Search NASA⌕ Search

SEARCH · Search NASA

Results for “condition”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 307 records · Page 17

Measured far-field flight noise of a counterrotation turboprop at cruise conditions

Modern high speed propeller (advanced turboprop) aircraft are expected to operate on 50 to 60 percent less fuel than the 1980 vintage turbofan fleet while at the same time matching the flight speed and performance of those aircraft. Counterrotation turboprop engines offer additional fuel savings by means of upstream propeller swirl recovery. This paper presents acoustic sideline results for a full-scale counterrotation turboprop engine at cruise conditions. The engine was installed on a Boeing 727 aircraft in place of the right-side turbofan engine. Acoustic data were taken from an instrumented Learjet chase plane. Sideline acoustic results are presented for 0.50 and 0.72 Mach cruise conditions. A scale model of the engine propeller was tested in a wind tunnel at 0.72 Mach cruise conditions. The model data were adjusted to flight acquisition conditions and were in general agreement with the flight results.

Woodward, Richard P.↗

New approximate boundary conditions for large eddy simulations of wall-bounded flows

Two new approximate boundary conditions have been applied to the large eddy simulation of channel flow with and without transpiration. These new boundary conditions give more accurate results than those previously in use, and allow significant reduction of the required CPU time over simulations in which no-slip conditions are applied. Mean velocity profiles and turbulence intensities compare well both with experimental data and with the results of resolved simulations. The influence of the approximate boundary conditions remains confined near the point of application and does not affect the turbulence statistics in the core of the flow.

Piomelli, Ugo↗

Conditions at the downstream boundary for simulations of viscous incompressible flow

The proper specification of boundary conditions at artificial boundaries for the simulation of time-dependent fluid flows has long been a matter of controversy. A general theory of asymptotic boundary conditions for dissipative waves is applied to the design of simple, accurate conditions at downstream boundary for incompressible flows. For Reynolds numbers far enough below the critical value for linear stability, a scaling is introduced which greatly simplifies the construction of the asymptotic conditions. Numerical experiments with the nonlinear dynamics of vortical disturbances to plane Poiseuille flow are presented which illustrate the accuracy of our approach. The consequences of directly applying the scalings to the equations are also considered.

Hagstrom, Thomas↗

Consistency and convergence for numerical radiation conditions

The problem of imposing radiation conditions at artificial boundaries for the numerical simulation of wave propagation is considered. Emphasis is on the behavior and analysis of the error which results from the restriction of the domain. The theory of error estimation is briefly outlined for boundary conditions. Use is made of the asymptotic analysis of propagating wave groups to derive and analyze boundary operators. For dissipative problems this leads to local, accurate conditions, but falls short in the hyperbolic case. A numerical experiment on the solution of the wave equation with cylindrical symmetry is described. A unified presentation of a number of conditions which have been proposed in the literature is given and the time dependence of the error which results from their use is displayed. The results are in qualitative agreement with theoretical considerations. It was found, however, that for this model problem it is particularly difficult to force the error to decay rapidly in time.

Hagstrom, Thomas↗

Derivation and application of a class of generalized boundary conditions

Boundary conditions involving higher order derivatives are presented for simulating surfaces whose reflection coefficients are known analytically, numerically, or experimentally. Procedures for determining the coefficients of the derivatives are discussed, along with the effect of displacing the surface where the boundary conditions are applied. Provided the coefficients satisfy a duality relation, equivalent forms of the boundary conditions involving tangential field components are deduced, and these provide the natural extension to nonplanar surfaces. As an illustration, the simulation of metal-backed uniform and three-layer dielectric coatings is given. It is shown that fourth order conditions are capable of providing an accurate simulation for uniform coating at least a quarter of a wavelength in thickness.

Senior, Thomas B. A.↗

Time-dependent boundary conditions for hyperbolic systems. II

A general boundary condition formalism is developed for all types of boundary conditions to which hyperbolic systems are subject; the formalism makes possible a 'cookbook' approach to boundary conditions, by means of which novel boundary 'recipes' may be derived and previously devised ones may be consulted as required. Numerous useful conditions are derived for such CFD problems as subsonic and supersonic inflows and outflows, nonreflecting boundaries, force-free boundaries, constant pressure boundaries, and constant mass flux. Attention is given to the computation and integration of time derivatives.

