Search NASA⌕ Search

SEARCH · Search NASA

Results for “LINK”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 289 records · Page 16

DC Link Capacitor Reduction with Feedforward Control in Series-Series Compensated Wireless Power Transfer Systems

This paper presents the use of feedforward control to reduce the input side DC link capacitance of series-series compensated wireless power transfer (WPT) systems. Compared to conventional control schemes for WPT systems, the proposed feedforward-based approach achieves significant reduction in the DC link capacitor without any complicated voltage or current sensing requirements from the secondary side. This results in more compact hardware architecture. The proposed method shows minimal increase in the turn-on switching loss of the inverter. The switching loss is analyzed, and detailed results are presented relating the switching loss to the DC link capacitance and voltage ripple for proper tradeoff between losses and capacitor size. Simulation and experimental results presented validate the proposed scheme.

Mukherjee, Subho↗

Constitutive Modeling of the Cross-Linked Polymers During the Trio-Aging Mechanism: Effects of Water, Oxygen, UV

Abstract The synergized effects of diverse environmental conditions such as humidity, temperature, UV, and oxygen, are considered through a generic model by combining the concepts of network alteration, hygrothermal, and Photo-thermo oxidation Models [1–4]. Hygrothermal and Photo-oxidation are considered dual aging mechanisms which are due to the synergized effects of moisture-oxygen, and UV-oxygen, respectively at elevated temperatures. Here Trio-aging is considered as the synergized effects of Hygrothermal, and Photo-oxidation which the main environmental elements involved in polymer degradation are oxygen, water, and UV radiation where each of which has a different micro-structural impact on the polymer matrix. While oxygen imposes chain scission and cross-link formation, water, and UV radiation mainly cause chain scission. Similar to our recent models, the dual network hypothesis of Topolosky is utilized and as a result, the strain energy of the polymer matrix is written in terms of two states namely unaged and infinity. The infinity state network, itself, is decomposed into three networks, namely brittle, flexible, and dead networks. While the brittle network models the cross-link formation as sub-structural phenomena, the flexible and dead networks are utilized to represent the cross-link reduction and chain scission. The contribution of these networks in the infinity state is based on the amount of relevant environmental elements. The model is developed for a domain with plenty of oxygen and holds true for a gradual aging process that happens in super-thin samples.

Bahrololoumi, Amir↗

Linking crop traits to transcriptome differences in a progeny population of tetraploid potato

Background: Potato is the third most consumed crop in the world. Breeding for traits such as yield, product quality and pathogen resistance are main priorities. Identifying molecular signatures of these and other important traits is important in future breeding efforts. In this study, a progeny population from a cross between a breeding line, SW93–1015, and a cultivar, Désirée, was studied by trait analysis and RNA-seq in order to develop understanding of segregating traits at the molecular level and identify transcripts with expressional correlation to these traits. Transcript markers with predictive value for field performance applicable under controlled environments would be of great value for plant breeding.Results: A total of 34 progeny lines from SW93–1015 and Désirée were phenotyped for 17 different traits in a field in Nordic climate conditions and controlled climate settings. A master transcriptome was constructed with all 34 progeny lines and the parents through a de novo assembly of RNA-seq reads. Gene expression data obtained in a controlled environment from the 34 lines was correlated to traits by different similarity indices, including Pearson and Spearman, as well as DUO, which calculates the co-occurrence between high and low values for gene expression and trait. Our study linked transcripts to traits such as yield, growth rate, high laying tubers, late and tuber blight, tuber greening and early flowering. We found several transcripts associated to late blight resistance and transcripts encoding receptors were associated to Dickeya solani susceptibility. Transcript levels of a UBX-domain protein was negatively associated to yield and a GLABRA2 expression modulator was negatively associated to growth rate.Conclusion: In our study, we identify 100’s of transcripts, putatively linked based on expression with 17 traits of potato, representing both well-known and novel associations. This approach can be used to link the transcriptome to traits. We explore the possibility of associating the level of transcript expression from controlled, optimal environments to traits in a progeny population with different methods introducing the application of DUO for the first time on transcriptome data. We verify the expression pattern for five of the putative transcript markers in another progeny population.

