SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Long-arc orbit computation of highest accuracy can provide pole positions. Optical Baker-Nunn and laser range observations of several satellites are combined. The accuracy of the pole position is comparable to that of the mean satellite-tracking station coordinates (plus or minus 5 m) when sufficient tracking data are available. Exploitation of the technique requires more accurate tracking data.
A spatio-temporal adaptive algorithm for solving the unsteady Euler equations with chemical source terms is presented. Quadrilateral cells are used in two spatial dimensions which allow for embedded meshes tracking moving flow features with spatially varying time-steps which are multiples of global minimum time-steps. Blast wave interactions corresponding to a perfect gas (frozen) and a Lighthill dissociating gas (nonequilibrium) are considered for circular arc cascade and 90 degree bend duct geometries.
This paper describes a navigation error covariance analysis of two scenarios derived from the Mars Observer mission and the planned Mars Environmental SURvey (MESUR) Pathfinder mission, respectively. The analysis was performed to establish the potential navigational performance of the X-band tracking system in NASA's Deep Space Network, and to evaluate the sensitivity of the predicted performance to variations in the quantity of data acquired, the ground system error modeling assumptions, and data reduction schemes. The simulated data arcs used in the analysis are representative of the actual data arcs that will be used to predict the aim point for the Mars orbit insertion maneuver, in the case of Mars Observer, and the interplanetary trajectory aim point corresponding to the target Mars landing site in the case of MESUR Pathfinder. The results indicate that with a suitable sequential data reduction scheme and accurate calibrations of instrumentation, transmission media, and platform model parameters, navigation accuracies of 5 to 15 km (1 sigma) can be achieved, equivalent to 15 to 40 nrad in geocentric angle uncertainty.
The IUE spacecraft was launched with prime and redundant mechanical Panoramic Attitude Sensors (PAS) to determine coarse spacecraft pointing. Attitude determination typically took at least 24 hours. After launch both systems failed. A new method was developed which required pointing the spacecraft at the antisolar position. After the failure of the 4th IUE gyro, it was no longer possible to point in the antisolar direction. A second method was developed which utilizes IUE's ability to track the sun with a solid state two-dimensional sun sensor. Attitude determination can now be completed in several hours. An hour is required for coarse position measurement and several more hours are needed, using a small 15 arc minute square finder camera, for final attitude confirmation. These methods should be of use for other spacecraft where weight is critical or there is a desire to avoid mechanical devices.
Tracking of the Beacon Explorer-C satellite by a precision laser system was used to measure the polar motion and solid earth tide. The tidal perturbation of satellite latitude is plotted as variation in maximum latitude in seconds of arc on earth's surface as a function of the date, and polar motion is shown by plotting the variation in latitude of the laser in seconds of arc along the earth's surface as a function of date
The extended sequential filter has been applied to the problem of dynamically determining the geocentric coordinates of two laser satellite tracking stations. This filter provides significant advantages over the classical batch methods through (1) fewer iterations required for convergence, (2) wider radius of convergence, and (3) availability of the parameter estimate evolution. Processing the data sequentially readily identifies the data arcs required to minimize the effects of geopotential model errors. By means of the Smithsonian standard earth 2 and the Goddard earth model 1 geopotentials to reduce laser range observations of the Beacon Explorer-C satellite, it is demonstrated that a two-pass arc is optimal for estimating the height of one station and all coordinates of the second station while minimizing the effect of geopotential model error. These two-pass estimates are in good agreement with other determinations that utilize considerably more data as well as different satellites.
A basic problem in the application of robots for welding which is how to guide a torch along a weld seam using sensory information was studied. Improvement of the quality and consistency of certain Gas Tungsten Arc welds on the Space Shuttle Main Engine (SSME) that are too complex geometrically for conventional automation and therefore are done by hand was examined. The particular problems associated with space shuttle main egnine (SSME) manufacturing and weld-seam tracking with an emphasis on computer vision methods were analyzed. Special interface software for the MINC computr are developed which will allow it to be used both as a test system to check out the robot interface software and later as a development tool for further investigation of sensory systems to be incorporated in welding procedures.
