Search NASA⌕ Search

SEARCH · Search NASA

Results for “THRUST MEASUREMENT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 289 records · Page 16
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Measurement of mass, momentum and energy distributions in a quasi-steady MPD discharge.

Piezoelectric impact pressure measurements in the exhaust flow of a quasi-steady MPD accelerator are used to compute the profile of momentum flux 25.4 cm downstream of a 2.8 MW discharge. The integral of this profile is in good agreement with the sum of calculated electromagnetic and measured electrothermal thrust components. Velocity vector profiles obtained by a time-of-flight technique reveal a radial variation of velocity ranging from 31,000 m/sec on the centerline to 11,000 m/sec at a radius of 20 cm. When combined with the momentum flux profiles, these velocities yield information on the distribution of mass and energy in the plasma exhaust.

Clark, K. E.↗
NASA NTRS1972

Performance testing of a solid propellant pulsed plasma microthruster.

Extensive performance testing has been carried out on a solid propellant, pulsed plasma microthruster essentially identical to the four units aboard the DOD, Lincoln Experimental Satellite (LES)-6. Tests include measurements of thrust, specific impulse, thrust vector, impulse bit repeatability, intermittency and endurance. The results show good impulse bit repeatability and a well defined thrust vector. The impulse bit, with a 1.85-joule input, was found to be approximately 26 micronewton-seconds at 190 seconds specific impulse. Based upon the results of the intermittency tests, a better understanding of the intermittency mechanism has been achieved.

Williams, T. E.↗
NASA NTRS1976

The 2.5 kW advanced technology ion thruster

A representative thruster was extensively documented with respect to performance parameters and characteristics at selected ion beam currents in the 0.5 to 2.75 A range, including measurements of thrust losses resulting from doubly-charged ions and ion beam divergence. Corrected total efficiency was shown to be relatively insensitive to operating parameter selection at any given power level. Factors affecting doubly-charged ionization were studied and it was found that the fraction of doubly-charged ions is directly proportional to the discharge chamber propellant utilization. The parameter that most affects this proportionality is the accel aperture diameter (which controls neutral atom loss). Thruster-power conditioner interactions were studied with the result that previous power supply specifications remain satisfactory. Options for reducing the number of power supplies required were demonstrated to be feasible. Gimbal actuator designs were studied with the goal of selecting a particular approach for design and development. The conclusion drawn was that optimum gimbal actuator design depends heavily on the thruster application and consequently the effort was concluded by developing a computer program to aid in specifying the gimbal requirements for the thrust vectoring required in a specific application.

Poeschel, R. L.↗
NASA NTRS1979

Aerodynamic and acoustic investigation of inverted velocity profile coannular exhaust nozzle models and development of aerodynamic and acoustic prediction procedures

Five co-annular nozzle models, covering a systematic variation of nozzle geometry, were tested statically over a range of exhaust conditions including inverted velocity profile (IVP) (fan to primary stream velocity ratio 1) and non IVP profiles. Fan nozzle pressure ratio (FNPR) was varied from 1.3 to 4.1 at primary nozzle pressure ratios (PNPR) of 1.53 and 2.0. Fan stream temperatures of 700 K (1260 deg R) and 1089 K(1960 deg R) were tested with primary stream temperatures of 700 K (1260 deg R), 811 K (1460 deg R), and 1089 K (1960 deg R). At fan and primary stream velocities of 610 and 427 m/sec (2000 and 1400 ft/sec), respectively, increasing fan radius ratio from 0.69 to 0.83 reduced peak perceived noise level (PNL) 3 dB, and an increase in primary radius ratio from 0 to 0.81 (fan radius ratio constant at 0.83) reduced peak PNL an additional 1.0 dB. There were no noise reductions at a fan stream velocity of 853 m/sec (2800 ft/sec). Increasing fan radius ratio from 0.69 to 0.83 reduced nozzle thrust coefficient 1.2 to 1.5% at a PNPR of 1.53, and 1.7 to 2.0% at a PNPR of 2.0. The developed acoustic prediction procedure collapsed the existing data with standard deviation varying from + or - 8 dB to + or - 7 dB. The aerodynamic performance prediction procedure collapsed thrust coefficient measurements to within + or - .004 at a FNPR of 4.0 and a PNPR of 2.0.

