Modeling of environmental torques of a spin- stabilized spacecraft in a near-earth orbit
Computerized simulation of disturbance torques of spin stabilized spacecraft in near earth orbit
SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Computerized simulation of disturbance torques of spin stabilized spacecraft in near earth orbit
The physical charged particle dose to be encountered in low earth orbit Spacelab missions is estimated for orbits of inclinations from e8.5 to 90 deg and altitudes from 200 to 800 km. The dose encountered is strongly altitude dependent, with a weaker dependence on inclination. Doses range from 0.007 rads/day at 28.5 deg and 200 km to 1.57 rads/day at 28.5 deg and 800 km behind a 5.0 g/sq cm shield. Geomagnetically trapped protons were the primary source of damage over most of the range of altitudes and inclinations, with galactic cosmic rays making a significant contribution at the lowest altitudes.
Solar array systems have been studied and compared for earth orbital and orbit transfer missions with the principal objective of quantifying the cost tradeoffs between gallium arsenide and silicon array for specific classes of missions and system characteristics. For the missions considered, it is found that the purchase cost advantage of Si arrays is not overcome by the greater radiation resistance of GaAs arrays. The use of reflectors for concentration may significantly reduce the power system cost. However, GaAs arrays benefit considerably more from solar concentration than Si arrays in terms of mission cost because of their higher allowable temperature. In the case of orbit transfer missions, a cover glass thickness of at least 0.05 cm is recommended to reduce total mission cost.
A nickel-hydrogen cell completed 10,080 simulated low earth orbit charge/discharge cycles at depths-of-discharge ranging from 50 to 80 percent prior to failure. The cell is of the Air Force design, rated at 50 ampere-hours, 8.9 cm (3.5 inches) in diameter. Upon disassembly, the end of the polysulfone core supporting the electrode stack was found to have fractured. This allowed the electrode stack to expand. A massive short was found at the inner diameter of the electrodes centered roughly at plate set 34 to 37 from the positive end of the electrode stack. The damaged area extended through approximately one third of the electrode stack, with the effect becoming progressively less with distance from plate set 34 to 37. Measured thicknesses of the positive plates were significantly greater than the initial specification values. The postulated cause of failure is that positive plate growth caused fracture of the shoulder from the end of the polysulfone core on which the electrodes are mounted. The electrode stack relieved and pressure points were created at the area near the inner diameter of the plates at the tab attachment. A short occurred at a pressure point between opposing plates and propagated to other electrode sets due to thermal and mechanical stresses caused by the short.
A brief synopsis of the low Earth orbit (LEO) satellite environment is presented including neutral and ionic species. Two ground based atomic and molecular beam instruments are described which are capable of simulating the interaction of spacecraft surfaces with the LEO environment and detecting the results of these interactions. The first detects mass spectrometrically low level fluxes of reactively and nonreactively surface scattered species as a function of scattering angle and velocity while the second ultrahigh velocity (UHV) molecular beam, laser induced fluorescence apparatus is capable of measuring chemiluminescence produced by either gas phase or gas-surface interactions. A number of proposed experiments are described.
Computer subroutines to calculate human exposure to trapped radiations in low Earth orbit (LEO) on the basis of a simple approximation of the human geometry by spherical shell shields of varying thickness are presented and detailed. The subroutines calculate the dose to critical body organs and the fraction of exposure limit reached as a function of altitude of orbit, degree of inclination, shield thickness, and days in mission. Exposure rates are compared with current exposure limits.
A set of computer codes, which include the effects of the Earth's magnetic field, used to predict the cosmic ray environment (atomic numbers 1 through 28) for a spacecraft in a near-Earth orbit is described. A simple transport analysis is used to approximate the environment at the center of a spherical shield of arbitrary thickness. The final output is in a form (a Heinrich Curve) which has immediate applications for single event upset rate predictions. The codes will culate the time average environment for an arbitrary number (fractional or whole) of circular orbits. The computer codes were run for some selected orbits and the results, which can be useful for quick estimates of single event upset rates, are given. The codes were listed in the language HPL, which is appropriate or a Hewlett Packard 9825B desk top computer. Extensive documentation of the codes is available from COSMIC, except where explanations have been deferred to references where extensive documentation can be found. Some qualitative aspects of the effects of mass and magnetic shielding are also discussed.