The Geosynchronous Imaging Fourier Transform Spectrometer (GIFTS) Instrument is the next generation spectrometer for remote sensing weather satellites. The GIFTS instrument will be used to perform scans of the Earth s atmosphere by assembling a series of field-of- views (FOV) into a larger pattern. Realization of this process is achieved by step scanning the instrument FOV in a contiguous fashion across any desired portion of the visible Earth. A 2.3 arc second pointing stability, with respect to the scanning instrument, must be maintained for the duration of the FOV scan. A star tracker producing attitude data at 100 Hz rate will be used by the autonomous pointing algorithm to precisely track target FOV s on the surface of the Earth. The main objective is to validate the pointing algorithm in the presence of spacecraft disturbances and determine acceptable disturbance limits from expected noise sources. Proof of concept validation of the pointing system algorithm is carried out with a full system simulation developed using Matlab Simulink. Models for the following components function within the full system simulation: inertial reference unit (IRU), attitude control system (ACS), reaction wheels, star tracker, and mirror controller. With the spacecraft orbital position and attitude maintained to within specified limits the pointing algorithm receives quaternion, ephemeris, and initialization data that are used to construct the required mirror pointing commands at a 100 Hz rate. This comprehensive simulation will also aid in obtaining a thorough understanding of spacecraft disturbances and other sources of pointing system errors. Parameter sensitivity studies and disturbance analysis will be used to obtain limits of operability for the GIFTS instrument. The culmination of this simulation development and analysis will be used to validate the specified performance requirements outlined for this instrument.
In a world of ever-changing travel behavior and ever-increasing modal options, is vital to have integrated models that could capture the interactions between supply and demand layers of travel. Addressing this need, we propose three different versions of network representation and mathematical models for the activity-based vehicle routing problem to connect activity-travel graphs of passengers (demand layer) to spatio-temporal networks of vehicles (supply layer). Versions I and II are arc-based, while version III is path-based. In version I, we introduce the concept of activity-travel graphs for passengers. For vehicles, we construct space–time networks and add a new dimension, called “under-service state”, to track the execution status of trip requests at any location and time. In version II, we reduce the complexity of the network structure by eliminating the state dimension and some other modifications in the structure of the passengers’ and vehicles’ network. Although both versions can capture various behavioral constraints of the activity-based vehicle routing problem (e.g., mandatory and optimal activities, duration of activities, chain of activities, preferred starting and ending times of activities), due to the high level of complexity of the network structure, both versions can only solve small-sized problems. To tackle the computational complexity, we propose a path-based network representation in version III, and to make a balance between the disutility of passengers and vehicles, we present a tolled user equilibrium problem. Mathematical models are coded in C and GAMS and implemented on real-world Phoenix regional transportation network with more than 39 million trip requests, which demonstrate the effectiveness of the proposed solution for the original and restricted master problems.
Report describes technique for using Global Positioning System (GPS) to determine position of low Earth orbiter without need for dynamic models. Differential observing strategy requires GPS receiver on user vehicle and network of six ground receivers. Computationally efficient technique delivers decimeter accuracy on orbits down to lowest altitudes. New technique nondynamic long-arc strategy having potential for accuracy of best dynamic techniques while retaining much of computational simplicity of geometric techniques.
Evaluation of numerous laser range data obtained in orbit determination experiments and by analysis of orbit perturbations due to solid-earth and ocean tides. Results obtained from both a single-laser tracking system and two-laser systems are discussed. With the introduction of radar altimeters, satellite-to-satellite tracking techniques, and more accurate laser data in greater quantities, significant improvements in the gravity field, GM, and station coordinates can be projected such that 10-cm precision relative positioning should be a realizable objective from a single four-pass orbital arc. The use of simultaneous range measurements to a satellite from two stations several hundred km apart is being used to measure the motion between points 900 km apart on opposite sides of the San Andreas fault. Computer simulation of this experiment shows that it will permit determination of the change in baseline (plate motion) to better than 0.5 cm/yr over a seven-year period.
The Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER) is a 14-channel imaging instrument operating on NASA’s Terra satellite since 1999. ASTER’s visible–near infrared (VNIR) instrument, with three bands and a 15 m Instantaneous field of view (IFOV), is accompanied by an additional VNIR band using a second, backward-looking telescope. Collecting along-track stereo pairs, the geometry produces a base-to-height ratio of 0.6. In 2009, the ASTER Science Team released Version 1 of the global DEM (GDEM) based on stereo correlation of 1.2 million ASTER scenes. The DEM has 1 arc-second latitude and longitude postings (~30 m) and employed cloud masking to avoid cloud-contaminated pixels. The GDEM covers all of the Earth’s land surface from 83 degrees north to 83 degrees south latitude. Version 2 was released in 2011, with notable improvements in coverage and accuracy. In 2019, the final, Version 3, was released; again improving on coverage and removing almost all artifacts. Th GDEM is a unique, global high spatial resolution digital elevation dataset available to all users at no cost. In addition, a second unique dataset was produced and released. The raster-based ASTER Global Water Body Dataset (ASTWBD) identifies the presence of permanent water bodies, and marks them as ocean, lake, or river. An accompanying DEM file indicates the elevation for each water pixel. To date, over 110+ million 1x1 degree GDEM tiles have been distributed.
