Search NASA⌕ Search

SEARCH · Search NASA

Results for “AIRCRAFT WAKE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 307 records · Page 17
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Measurements in 80- by 120-foot wind tunnel of hazard posed by lift-generated wakes

The large, low speed wind tunnel at NASA-Ames has been used to study the characteristics of lift-generated vortices involved in the definition of aircraft-separation criteria, in order to enhance airport capacity without compromising safety. Attention is given to the potential hazard caused by the vortex wake of several configurations of a subsonic transport. Measured downwash distributions in the wake of three different wake-generator configurations are obtained by means of a vortex-lattice method, in order to predict the lift and rolling moment on several models of wake-following aircraft.

Rossow, V. J.↗
NASA NTRS1977

Demonstration of rapid-scan two-dimensional laser velocimetry in the Langley Vortex Research Facility for research in aerial applications

Tests were conducted to demonstrate a rapid scan two dimensional laser velocimeter (LV) measurement technique for aerial applications research. The LV system is capable of simultaneously measuring both vertical and axial flow velocity components in a near or far field vortex system. Velocity profiles were successfully measured in the wake vortex of a representative agricultural aircraft model, with the vortex system rapidly transporting in ground effect. Results indicate that the laser velocimetry technique can provide quantitative information of wake vortex characteristics in ground effect.

Gartrell, L. R.↗
NASA NTRS1993

NASA wake vortex research

NASA is conducting research that will enable safe improvements in the capacity of the nation's air transportation system. The wake-vortex hazard is a factor in establishing the minimum safe spacing between aircraft during landing and takeoff operations and, thus, impacts airport capacity. The ability to accurately model the wake hazard and determine safe separation distances for a wide range of aircraft and operational scenarios may provide the basis for significant increases in airport capacity. Current and planned NASA research is described which is focused on increasing airport capacity by safely reducing wake-hazard-imposed aircraft separations through advances in a number of technologies including vortex motion and decay prediction, vortex encounter modeling, wake-vortex hazard characterization, and in situ flow sensing.

Stough, H. P., III↗
NASA NTRS1980

Operational implications of some NACA/NASA rotary wing induced velocity studies

Wind tunnel measurements show that the wake of a rotor, except at near-hovering speeds, is not like that of a propeller. The wake is more like that of a wing except that, because of the slow speeds, the wake velocities may be much greater. The helicopter can produce a wake hazard to following light aircraft that is disproportionately great compared to an equivalent fixed-wing aircraft. This hazard should be recognized by both pilots and airport controllers when operating in congested areas. Even simple momentum theory shows that, in autorotation and partial-power descent, the required power is a complex function of both airspeed and descent angle. The nonlinear characteristic, together with an almost total lack of usable instrumentation at low airspeeds, has led to numerous power-settling accidents. The same theory shows that there is a minimum forward speed at which a rotor can autorotate. Neglect of, or inadequate appraisal of this minimum speed has also led to numerous accidents. Ground effect and the problems it creates is discussed.

Heyson, H. H.↗
NASA NTRS1980

Some wake-related operational limitations of rotorcraft

Wind tunnel measurements show that the wake of a rotor, except at near hovering speeds, is not like that of a propeller. The wake is more like that of a wing except that, because of the slow speeds, the wake velocities may be much greater. The helicopter can produce a wake hazard to following light aircraft that is disproportionately great compared to an equivalent fixed wing aircraft. This hazard should be recognized by both pilots and airport controllers when operating in congested areas. Ground effect is generally counted as a blessing since it allows overloaded takeoffs; however, it also introduces additional operation problems. These problems include premature blade stall in hover, settling in forward transition, shuddering in approach to touchdown and complicatons with yaw control. Some of these problems were treated analytically in an approximate manner and reasonable experiment agreement was obtained. An awareness of these effects can prepare the user for their appearance and their consequences.

Heyson, H. H.↗
NASA NTRS1981

Wake Vortex Attenuation Flight Tests: A Status Report

Flight tests were conducted to evaluate the magnitude of aerodynamic attenuation of the wake vortices of large transport aircraft that can be achieved through the use of static spoiler deflection and lateral control oscillation. These methods of attenuation were tested on Boeing B-747 and Lockheed L-1011 commercial transport aircraft. Evaluations were made using probe aircraft, photographic and visual observations, and ground based measurements of the vortex velocity profiles. The magnitude of attenuation resulting from static spoiler deflection was evaluated both in and out of ground effect. A remotely piloted QF-86 drone aircraft was used to probe the attenuated vortices in flight in and out of ground effect, and to make landings behind an attenuated B-747 airplane at reduced separation distances.

