Search NASA⌕ Search

SEARCH · Search NASA

Results for “phase error”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 307 records · Page 17
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

Digital carrier demodulation for the DSN Advanced Receiver

The digital in-phase and quadrature (I and Q) carrier demodulation for the Deep Space Network's (DSN) Advanced Receiver is described and analyzed. The system provides coherent demodulation for a variety of modulation formats including Binary Phase Shift Keying (BPSK), BPSK with a carrier residual, Quadrature Phase Shift Keying (QPSK), Offset-QPSK (OQPSK), and Minimum Shift Keying (MSK). The focus is on the theory and hardware design of the halfband filters which are the integral part of the demodulator. The underlying theory of the filters is summarized, a breadboard hardware design is described, and a VLSI implementation is proposed which significantly decreases the hardware. A second important problem analyzed is DC-offset in the demodulator. This is a serious problem which translates into bias error in the residual carrier phase detector. The dynamic range of the complex mixer is analyzed using a probabilistic approach. It is deduced that the resulting static phase error is less than 0.2 deg when the ratio of carrier power to noise power in the demodulator input bandwidth is -72 dB or higher. Thus, the static phase error is negligible at a carrier power to noise spectral density of 0 dB-Hz for a 15 MHz bandwidth demodulator.

Sadr, R.↗
NASA NTRS1977

Analysis of a first order phase locked loop in the presence of Gaussian noise

A first-order digital phase locked loop is analyzed by application of a Markov chain model. Steady state loop error probabilities, phase standard deviation, and mean loop transient times are determined for various input signal to noise ratios. Results for direct loop simulation are presented for comparison.

Blasche, P. R.↗
NASA NTRS1987

Fast autotuning of a hydrogen maser by cavity Q modulation

A new fast autotuner for the hydrogen maser was implemented. By modulating the cavity, a phase shift in the maser output signal is induced which is proportional to the cavity tuning error. The phase shift is detected and fed back to a varactor tuner to stabilize the cavity against long-term drifts. Also, a PIN-diode cavity modulator which gives no incidental frequency shift over a very wide range of operation was developed. Modulated at over 200 Hz, it allows variations in maser cavity frequency to be compensated with a loop gain greater than 1000. Compensation of incidental amplitude modulation of the output was demonstrated.

Dick, G. J.↗
NASA NTRS1979

ATS-6 satellite radio beacon measurements at Ootacamund, India

ATS-6 radio beacon measurements of modulation phase and Faraday rotation made at Ootacamund, India in 1975-1976 are discussed with emphasis on the measurement and analysis errors. The modulation-phase errors are insensitive to the geomagnetic field and provide an accurate determination of the total columnar electron content. Comparison of modulation-phase measurements at different frequencies shows a minor sensitivity to the ATS-6 pitch angle. For the low geomagnetic latitude and nearly transverse propagation conditions of Ootacamund, the use of a fixed conversion coefficient gives an unreliable Faraday content. However, the Faraday rotation measurements may be used to determine the shape factor F, which provides information about the electron density height profile.

Davies, K.↗
NASA NTRS1982

Error bounds for multi-h phase codes

Upper and lower bounds for the probability of a decoding error event and for symbol error probability are developed for the class of time-varying phase codes known as multi-h codes. The effect of finite decoder memory is also treated. The analysis is illustrated with numerical examples, and simulation results are compared.

Wilson, S. G.↗
NASA NTRS1989

Deferred electronic heterodyne moire deflectometry: A method for transient density fields measurement

Effects of spherical aberrations of the mirror used in the moire system on the angular resolution of the system are investigated. It is shown that the spherical aberrations may reduce significantly the performance of the conventional moire deflectometer. However, due to the heterodyne procedure, this is not the case with the heterodyne moire system. A moire system with a constant speed moving grating is demonstrated. It is shown that the system readout is linear and the system does not need calibration. In addition, the repeatability of the measurements is improved in this system as compared to the sinusoidally moving grating setup. The problem of the photographic plates alignment is solved by using a mechanical system in which the plate is held firmly throughout the experiment and accurately replaced after removing for photographic processing. The effect of a circular detector's aperture size on readout was tested. It is shown that the spatial phase variations, observed when scanning along a straight moire fringe, may considerably be reduced. At present we may say that both the on-line and the deferred heterodyne moire techniques may reliably be used. The errors of phase readings are 1 deg and 5 deg for the on-line and deferred methods. The total error due to subtraction of two readings at each position is, therefore, 1.4 deg and 7 deg, respectively. Further research for improving the deferred system is suggested.

