Search NASA⌕ Search

SEARCH · Search NASA

Results for “quantitative”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 289 records · Page 16
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

A theoretical/experimental program to develop active optical pollution sensors: Quantitative remote Raman lidar measurements of pollutants from stationary sources

Typical pollutant gas concentrations at the stack exits of stationary sources can be estimated to be about 500 ppm under the present emission standards. Raman lidar has a number of advantages which makes it a valuable tool for remote measurements of these stack emissions. Tests of the Langley Research Center Raman lidar at a calibration tank indicate that night measurements of SO2 concentrations and stack opacity are possible. Accuracies of 10 percent are shown to be achievable from a distance of 300 m within 30 min integration times for 500 ppm SO2 at the stack exits. All possible interferences were examined quantitatively (except for the fluorescence of aerosols in actual stack emissions) and found to have negligible effect on the measurements. An early test at an instrumented stack is strongly recommended.

Poultney, S. K.↗
NASA NTRS1975

Quantitative determination of smoke and toxic product potential of materials with the AMINCO (registered) NBS smoke density chamber

Quantitative measurements of smoke obscuration produced by standard area samples under high energy pyrolysis both with and without an ignition source, using a collimated vertical light beam in conjunction with an ultra-linear photomultiplier microphotometer are obtainable with the smoke density chamber. Results are expressed in dimensionless specific optical density permitting usage calculations in accordance with a geometric relationship.

Greenberg, S.↗
NASA NTRS1975

Quantitative water quality with LANDSAT and Skylab

Correlation studies were completed between LANDSAT Multispectral Scanner (MSS) band ratios derived from computer compatible tape (CCT) and 170 water samples taken from three large Kansas reservoirs, coincident with 16 different LANDSAT passes over a 13 month period. The following conclusions were obtained: (1) LANDSAT MSS reflectance levels are useful for quantitative measurement of suspended solids up to at least 900 ppm, (2) MSS band ratios derived from CCT can measure suspended solids with 67% confidence level accuracy of 12 ppm over the range 0-80 ppm and 35 ppm over the range 0900 ppm, (3) suspended solids contour maps can be easily constructed from CCT for water bodies larger than approximately 100 acres, (4) rationing suppresses MSS reflectance level dependence on seasonal sun angle variation and permits measurement of suspended load the year round in the middle latitudes. SKYLAB imagery from a single pass over three reservoirs compares favorably to LANDSAT results up to 100 ppm.

Yarger, H. L.↗
NASA NTRS1976

An evaluation of recent quantitative magnetospheric magnetic field models

Magnetospheric field models involving dipole tilt effects are discussed, with particular reference to defined magnetopause models and boundary surface models. The models are compared with observations and with each other whenever possible. It is shown that models containing only contributions from magnetopause and tail current systems are capable of reproducing the observed quiet time field just in a qualitative way. The best quantitative agreement between models and observations take place when currents distributed in the inner magnetosphere are added to the magnetopause and tail current systems. One region in which all the models fall short is the region around the polar cusp. Obtaining physically reasonable gradients should have high priority in the development of future models.

Walker, R. J.↗
NASA NTRS1977

Quantitative measurement of surface contamination

Portable and highly sensitive system permits quantitative determinations on test surfaces. Device is used in normal room light and permits detection of significantly smaller samples. Digitation of output permits easy evaluation of contamination cleanup techniques.

Richmond, R. G.↗
NASA NTRS1976

Quantitative determination of zero-gravity effects on crystal growth from the melt (experiment MA-060)

The purpose of experiment MA-060 was to investigate quantitatively the effects of near-zero gravity conditions on crystal growth and dopant segregation during directional solidification from the melt. Gallium-doped germanium single crystals were successfully grown from the melt with simultaneous interface demarcation during the Apollo Soyuz Test Project mission. The analysis of the experimental data indicates striking differences of dopant segregation and growth behavior in the presence and absence of gravity. The results obtained are believed to have far-reaching implications on materials processing under zero-gravity conditions and on the theory of crystal growth and segregation in general.

Gatos, H. C.↗
NASA NTRS1975

Clinical applications of a quantitative analysis of regional lift ventricular wall motion

Observations were summarized which may have clinical application. These were obtained from a quantitative analysis of wall motion that was used to detect both hypokinesis and tardokinesis in left ventricular cineangiograms. The method was based on statistical comparisons with normal values for regional wall motion derived from the cineangiograms of patients who were found not to have heart disease.

Leighton, R. F.↗
NASA NTRS1975

Clinical application of a light-pen computer system for quantitative angiography

The important features in a clinical system for quantitative angiography were examined. The human interface for data input, whether an electrostatic pen, sonic pen, or light-pen must be engineered to optimize the quality of margin definition. The computer programs which the technician uses for data entry and computation of ventriculographic measurements must be convenient to use on a routine basis in a laboratory performing multiple studies per day. The method used for magnification correction must be continuously monitored.

Alderman, E. L.↗
NASA NTRS1975

Quantitative analysis of regional myocardial performance in coronary artery disease

Findings from a group of subjects with significant coronary artery stenosis are given. A group of controls determined by use of a quantitative method for the study of regional myocardial performance based on the frame-by-frame analysis of biplane left ventricular angiograms are presented. Particular emphasis was placed upon the analysis of wall motion in terms of normalized segment dimensions, timing and velocity of contraction. The results were compared with the method of subjective assessment used clinically.