Consideration is given to the facilities in earth orbit that would be required to prepare for a manned mission to Mars. It is suggested that the facilities required for the development of technology for a Mars mission include the Space Station, a variable gravity research station, and an assembly dock, in addition to ground facilities. The types of research that would be conducted at each of these facilities are examined.
The highly anisotropic nature of the radiation in the low-earth orbit has been ignored for most spacecraft shielding calculations made to date because the standard environmental models describe the omnidirectional flux only, because the varying attitude of the spacecraft in the environment is assumed to average out the effect and because of the added complexity of the calculation. The Space Station is planned to be stabilized with respect to the velocity vector and local vertical. Thus it will pass through the South Atlantic Anomaly where most of the radiation flux is encountered in much the same attitude on each pass. Any calculation including a complex shielding geometry should thus consider the angular distributuon of the incident radiation. An approximate trapped proton angular distribution is presented which includes both the 'pan caked' distribution relative to the magnetic field direction and the east-west effect which is energy dependent. This distribution is then used with a planar shielding geometry to obtain an estimate of the effect of the anisotropy on radiation dose rates in spacecraft.
Two networking issues of communications systems with medium earth orbit (MEO) satellites, namely network architectures and location determination and registration methods for hand-held terminals, are investigated in this paper. For network architecture, five candidate architectures are considered and evaluated in terms of signaling traffic. For location determination and registration, two methods are discussed and evaluated.
Because of the continuing commitment to activity in low-Earth orbit (LEO), a facility is under development to produce energetic atmospheric species, particularly atomic oxygen, with energies ranging from 5 to 80 eV. This relatively high flux facility incorporates an ion engine to produce the corresponding specie ion which is charge exchanged to produce a neutral atomic beam. Ion fluxes of around 10(exp 15) sec(exp -1) with energies of 20-70 eV have been achieved. A geometrically augmented inertially tethered charge exchanger (GAITCE) was designed to provide a large column depth of charge exchange gas while reducing the gas load to the low pressure portion of the atomic beam facility. This is accomplished using opposed containment jets which act as collisional barriers to the escape of the dense gas region formed between the jets. Leak rate gains to the pumping system on the order of 10 were achieved for moderate jet mass flows. This system provides an attractive means for the charge exchange of atomic ions with a variety of gases to produce energetic atomic beams.
The continued presence and use of silicones on spacecraft in low Earth orbit (LEO) has been found to cause the deposition of contaminant films on surfaces which are also exposed to atomic oxygen. The composition and optical properties of the resulting SiO(x)- based (where x is near 2) contaminant films may be dependent upon the relative rates of arrival of atomic oxygen, silicone contaminant and hydrocarbons. This paper presents results of in-space silicone contamination tests, ground laboratory simulation tests and analytical modeling to identify controlling processes that affect contaminant characteristics.
Hydrocarbon based polymers that are exposed to atomic oxygen in low Earth orbit are slowly oxidized which results in recession of their surface. Atomic oxygen protective coatings have been developed which are both durable to atomic oxygen and effective in protecting underlying polymers. However, scratches, pin window defects, polymer surface roughness and protective coating layer configuration can result in erosion and potential failure of protected thin polymer films even though the coatings are themselves atomic oxygen durable. This paper will present issues that cause protective coatings to become ineffective in some cases yet effective in others due to the details of their specific application. Observed in-space examples of failed and successfully protected materials using identical protective thin films will be discussed and analyzed. Proposed approaches to prevent the failures that have been observed will also be presented.
