase over half a symbol (within a given symbol interval) contains only the Doppler-induced phase shift. Thus, by proper processing, the latter can be estimated and removed from the former. Analytical and simulation results are given for the variance of the above estimator, and the error probability performance of the MDPSK receiver is evaluated in the presence of the Doppler correction. Next, the practical considerations associated with the application of this technique on bandlimited Nyquist channels are discussed and incorporated into the final design. It is shown that the receiver can, in the absence of timing jitter, be designed to allow combined Doppler correction and data detection with no penalty due to intersymbol interference (ISI). The effects of ISI due to timing jitter are assessed by computer simulation.

Simon, Marvin K.↗
NASA NTRS1990

Frequency Synthesizer For Tracking Filter

Digital frequency-synthesizing subsystem generates trains of pulses, free of jitter, for use as frequency-control signals in tracking filters. Part of assembly of electronic equipment used to measure vibrations in bearings in rotating machinery. Designed to meet requirements for tracking narrow-band cage-rotation and ball-pass components of vibrations, as discussed in "Frequency-Tracking Error Detector" (MFS-29538) and "Ball-Pass Cage-Modulation Detector" (MFS-29539). Synthesizer includes preset counter, output of which controls signal for ball-pass filter. Input to this preset counter updated every 2 microseconds: responds almost immediately, effectively eliminating relatively long response time (lock-in time) and phase jitter.

Randall, Richard L.↗
NASA NTRS1991

The pulse-pair algorithm as a robust estimator of turbulent weather spectral parameters using airborne pulse Doppler radar

The pulse pair method for spectrum parameter estimation is commonly used in pulse Doppler weather radar signal processing since it is economical to implement and can be shown to be a maximum likelihood estimator. With the use of airborne weather radar for windshear detection, the turbulent weather and strong ground clutter return spectrum differs from that assumed in its derivation, so the performance robustness of the pulse pair technique must be understood. Here, the effect of radar system pulse to pulse phase jitter and signal spectrum skew on the pulse pair algorithm performance is discussed. Phase jitter effect may be significant when the weather return signal to clutter ratio is very low and clutter rejection filtering is attempted. The analysis can be used to develop design specifications for airborne radar system phase stability. It is also shown that the weather return spectrum skew can cause a significant bias in the pulse pair mean windspeed estimates, and that the poly pulse pair algorithm can reduce this bias. It is suggested that use of a spectrum mode estimator may be more appropriate in characterizing the windspeed within a radar range resolution cell for detection of hazardous windspeed gradients.

Baxa, Ernest G., Jr.↗
NASA NTRS1990

Interfacial dynamics of two liquids under an oscillating gravitational field

The evolution of two miscible liquids meeting at an initially sharp interface inside a cavity under microgravity g-jitter conditions is studied numerically. The response of the interface and kinematics of the flowfield to various g-jitter accelerations and aspect ratio variations is shown. The interface region acts like a vortex source sheet, and it can be unstable to Kelvin-Helmholtz and Rayleigh-Taylor instabilities. The vortices produced along the interface can serve as a stirring mechanism to promote local mixing. Below the critical Stokes-Reynolds number, the destabilization of the interface results in deformation into wavy structures. In some parameter regions, these structures oscillate in time; in others, they are quasi-steady. Above the critical Stokes-Reynolds number, 'chaotic' instability results, and the interface breaks into concentration pockets. The morphology of the initial breakup is similar to observed Rayleigh-Taylor instability. Subsequent mixing of the two fluids after the breakup of the interface is then very rapid.

Duval, Walter M. B.↗
NASA NTRS1991

Phase decorrelation of coherent structures in a free shear layer

The vortices near the origin of an initially laminar mixing layer have a single frequency with a well-defined phase; i.e., there is little phase jitter. Further downstream, however, the phase jitter increases suddenly. Even when the flow is forced, this same transition is observed. The forcing partially loses its influence because of the decorrelation of the phase between the forcing signal and the passing coherent structures. In the present investigation, this phenomenon is documented and the physical mechanism responsible for the phase decorrelation is identified.

Ho, Chih-Ming↗
NASA NTRS1992

Ranging performance of satellite laser altimeters

Topographic mapping of the earth, moon and planets can be accomplished with high resolution and accuracy using satellite laser altimeters. These systems employ nanosecond laser pulses and microradian beam divergences to achieve submeter vertical range resolution from orbital altitudes of several hundred kilometers. Here, we develop detailed expressions for the range and pulse width measurement accuracies and use the results to evaluate the ranging performances of several satellite laser altimeters currently under development by NASA for launch during the next decade. Our analysis includes the effects of the target surface characteristics, spacecraft pointing jitter and waveform digitizer characteristics. The results show that ranging accuracy is critically dependent on the pointing accuracy and stability of the altimeter especially over high relief terrain where surface slopes are large. At typical orbital altitudes of several hundred kilometers, single-shot accuracies of a few centimeters can be achieved only when the pointing jitter is on the order of 10 mu rad or less.

Gardner, Chester S.↗
NASA NTRS1992

A study of solution crystal growth in LOW-g (2-IML-1)

During the International Microgravity Laboratory-1 (IML-1) mission it is planned to grow triglycine sulfate (TGS) crystals from aqueous solution using the modified Fluids Experiment System (FES). A special cooled sting technique will be used for solution crystal growth. The objectives of the experiment are as follows: (1) to grow crystals of TGS using the modified FES; (2) to perform holographic interferometric tomography of the fluid field in three dimensions; (3) to study the fluid motion due to g-jitter by multiple exposure holography of tracer particles; and (4) to study the influence of g-jitter on the growth rate.

Lal, Ravindra B.↗
NASA NTRS1991

Comparison of the timing properties of the new Philips components (Amperex) XP2020/UR photomultiplier and the XP2020 photomultiplier

Timing characteristics are measured for the Philips Components (Amperex) XP2020/UR photomultiplier. The transit time jitter is significantly better than that of previously available XP2020 tubes. In a study of the transit time jitter, a single photoelectron resolution of 286 +/-3 ps was obtained for the XP2020 and 190 +/-2 ps for the XP2020/UR.

Kuhlen, M.↗