Search NASA⌕ Search

SEARCH · Search NASA

Results for “Aircraft stability and control”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 307 records · Page 17
All sourcesNASA NTRSDOE OSTI
NASA NTRS1961

Rapid-Transition Tests of a 1/4-Scale Model of the VZ-2 Tilt-Wing Aircraft

An investigation of the longitudinal stability and control characteristics of a 1/4-scale model of the VZ-2 tilt-wing vertical-take-off- and-landing aircraft during rapid transitions has been made on the Langley control-line facility. Only the longitudinal characteristics were studied because with the control-line technique the other phases of the model motion are partially restrained. The rapid transitions from hovering to forward flight could be performed easily at any of the accelerations attempted; whereas, the transitions from forward flight to hovering were generally accompanied by a strong nose up pitching moment which at times was uncontrollable because of an inadequate amount of available pitch control. The model was more difficult to control during rapid decelerations than during slow decelerations and was also more difficult to control for rearward center-of-gravity conditions than for forward ones.

Tosti, Louis P.↗
NASA NTRS1984

The drive for Aircraft Energy Efficiency

NASA's Aircraft Energy Efficiency (ACEE) program, which began in 1976, has mounted a development effort in four major transport aircraft technology fields: laminar flow systems, advanced aerodynamics, flight controls, and composite structures. ACEE has explored two basic methods for achieving drag-reducing boundary layer laminarization: the use of suction through the wing structure (via slots or perforations) to remove boundary layer turbulence, and the encouragement of natural laminar flow maintenance through refined design practices. Wind tunnel tests have been conducted for wide bodied aircraft equipped with high aspect ratio supercritical wings and winglets. Maneuver load control and pitch-active stability augmentation control systems reduce fuel consumption by reducing the drag associated with high aircraft stability margins. Composite structures yield lighter airframes that in turn call for smaller wing and empennage areas, reducing induced drag for a given payload. In combination, all four areas of development are expected to yield a fuel consumption reduction of 40 percent.

James, R. L., Jr.↗
NASA NTRS1974

Estimation of nonlinear aerodynamic derivatives of a variable geometry fighter aircraft from flight data

This paper is concerned with the estimation of stability and control parameters of a high performance fighter aircraft from data obtained from high angle of attack flight. The estimation process utilizes a maximum likelihood algorithm derived for the case of a nonlinear aerodynamic force and moment model. The aircraft used was a high speed variable sweep heavy weight fighter with twin vertical tails. Comparisons of results from the nonlinear analysis are made with linear theory and wind tunnel results when available.

Ramachandran, S.↗
NASA NTRS1997

Coupling Dynamics in Aircraft: A Historical Perspective

Coupling dynamics can produce either adverse or beneficial stability and controllability, depending on the characteristics of the aircraft. This report presents archival anecdotes and analyses of coupling problems experienced by the X-series, Century series, and Space Shuttle aircraft. The three catastrophic sequential coupling modes of the X-2 airplane and the two simultaneous unstable modes of the X-15 and Space Shuttle aircraft are discussed. In addition, the most complex of the coupling interactions, inertia roll coupling, is discussed for the X-2, X-3, F-100A, and YF-102 aircraft. The mechanics of gyroscopics, centrifugal effect, and resonance in coupling dynamics are described. The coupling modes discussed are interacting multiple degrees of freedom of inertial and aerodynamic forces and moments. The aircraft are assumed to be rigid bodies. Structural couplings are not addressed. Various solutions for coupling instabilities are discussed.

Day, Richard E.↗
NASA NTRS1978

Modeling and parameter uncertainties for aircraft flight control system design

As aircraft designs trend toward further applications of control-configured vehicle concepts, aircraft control systems increasingly rely on stability augmentation to obtain normal flying qualities and reasonable structural margins. Although the control system designer would choose to have a perfect dynamic description of the vehicle, he knows that a level of uncertainty of plant dynamics will exist. This paper gives typical values of plant uncertainties for some recent aircraft design and development programs. Histories of pertinent aerodynamic, inertial, and structural parameters from program initiation to aircraft certification are given. These data can be used as typical of future vehicles so that control system design concepts can be evaluated with due consideration to their sensitivity to uncertainties in plant dynamics.

Rickard, W. W.↗
NASA NTRS1980

Leading-edge 'Vortex Flaps' for enhanced subsonic aerodynamics of slender wings

The 'Vortex Flap' is a novel concept aimed at reducing the lift-dependent drag due to leading-edge flow separation on highly swept, slender wings at high angles of attack. The suction effect of coiled vortices generated via controlled separation over leading-edge flap surfaces is utilized to produce an aerodynamic thrust component. This principle was verified through wind-tunnel experiments on 74-deg and 60-deg delta wings and a supersonic-cruise slender wing aircraft configuration. Adaptation of the vortex-flap for augmentation of roll-control on the 74-deg delta at high angles of attack also was demonstrated. Selected results are presented in this paper to indicate the potential of the vortex flap concept to enhance the low-speed performance, stability and control of slender wing aircraft.

Rao, D. M.↗
NASA NTRS1977

Maximum likelihood estimation of aerodynamic derivatives for an oblique wing aircraft from flight data

There are several practical problems in using current techniques on 5-degree-of-freedom equations to estimate the stability and control derivatives of oblique wing aircraft from flight data. A technique has been developed to estimate these derivatives by separating the analysis of the longitudinal and lateral-directional motion without neglecting cross-coupling effects. This technique was used on flight data from a remotely piloted oblique wing aircraft. The results demonstrated that the relatively simple approach developed was adequate to obtain high quality estimates of the aerodynamic derivatives of such aircraft.