A GPS receiver flying on the High Earth Orbit (HEO) AMSAT-OSCAR 40 (AO-40) spacecraft has been returning GPS observations from high above the altitude of the GPS constellation. AO-40, an amateur radio satellite launched November 16, 2000, is currently in a low inclination, 1000 by 59000 lan altitude orbit. This low-cost experiment utilizes a mid 1990's era, 6-channel, CIA code receiver configured with high gain receiving antennas for tracking above the GPS constellation. The receiver has performed well, despite operating significantly outside of its original design environment. It has regularly returned GPS observations from points all around the orbit, with over ten weeks of GPS tracking data collected to date. Signal to noise levels as high as 48 B-Hz have been recorded near apogee, when the spacecraft was at an altitude of close to 60000 km. GPS side lobe signals have been tracked on several occasions, primarily from Block IIR GPS satellites. Although the receiver has not computed a solution in real-time, point solutions have been computed on the ground using simultaneous measurements from four satellites. This experiment has provided important experience dealing with the many challenges inherent to GPS tracking at high altitudes, and the measurements returned are providing valuable information about the characteristics of GPS signals available for future HE0 users.
As a result of the increasing number of debris in low Earth orbit (LEO), numerous national and international orbital debris mitigation guidelines recommend the removal of spacecraft and launch vehicle stages from LEO within 25 years after mission termination. The primary purpose of this action is to enhance space safety by significantly limiting the potential of future accidental collisions resulting in the creation of large numbers of new orbital debris. Likewise, the passivation of these objects, i.e., the removal of residual stored energies, while they remain in orbit is important to prevent the generation of debris via self-induced explosions. Characteristics and trends in the growth of the derelict spacecraft and launch vehicle stage populations in LEO are examined. Depending upon the final operational altitude of the vehicle, achieving the goal of orbital lifetime reduction can influence the design and deployment philosophy of a new space system. Some spacecraft and launch vehicle stages have combined their end-of-mission passivation operations with maneuvers to vacate long-lived orbital regimes. Perhaps the most dramatic demonstration of this type occurred in 2006 when a U.S. Delta IV second stage executed an unprecedented controlled-reentry maneuver from a circular orbit at an altitude near 850 km. For space systems in orbital regimes near the upper regions of LEO (i.e., between 1400 km and 2000 km altitude), maneuvers to place the vehicle above LEO might be more attractive than attempting to ensure an atmospheric reentry within 25 years, and at least one space system operator has selected this option. In some cases, careful consideration of natural orbital perturbations can also lead to reduced orbital lifetimes, although new launch constraints might need to be imposed.
There is growing interest in flying biological experiments beyond low-Earth orbit (LEO) to measure biological responses potentially relevant to those expected during a human mission to Mars. Such experiments could be payloads onboard precursor missions, including unmanned private-public partnerships, as well as small low-cost spacecraft (satellites) designed specifically for biosentinel type missions. Designing such experiments requires knowledge of the radiation environment and its interactions with both the spacecraft and the experimental payload. Information is provided here that is useful for designing such experiments.
The Commercial Low Earth Orbit (LEO) Development Program team has been working with NASA and the International Space Station (ISS) National Lab (NL) stakeholders to identify capabilities of interest to both conduct research/technology demonstrations and estimate the resources that will be needed from Commercial LEO Destinations (CLDs). Through a series of one-on-one and working group meetings with users/stakeholders, hardware items of interest to the user community were identified and converted into capabilities (e.g., centrifugation, microscope, pressure chamber, etc.). In parallel, resources needed to operate the research equipment (e.g., crew time, number of experiments, volume, etc.) were estimated in order for the CLD providers to better understand NASA’s potential future service requirements. The capabilities and the resources included in this White Paper do not represent NASA requirements. Instead, they constitute a preliminary set of potential capability and resource needs collated to guide CLD providers in appropriately sizing and outfitting their CLD designs. NASA is requesting feedback from industry on how these capabilities and resources align with their own needs as well as those of their non-NASA customers. Information on how the capabilities/resources impact the CLD designs is also requested. After assessing industry’s feedback to this white paper, NASA plans to issue a preliminary set of requirements for review.
In the mid 1960's the NASA/JPL Deep Space Network installed a global 26-meter antenna network to support a large group of Low Earth Orbiters and Highly Elliptical Orbiters. Although this network was equipped with then state-of-the-art equipment, operations were labor- intensive. A study is discussed which takes a close look at re- engineering the 26-meter antenna network from all aspects.