Barber, Marvin R.↗
NASA NTRS1990

Control of submersible vortex flows

Vortex flows produced by submersibles typically unfavorably influence key figures of merit such as acoustic and nonacoustic stealth, control effectiveness/maneuverability, and propulsor efficiency/body drag. Sources of such organized, primarily longitudinal, vorticity include the basic body (nose and sides) and appendages (both base/intersection and tip regions) such as the fairwater, dive planes, rear control surfaces, and propulsor stators/tips. Two fundamentally different vortex control approaches are available: (1) deintensification of the amplitude and/or organization of the vortex during its initiation process; and (2) downstream vortex disablement. Vortex control techniques applicable to the initiation region (deintensification approach) include transverse pressure gradient minimization via altered body cross section, appendage dillets, fillets, and sweep, and various appendage tip and spanload treatment along with the use of active controls to minimize control surface size and motions. Vortex disablement can be accomplished either via use of control vortices (which can also be used to steer the vortices off-board), direct unwinding, inducement of vortex bursting, or segmentation/tailoring for enhanced dissipation. Submersible-applicable vortex control technology is also included derived from various aeronautical applications such as mitigation of the wing wake vortex hazard and flight aircraft maneuverability at high angle of attack as well as the status of vortex effects upon, and mitigation of, nonlinear control forces on submersibles. Specific suggestions for submersible-applicable vortex control techniques are presented.

Bushnell, D. M.↗
NASA NTRS1995

Vortex wakes of rotorcraft

This paper presents an overview of the complex unsteady vortical flows that comprise the wakes of rotary-wing aircraft; of the effects these tangled vortical structures have on the performance, noise, and vibration; and of some of the recent attempts to measure, predict, and control the phenomena. The main points are illustrated with a number of examples from the recent literature and technical conferences.

Mccroskey, W. J.↗
NASA NTRS2001

Changes in Cirrus Cloudiness and their Relationship to Contrails

Condensation trails, or contrails, formed in the wake of high-altitude aircraft have long been suspected of causing the formation of additional cirrus cloud cover. More cirrus is possible because 10 - 20% of the atmosphere at typical commercial flight altitudes is clear but ice-saturated. Since they can affect the radiation budget like natural cirrus clouds of equivalent optical depth and microphysical properties, contrail -generated cirrus clouds are another potential source of anthropogenic influence on climate. Initial estimates of contrail radiative forcing (CRF) were based on linear contrail coverage and optical depths derived from a limited number of satellite observations. Assuming that such estimates are accurate, they can be considered as the minimum possible CRF because contrails often develop into cirrus clouds unrecognizable as contrails. These anthropogenic cirrus are not likely to be identified as contrails from satellites and would, therefore, not contribute to estimates of contrail coverage. The mean lifetime and coverage of spreading contrails relative to linear contrails are needed to fully assess the climatic effect of contrails, but are difficult to measure directly. However, the maximum possible impact can be estimated using the relative trends in cirrus coverage over regions with and without air traffic. In this paper, the upper bound of CRF is derived by first computing the change in cirrus coverage over areas with heavy air traffic relative to that over the remainder of the globe assuming that the difference between the two trends is due solely to contrails. This difference is normalized to the corresponding linear contrail coverage for the same regions to obtain an average spreading factor. The maximum contrail-cirrus coverage, estimated as the product of the spreading factor and the linear contrail coverage, is then used in the radiative model to estimate the maximum potential CRF for current air traffic.

Minnis, Patrick↗
NASA NTRS2001

Influence of Wake Models on Calculated Tiltrotor Aerodynamics

The tiltrotor aircraft configuration has the potential to revolutionize air transportation by providing an economical combination of vertical take-off and landing capability with efficient, high-speed cruise flight. To achieve this potential it is necessary to have validated analytical tools that will support future tiltrotor aircraft development. These analytical tools must calculate tiltrotor aeromechanical behavior, including performance, structural loads, vibration, and aeroelastic stability, with an accuracy established by correlation with measured tiltrotor data. The recent test of the Tilt Rotor Aeroacoustic Model (TRAM) with a single,l/4-scale V-22 rotor in the German-Dutch Wind Tunnel (DNW) provides an extensive set of aeroacoustic, performance, and structural loads data. This paper will examine the influence of wake models on calculated tiltrotor aerodynamics, comparing calculations of performance and airloads with TRAM DNW measurements. The calculations will be performed using the comprehensive analysis CAMRAD II.

Johnson, Wayne↗
NASA NTRS1995

Evaluation of Computer Aided Vortex Forecast System

Several countries, including the United States. Canada, Germany, England and Russia, are in the process of trying to develop some sort of computer-aided system that will guide controllers at airports on the hazard posed by lift-generated vortices that trail behind subsonic transport aircraft. The emphasis on this particular subject has come about because the hazard posed by wake vortices is currently the only reason why aircraft are spaced at 3 to 6 miles apart during landing and takeoff rather than something like 2 miles. It is well known that under certain weather conditions, aircraft spacings can be safely reduced to as little as the desired 2 miles. In an effort to perhaps capitalize on such a possibility, a combined FAA and NASA program is currently underway in the United States to develop such a system. Needless to say, the problems associated with anticipating the required separation distances when weather conditions are involved is very difficult. Similarly, Canada has a corresponding program to develop a vortex forecast system of their own.