Stricker, Josef↗
NASA NTRS1994

High Earth orbit design for lunar assisted small Explorer class missions

Small Expendable launch vehicles are capable of injecting modest payloads into high Earth orbits having apogee near the lunar distance. However, lunar and solar perturbations can quickly lower perigee and cause premature reentry. Costly perigee raising maneuvers by the spacecraft are required to maintain the orbit. In addition, the range of inclinations achievable is limited to those of launch sites unless costly spacecraft maneuvers are performed. This study investigates the use of a lunar swingby in a near-Hohmann transfer trajectory to raise perigee into the 8 to 25 solar radius range and reach a wide variety of inclinations without spacecraft maneuvers. It is found that extremely stable orbits can be obtained if the postencounter spacecraft orbital period is one-half of a lunar sidereal revolution and the Earth-vehicle-Moon geometry is within a specified range. Criteria for achieving stable orbits with various perigee heights and ecliptic inclinations are developed, and the sensitivity of the resulting mission orbits to transfer trajectory injection (TTI) errors is examined. It is shown that carefully designed orbits yield lifetimes of several years, with excellent ground station coverage characteristics and minimal eclipses. A phasing loop error correction strategy is considered with the spacecraft propulsion system delta V demand for TTI error correction and a postlunar encounter apogee trim maneuver typically in the 30 to 120 meters per second range.

Mathews, M.↗
NASA NTRS1989

Active wavefront control challenges of the NASA Large Deployable Reflector (LDR)

The 20-m Large Deployable Reflector will have a segmented primary mirror. Achieving diffraction-limited performance at 50 microns requires correction for the errors of tilt and piston of the primary mirror. This correction can be obtained in two ways, the use of an active primary or a correction at a demagnified pupil of the primary. A critical requirement is the means for measurement of the wavefront error and maintaining phasing during the observation of objects that may be too faint for determining the error. Absolute phasing can only be determined using a cooperative source. Maintenance of phasing can be done with an on-board source. A number of options are being explored as discussed below. The many issues concerning the assessment and control of an active segmented mirror will be addressed with an early construction of the Precision Segmented Reflector testbed.

Meinel, Aden B.↗
NASA NTRS1974

Recent results on parametric analysis of differential Omega error

Previous tests of the differential Omega concept and an analysis of the characteristics of VLF propagation make it possible to delineate various factors which might contribute to the variation of errors in phase measurements at an Omega receiver site. An experimental investigation is conducted to determine the effect of each of a number of parameters on differential Omega accuracy and to develop prediction equations. The differential Omega error form is considered and preliminary results are presented of the regression analysis used to study differential error.

Baxa, E. G., Jr.↗
NASA NTRS1990

Fiber-optic projected-fringe digital interferometry

A phase-stepped projected-fringe interferometer was developed which uses a closed-loop fiber-optic phase-control system to make very accurate surface profile measurements. The closed-loop phase-control system greatly reduces phase-stepping error, which is frequently the dominant source of error in digital interferometers. Two beams emitted from a fiber-optic coupler are combined to form an interference fringe pattern on a diffusely reflecting object. Reflections off of the fibers' output faces are used to create a phase-indicating signal for the closed-loop optical phase controller. The controller steps the phase difference between the two beams by pi/2 radians in order to determine the object's surface profile using a solid-state camera and a computer. The system combines the ease of alignment and automated data reduction of phase-stepping projected-fringe interferometry with the greatly improved phase-stepping accuracy of our closed-loop phase-controller. The system is demonstrated by measuring the profile of a plate containing several convex surfaces whose heights range from 15 to 25 micron high.

