SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Phase stability of very low frequency radio signal propagation, electronically scanned tracking antenna array, and inverted rf tracking system
New frequency divider circuit can be synchronized over a wider input control frequency range, has greater phase stability, and is less sensitive to temperature changes than conventional synchronized oscillators. The new circuit uses the avalanche breakdown mode of operation of transistors.
The effect of buffer gas and pumping light on the output frequency of the Rb-85 maser is discussed. In contrast to a primary standard, these frequency shifts can be used to advantage when it is necessary to operate the maser at a frequency which differs from the ground-state hyperfine frequency by a few kilohertz. Using appropriate mixtures of buffer gas and carefully shaped lamp spectral profiles, it is also possible to operate the maser exactly at the ground-state hyperfine frequency. It is pointed out that the short-term phase stability of the maser is not impaired by these shifts.
The construction of a Ku-band radio interferometer and some preliminary observations are reported. The interferometer was built for the purpose of mapping discrete radio sources like the Crab Nebula, Cassiopeia A, and Cygnus A. It has two 8-ft parabolic antennas operating at 17.128 GHz. The maximum baseline of 100 m corresponds to a resolution of 35 sec of arc. A PDP-8 computer is incorporated in the system and is used for pointing, tracking, delay compensation, and real-time data analysis. The phase stability of the system was better than 10 deg over a period of 2 hours. Consistent fringe components were obtained from the Crab Nebula with a baseline set at 8 m.
The thermal shock resistance of hafnia based composites containing graphite powder or tungsten fibers was investigated in terms of material properties which include thermal expansion, thermal conductivity, compressive fracture stress, modulus of elasticity, and phase stability in terms of the processing parameters of hot pressing pressure and/or density, degree of stabilization of the hafnia, and composition. All other parameters were held constant or assumed constant. The thermal shock resistance was directly proportional to the compressive fracture stress to modulus of elasticity ratio and was not affected appreciably by the small thermal expansion or thermal conductivity changes. This ratio was found to vary strongly with the composition and density such that the composites containing graphite had relatively poor thermal shock resistance, while the composites containing tungsten had superior thermal shock resistance.
Loran-C is a low frequency (100 kHz) pulse navigation system. The pulse format and phase stability of the system are of paramount importance for both navigation and time synchronization using this system. Present Loran-C installations operated by the U. S. Coast Guard cover much of the northern hemisphere. A recent government-wide decision has declared that Loran-C will be the U. S. Coastal confluence navigation system for the immediate future. Therefore, Loran-C stations are presently being installed or planned to cover the entire U. S. coastline.
The first experimental European communications satellite Symphonie is a geostationary satellite. The satellite is designed and built in a joint project by French and German aerospace firms. A description is given of the basic technical concept of the satellite. The apogee motor is discussed along with the satellite stabilization system. The stabilization system provides a three-axis positional stabilization and an orbital stabilization. Attention is given to the spin stabilization phase, the sensors employed, the approache used for orbital correction maneuvers, and the conduction of simulation tests on the ground.
The influence of microstructure on the fracture mechanism and plane-strain fracture toughness of Ti-5Al-2.5Sn was studied through the use of fractography and metallographic sectioning techniques. One-inch thick plates of extra low interstitial (ELI) and normal interstitial Ti-5Al-2.5Sn were mill annealed at 815 C followed by either air or furnace cooling. These variations in composition and cooling rate resulted in differences in the volume fraction and internal structure of the iron-stabilized phase, and in the crystallographic texture and ordering of the alpha matrix. The tensile properties of these plates were determined at 20 K, 77 K, and 295 K. The air-cooled ELI plate was the toughest material evaluated.
Superalloy for advanced temperature use is suited to cost-saving powder-metallurgy manufacturing methods and has improved phase stability during longtime heating. Wide variety of applications exists where stainless steels are used for oxidation and/or corrosion resistance.
The relationship between the Slater-Condon theory and the conditions within the atom as revealed by experimental data was investigated. The first spectrum of Si, Rb, Cl, Br, I, Ne, Ar, and Xe-136 and the second spectrum of As, Cu, and P were determined. Methods for assessing the phase stability of fringe counting interferometers and the design of an autoranging scanning system for digitizing the output of an infrared spectrometer and recording it on magnetic tape are described.