Maine, R. E.↗
NASA NTRS1976

Design of a control configured tanker aircraft

The benefits that accrue from using control configured vehicle (CCV) concepts were examined along with the techniques for applying these concepts to an advanced tanker aircraft design. Reduced static stability (RSS) and flutter mode control (FMC) were the two primary CCV concepts used in the design. The CCV tanker was designed to the same mission requirements specified for a conventional tanker design. A seven degree of freedom mathematical model of the flexible aircraft was derived and used to synthesize a lateral stability augmentation system (SAS), a longitudinal control augmentation system (CAS), and a FMC system. Fatigue life and cost analyses followed the control system synthesis, after which a comparative evaluation of the CCV and conventional tankers was made. This comparison indicated that the CCV weight and cost were lower but that, for this design iteration, the CCV fatigue life was shorter. Also, the CCV crew station acceleration was lower, but the acceleration at the boom operator station was higher relative to the corresponding conventional tanker. Comparison of the design processes used in the CCV and conventional design studies revealed that they were basically the same.

Walker, S. A.↗
NASA NTRS1976

RSRA flight control and stabilization

Handling qualities of the RSRA (rotor systems research aircraft), a special test vehicle with optional configurations (forewings, removable horizontal tailplanes, main rotor, tail rotor, and twin engines for forward flight all removable), are described. The aircraft can be fitted to fly as a conventional rotary-wing aircraft, fixed-wing aircraft, or compound helicopter, and is designed for testing existing and future rotor systems in flight. Controls include full-authority fly-by-wire controls and mechanical controls for rotary wing and for fixed wing. Stability augmentation, rotor test measurement systems, variable center of gravity capability, and rotor loading potential of the RSRA are also described.

Linden, A. W.↗
NASA NTRS2001

An Experimental Evaluation of Generalized Predictive Control for Tiltrotor Aeroelastic Stability Augmentation in Airplane Mode of Flight

The results of a joint NASA/Army/Bell Helicopter Textron wind-tunnel test to assess the potential of Generalized Predictive Control (GPC) for actively controlling the swashplate of tiltrotor aircraft to enhance aeroelastic stability in the airplane mode of flight are presented. GPC is an adaptive time-domain predictive control method that uses a linear difference equation to describe the input-output relationship of the system and to design the controller. The test was conducted in the Langley Transonic Dynamics Tunnel using an unpowered 1/5-scale semispan aeroelastic model of the V-22 that was modified to incorporate a GPC-based multi-input multi-output control algorithm to individually control each of the three swashplate actuators. Wing responses were used for feedback. The GPC-based control system was highly effective in increasing the stability of the critical wing mode for all of the conditions tested, without measurable degradation of the damping in the other modes. The algorithm was also robust with respect to its performance in adjusting to rapid changes in both the rotor speed and the tunnel airspeed.

Kvaternik, Raymond G.↗
NASA NTRSDate not supplied

Generalized Predictive Control for Active Stability Augmentation and Vibration Reduction on an Aeroelastic Tiltrotor Model

Tiltrotor aircraft are defining the state-of-the-art in vertical lift technology as they have the potential to greatly expand rotary-wing operational boundaries. However, they are often limited in forward flight speed due to complex coupled rotor and wing dynamic instabilities. The U.S. Army and NASA have been developing a new wind tunnel model, the TiltRotor Aeroelastic Stability Testbed(TRAST), to test proprotors in the NASA Langley Research Center Transonic Dynamics Tunnel (TDT) to investigate aeroelastic stability in cruise. The test is intended to provide high-quality research data for analytical tool development and validation. In addition, the TRAST model will support, develop, and mature new technologies for the design of advanced proprotor aircraft. Stability augmentation and vibration reduction during testing is planned with the use of an active control methodology known as Generalized Predictive Control(GPC). GPC is an autoregressive control law that experimentally acquires a system identification to derive the input-output relation of controls and corresponding sensors. This type of control law is especially useful for complex dynamic interactions that are difficult to explicitly model such as proprotor pylon instability, often referred to as whirl flutter. GPC has been successfully employed on other tiltrotor vehicles to suppress whirl flutter instabilities and vibrations. To aid in the characterization of the wind-tunnel model and in tool development, an analytical representation of the wind-tunnel model was developed using the rotorcraft comprehensive analysis system (RCAS) that simulates structural dynamics and aerodynamics. RCAS was used to derive state-space estimates of the physical plant at various flight conditions to test control law effectiveness. This paper will present an overview of the test article development, a description of RCAS, an explanation of the GPC methodology, and results of GPC being applied to state-space plant estimates of the TRAST model. In these simulations, GPC was effective at stabilizing the aircraft beyond the whirl-flutter boundary while simultaneously reducing vibrations across the flight regime. Additionally, a modern advancement to GPC, termed advanced GPC (AGPC), is introduced that enables a self-adapting system identification. Preliminary results show that AGPC is successful at self-correction as the plant changes from what was used for system identification.

tiltrotor↗
NASA NTRS1976

Wind-tunnel tests of a 1/4 scale model of the Bell XS-1 transonic airplane. 1: Longitudinal stability and control characteristics

A 1/4 scale model of the Bell XS-1 transonic aircraft was tested in the Langley 300 mile-per-hour 7 by 10 foot tunnel to determine its low speed longitudinal stability and control characteristics. Pertinent longitudinal flying qualities expected of the XS-1 research airplane were estimated from the results of these tests including the effects of compressibility likely to be encountered at speeds below the force break. It appears that the static longitudinal stability and elevator control power will be adequate, but that the elevator control force gradient in steady flight will be undesirably low for all configurations. It is suggested that a centering spring be incorporated in the elevator control system of the airplane in order to increase the control force gradient in steady flight and in maneuvers.

Donlan, C. J.↗