Mercer, Carolyn R.↗
NASA NTRS1993

Array Simulations Platform (ASP) predicts NASA Data Link Module (NDLM) performance

Through a variety of imbedded theoretical and actual antenna patterns, the array simulation platform (ASP) enhanced analysis of the array antenna pattern effects for the KTx (Ku-Band Transmit) service of the NDLM (NASA Data Link Module). The ASP utilizes internally stored models of the NDLM antennas and can develop the overall pattern of antenna arrays through common array calculation techniques. ASP expertly assisted in the diagnosing of element phase shifter errors during KTx testing and was able to accurately predict the overall array pattern from combinations of the four internally held element patterns. This paper provides an overview of the use of the ASP software in the solving of array mis-phasing problems.

Snook, Allen David↗
NASA NTRS2000

Topographic Phase Recovery from Stacked ERS Interferometry and a Low-Resolution Digital Elevation Model

A hybrid approach to topographic recovery from ERS interferometry is developed and assessed. Tropospheric/ionospheric artifacts, imprecise orbital information, and layover are key issues in recovering topography and surface deformation from repeat-pass interferometry. Previously, we developed a phase gradient approach to stacking interferograms to reduce these errors and also to reduce the short-wavelength phase noise (see Sandwell arid Price [1998] and Appendix A). Here the method is extended to use a low-resolution digital elevation model to constrain long-wavelength phase errors and an iteration scheme to minimize errors in the computation of phase gradient. We demonstrate the topographic phase recovery on 16-m postings using 25 ERS synthetic aperture radar images from an area of southern California containing 2700 m of relief. On the basis of a comparison with 81 GPS monuments, the ERS derived topography has a typical absolute accuracy of better than 10 m except in areas of layover. The resulting topographic phase enables accurate two-pass, real-time interferometry even in mountainous areas where traditional phase unwrapping schemes fail. As an example, we form a topography-free (127-m perpendicular baseline) interferogram spanning 7.5 years; fringes from two major earthquakes and a seismic slip on the San Andreas Fault are clearly isolated.

Sandwell, David T.↗
NASA NTRS2011

The EVE Doppler Sensitivity and Flare Observations

The Extreme-ultraviolet Variability Experiment (EVE) obtains continuous EUV spectra of the Sun viewed as a star. Its primary objective is the characterization of solar spectral irradiance, but its sensitivity and stability make it extremely interesting for observations of variability on time scales down to the limit imposed by its basic 10 s sample interval. In this paper we characterize the Doppler sensitivity of the EVE data. We find that the 30.4 nm line of He II has a random Doppler error below 0.001 nm (1 pm, better than 10 km/s as a redshift), with ample stability to detect the orbital motion of its satellite, the Solar Dynamics Observatory (SDO). Solar flares also displace the spectrum, both because of Doppler shifts and because of EVE's optical layout, which (as with a slitless spectrograph) confuses position and wavelength. As a flare develops, the centroid of the line displays variations that reflect Doppler shifts and therefore flare dynamics. For the impulsive phase of the flare SOL2010-06-12, we find the line centroid to have a redshift of 16.8 +/- 5.9 km/s relative to that of the flare gradual phase (statistical errors only). We find also that high-temperature lines, such as Fe XXIV 19.2 nm, have well-determined Doppler components for major flares, with decreasing apparent blueshifts as expected from chromospheric evaporation flows.

Hudson, H. S.↗
NASA NTRS1967

Mercury's microwave phase effect.

Incompatibility of microwave phase effects measurements in Mercury thermal emission with simple model for thermal behavior of planet surface

ASTRONOMICAL MODEL↗
NASA NTRS1971

A multiple-beam spherical reflector antenna

A spherical reflector with multiple feeds is considered for application in communications satellite systems. Data are presented which show that spherical reflectors possessing relatively high gain (40 db) and very small phase path error are feasible. A design of a spherical reflector utilizing corrugated horn feeds is considered. Radiation patterns are computed using the physical-optics technique. The designed antenna is approximately 60 lambda in diameter. Calculations performed for this antenna with three beams indicate that each beam has a gain of about 42 db, a beamwidth of 1.4 deg, and sidelobes that can be expected to be at least 28 db down. These results indicate that the feature of low sidelobes makes the spherical reflector a consideration for a multiple-beam communications satellite antenna.

Woo, R.↗