Rossow, Vernon J.↗
NASA NTRS1976

A nonlinear finite-element analysis of wings in steady incompressible flows with wake roll-up

The problem of lifting surfaces and complex aircraft configurations in steady incompressible flow is considered. For lifting surfaces the problem is formulated in terms of an integral equation relating the potential discontinuity on wing and wake to the normal derivative of the potential on the lifting surface. For complex configurations the problem is formulated in terms of an integral equation relating the potential to its normal derivative on the surface of the aircraft. The integral equation is approximated by a system of linear algebraic equations obtained by dividing the surfaces into small quadrilateral elements and by assuming the potential (or the potential discontinuity) and its normal derivative to be constant within each element. The wake geometry is obtained by iteration by satisfying the condition that the velocity be tangent to the surface of the wake and that the potential discontinuity be constant along the streamlines.

Suciu, E. O.↗
NASA NTRS1987

Fundamental issues in the calculation of rotor wakes

The structure of a helicopter rotor wake and its effects on the aircraft aerodynamics and aeroacoustics are characterized, reviewing the results of recent analytical investigations. The focus is on the role of vortex structure and stability, and consideration is given to Lagrangian computational approaches, two-dimensional and three-dimensional representations of rotor wakes, vortex-sheet rollup computations, and the role of flow instability in the calculation of three-dimensional vortex sheets. Sample results from the author's studies (Sugioka and Widnall, 1985; Kantelis and Widnall, 1986) are presented in graphs and briefly discussed.

Widnall, Sheila↗
NASA NTRS2014

Evaluation of Fast-Time Wake Vortex Models using Wake Encounter Flight Test Data

This paper describes a methodology for the integration and evaluation of fast-time wake models with flight data. The National Aeronautics and Space Administration conducted detailed flight tests in 1995 and 1997 under the Aircraft Vortex Spacing System Program to characterize wake vortex decay and wake encounter dynamics. In this study, data collected during Flight 705 were used to evaluate NASA's fast-time wake transport and decay models. Deterministic and Monte-Carlo simulations were conducted to define wake hazard bounds behind the wake generator. The methodology described in this paper can be used for further validation of fast-time wake models using en-route flight data, and for determining wake turbulence constraints in the design of air traffic management concepts.

Ahmad, Nashat N.↗
NASA NTRS1997

On Use of Global Positioning Technology for Solution of Wake Vortex Problem

Improved precision of the flight paths used by aircraft to approach and depart airports is becoming available when the Global Positioning System (GPS) is implemented at airports. An overview will be given of published information on how GPS precision guidance at airports can be used to avoid encounters with the lift-generated vortices shed by preceding aircraft during landing. It is pointed out that GPS provides two needed services to bring about improved avoidance capability. Firstly, GPS pseudolites are being built and installed at airports so that, when coupled with autopilot systems currently available on subsonic transport aircraft, the aircraft can make precision approaches for zero visibility landings. The same equipment can also be used for precision approaches for wake-vortex avoidance. Secondly, regular monitoring of atmospheric motions along the approach corridor can be obtained by use of GPS equipment on board aircraft that are in the flight corridors. That is, wind velocity is determined by use of GPS equipment to measure the ground speed of the aircraft and then combined with onboard instrumentation to measure the airspeed of the aircraft. The difference between the two measurements yields the wind velocity. When the measured wind velocities are transmitted to an airport ground station they are used to monitor whether air motions adverse for safety in the flight corridor are present. If any parts of the corridor are unsafe, the spacing of the aircraft, or the location of the flight corridor being used, is modified. It is estimated that the spacings between any combination of aircraft can then be safely reduced to a uniform 3 n. mi. Information to be presented is contained in an article published in the AIAA Journal of Aircraft, May-June 1996.

Rossow, Vernon J.↗
NASA NTRS1977

Aerodynamic characteristics of a 1/6-scale powered model of the rotor systems research aircraft

A wind-tunnel investigation was conducted to determine the effects of the main-rotor wake on the aerodynamic characteristics of the rotor systems research aircraft (RSRA). For the investigation, a 1/6-scale model with a four-blade articulated main rotor was used. Tests were conducted with and without the main rotor. Both the helicopter and the compound helicopter were tested. The latter configuration included the auxiliary thrust engines and the variable-incidence wing. Data were obtained over ranges of angle of attack, angle of sideslip, and main-rotor collective pitch angle at several main-rotor advance ratios. Results are presented for the total loads on the airframe as well as the loads on the rotor, the wing, and the tail. The results indicated that without the effect of the rotor wake, the RSRA had static longitudinal and directional stability and positive effective dihedral. With the effect of the main rotor and its wake, the RSRA exhibited longitudinal instability but retained static directional stability and positive effective dihedral.

Mineck, R. E.↗