SEARCH · Search NASA

Results for “Sound”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 307 records · Page 17

All sources NASA NTRS DOE OSTI

NASA NTRS1974

Device for recording the 20 Hz - 200 KHz sound frequency spectrum using teletransmission

The device described consists of two distinct parts: (1) The sound pickup system consisting of the wide-frequency band condenser microphone which contains in the same assembly the frequency-modulated oscillator and the output stage. Being transistorized and small, this system can be easily moved, so that sounds can be picked up even in places that are difficult to reach with larger devices. (2) The receiving and recording part is separate and can be at a great distance from the sound pickup system. This part contains a 72 MHz input stage, a frequency changer that gives an intermediate frequency of 30 MHz and a multichannel analyzer coupled to an oscilloscope and a recorder.

Baciu, I.↗

NASA NTRS1974

Concerns of the Institute of Transport Study and Research for reducing the sound level inside completely repaired buses

Sound level measurements on noise sources on buses are used to observe the effects of attenuating acoustic pressure levels inside the bus by sound-proofing during complete repair. A spectral analysis of the sound level as a function of motor speed, bus speed along the road, and the category of the road is reported.

Groza, A.↗

NASA NTRS1974

Broadband sound radiated from subsonic rotors

Recent theoretical work on sound sources in subsonic turbomachinery is applied to the correlation of axial-flow fan and compressor noise measurements. Correlations are presented for directivity and sound-power spectra associated with broadband noise. A simple explanation is given to account for the relative amounts of sound power transmitted upstream and downstream from a single-stage fan.

Morfey, C. L.↗

NASA NTRS1975

Amplification, attenuation, and dispersion of sound in inhomogeneous flows

First order effects of gradients in nonuniform potential flows of a compressible gas are included in a dispersion relation for sound waves. Three nondimensional numbers, the ratio of the change in the kinetic energy in one wavelength to the thermal energy of the gas, the ratio of the change in the total energy in one wavelength to the thermal energy, and the ratio of the dillatation frequency (the rate of expansion per unit volume) to the acoustic frequency, play a role in the separation of the effects of flow gradients into isotropic and anisotropic effects. Dispersion and attenuation (or amplification) of sound are found to be proportional to the wavelength for small wavelength, and depend on the direction of wave propagation relative to flow gradients. Modification of ray acoustics for the effects of flow gradients is suggested, and conditions for amplification and attenuation of sound are discussed.

Kentzer, C. P.↗

NASA NTRS1975

Propagation of Sound at Moderate and High Intensities in Absorbent and Hard-Walled Cylindrical Ducts

The propagation of plane wave and higher order acoustic modes in both hard-walled and absorbent cylindrical ducts was studied at moderate sound intensities where the linear wave equation is valid, and at high intensities where nonlinear effects can be observed. The experiments were conducted with an anechoically terminated twelve-inch inside-diameter transite pipe. Various types of sound sources were mounted at one end of the duct to generate the desired acoustic fields within the duct. Arrays of conventional loudspeakers were used to generate plane waves and higher order acoustic modes at moderate intensities, and an array of four high intensity electro-pneumatic sound sources was used for the experiments in the nonlinear region. The attenuation of absorbent liners made of several different materials was obtained at moderate intensities for both plane waves and high order modes. It was found that the characteristics of the liners studied did not change appreciably at high intensities.

Mcdaniel, Oliver Herbert↗

NASA NTRS1975

Annoyance resulting from intrusion of aircraft sounds upon various activities

An experiment was conducted in which subjects were engaged in TV viewing, telephone listening, or reverie (no activity) for a 1/2-hour session. During the session, they were exposed to a series of recorded aircraft sounds at the rate of one flight every 2 minutes. Within each session, four levels of flyover noise, separated by dB increments, were presented several times in a Latin Square balanced sequence. The peak level of the noisiest flyover in any session was fixed at 95, 90, 85, 75, or 70 dBA. At the end of the test session, subjects recorded their responses to the aircraft sounds, using a bipolar scale which covered the range from very pleasant to extremely annoying. Responses to aircraft noises were found to be significantly affected by the particular activity in which the subjects were engaged. Not all subjects found the aircraft sounds to be annoying.

