Search NASA⌕ Search

SEARCH · Search NASA

Results for “linear optimization”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 307 records · Page 17
All sourcesNASA NTRSDOE OSTI
NASA NTRS2019

Measurement of CH3D on Titan at Submillimeter Wavelengths

We present the first radio/submillimeter detection of monodeuterated methane (CH3D) in Titan's atmosphere, using archival data from of the Atacama Large Millimeter/submillimeter Array (ALMA). The J (sub K) equals 2 (sub 1) minus 1 (sub 1) and J (sub K) equals 2 (sub 0) minus 1 (sub 0) transitions at 465.235 and 465.250 gigahertz (approximately 0.644 millimeters) were measured at significance levels of 4.6 sigma and 5.7 sigma, respectively. These two lines were modeled using the Non-linear optimal Estimator for MultivariatE spectral analySIS (NEMESIS) radiative transfer code to determine the disk-averaged CH3D volume mixing ratio equals 6.157 times 10 (sup minus 6) in Titan's stratosphere (at altitudes greater than 130 kilometers). By comparison with the CH4 vertical abundance profile measured by Cassini-Huygens mass spectrometry, the resulting value for D/H in CH4 is (1.033 plus or minus 0.081) times 10 (sup minus 4). This is consistent with previous ground-based and in situ measurements from the Cassini-Huygens mission, though slightly lower than the average of the previous values. Additional CH3D observations at higher spatial resolution will be required to determine a value truly comparable with the Cassini-Huygens CH4 measurements, by measuring CH3D with ALMA close to Titan's equator. In the post-Cassini era, spatially resolved observations of CH3D with ALMA will enable the latitudinal distribution of methane to be determined, making this an important molecule for further studies.

Thelen, Alexander E.↗
DOE OSTI2021

Resilient Operation of Power Distribution Systems Using MPC-Based Critical Service Restoration: Preprint

Power distribution systems are more prone to disruptions and cause most power system outages. We propose a service restoration technique to recover the system service (electricity delivery) following an extreme event-triggered substation outage. The proposed technique considers the problem of controlling distributed energy resources (DERs) of a distribution system with the objective of achieving maximum load pick up while satisfying network flow and voltage constraints. The problem is formulated as a model predictive control (MPC), where a linearized optimal power flow (OPF) model is employed to describe the network. The formulation is augmented with a ramping (up) reserve product for the DERs to ensure an upward monotonic load restoration as time evolves. We perform simulations considering the IEEE 13-bus test feeder integrated with wind, solar, microturbine, and energy storage devices. We demonstrate the efficacy of the devised technique in restoring the system loads monotonically, without shedding previously restored loads. We also show the benefit of co-optimization of power and reserve products for DERs on service restoration. In addition, the capability of the technique in regulating nodal voltages and reducing renewable power curtailment is demonstrated.

61 RADIATION PROTECTION AND DOSIMETRY↗
DOE OSTI2021

Resilient Operation of Power Distribution Systems Using MPC-Based Critical Service Restoration

Power distribution systems are more prone to disruptions and cause most power system outages. We propose a service restoration technique to recover the system service (electricity delivery) following an extreme event-triggered substation outage. The proposed technique considers the problem of controlling distributed energy resources (DERs) of a distribution system with the objective of achieving maximum load pick up while satisfying network flow and voltage constraints. The problem is formulated as a model predictive control (MPC), where a linearized optimal power flow (OPF) model is employed to describe the network. The formulation is augmented with a ramping (up) reserve product for the DERs to ensure an upward monotonic load restoration as time evolves. We perform simulations considering the IEEE 13-bus test feeder integrated with wind, solar, microturbine, and energy storage devices. We demonstrate the efficacy of the devised technique in restoring the system loads monotonically, without shedding previously restored loads. We also show the benefit of co-optimization of power and reserve products for DERs on service restoration. In addition, the capability of the technique in regulating nodal voltages and reducing renewable power curtailment is demonstrated.

61 RADIATION PROTECTION AND DOSIMETRY↗
DOE OSTI2020

Identification and Quantification of Beta-Emitters in Waste Packages by Segmented Gamma-Scanning - 20114