The techniques of fabricating BVA resonators are discussed in terms of aging, amplitude-frequency effect, and acceleration sensitivity. Results on 5 MHz resonators concerning aging versus drive level, reduced amplitude-frequency effect, frequency and phase stability performance, and frequency retrace following power interruption are presented. It is indicated that a zero aging rate is possible at a drive level which depends on the qaurtz material used. For natural AT quartz, a level of 70 to 90 micro W appears to be optimum, and for SC quartz approximately 160 micro W.
A proposal to operate a two element interferometer using the 64 m and 26 m antennas of the Tidbinbilla Deep Space Station is discussed. The instrument is to be operated as a correlation interferometer, the sine and cosine products being sampled once per second and recorded for later analysis. The receiver systems are currently under development. Preliminary measurements of the delay line and local oscillator systems and the site cables suggest that a phase stability to within about 1 deg should be achievable with temperature control of the receiver packages.
Extremely low noise, high performance, wideband buffer amplifiers and buffered phase comparators were developed. These buffer amplifiers are designed to distribute reference frequencies from 30 KHz to 45 MHz from a hydrogen maser without degrading the hydrogen maser's performance. The buffered phase comparators are designed to intercompare the phase of state of the art hydrogen masers without adding any significant measurement system noise. These devices have a 27 femtosecond phase stability floor and are stable to better than one picosecond for long periods of time. Their temperature coefficient is less than one picosecond per degree C, and they have shown virtually no voltage coefficients.
The receiver subsystem supplies the front end assembly (downconverter) and power supply for the ORION Mobile Station. These assemblies are designed to withstand severe environmental conditions. The mechanical, electronic, environmental and maintenance design considerations encountered during the design phase of this project are discussed. The two channel S/X downconverter has a 400 MHz bandwidth channel. Phase stability of 2 and 7 deg at S- and X-bands, respectively, is achieved with a temperature stabilized first local oscillator.
A summary of metallo-organic deposition (MOD) films for solar cells was presented. The MOD materials are metal ions compounded with organic radicals. The technology is evolving quickly for solar cell metallization. Silver compounds, especially silver neodecanoate, were developed which can be applied by thick-film screening, ink-jet printing, spin-on, spray, or dip methods. Some of the advantages of MOD are: high uniform metal content, lower firing temperatures, decomposition without leaving a carbon deposit or toxic materials, and a film that is stable under ambient conditions. Molecular design criteria were explained along with compounds formulated to date, and the accompanying reactions for these compounds. Phase stability and the other experimental and analytic results of MOD films were presented.
Two new X-(7.2 GHz up, 8.4 GHz down) and S-band (2.1 to 2.3 Ghz) common aperture (XSC) feedcones are being added to the DSS 45 and DSS 65 34-Meter Efficiency Antennas. These new feedcones are modifications of the existing SXC feedcone design incorporating a new high power (20-kW) X-band transmitter. The modified Antenna Microwave Subsystem design also incorporates two additional X-band low noise amplifiers and greater phase stability performance to meet both the increased stability requirements for Galileo gravity wave experiments and requirements for spacecraft navigation near the Sun. A third XSC will be constructed for DSS 15 later.
The prospects for applying aperture-synthesis interferometry to the optical domain are reviewed. The radio examples such as the VLA provide a model, since the concepts are equally valid for radio and optical wavelengths. If scientific problems at the milliarc-second resolution level (or better) are to be addressed, a space-based optical array seems to be the only practical alternative, for the same reasons that dictated array development at radio wavelengths. One concept is examined, and speculations are offered concerning the prospects for developing real systems. Phase-coherence is strongly desired for a practical array, although self-calibration and phase-closure techniques allow one to relax the restriction on absolute phase stability. The design of an array must be guided by the scientific problems to be addressed.
A fine resolution polarimetric FM SAR was developed for optimization of polarimetric SARs and interpretation of SAR data via controlled experiments with surface-base sensors. The system is designed for collecting polarimetric data at 5.3 and 10 GHz over incidence angles from 0 to 60 deg. Features of the system include broad bandwidth to obtain fine range resolution, phase stabilization and linearization loop circuitry, and digital signal processing capability. The system is used in a research program to collect polarimetric backscatter data from artificial sea ice research and design trade-offs, laboratory and field evaluation, as well as results from experiments on artificial sea ice are presented.