Larson, R. S.↗
NASA NTRS1979

Initial wind tunnel tests at Mach 4 and 7 of a hydrogen-burning, airframe-integrated scramjet

A research investigation of a new, fixed-geometry, hydrogen-burning scramjet engine concept, designed for total airframe integration, is currently in progress. Two heavily instrumented engine models incorporate inlet and combustor designs developed previously in component tests. Initial tests of these subscale engine models are being conducted in ground facilities at conditions simulating flight at Mach numbers 4 and 7. The scramjet test results which are presented include inlet performance, ignition/reaction aids, inlet-combustor interactions, and engine performance in terms of thrust balance measurements and internal pressure and heating rate distributions. The relationship of these results to flight engine performance is discussed.

Guy, R. W.↗
NASA NTRS1981

Propeller propulsion integration, phase 1

A bibliography was compiled of all readily available sources of propeller analytical and experimental studies conducted during the 1930 through 1960 period. A propeller test stand was developed for the measurement of thrust and torque characteristics of full scale general aviation propellers and installed in the LaRC 30 x 60 foot full scale wind tunnel. A tunnel entry was made during the January through February 1980 period. Several propellers were tested, but unforseen difficulties with the shaft thrust torque balance severely degraded the data quality.

Bennett, G.↗
NASA NTRS1982

Measurements of energy distribution and thrust for microwave plasma coupling of electrical energy to hydrogen for propulsion

A microwave plasma system for transfer of electrical energy to hydrogen flowing through the system has potential application for coupling energy to a flowing gas in the electrothermal propulsion concept. Experimental systems have been designed and built for determination of the energy inputs and outputs and thrust for the microwave coupling of energy to hydrogen. Results for experiments with pressure in the range 100 microns-6 torr, hydrogen flow rate up to 1000 micronmoles/s, and total absorbed power to 700 w are presented.

Morin, T.↗
NASA NTRS1985

MPD thruster performance - Propellant distribution and species effects

Previous research has shown that MPD thruster performance, as measured by thrust, specific impulse, and efficiency, is limited by a so-called 'onset' current level. Experimental results are presented which show that the onset current level varies with the radial position of mass injection. Specifically, mass injection into either of two zones results in drastically different performance for both argon and xenon propellants. This difference in performance is evidenced by the onset current levels, the onset V-J signatures, and the overall V-J characteristics. The behavior of the thruster with the total mass flow split between the two zones follows a transition between the zonal behavioral limits. The behavior of propellant mixtures also follows a transition between the behavior of the individual propellant species. The flow region between the two zones is characterized by a particle number density discontinuity, a large axial current density, and a large electron Hall parameter, suggesting a possible correlation between observed onset phenomena and a shear-flow discontinuity located in the region between the two zones.

Kelly, A. J.↗
NASA NTRS1990

A computational investigation of flow losses in a supersonic combustor

This computational investigation provides a detailed comparative study of both non-reacting and reacting supersonic combustor flow-fields and attendant flow losses. Three different injection configurations in the same combustor are examined; a swept-sided ramp with base hydrogen injection, a straight ramp with base hydrogen injection and a thirty-degree downstream directed wall jet. Detailed comparisons are made with available reacting experimental data for the swept and the unswept ramps. A seven reaction, seven species reaction model as well as a global (one reaction) model are used for all three reacting cases. Relative performance (as measured by thrust) of all cases are described. Details of the flow, mixing, and combustion processes are discussed.

Riggins, David W.↗
NASA NTRS1995

Balances for the measurement of multiple components of force in flows of a millisecond duration

This paper reports a new balance for the measurement of three components of force - lift, drag and pitching moment - in impulsively starting flows which have a duration of about one millisecond. The basics of the design of the balance are presented and results of tests on a 15 deg semi-angle cone set at incidence in the T4 shock tunnel are compared with predictions. These results indicate that the prototype balance performs well for a 1.9 kg, 220 mm long model. Also presented are results from initial bench tests of another application of the deconvolution force balance to the measurement of thrust produced by a 2D scramjet nozzle.

Mee, D. J.↗