Gunn, W. J.↗

NASA NTRS1975

Amplification, attenuation, and dispersion of sound in inhomogeneous flows

First order effects of gradients in nonuniform potential flows of a compressible gas are included in a dispersion relation for sound waves. Three nondimensional numbers, the ratio of the change in the kinetic energy in one wavelength to the thermal energy of the gas, the ratio of the change in the total energy in one wavelength to the thermal energy, and the ratio of the dilatation frequency (the rate of expansion per unit volume) to the acoustic frequency, play the dominant role permitting the separation of the effects of flow gradients into isotropic and anisotropic effects. Dispersion and attenuation (or amplification) of sound are proportional to the wavelength for small wavelength and depend on the direction of wave propagation relative to flow gradients. Modification of ray acoustics for the effects of flow gradients is suggested and conditions for amplification and attenuation of sound are discussed.

Kentzer, C. P.↗

NASA NTRS1975

Convection measurement package for space processing sounding rocket flights

The effects on heated fluids of nonconstant accelerations, rocket vibrations, and spin rates, was studied. A system is discussed which can determine the influence of the convective effects on fluid experiments. The general suitability of sounding rockets for performing these experiments is treated. An analytical investigation of convection in an enclosure which is heated in low gravity is examined. The gravitational body force was taken as a time-varying function using anticipated sounding rocket accelerations, since accelerometer flight data were not available. A computer program was used to calculate the flow rates and heat transfer in fluids with geometries and boundary conditions typical of space processing configurations. Results of the analytical investigation identify the configurations, fluids and boundary values which are most suitable for measuring the convective environment of sounding rockets. A short description of fabricated fluid cells and the convection measurement package is given. Photographs are included.

Spradley, L. W.↗

NASA NTRS1975

Attenuation of sound in ducts with acoustic treatment: A generalized approximate equation

A generalized approximate equation for duct lining sound attenuation is presented. The specification of two parameters, the maximum possible attenuation and the optimum wall acoustic impedance is shown to completely determine the sound attenuation for any acoustic mode at any selected wall impedance. The equation is based on the nearly circular shape of the constant attenuation contours in the wall acoustic impedance plane. For impedances far from the optimum, the equation reduces to Morse's approximate expression. The equation can be used for initial acoustic liner design. Not least important is the illustrative nature of the solutions which provide an understanding of the duct propagation problem usually obscured in the exact calculations. Sample calculations using the approximate attenuation equation show that the peak and the bandwidth of the sound attenuation spectrum can be represented by quite simple functions of the ratio of actual wall acoustic resistance to optimum resistance.

Rice, E. J.↗

NASA NTRS1975

Design and preliminary test results at Mach 5 of an axisymmetric slotted sound shield

The basic theory and sound attenuation mechanisms, the design procedures, and preliminary experimental results are presented for a small axisymmetric sound shield for supersonic wind tunnels. The shield consists of an array of small diameter rods aligned nearly parallel to the entrance flow with small gaps between the rods for boundary layer suction. Results show that at the lowest test Reynolds number (based on rod diameter) of 52,000 the noise shield reduced the test section noise by about 60 percent ( or 8 db attenuation) but no attenuation was measured for the higher range of test reynolds numbers from 73,000 to 190,000. These results are below expectations based on data reported elsewhere on a flat sound shield model. The smaller attenuation from the present tests is attributed to insufficient suction at the gaps to prevent feedback of vacuum manifold noise into the shielded test flow and to insufficient suction to prevent transition of the rod boundary layers to turbulent flow at the higher Reynolds numbers. Schlieren photographs of the flow are shown.

Beckwith, I. E.↗

NASA NTRS1976

Feasibility of making sound power measurements in the NASA Langley V/STOL tunnel test section

Based on exploratory acoustic measurements in Langley's V/STOL wind tunnel, recommendations are made on the methodology for making sound power measurements of aircraft components in the closed tunnel test section. During airflow, tunnel self-noise and microphone flow-induced noise place restrictions on the amplitude and spectrum of the sound source to be measured. Models of aircraft components with high sound level sources, such as thrust engines and powered lift systems, seem likely candidates for acoustic testing.

