Search NASA⌕ Search

SEARCH · Search NASA

Results for “GLIDE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 307 records · Page 17
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Initial feasibility study of a microwave-powered sailplane as a high-altitude observation platform

It is shown that a microwave-powered sailplane can be a reasonable substitute for a satellite in some missions requiring only limited coverage of the surface of the earth. A mode of operation in which the aircraft cyclically climbs to high altitude in the beam, and then glides for several hundred kilometers, is feasible and takes advantage of the inherent forward speed of the sailplane at high altitude.

Heyson, H. H.↗
NASA NTRS1979

Development of a digital guidance and control law for steep approach automatic landings using modern control techniques

The development of a digital automatic control law for a small jet transport to perform a steep final approach in automatic landings is reported along with the development of a steady-state Kalman filter used to provide smooth estimates to the control law. The control law performs the functions of localizer and glides capture, localizer and glideslope track, decrab, and place. The control law uses the microwave landing system position data, and aircraft body-mounted accelerators, attitude and attitude rate information. The results obtained from a digital simulation of the aircraft dynamics, wind conditions, and sensor noises using the control law and filter developed are described.

Halyo, N.↗
NASA NTRS1978

Large engines and vehicles, 1958

During the mid-1950s, the Air Force sponsored work on the feasibility of building large, single-chamber engines, presumably for boost-glide aircraft or spacecraft. In 1956, the Army missile development group began studies of large launch vehicles. The possibilities opened up by Sputnik accelerated this work and gave the Army an opportunity to bid for the leading role in launch vehicles. The Air Force had the responsibility for the largest ballistic missiles and hence a ready-made base for extending their capability for spaceflight. During 1958, actions taken to establish a civilian space agency, and the launch vehicle needs seen by its planners, added a third contender to the space vehicle competition. These activities during 1958 are examined as to how they resulted in the initiation of a large rocket engine and the first large launch vehicle.

Source record↗
NASA NTRS1978

Optimum reentry trajectories of a lifting vehicle

The optimum maneuver of a space shuttle vehicle reentering a spherical, stationary, and locally exponential atmosphere was investigated. The use of Chapman's modified variables and a rescaled lift-drag polar leads to the formulation of a set of dimensionless equations of motion for flight analysis. The resulting equations are exact in the sense that they are also valid for flight in the vacuum. For planar flight several typical optimum maneuvers are investigated at different altitude ranges, low, moderate and very high. For three-dimensional flight, the procedure to solve the optimum trajectory for maximum cross range is discussed. Finally, using the equilibrium glide condition the maximum cross ranges for entry from circular speed, for several values of E*, and the footprint for E* = 1.5 are computed in this reduced problem.

Chern, J. S.↗
NASA NTRS1979

Fixed-base simulation study of decoupled longitudinal controls during approach and landing of a medium jet transport in the presence of wind shear

The use of decoupled longitudinal controls during the approach and landing of a typical twin-engine jet transport in the presence of wind shear was studied. The simulation included use of a localizer and flight director to capture and maintain a 3 deg glide slope. The pilot then completed the landing by using visual cues provided below an altitude of 200 m by closed-circuit television and a terrain model. The decoupled controls used constant prefilter and feedback gains to provide steady state decoupling of flight path angle, pitch angle, and forward velocity. The use of the decoupled control system improved pilot performance during the approach and at touchdown in the presence of wind shears. The pilots preferred the decoupled controls and rated the task 1 to 3 increments better on a pilot rating scale, depending on wind conditions, than was the case when conventional controls were used.

Miller, G. K., Jr.↗
NASA NTRS1978

Experimental evaluation of a wind shear alert and energy management display

A method is proposed for onboard measurement and display of specific windshear and energy management data derived from an air data computer. An open-loop simulation study is described which was carried out to verify the feasibility of this display concept, and whose results were used as a basis to develop the respective cockpit instrumentation. The task was to fly a three-degree landing approach under various shear conditions with and without specific information on the shear. Improved performance due to augmented cockpit information was observed. Critical shears with increasing tailwinds could be handled more consistently and with less deviation from the glide path.

