Search NASA⌕ Search

SEARCH · Search NASA

Results for “controller stability”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 289 records · Page 16
All sourcesNASA NTRSDOE OSTI
NASA NTRS1945

Analysis of wind-tunnel stability and control tests in terms of flying qualities of full-scale airplanes

The analysis of results of wind-tunnel stability and control tests of powered airplane models in terms of the flying qualities of full-scale airplanes is advocated. In order to indicated the topics upon which comments are considered desirable in the report of a wind-tunnel stability and control investigation and to demonstrate the nature of the suggested analysis, the present NACA flying-qualities requirements are discussed in relation to wind-tunnel tests. General procedures for the estimation of flying qualities from wind-tunnel tests are outlined.

Kayten, Gerald G↗
NASA NTRS1953

Preliminary Results of Stability and Control Investigation of the Bell X-5 Research Airplane

During the acceptance tests of the Bell X-5 airplane, measurements of the static stability and control characteristics and horizontal-tail loads were obtained by the NACA High-Speed Flight Research Station. The results of the stability and control measurements are presented in this paper. A change in sweep angle between 20 deg and 59 deg had a minor effect on the longitudinal trim, with a maximum change of about 2.5 deg in elevator deflection being required at a Mach number near 0.85; however, sweeping the wings produced a total stick-force change of about 40 pounds. At low Mach numbers there was a rapid increase in stability at high normal-force coefficients for both 20 0 and 1100 sweepback, whereas a condition of neutral stability existed for 58 0 sweepback at high normal-force coefficients. At Mach numbers near 0.8 there was an instability at normal-force coefficients above 0.5 for all sweep angles tested. In the low normal-force-coefficient range a high degree of stability resulted in high stick forces which limited the maximum load factors attainable in the demonstration flights to values under 5g for all sweep angles at a Mach number near 0.8 and an altitude of 12,000 feet. The aileron effectiveness at 200 sweepback was found to be low over the Mach number range tested.

Finch, Thomas W↗
NASA NTRS1983

Effect of modifications of aerodynamic characteristics of a single-stage-to-orbit vehicle at Mach 5.9

Hypersonic stability, control, and performance characteristics were determined on a single-stage-to-orbit vehicle based on control-configured stability concepts. The configuration (0.006-scale model) had a large body with a small 50 deg swept wing. Two vertical-fin arrangements were investigated which consisted of a large center-line vertical tail and small wing-tip fins. The wing-tip fins had movable surfaces called controllers which could be deflected outward. Longitudinal and lateral directional characteristics were obtained over an angle-of-attack rage from 0 deg to 40 deg. The effects of tip-fin controller deflection on roll- and yaw-control characteristics at a sideslip angle of 0 deg were obtained. This investigation was conducted in the Langley 20 Inch Mach 6 Tunnel.

Bernot, P. T.↗
NASA NTRS1999

Critical Stability and Control Issues in High-Speed Aerodynamics for the HSCT

The stability and control issues in high speed aerodynamics of most significance for the development of a viable HSCT are identified, and the status of the Ref. H configuration with respect to these issues is discussed. The interdependence between aerodynamic requirements and assumptions about airplane system functions such as Envelope Protection and Integrated Flight/Propulsion Control is highlighted. The conclusions presented draw on results from the Ref. H Assessment and Alternate Control Concepts Assessment performed under Configuration Aerodynamics Subtask 5 during 1995.

Wilson, Douglas L.↗
NASA NTRS1999

High Reynolds Number Effects on HSCT Stability and Control Characteristics

Two wind tunnel tests during 1995 in the National Transonic Facility (NTF 070 and 073) served to define Reynolds number effects on longitudinal and lateral-directional stability and control. Testing was completed at both high lift and transonic conditions. The effect of Reynolds number on the total airplane configuration, horizontal and vertical tail effectiveness, forebody chine performance, rudder control and model aeroelastics was investigated. This paper will present pertinent stability and control results from these two test entries. Note that while model aeroelastic effects are examined in this presentation, no corrections for these effects have been made to the data.