Brooks, T. F.↗

NASA NTRS1976

Wake-related sound generation from isolated airfoils

A model for the prediction of wake-related sound generation by a single airfoil is presented which assumes that the net force fluctuation on an airfoil can be expressed in terms of the net momentum fluctuation in the near wake of the airfoil. The model predicts a forcing function for sound generation which is related to the spectra of the two-point velocity correlations in the turbulent region near the airfoil trailing edge. Cross spectra were obtained from correlations of the longitudinal and transverse components of turbulence in the wake of a 36-in. chord airfoil in a wind tunnel using x-probe hot-wire sensors. Additional data were obtained from a 10-in. chord airfoil in a free-jet facility. Based on results from these tests, a scaling model was developed using the turbulent boundary-layer thickness as the primary length measure. The model was used to predict the sound radiated from a 2-in. chord airfoil for which acoustical data was available; good agreement was obtained both in level and spectral shape. The single-airfoil result is extended to a rotor geometry, and comparisons are studied for various aerodynamic parameters.

Clark, L. T.↗

NASA NTRS1975

Attenuation of sound in ducts with acoustic treatment - A generalized approximate equation

Rice, E. J.↗

NASA NTRS1976

Non-dimensional groups in the description of finite-amplitude sound propagation through aerosols

Several parameters, which have fairly transparent physical interpretations, appear in the analytic description of finite-amplitude sound propagation through aerosols. Typically, each of these parameters characterizes, in some sense, either the sound or the aerosol. It also turns out that fairly obvious combinations of these parameters yield non-dimensional groups which, in turn, characterize the nature of the acoustic-aerosol interaction. This theme is developed in order to illustrate how a quick examination of such parameters and groups can yield information about the nature of the processes involved, without the necessity of extensive mathematical analysis. This concept is developed primarily from the viewpoint of sound propagation through aerosols, although complimentary acoustic-aerosol interaction phenomena are briefly noted.

Scott, D. S.↗

NASA NTRS1976

A microscopic description of sound absorption in the atmosphere

The various mechanisms which contribute to sound absorption in the atmosphere are identified and a technique for computing the contribution from each is presented. The similarities between sound absorption, laser fluorescence measurements, and the opto-acoustic effect are discussed. Finally, experimental sound absorption results are compared to predictions to test the microscopic energy transfer approach.

Bass, H. E.↗

NASA NTRS1976

The prediction and measurement of sound radiated by structures

Theories regarding the radiation of sound are reviewed and the implementation in strategies for explaining or measuring the sound produced by practical strucutres are discussed. Particular attention is given to those aspects that relate to the determination of the relative amounts of sound generated by various parts of a machine or structure, which can be very useful information for noise reduction efforts.

Lyon, R. H.↗

NASA NTRS1976

Sound radiation from randomly vibrating beams of finite circular cross section

The radiation of sound from vibrating cylindrical beams is analyzed based on the frequency of the beam vibrations and the physical characteristics of the beam and its surroundings. A statistical analysis of random beam vibrations allows this result to be independent of the boundary conditions at the ends of the beam. The acoustic power radiated by the beam can be determined from a knowledge of the frequency band vibration data without a knowledge of the individual modal vibration amplitudes. A practical example of the usefulness of this technique is provided by the application of the theoretical calculations to the prediction of the octave band acoustic power output of the picking sticks of an automatic textile loom. Calculations are made of the expected octave band sound pressure levels based on measured acceleration data. These theoretical levels are subsequently compared with actual sound pressure level measurements of loom noise.

Sutterlin, M. W.↗

NASA NTRS1976

Field support, data analysis and associated research for the acoustic grenade sounding program

Temperature and horizontal winds in the 30 to 90 km altitude range of the upper atmosphere, were determined by acoustic grenade soundings conducted at Wallops Island, Virginia and Kourou, French Guiana. Field support provided at these locations included deployment of the large area microphone system, supervision, maintenance and operation of sound ranging stations; and coordination of activities. Data analysis efforts included the analysis of field data to determine upper atmospheric meteorological parameters. Profiles for upper atmospheric temperature, wind and density are provided in plots and tables for each of the acoustic grenade soundings conducted during the contract period. Research efforts were directed toward a systematic comparison of temperature data from acoustic grenade with other meteorological sensor probes in the upper atmosphere.

Barnes, T. G.↗