Thompson, Kevin W.↗

System characterization of positive real conditions

Necessary and sufficient conditions for positive realness in terms of state space matrices are presented under the assumption of complete controllability and complete observability of square systems with independent inputs. As an alternative to the positive real lemma and to the s-domain inequalities, these conditions provide a recursive algorithm for testing positive realness which result in a set of simple algebraic conditions. By relating the positive real property to the associated variational problem, a unified derivation of necessary and sufficient conditions for optimality of both singular and nonsingular problems is derived.

Wang, Q.↗

On the far-field stream function condition for two-dimensional incompressible flows

The present demonstration of the usefulness of the integral series expansion of the stream function as a far-field computational boundary condition shows the method to require only a 10-percent/time-step increase in computational effort over alternative boundary conditions, in the case of implementation of unsteady problems using a direct elliptic solver. So long as the vorticity was encompassed within the computational domain, the method proved sufficiently accurate to yield virtually identical results for two widely different domains. While the integral-series condition yielded the best results for periodic flow, the Neumann condition gave comparable accuracy with less computation time for the steady-flow case despite its inability to treat periodic flow with vortex shedding.

Sa, Jong-Youb↗

System characterization of positive real conditions

Necessary and sufficient conditions for positive realness in terms of state space matrices are presented under the assumption of complete controllability and complete observability of square systems with independent inputs. As an alternative to the positive real lemma and to the s-domain inequalities, these conditions provide a recursive algorithm for testing positive realness which results in a set of simple algebraic conditions. By relating the positive real property to the associated variational problem, a unified derivation of necessary and sufficient conditions for optimality of both singular and nonsingular problems is derived.

Wang, Q.↗

Modeling of solid/porous wall boundary conditions for the validation of computational fluid dynamics codes

A computational study has been undertaken to investigate method of modeling solid and porous wall boundary conditions in computational fluid dynamics (CFD) codes. The procedure utilizes experimental measurements at the walls to develop a flow field solution based on the method of singularities. This flow field solution is then imposed as a boundary condition in a CFD simulation of the internal flow field. The effectiveness of this method in describing the boundary conditions at the wind tunnel walls using only sparse experimental measurements has been investigated. Position and refinement of experimental measurement locations required to describe porous wall boundary conditions has also been considered.

Beutner, Thomas J.↗

Sufficient conditions for a local minimum of the Bolza problem with a scalar terminal point constraint

Sufficient conditions for a weak relative minimum for a form of the Bolza problem of variational calculus are derived. Testing of the second-order conditions requires the backward integration of fewer matrix elements than in the case of most previously published sets of conditions. The derivation is felt to be more complete and straightforward than previous derivations. The variational problem considered is relatively simple, with just a scalar constraint to implicitly or explicitly determine the final time, in order to avoid the complexities associated with controllability considerations. Sufficient conditions for a local minimum for more general optimal control problems can be approached by building upon the derivation and results presented here.

Wood, Lincoln J.↗

Sufficient conditions for a local minimum of the Bolza problem with multiple terminal point constraints

Sufficient conditions for a weak relative minimum are derived for a form of the Bolza problem of variational calculus. The derivation ties together first-order and second-order conditions in a unified consistent manner, addresses controllability considerations in some detail, and clarifies some small inconsistencies in earlier work. The resulting second-order conditions of optimality involve the integration of fewer backward-sweep matrix elements than the standard conditions in the literature for problems with an unspecified final time. As a result, the backward-sweep matrices have the same general structure and dimensionality whether the final time is specified or free, with the terminal values of two of three sweep matrices being more complicated in the latter case.