Kraiss, K.-F.↗
NASA NTRS1979

Stability of sequences generated by nonlinear differential systems

A local stability analysis is presented for both the analytic and numerical solutions of the initial value problem for a system of ordinary differential equations. It is shown that, using a proper choice of Liapunov function, a connected region of stable initial values of both the analytic solution and the one-leg k-step numerical solution can be approximated. Attention is given to the example of the two-dimensional problem involving the stability of the longitudinal equations of motion of a gliding jet aircraft.

Brown, R. L.↗
NASA NTRS1979

Three-dimensional optimum maneuvers of a hypervelocity vehicle

In this paper the optimum three-dimensional maneuver in lift and bank control of a reentry vehicle is investigated. The use of the modified Chapman's variables and a normalized lift coefficient allows a general discussion of the optimum control of an arbitrary vehicle reentering any planetary atmosphere. Several planar problems are solved. Using the condition of equilibrium glide, the maximum cross range and the footprint of a reentry vehicle from circular speed are computed in terms of the maximum lift-to-drag ratio.

Vinh, N. X.↗
NASA NTRS1980

Head-up display in the non-precision approach

The problem of head-up guidance for an aircraft making an instrument approach without glide slope information is discussed. Requirements for path control are considered for each section of the approach profile and a head-up display is developed to meet these needs. The display is an unreferenced flight director which is modified by adding a ground referenced symbol as an alternative guidance component. The director is used for holding altitude in the first segment and for descent at a controlled rate in the second segment. It is used in the third segment to maintain the minimum decision altitude while assessing the approach situation. This is done by means of occasional brief changes to the referenced symbol. In the final segment a visual approach is made with the referenced symbol used continuously for path control. The display is investigated experimentally in simulated approaches made by three pilots. The results show a fair agreement between objective and subjective estimates of the quality of landing decisions.

Naish, J. M.↗
NASA NTRS1980

STS-1 operational flight profile. Volume 5: Descent cycle 3. Appendix D: GRTLS six degree of freedom Monte Carlo dispersion analysis

The results of a six degree of freedom (6-DOF) nonlinear Monte Carlo dispersion analysis for the latest glide return to landing site (GRTLS) abort trajectory for the Space Transportation System 1 Flight are presented. For this GRTLS, the number two main engine fails at 262.5 seconds ground elapsed time. Fifty randomly selected simulations, initialized at external tank separation, are analyzed. The initial covariance matrix is a 20 x 20 matrix and includes navigation errors and dispersions in position and velocity, time, accelerometer bias, and inertial platform misalinements. In all 50 samples, speedbrake, rudder, elevon, and body flap hinge moments are acceptable. Transitions to autoland begin before 9,000 feet and there are no tailscrapes. Navigation derived dynamic pressure accuracies exceed the flight control system constraints above Mach 2.5. Three out of 50 landings exceeded tire specification limit speed of 222 knots. Pilot manual landings are expected to reduce landing speed by landing farther downrange.

Montez, M. N.↗
NASA NTRS1980

Wing profile design of the world championship sail plane SB 11

A glider capable of climbing while circling in an updraft at low speed with a great mount of lift while gliding to the next updraft at high speed and with minimal altitude loss was designed. The wing profile design alleviates several problems and leaves no gap between wind and flap. A constant thickness flap eliminates the need for a flexible contour section which in turn reduces control effort. The conventional method of banking with ailerons is retained. Improved performance is demonstrated.

Horstmann, K. H.↗
NASA NTRS1980

Comparison of calculated and measured helicopter rotor lateral flapping angles

Calculated and measured values of helicopter rotor flapping angles in forward flight are compared for a model rotor in a wind tunnel and an autogiro in gliding flight. The lateral flapping angles can be accurately predicted when a calculation of the nonuniform wake-induced velocity is used. At low advance ratios, it is also necessary to use a free wake geometry calculation. For the cases considered, the tip vortices in the rotor wake remain very close to the tip-path plane, so the calculated values of the flapping motion are sensitive to the fine details of the wake structure, specifically the viscous core radius of the tip vortices.

Johnson, W.↗
NASA NTRS1980

Pilot-aircraft system response to wind shear

The nonlinear aircraft motion and automatic control computer model of Frost and Reddy has been expanded to incorporate the human pilot into simulations of aircraft response to wind shear. Fixed-stick, autopilot, and manned computer simulations are made with an aircraft having characteristics of a Queen Air (small commuter-type aircraft) flown through longitudinal winds measured by a Doppler radar beamed along the glide slope during the SESAME '79 experiments in Oklahoma. Simulations are also made flying a model Boeing 727 through sinusoidal head wind to tail wind shears at the phugoid frequency to evaluate the response of manned aircraft in thunderstorm wind environments.