59 BASIC BIOLOGICAL SCIENCES↗

Ploidy evolution in a wild yeast is linked to an interaction between cell type and metabolism

Ploidy is an evolutionarily labile trait, and its variation across the tree of life has profound impacts on evolutionary trajectories and life histories. The immediate consequences and molecular causes of ploidy variation on organismal fitness are frequently less clear, although extreme mating type skews in some fungi hint at links between cell type and adaptive traits. Here, we report an unusual recurrent ploidy reduction in replicate populations of the budding yeast Saccharomyces eubayanus experimentally evolved for improvement of a key metabolic trait, the ability to use maltose as a carbon source. We find that haploids have a substantial, but conditional, fitness advantage in the absence of other genetic variation. Using engineered genotypes that decouple the effects of ploidy and cell type, we show that increased fitness is primarily due to the distinct transcriptional program deployed by haploid-like cell types, with a significant but smaller contribution from absolute ploidy. The link between cell-type specification and the carbon metabolism adaptation can be traced to the noncanonical regulation of a maltose transporter by a haploid-specific gene. This study provides novel mechanistic insight into the molecular basis of an environment–cell type fitness interaction and illustrates how selection on traits unexpectedly linked to ploidy states or cell types can drive karyotypic evolution in fungi.

59 BASIC BIOLOGICAL SCIENCES↗

Versatile Link+ Transceiver Production Readiness

The Versatile Link + project is about to enter its production phase, ready for the Phase 2 HL-LHC detector upgrades. We present the status of the front-end part of the Versatile Link$^+$ project: the Versatile Link$^+$ Transceiver, which provides a low-mass, radiation tolerant, optical transmit- and receive module for tight integration in the upgrading HL-LHC detectors. We describe the development and thorough testing carried out with the transceiver prototypes and their sub-components and the design decisions that have led to the final production-ready prototype. The planned production schedule is also presented.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Coded communication link for an advanced manned spacecraft.

An analysis, in terms of key design parameters, is presented of a digital link for bidirectional communication between an advanced manned spacecraft, such as the space shuttle, and a ground terminal by means of a synchronous communication relay satellite. Performance of both ground to manned spacecraft and return links are compared with and without coding. A breadboard terminal for simulating the two-way link is described. Results of error rate tests are discussed.

Gould, L. M.↗

Data link relay design

The data link for the Ames baseline probe as applied to the MJU spacecraft specifically with an entry at Uranus is analyzed. A frequency analysis, a trajectory analysis, and a discussion of the effects on the spacecraft design by the data link are presented. The possibilities of a two-way link are considered.

Parsons, P.↗

Source encoding for orbiter communications links

The feasibility of using data compression to improve link efficiency as an alternative to increased transmitter power, reducing receiver noise figures, increasing antenna gain through more stringent orbiter attitude constraints, etc. is studied. A method of encoding digital data is developed which permits low band-width encoding as well as a unique system of adaptive run length encoding. The effectiveness of these techniques for the air-to-ground link and for the bandwidth-limited ground-to-ground data link used for the orbiter downlink data is evaluated. Results are presented.

Source record↗

Coding/modulation trade-offs for Shuttle wideband data links

This paper describes various modulation and coding schemes which are potentially applicable to the Shuttle wideband data relay communications link. This link will be capable of accommodating up to 50 Mbps of scientific data and will be subject to a power constraint which forces the use of channel coding. Although convolutionally encoded coherent binary PSK is the tentative signal design choice for the wideband data relay link, FM techniques are of interest because of the associated hardware simplicity and because an FM system is already planned to be available for transmission of television via relay satellite to the ground. Binary and M-ary FSK are considered as candidate modulation techniques, and both coherent and noncoherent ground station detection schemes are examined. The potential use of convolutional coding is considered in conjunction with each of the candidate modulation techniques.

Batson, B. H.↗

Space Shuttle communications - Wideband direct link signal and system design

This paper describes the design of a wideband S-band communications link from the Space Shuttle Orbiter to a ground-based terminal. This link will be used for transmission of television, digital data (various rates), or analog data, and is of interest because of the presence of bandwidth, power, and hardware constraints. The procedure followed to arrive at an overall signal and system design is outlined, and system performance margins are presented for various operational configurations. Finally, the growth potential of this link for digital data transmission is discussed.

Batson, B. H.↗

System measurements of a CO2 laser communications link

Measurements were made under simulated operating conditions to establish the capability of a CO2 laser transmitting heterodyne receiver link to acquire weak laser transmitter beams and maintain spatial tracking during communications. For the case of a synchronous satellite-to-earth station link, analysis and laboratory measurements indicate that the infrared heterodyne receiver subsystem is capable of performing the acquisition, acquisition confirm, and spatial tracking functions at IF signal-to-noise ratio of -17 dB. For the case of a low-altitude satellite-to-earth station link, the laser transmit signal is Doppler-shifted due to the difference in relative velocity of the two stations. The resultant Doppler frequency shift varies with time and must be spectrally acquired and tracked.