Elzey, Michael B.↗
NASA NTRS1990

Lateral-directional stability and control characteristics of the Quiet Short-Haul Research Aircraft (QSRA)

The results are presented of flight experiments to determine the lateral-directional stability and control characteristics of the Quiet Short-Haul Research Aircraft (QSRA), an experimental aircraft designed to furnish information on various aerodynamic characteristics of a transport type of airplane that makes use of the upper-surface blown (USB) flap technology to achieve short takeoff and landing (STOL) performance. The flight program designed to acquire the data consisted of maneuvers produced by rudder and control-wheel inputs with the airplane in several configurations that had been proposed for landing approach and takeoff operation. The normal stability augmentation system was not engaged during these maneuvers. Time-history records from the maneuvers were analyzed with a parameter estimation procedure to extract lateral-directional stability and control derivatives. For one aircraft configuration in which the USB flaps were deflected 50 deg, several maneuvers were performed to determine the effects of varying the average angle of attack, varying the thrust coefficient, and setting the airplane's upper surface spoilers at a 13 deg symmetrical bias angle . The effects on the lateral characteristics of deflecting the spoilers were rather small and generally favorable. The data indicate that for one test, conducted at low thrust (a thrust coefficient of 0.38), compared with results from tests at thrust coefficients of 0.77 and larger, there was a significant decrease in the lateral control effectiveness, in the yaw damping and in the directional derivative. The directional derivative was also decreased (by about 30 percent) when the average angle of attack of the test was increased from 3 to 16 deg.

Stephenson, Jack D.↗
NASA NTRS1949

Investigation of Stability and Control Characteristics of a 1/10-scale Model of a Canadian Tailless Glider in the Langley Free-flight Tunnel

An investigation of the stability and control characteristics of a 1/10-scale model of a Canadian tailless glider has been conducted in the 10 Langley free-flight tunnel. The glider designated the N.R.L. tailless glider has a straight center section and outboard panels sweptback 43 deg. along the leading edge of the wing. The aspect ratio is 5.83 and the taper ratio is 0.323. From the results of the investigation and on the basis of comparison with higher-scale static tests of the National Research Council of Canada, it is expected that the longitudinal stability of the airplane will be satisfactory with flap up but unsatisfactory near the stall with flap down. The airplane is expected to have unsatisfactory lateral stability and control characteristics in the design configuration with either flap up or flap down. The model flights showed very low damping of the lateral oscillation. Increasing the vertical-tail area improved the lateral stability, and it appeared that a value of the directional-stability parameter C(sub n beta) of at least 0.002 per degree would probably be necessary for satisfactory lateral flying characteristics. A comparison of the calculated dynamic lateral stability characteristics of the N.R.L. tailless glider with those of a conventional-type sweptback airplane having a similar wing plan form and about the same inclination of the principal longitudinal axis of inertia showed that the tailless glider had poorer lateral stability because of the relatively larger radius of gyration in roll and the smaller damping-in-yaw factor C(sub nr).

Johnson, Joseph L.↗
DOE OSTI2023

Stability and Control of Burning Tokamak Plasmas with Resistive Walls (Final Report)

Work supported by the grant, "Stability and Control of Burning Tokamak Plasmas with Resistive Walls" in the period Aug 2017 to 2023 can be cast in three general categories: (1) linear tearing regimes and the effects on the response to error fields and resistive walls: (2) nonlinear tearing modes in the presence of error fields, with locking; and (3) energetic particle effects. In the first category, we have completed a study of tearing mode regimes with extended MHD effects, including parallel dynamics and toroidal effects, notably favorable average curvature. This work has been presented at the 2018 Sherwood Conference. This work has been published in the ArXiv and is being prepared for publication in Physics of Plasmas. A systematic study of shaping in a tokamak plasma with resistive tearing layers and a resistive wall has been presented in the PhD dissertation by Dov Rhodes, a student of Andrew Cole at Columbia University. John Finn was on Rhodes's PhD committee, and was a co-author of a paper published in Physics of Plasmas on that work. A detailed study of nonlinear tearing modes in the presence of finite beta, favorable average curvature, and an error field has been nearly completed. In this study it was found that the response to an error field with real frequency a tearing layer agreed with analytic results, and that tearing mode saturation by flattening of the current profile as well as destabilization due to flattening of the pressure profile were important factors in the locking process. This work was presented at the 2017 APS/DPP Conference and at the 2018 Sherwood Conference. The effects of energetic ions on tearing modes was presented at the 2017 APS/DPP Conference and in the PhD dissertation of Michael Halfmoon. John Finn served as a committee member on Halfmoon's PhD committee. Extensions to this work including two fluid effects were performed and presented at the APS/DPP Conference in 2017.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