Turkel, B. S.↗
NASA NTRS1980

Pilot-aircraft system reponse to wind shear

The nonlinear aircraft motion and automatic control model is expanded to incorporate the human pilot into simulations of aircraft response to wind to wind shear. The human pilot is described by a constant gains lag filter. Two runs are carried out using pilot transfer functions. Fixed-stick, autopilot, and manned computer simulations are made with an aircraft having characteristics of a small commuter type aircraft flown through longitudinal winds measured by a Doppler radar beamed along the glide slope. Simulations are also made flying an aircraft through sinusoidal head wind and tail wind shears at the phugoid frequency to evaluate the response of manned aircraft in thunderstorm wind environments.

Turkel, B. S.↗
NASA NTRS1980

Simulation comparison of a decoupled longitudinal control system and a velocity vector control wheel steering system during landings in wind shear

A simulator comparison of the velocity vector control wheel steering (VCWS) system and a decoupled longitudinal control system is presented. The piloting task was to use the electronic attitude direction indicator (EADI) to capture and maintain a 3 degree glide slope in the presence of wind shear and to complete the landing using the perspective runway included on the EADI. The decoupled control system used constant prefilter and feedback gains to provide steady state decoupling of flight path angle, pitch angle, and forward velocity. The decoupled control system improved the pilots' ability to control airspeed and flight path angle during the final stages of an approach made in severe wind shear. The system also improved their ability to complete safe landings. The pilots preferred the decoupled control system in severe winds and, on a pilot rating scale, rated the approach and landing task with the decoupled control system as much as 3 to 4 increments better than use of the VCWS system.

Kimball, G., Jr.↗
NASA NTRS1980

Bird flight and airplane flight

Research was based on a series of mechanical, electrical, and cinematographic instruments developed to measure various features of air current behavior as well as bird and airplane flight. Investigation of rising obstruction and thermal currents led to a theory of bird flight, especially of the gliding and soaring types. It was shown how a knowledge of bird flight can be applied to glider and ultimately motorized aircraft construction. The instruments and methods used in studying stress in airplanes and in comparing the lift to drag ratios of airplanes and birds are described.

Magnan, A.↗
NASA NTRS1980

Simulator study of conventional general aviation instrument displays in path-following tasks with emphasis on pilot-induced oscillations

A study of the use of conventional general aviation instruments by general aviation pilots in a six degree of freedom, fixed base simulator was conducted. The tasks performed were tracking a VOR radial and making an ILS approach to landing. A special feature of the tests was that the sensitivity of the displacement indicating instruments (the RMI, CDI, and HSI) was kept constant at values corresponding to 5 n. mi. and 1.25 n. mi. from the station. Both statistical and pilot model analyses of the data were made. The results show that performance in path following improved with increases in display sensitivity up to the highest sensitivity tested. At this maximum test sensitivity, which corresponds to the sensitivity existing at 1.25 n. mi. for the ILS glide slope transmitter, tracking accuracy was no better than it was at 5 n. mi. from the station and the pilot aircraft system exhibited a marked reduction in damping. In some cases, a pilot induced, long period unstable oscillation occurred.

Adams, J. J.↗
NASA NTRS1980

V/STOLAND digital avionics system for XV-15 tilt rotor

A digital flight control system for the tilt rotor research aircraft provides sophisticated navigation, guidance, control, display and data acquisition capabilities for performing terminal area navigation, guidance and control research. All functions of the XV-15 V/STOLAND system were demonstrated on the NASA-ARC S-19 simulation facility under a comprehensive dynamic acceptance test. The most noteworthy accomplishments of the system are: (1) automatic configuration control of a tilt-rotor aircraft over the total operating range; (2) total hands-off landing to touchdown on various selectable straight-in glide slopes and on a flight path that includes a two-revolution helix; (3) automatic guidance along a programmed three-dimensional reference flight path; (4) navigation data for the automatic guidance computed on board, based on VOR/DME, TACAN, or MLS navid data; and (5) integration of a large set of functions in a single computer, utilizing 16k words of storage for programs and data.

Liden, S.↗