Wood, Lincoln J.↗

Analytic and numerical models of wave-CISK with conditional heating

Wave-CISK with conditional heating is investigated in the equatorial zonal-height plane by analytic and numerical techniques. For two- and three-level models, previous results are extended to give additional evidence that the most unstable mode has a single wet region of infinitesimal width. A three-level model has qualitatively similar behavior as the two-level model except that propagating solutions are possible due to coalescence of internal vertical modes. Phase speeds with conditional heating are found to be slightly greater than those for unconditional heating. The structure has one circulation cell in the vertical and is asymmetric in longitude with stronger motion on the leading edge. Growth rate is inversely proportional to the width of the single wet region. That width can be limited by second-order diffusion. A general integral relationship between growth rate, viscosity, phase speed, and heating is derived. The main conclusion is that the linear wave-CISK catastrophe is modified by conditional heating but not eliminated. The preferred mode of instability has one wet region, but it occurs on the smallest possible scale. It is likely that numerical models that use conditional heating are sensitive to resolution, especially for the commonly used spectral truncations, unless there is sufficiently strong damping at the smallest scales.

Crum, Francis X.↗

On the accurate long-time solution of the wave equation in exterior domains: Asymptotic expansions and corrected boundary conditions

We consider the solution of scattering problems for the wave equation using approximate boundary conditions at artificial boundaries. These conditions are explicitly viewed as approximations to an exact boundary condition satisfied by the solution on the unbounded domain. We study the short and long term behavior of the error. It is provided that, in two space dimensions, no local in time, constant coefficient boundary operator can lead to accurate results uniformly in time for the class of problems we consider. A variable coefficient operator is developed which attains better accuracy (uniformly in time) than is possible with constant coefficient approximations. The theory is illustrated by numerical examples. We also analyze the proposed boundary conditions using energy methods, leading to asymptotically correct error bounds.

Hagstrom, Thomas↗

Determination of solid/porous wall boundary conditions from wind tunnel data for computational fluid dynamics codes

A computational and experimental study has been undertaken to investigate methods of modeling solid and porous wall boundary conditions in CFD codes. The procedure utilizes experimental measurements at the walls to develop a flow field solution based on the method of singularities. This flow field solution is then imposed as a boundary condition in a CFD simulation of the internal flow field. The effectiveness of this method in describing the boundary conditions at the wind tunnel walls using only sparse experimental measurements has been investigated. Verification of the approach using computational studies has been carried out using an incompressible flow solver. The current work demonstrates this technique for low speed flows and compares the result with experimental data obtained from a heavily instrumented variable porosity test section. Position and refinement of experimental measurements required to describe porous wall boundary conditions has also been considered for application to other porous wall wind tunnels.

Beutner, Thomas J.↗

Sufficient conditions for a local minimum of the Bolza problem with a variable initial point

Sufficient conditions for a weak relative minimum of a form of the Bolza problem of variational calculus are derived. The variational problem considered includes arbitrary numbers of constraints on the initial and terminal points, but assumes no control constraints or interior point constraints. Testing of the second-order conditions requires the backward integration of fewer matrix elements than in the case of previously published sets of conditions. The derivation, though lengthy, is felt to be simpler in concept than previous derivations. The application of these conditions is demonstrated in the context of a simple geometric problem.

Wood, Lincoln J.↗

Investigation of Meteorological Conditions Associated with Aircraft Icing in Layer-Type Clouds for 1947-48 Winter

Rotating-cylinder measurements of the icing conditions encountered in flight during the winter of 1947-48 are presented. Liquid water content, drop size, and temperature data are shown to be consistent with previously measured conditions and with proposed maximum icing conditions in supercooled layer-type clouds. Cumulative frequency graphs of meteorological parameters indicate the frequency with which various icing conditions have been encountered in the Great Lakes area and surrounding states.

WATER, SUPERCOOLED↗

A Study of Normal Accelerations and Operating Conditions Experienced by Helicopters in Commercial and Military Operations

An analysis is presented of the normal accelerations and operating conditions encountered by two different airmail helicopters and a military pilot-training helicopter. The results, based on 4,325 flights (618 hours of flying time), indicate that maneuvers are usually responsible for the relatively large accelerations encountered, whereas gusts contribute primarily to the large number of smaller accelerations and the corresponding increase in the amount of time spent in the accelerated state. The largest maneuver loads recorded to date are increments (measured from the 1 g normal-flight condition) of 1.40g and -1.25g, whereas the largest gust-acceleration increment was 0.90g. The percentages of total flight time spent in the various flight conditions and speed ranges, as well as the acceleration time histories, are very similar for the two airmail helicopters and appear to follow a definite pattern as contrasted to the varied operating conditions of the military pilot-training helicopter.

Marlin E Hazen↗