The communications performances of laser intersatellite links for a future NASA data-relay system are analyzed, and block diagrams of necessary optical terminals are generated based on technology projected to be available by 1992. Direct-detection optical communications subsystems are selected to interconnect two geosynchronous (GEO) satellites separated by 160 deg along the GEO arc and to interconnect a low-earth-orbit (LEO) satellite and either of the GEO satellites. The terminal designs are based on power budget calculations performed for the various links with and without an optical background in either the receiver or transmitter fields of view (FOVs). Optical antennas with 18-cm and 30-cm primary mirror diameters on the LEO and GEO satellites can achieve a 0.000001 average bit error rate during normal operations in each of the forward and return optical links with beginning-of-life (BOL) power margins of approximately 7 dB. With an optical background in the receiver FOV, communications in the GEO-GEO return link are interrupted, the LEO-GEO return link is undegraded, and the GEO-GEO and LEO-GEO forward links remain functional with reduced BOL power margins. With an optical background in the transmitter FOV, the GEO-GEO forward and return links are noticeably degraded, the LEO-GEO return link is only slightly degraded, and the LEO-GEO forward link remains undegraded.
The effects of tropospheric and ionospheric refraction errors are analyzed for the GEOS-C altimeter project in terms of their resultant effects on C-band orbits and the altimeter measurement itself. Operational procedures using surface meteorological measurements at ground stations and monthly means for ocean surface conditions are assumed, with no corrections made for ionospheric effects. Effects on the orbit height due to tropospheric errors are approximately 15 cm for single pass short arcs (such as for calibration) and 10 cm for global orbits of one revolution. Orbit height errors due to neglect of the ionosphere have an amplitude of approximately 40 cm when the orbits are determined from C-band range data with predominantly daylight tracking. Altimeter measurement errors are approximately 10 cm due to residual tropospheric refraction correction errors. Ionospheric effects on the altimeter range measurement are also on the order of 10 cm during the GEOS-C launch and early operation period.
The Starlette satellite, launched in February 1975 was designed to minimize the effects of nongravitational forces and to obtain the highest possible accuracy for laser range measurements. Analyses of the first four months of laser tracking data from nine stations have confirmed the stability of the orbit and the precision to which the satellite's position can be established. Initial orbit computations using the GSFC GEM - 7 gravity model produced rms fits of about 8 to 10 meters for arc lengths of 5 days. After tailoring a gravity model specifically to Starlette, the rms fits for the 5 day arcs were reduced significantly to the 1 to 2 meter level. An rms fit of 4.3 meters was obtained for a 90 day arc. Five day arcs overlapped by 2.5 days showed rms satellite position differences generally less than 2 meters. Prediction errors at the end of two months were less than 30 milliseconds.
Recognition of underlying straight lines and quadratic arcs in line drawings, and approximation of very noisy data by such line/curve segments, is addressed as a subproblem of the more general problem of optimum recognition of complicated line/curve drawings. Some specific algorithms are presented with extensions and interpretations for more complicated applications, and a data generation model is developed for the problem. Data are generated as a perturbation of a single underlying straight line or an elliptic or hyperbolic arc. Recursive estimation techniques, minimization of central processing unit time, decision making with controlled error probabilities, and modeling and recognition of pictures consisting of noisy curves are dealt with. Applications envisaged include: picture data compression, contour line representation in maps, intelligent data searches, and ballistic missile decoy tracking.
The stations of the Global Laser Tracking Network have significantly contributed to the measurement of plate kinematics. The expanding network of progressively improved instruments clearly demonstrates the systems' centimeter positioning accuracy. Several satellite laser ranging (SLR) analysis groups have adopted techniques to distill geodynamic information from the Lageos-1 satellite observations using orbital arc lengths from an hour to a decade. SLR observations now provide the scale for the International Terrestrial Reference System and help to define the Earth's polar motion in this system. Agreement between positions separately determined with SLR, VLBI and GPS systems has been established at the level of a few centimeters in position and a few millimeters per year in horizontal velocity.
A new guidance technique, referred to as 4-D guidance, is being developed to improve the operation of future STOL aircraft transportation systems. 4-D guidance refers to a technique of synthesizing a complex three-dimensional flight path from simple pilot inputs and flying the aircraft along the path according to an ATC specified time schedule. The two major elements of a 4-D guidance system are the trajectory synthesizer and the control law for flying the aircraft along the synthesized trajectory using the aircraft's autopilot and autothrottle. Inputs to the trajectory synthesizer are the three-dimensional coordinates of waypoints, the turning radius, the speed range, the acceleration limits and the arrival time at time control waypoints. First the three-dimensional trajectory is computed using circular arcs and straight lines. Then the airspeed profile, compensated for wind, is calculated to achieve the desired arrival times. The pilot is informed if the arrival times cannot be achieved. The synthesized trajectory is stored as a time sequence of reference states and controls which the aircraft is forced to track using a linear feedback law.