Peyton, B. J.↗

A statistical model for telecommunication link design

An evaluation is conducted of the current telecommunication link design technique and a description is presented of an alternative method, called the probability distribution method (PDM), which is free of the disadvantages of the current technique while retaining its advantages. The PDM preserves the simplicity of the design control table (DCT) format. The use of the DCT as a management design control tool is continued. The telecommunication link margin probability density function used presents the probability of achieving any particular value of link performance. It is, therefore, possible to assess the performance risk and other tradeoffs.

Yuen, J. H.↗

A high-speed computer link for moderate distances and noisy environments

To satisfy the need for a fully duplex high-speed computer data link for the antenna automation project at DSS 13, a very simple and inexpensive scheme was employed. The link requires two coaxial cables over which is sent a unipolar digital frequency modulated signal in which a logical 1 has twice the frequency of a logical 0. Optical isolators and filters reduce ground loop effects and increase noise immunity. Tests conducted in various environments and over different cable lengths at JPL, DSS 14 and DSS 13 have indicated that the link is highly effective.

Sievers, M. W.↗

Three methods for in situ cross-linking of polyvinyl alcohol films for application as ion-conducting membranes in potassium hydroxide electrolyte

Three methods of in situ cross-linking polyvinyl alcohol films are presented. They are: (1) acetalization with a dialdehyde such as glutaraldehyde, (2) acetalization with aldehyde groups formed by selective oxidative cleaving of the few percent of 1,2 diol units present in polyvinyl alcohol, and (3) cross-linking by hydrogen abstraction by reaction with hydrogen atoms and hydroxyl radicals from irradiated water. For the third method, improvement in film conductivity in KOH solution at the expense of mechanical strength is obtained by the presence of polyacrylic acid in the polyvinyl alcohol films. Resistivities in 45 percent KOH are given for in situ cross-linked films prepared by each of the three methods.

Philipp, W. H.↗

Spread spectrum acquisition and tracking performance for Shuttle communication links

The spread spectrum acquisition and tracking performance for the Shuttle S-band and Ku-band communication links are analyzed and compared to test results. The S-band link requirements are more severe than those of the Ku-band links, hence, different despreader designs were developed for the two systems. The S-band despreader acquires pseudonoise code lock by examining all possible code phases in half chip steps while the Ku-band despreader acquires pseudonoise code lock by continuously sweeping a tau-jitter loop. Both despreaders employ a tau-jitter loop for code tracking. The code tracking performance is computed for the tau-jitter loop and compared to that of the more complex delay lock loop.

Alem, W. K.↗

RF coverage analysis and performance for Shuttle communication links

This paper describes the current work at NASA/Johnson Space Center in the area of RF coverage analysis and performance-assessment for the Space Shuttle Program communication and tracking radio links. Trajectories, antenna data, ground station and Shuttle hardware performance characteristics and RF link math models were assimilated to generate RF link performance predictions for the three basic mission phases - ascent, on-orbit, and descent. Results identify some earlier deficiencies that required re-configuration of the ground station. Overall performance is currently satisfactory.

Loh, Y.-C.↗

Orbiter S-band direct link system verification test report

Space-to-ground S-band communications system compatibility and performance tests were performed for the various radio frequency links. These tests consisted of the various uplink and downlink signal combinations (data rates) for the phase modulation system and both realtime and playback data rates for the frequency modulated downlink systems. In addition, tests involving encryption/decryption, Doppler, and acquisition were performed. Results show that the S-band transponder for the space shuttle orbiter is compatible with the S-band equipment of the AFSCF/RTS (Air Force Satellite Control Facility/Remote Tracking Station). It is also concluded that the performance of the orbiter-AFSCF/RTS direct link exceeds the required performance and that this communications link will meet the system requirements of the Space Transportation System.

Vermillion, B. K.↗

Ion exchange selectivity for cross-linked polyacrylic acid

The ion separation factors for 21 common metal ions with cross-linked polyacrylic acid were determined as a function of pH and the percent of the cross-linked polyacrylic acid neutralized. The calcium ion was used as a reference. At a pH of 5 the decreasing order of affinity of the ions for the cross-linked polyacrylic acid was found to be: Hg++, Fe+++, Pb++, Cr+++, Cu++, Cd++, Al+++, Ag+, Zn++, Ni++, Mn++, Co++, Ca++, Sr++, Ba++, Mg++, K+, Rb+, Cs+, Na+, and Li+. Members of a chemical family exhibited similar selectivities. The Hg++ ion appeared to be about a million times more strongly bound than the alkali metal ions. The relative binding of most of the metal ions varied with pH; the very tightly and very weakly bound ions showed the largest variations with pH. The calcium ion-hydrogen ion equilibrium was perturbed very little by the presence of the other ions. The separation factors and selectivity coefficients are discussed in terms of equilibrium and thermodynamic significance.

May, C. E.↗