Search NASA⌕ Search

SEARCH · Search NASA

Results for “Mixing layer”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 307 records · Page 17
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Quasi-instantaneous transverse vorticity measurements in an excited, two-dimensional, single stream mixing layer

Quasi-instantaneous transverse vorticity time series were obtained with a four-wire array at each of the 414 points in the measurement grid. These vorticity measurements indicate absolute values of peak vorticity which are an order of magnitude greater than those indicated by phase averaged transverse vorticity measurements. These large quasi-instantaneous transverse vorticity fluctuations indicate strong mixing throughout the core and periphery of the newly formed and saturated vortical structures. Although the magnitude is approximately the same throughout these structures, the frequency of occurrence of these large fluctuations appears to be less on the low speed side of the newly formed vortex.

Disimile, P. J.↗
NASA NTRS1991

The direct simulation of high-speed mixing-layers without and with chemical heat release

A direct numerical simulation of high speed reacting and non-reacting flows for H2-air systems is presented. The calculations are made for a convective Mach number of 0.38 with hyperbolic tangent initial profile and finite rate chemical reactions. A higher-order numerical method is used in time accurate mode to time advance the solution to a statistical steady state. About 600 time slices of all the variables are then stored for statistical analysis. It is shown that most of the problems of high-speed combustion with air are characterized by relatively weak heat release. The present study shows that: (1) the convective speed is reduced by heat release by about 10 percent at this convective Mach number M(sub c) = 0.38; (2) the variation of the mean and rms fluctuation of temperature can be explained on the basis of temperature fluctuation between the flame temperature and the ambient; (3) the growth rate with heat release is reduced by 7 percent; and (4) the entrainment is reduced by 25 percent with heat release. These differences are small in comparison with incompressible flow dynamics, and are argued to be due to the reduced importance of heat release in comparison with the large enthalpy gradients resulting from the large-scale vortex dynamics. It is finally suggested that the problems of reduced mixing in high-speed flows are not severely complicated by heat release.

Sekar, B.↗
NASA NTRS2018

Parameterization of Mixed Layer and Deep-Ocean Mesoscales Including Nonlinearity

In 2011, Chelton et al. carried out a comprehensive census of mesoscales using altimetry data and reached the following conclusions: "essentially all of the observed mesoscale features are nonlinear" and "mesoscales do not move with the mean velocity but with their own drift velocity," which is "the most germane of all the nonlinear metrics." Accounting for these results in a mesoscale parameterization presents conceptual and practical challenges since linear analysis is no longer usable and one needs a model of nonlinearity. A mesoscale parameterization is presented that has the following features: 1) it is based on the solutions of the nonlinear mesoscale dynamical equations, 2) it describes arbitrary tracers, 3) it includes adiabatic (A) and diabatic (D) regimes, 4) the eddy-induced velocity is the sum of a Gent and McWilliams (GM) term plus a new term representing the difference between drift and mean velocities, 5) the new term lowers the transfer of mean potential energy to mesoscales, 6) the isopycnal slopes are not as flat as in the GM case, 7) deep-ocean stratification is enhanced compared to previous parameterizations where being more weakly stratified allowed a large heat uptake that is not observed, 8) the strength of the Deacon cell is reduced. The numerical results are from a stand-alone ocean code with Coordinated Ocean-Ice Reference Experiment I (CORE-I) normal-year forcing.

Baroclinic flows; Mesoscale processes; Mixing; Sub↗
DOE OSTI2024

Investigation of Key Electronic States in Layered Mixed Chalcogenides With a d 0 Transition Metal as Li-Ion Cathodes

Lithium-rich transition metal chalcogenides are witnessing a revival as candidates for Li-ion cathode materials, spurred by the boost in their capacities from transcending conventional redox processes based on cationic states and tapping into additional chalcogenide states. A particularly striking case is Li 2 TiS 3-y Se y , which features a d 0 metal. While the end members are expectedly inactive, substantial capacities are measured when both Se and S are present. Using X-ray absorption spectroscopy, it is shown that the electronic structure of Li 2 TiS 3-y Se y is not a simple combination of the end members. The data confirm previous hypotheses that, in Li 2 TiS 2.4 Se 0.6 , this behavior is underpinned by concurrent and reversible redox of only S and Se, and identify key electronic states. Moreover, wavelet transforms of the extended X-ray absorption fine structure provide direct evidence of the formation of short Se–Se units upon charging. The study uncovers the underpinnings of this intriguing reactivity and highlights the richness of redox chemistry in complex solids.

25 ENERGY STORAGE↗
NASA NTRS1975

Supersonic free turbulent mixing layers

A mean turbulent closure method with a length scale function is developed for predicting the reduced spreading rate in high Mach number, high Reynolds number free shear layers. The new feature of the method is the inclusion of effects of the pressure-dilation term which appears in the compressible form of the turbulence energy equation. The model indicates that the pressure-dilation correlation may act as a turbulence energy sink or source depending on whether the transverse gradients of mean Mach number and mean density have the same or opposite signs.

Oh, Y. H.↗
NASA NTRS1985

Noniterative cross-flow integration for the pressure-split analysis of subsonic mixing-layer problems

In utilizing pressure-split methodology for the two-dimensional analysis of curved wall jets and the subsonic regions of underexpanded free jets, Dash et al (1984) employed the cross flow procedure of Bradshaw et al (1979, 1984). In assessing this procedure, it was noted that the iterative steps required between the continuity and cross flow momentum equation solutions could be eliminated by combining these equations into a unified equation for the cross flow velocity, yielding a significant reduction in computer time and eliminating possible convergence problems which occur in iterative approaches. Attention is presently given to the application of this noniterative procedure to a two-dimensional curved wall jet problem.

Dash, S. M.↗
NASA NTRS1987

Nonlinear binary-mode interactions in a developing mixing layer

This paper presents the formulation and results of two-wave interactions in a spatially developing shear layer, directed at understanding and interpreting the physical mechanisms that underlie the results of quantitative observation. The study confirms the existence of Kelly's (1967) mechanism that augments the growth of a subharmonic disturbance by extracting energy from its fundamental or vice versa. This mechanism is shown to be strongest in the region where the fundamental begins to return energy to the mean flow and the two wave modes are of comparable energy levels. It is found that the initial conditions and, especially, the initial phase angle between the two disturbances play a very significant role in the modal development and that of the shear layer itself. A doubling of the shear-layer thickness is shown to take place; the two successive plateaux in its growth are attributed to the peaking in the energy production rates of the fundamental and subharmonic fluctuations.

Nikitopoulos, D. E.↗
NASA NTRS1988

A two-dimensional numerical simulation of a supersonic, chemically reacting mixing layer

Research has been undertaken to achieve an improved understanding of physical phenomena present when a supersonic flow undergoes chemical reaction. A detailed understanding of supersonic reacting flows is necessary to successfully develop advanced propulsion systems now planned for use late in this century and beyond. In order to explore such flows, a study was begun to create appropriate physical models for describing supersonic combustion, and to develop accurate and efficient numerical techniques for solving the governing equations that result from these models. From this work, two computer programs were written to study reacting flows. Both programs were constructed to consider the multicomponent diffusion and convection of important chemical species, the finite rate reaction of these species, and the resulting interaction of the fluid mechanics and the chemistry. The first program employed a finite difference scheme for integrating the governing equations, whereas the second used a hybrid Chebyshev pseudospectral technique for improved accuracy.

Drummond, J. Philip↗