A commonly applied method for the non-destructive characterization of the radioactive inventory of waste packages (e.g. 200-l drums) is segmented gamma-scanning. The gamma-emitting inventory is identified via their characteristic lines in the measured spectra. The corresponding net peak areas allow for quantification applying appropriate models. The identification and quantification of beta-emitters present in the waste package require further evaluation. While some of them emit gamma-rays, too, which can be used for identification and quantification, pure beta-emitters contribute to the gamma-spectra only by their Bremsstrahlung-spectra. {sup 32}P, {sup 90}Sr and {sup 90}Y are typical representatives of these isotopes. A method is developed for identification and quantification of these pure beta-emitters in radioactive waste packages. Origin of the procedure is the evaluation of the measured gamma-spectrum. After the identification of all lines present in the spectrum (characteristic gamma-lines, single- and double-escape-lines, X-ray-lines, annihilation peak etc.) this information is used together with calibration data of the detection system and further a-priori information like matrix composition, cross-section data from databases etc. to simulate the spectra without the Bremsstrahlung-components by an appropriate method. This may be Monte Carlo simulations or, like in our case, a computer code taking into account mathematical descriptions of the physical effects like photo effect, (multiple) Compton scattering, backscattering etc. and the attenuation effects of the waste matrix. In any case, the resulting spectrum must simulate the real spectrum without its Bremsstrahlung-component as good as possible. Subtracting the simulated from the measured spectrum then results in the Bremsstrahlung-components caused by the beta-emitters. Prior to evaluation, a set of Bremsstrahlung-spectra is calculated and stored for different beta-emitters in different matrices using the Bethe-Heitler equation. This data set can be extended for new conditions, if necessary, and is allocated in a data base for future application. Applying a non-linear optimization using the generalized reduced gradient method for comparing the calculated with the derived Bremsstrahlung-spectra results in the identification of the beta-emitter and a factor, which is proportional to its activity. The proportionality is determined by previous calibration measurements. The application of the method is demonstrated by measurements on a 200-l mock-up drum and a real waste package. (authors)

07 ISOTOPE AND RADIATION SOURCES↗
DOE OSTI2022

Approximating a linear multiplicative objective in watershed management optimization

Implementing management practices in a cost-efficient manner is critical for regional efforts to reduce the amount of pollutants entering the Chesapeake Bay. We study the problem of selecting a subset of practices that minimizes pollutant load—subject to budgetary and environmental constraints—as simulated in a widely used regulatory watershed model. Mimicking the computation of pollutant load in the regulatory model, we formulate this problem as a continuous optimization model with a linear multiplicative objective function and linear constraints. To lay the groundwork for incorporating additional stakeholder requirements in the future, especially those that would require integer variables, we present and study a continuous linear optimization model that approximates the nonlinear model. The linear model, which requires an exponential number of variables, arises naturally as an alternative model for the same underlying physical process. We examine the theoretical behavior of these optimization models and investigate restrictions of the linear model to handle its large number of variables. Through extensive computational tests on real and randomly generated instances, we demonstrate that the linear model and its restrictions provide optimal solutions close to those of the nonlinear model in practice, despite poor approximation properties in the worst case. We conclude that the linear model—together with our approach to handling its large number of variables—provides a viable framework from which to extend the optimization model to better meet the needs of the Chesapeake Bay watershed management stakeholders.

54 ENVIRONMENTAL SCIENCES↗
NASA NTRS1974

Optimal compensator structure for linear time-invariant plant with inaccessible states

The problem is considered of designing an optimal linear time-invariant dynamic compensator for the regulation of an n-th order linear time-invariant plant with m independent outputs. The initial plant state is characterized by its first and second moments, and the cost is usual quadratic infinite-time penalty on the state and control, averaged over the initial plant and compensator states. The compensator is based on a minimal-order Luenberger observer and consequently has fixed dimension n-m. Necessary and sufficient conditions are derived for optimality of the compensator gains. The optimal compensator is shown to be unique if the plant has a particular canonical form, and, in general, for any arbitrary plant, the class of all optimal compensators is precisely determined.

Blanvillain, P. J. P.↗
NASA NTRS1983

Solution algorithms for non-linear singularly perturbed optimal control problems

The applicability and usefulness of several classical and other methods for solving the two-point boundary-value problem which arises in non-linear singularly perturbed optimal control are assessed. Specific algorithms of the Picard, Newton and averaging types are formally developed for this class of problem. The computational requirements associated with each algorithm are analysed and compared with the computational requirement of the method of matched asymptotic expansions. Approximate solutions to a linear and a non-linear problem are obtained by each method and compared.

Ardema, M. D.↗
NASA NTRS1991

Multivariable control of the Space Shuttle remote manipulator system using H2 and H(infinity) optimization

Three linear controllers are desiged to regulate the end effector of the Space Shuttle Remote Manipulator System (SRMS) operating in Position Hold Mode. In this mode of operation, jet firings of the Orbiter can be treated as disturbances while the controller tries to keep the end effector stationary in an orbiter-fixed reference frame. The three design techniques used include: the Linear Quadratic Regulator (LQR), H2 optimization, and H-infinity optimization. The nonlinear SRMS is linearized by modelling the effects of the significant nonlinearities as uncertain parameters. Each regulator design is evaluated for robust stability in light of the parametric uncertanties using both the small gain theorem with an H-infinity norm and the less conservative micro-analysis test. All three regulator designs offer significant improvement over the current system on the nominal plant. Unfortunately, even after dropping performance requirements and designing exclusively for robust stability, robust stability cannot be achieved. The SRMS suffers from lightly damped poles with real parametric uncertainties. Such a system renders the micro-analysis test, which allows for complex peturbations, too conservative.