Stewart, D. K.↗
NASA NTRS1975

Quantitative multielement analysis using high energy particle bombardment

Charged particles ranging in energy from 0.8 to 4.0 MeV are used to induce resonant nuclear reactions, Coulomb excitation (gamma-rays), and X-ray emission in both thick and thin targets. Quantitative analysis is possible for elements from Li to Pb in complex environmental samples, although the matrix can severely reduce the sensitivity. It is necessary to use a comparator technique for the gamma-rays while for X-rays an internal standard can be used. A USGS standard rock is analyzed for a total of 28 elements. Water samples can be analyzed either by nebulizing the sample doped with Cs or Y a thin Formvar film or by extracting the sample onto ion exchange resin which is pressed into a pellet.

Clark, P. J.↗
NASA NTRS1976

Survey of quantitative data on the solar energy and its spectra distribution

This paper presents a survey of available quantitative data on the total and spectral solar irradiance at ground level and outside the atmosphere. Measurements from research aircraft have resulted in the currently accepted NASA/ASTM standards of the solar constant and zero air mass solar spectral irradiance. The intrinsic variability of solar energy output and programs currently under way for more precise measurements from spacecraft are discussed. Instrumentation for solar measurements and their reference radiation scales are examined. Insolation data available from the records of weather stations are reviewed for their applicability to solar energy conversion. Two alternate methods of solarimetry are briefly discussed.

Thekaekara, M. P.↗
NASA NTRS1977

Quantitative mapping of chlorophyll a distributions in coastal zones by remote sensing

Results of experiments conducted in the James River, Virginia and the New York Bight indicate that concurrently collected sea-truth measurements may be used to calibrate remotely sensed multispectral scanner data collected over each of these environmentally different scenes. Statistical stepwise regression analysis was used in both experiments to incorporate significant bands of MSS data into regression equations that quantitatively relate remotely sensed data to water quality parameters, such as chlorophyll a and suspended sediment. These regression equations are used to map synoptic distributions of chlorophyll a in the remotely sensed scenes.

Johnson, R. W.↗
NASA NTRS1977

Quantitative density visualization in a transonic compressor rotor

The flow in a 59-cm-diameter high-work transonic compressor rotor has been visualized using a fluorescent gas, 2,3, butanedione, as a tracer. The technique allows the three-dimensional flow to be imaged as a set of distinct planes. Quantitative static density maps were obtained by correcting the images for distortion and nonlinearities introduced by the illumination and imaging systems. These images and maps were used to analyze the three-dimensional nature of the blade's boundary layer and shock system.

Epstein, A. H.↗
NASA NTRS1978

Quantitative mapping by remote sensing of an ocean acid-waste dump

Results from quantitative analysis show that airplane remotely sensed spectral data can be used to quantify and map an acid-waste dump in terms of its particulate iron concentration. These same data, however, could not be used to map the dump in terms of total suspended solids, organic suspended solids, or inorganic suspended solids concentrations. A single-variable equation using the ratio of band 2 (440 to 490 nm) radiance to band 4 (540 to 580 nm) radiance was used to quantify the iron concentration in the acid-waste dump. The acid waste that was mapped varied in age from freshly dumped to 31/2 hr. Particulate iron concentrations in the acid waste were estimated to range up to 1.1 mg/l at a depth of 0.46 m. A classification technique was developed to identify pixels in the data set affected by sun glitter.

Ohlhorst, C. W.↗
NASA NTRS1977

Quantitative remote measurements of pollutants from stationary sources using Raman lidar

The several advantages of Raman lidar for remote measurements of stationary source emissions were quantitatively evaluated using a calibration tank at a distance of 300 m at night. Measurements of approximately 10 to the 3rd ppm SO2 with a 12% accuracy were demonstrated in an observation time of 15 min using a 1.5-J ruby laser at 30 pulses/min, 6-m range resolution, interference filters, photon counting detection, and a 20-cm receiver. Measurement accuracy was checked by measuring known concentrations of SO2 in the tank, by tuning the interference filters through the SO2 Raman line, and by varying the CO2 concentration to very high levels during the SO2 measurements. Evaluation of the seriousness of induced fluorescence from plume aerosols failed due to the inability to simulate the plume aerosols.

Poultney, S. K.↗
NASA NTRS1977

Quantitative comparison of combined gas chromatographic/mass spectrometric profiles of complex mixtures

The paper describes a method called HISLIB for automatic quantitative comparison of gas chromatographic/mass spectrometric (GC/MS) results obtained on complex mixtures of organic compounds. The method is based on comparing new mixtures to 'historical' libraries of previous results. Co-occurrence of components is determined by matching relative retention indices (RRIs) and mass spectra after background removal and resolution of overlapping GC components. Internal standards are used to quantify the relative concentrations of components. Applications of HISLIB include validation of analytical procedures to isolate complex mixtures; development of historical libraries which might include complete summaries of all past observations, compilations of controls, or any other selected subset of results; improvement of the quality of existing libraries of mass spectral data; and detection of differences in kind and/or amounts of individual components. Limitations of the method are mentioned along with causes of their occurrence.

Smith, D. H.↗
NASA NTRS1979

Quantitative Analysis of Radar Returns from Insects

When a number of flying insects is low enough to permit their resolution as individual radar targets, quantitative estimates of their aerial density are developed. Accurate measurements of heading distribution using a rotating polarization radar to enhance the wingbeat frequency method of identification are presented.

Riley, J. R.↗