Prakash, OM, II↗
NASA NTRSDate not supplied

Flutter-Constrained Optimization with the Linearized Frequency-Domain Approach

Due to the high computational cost associated with unsteady aeroelastic analysis, state-of-the-art aeroelastic optimizations based on computational fluid dynamics typically ignore critical constraints like flutter and aeroelastic gust response. The linearized frequency-domain method offers an approach for adding high-fidelity flutter constraints to multidisciplinary optimizations at relatively low cost compared to other unsteady computational fluid dynamics methods. In recent work, sensitivities have been implemented for the linearized frequency-domain method in FUN3D. In this work, the linearized frequency-domain method and associated sensitivities are applied to gradient-based aeroelastic optimization with flutter constraints based on computational fluid dynamics. An overview of the flutter constraint formulation and implementation is provided, and then two optimization problems are presented. The first optimization increases the flutter speed of a pitch and plunge airfoil at transonic conditions using the minimal amount of geometric changes. The second optimization minimizes the mass of the AGARD 445.6 wing subject to a flutter constraint.

Aeroelasticity↗
NASA NTRSDate not supplied

Flutter-Constrained Optimization with the Linearized Frequency-Domain Approach

Due to the high computational cost associated with unsteady aeroelastic analysis, state-of-the-art aeroelastic optimizations based on computational fluid dynamics typically ignore critical constraints like flutter and aeroelastic gust response. The linearized frequency-domain method offers an approach for adding high-fidelity flutter constraints to multidisciplinary optimizations at relatively low cost compared to other unsteady computational fluid dynamics methods. In recent work, sensitivities have been implemented for the linearized frequency-domain method in FUN3D. In this work, the linearized frequency-domain method and associated sensitivities are applied to gradient-based aeroelastic optimization with flutter constraints based on computational fluid dynamics. An overview of the flutter constraint formulation and implementation is provided, and then two optimization problems are presented. The first optimization increases the flutter speed of a pitch and plunge airfoil at transonic conditions using the minimal amount of geometric changes. The second optimization minimizes the mass of the AGARD 445.6 wing subject to a flutter constraint.

Aeroelasticity↗
DOE OSTI2026

Augmenting subspace optimization methods with linear bandits

In this work, we consider the framework of methods for unconstrained minimization that are, in each iteration, restricted to a model that is only a valid approximation to the objective function on some affine subspace containing an incumbent point. These methods are of practical interest in computational settings where derivative information is either expensive or impossible to obtain. Recent attention has been paid in the literature to employing randomized matrix sketching for generating the affine subspaces within this framework. We consider a relatively straightforward, deterministic augmentation of such a generic subspace optimization method. In particular, we consider a sequential optimization framework where actions consist of one-dimensional linear subspaces and rewards consist of (approximations to) the magnitudes of directional derivatives computed in the direction of the action subspace. Reward maximization in this context is consistent with maximizing lower bounds on descent guaranteed by first-order Taylor models. This sequential optimization problem can be analysed through the lens of dynamic regret. We modify an existing linear upper confidence bound (UCB) bandit method and prove sublinear dynamic regret in the subspace optimization setting. We demonstrate the efficacy of employing this linear UCB method in a setting where forward-mode algorithmic differentiation can provide directional derivatives in arbitrary directions and in a derivative-free setting. For the derivative-free setting, we propose SS-POUNDers, an extension of the derivative-free optimization method POUNDers that employs the linear UCB mechanism to identify promising subspaces. Our numerical experiments suggest a preference, in either computational setting, for employing a linear UCB mechanism within a subspace optimization method.

97 MATHEMATICS AND COMPUTING↗
NASA NTRS2011

Linear Approximation to Optimal Control Allocation for Rocket Nozzles with Elliptical Constraints

In this paper we present a straightforward technique for assessing and realizing the maximum control moment effectiveness for a launch vehicle with multiple constrained rocket nozzles, where elliptical deflection limits in gimbal axes are expressed as an ensemble of independent quadratic constraints. A direct method of determining an approximating ellipsoid that inscribes the set of attainable angular accelerations is derived. In the case of a parameterized linear generalized inverse, the geometry of the attainable set is computationally expensive to obtain but can be approximated to a high degree of accuracy with the proposed method. A linear inverse can then be optimized to maximize the volume of the true attainable set by maximizing the volume of the approximating ellipsoid. The use of a linear inverse does not preclude the use of linear methods for stability analysis and control design, preferred in practice for assessing the stability characteristics of the inertial and servoelastic coupling appearing in large boosters. The present techniques are demonstrated via application to the control allocation scheme for a concept heavy-lift launch vehicle.

Orr, Jeb S.↗