SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
This paper describes navigation results obtained in the field tests, where cross-track error was only 6% of distance traveled. Comparison with previous results of other planetary rover systems shows this to be a significant improvement.
Observations made during a mountain-top-to-mountain-top horizontal optical link demonstration are described. The optical link spans a range of 45 Km at an average altitude of 2 Km above sea level. A multi-beam beacon comprised of eight laser beams emerging from multi-mode fiber coupled lasers (780 nm) are launched through a 0.6 m diameter telescope located at the JPL Table Mountain Facility (TMF) in Wrightwood, California. The multibeam beacon is received at Strawberry Peak located in the San Bernadino Mountains of California. The NASA, JPL developed optical communications demonstrator (OCD) receives the beacon, senses the atmosphere induced motion and using an upgraded fine steering loop compensates the re-transmission of a communications laser beam (852 nm, 400 Mbps) to TMF. The eight-beam beacon allowed a four reduction in normalized irradiance or scintillation index. This in turn was sufficient to eliminate beacon fades sensed b the OCD and allowed the fine steering loop performance evaluation. The uncompensated tracking error was determined to be 2.2 - 3 prad compared to a model prediction of 3.4 prad. The paper also discusses various auxiliary observations made during the campaign
The LQG controllers, designed for the NASA Deep Space Network antennas have small tracking errors and are resistant to wind disturbances.
The upcoming NASA missions will require tracking of low-orbit satellites. As a consequence, NASA antennas will be required to track satellites at higher rates than for the current deep space missions. This paper investigates servo design issues for the 34-m beam-waveguide (BWG) antennas that track low-orbit satellites. This includes the upgrade of the servo with the feedforward loop, monopulse controller design, and tracking error reduction through proper choice of elevation pinion location, through application of a notch filter, and through the elevation drive amplifier gain adjustment. Finally, improvement of the signal-to-noise ratio through averaging of the oversampled monopulse signal is presented.
The InSAR Scientific Computing Environment (ISCE) was first developed under the NASA Advanced Information Systems Technology as a flexible, extensible object-oriented framework for Interferometric Synthetic Aperture Radar (InSAR) processing. The ISCE framework uses Python 3 at the workflow level, controlling modules of compiled code for functional processing, and managing inputs, outputs, and other flow control services. The currently released version, called ISCE 2.1, is distributed to the research community through the Western North America InSAR Consortium under a research license. The ISCE team is working on the next generation of the code in order to prepare for the NASAISRO SAR (NISAR) mission operational processing. Innovations in this code include augmentation or conversion of the custom Python framework elements in ISCE with the Pyre framework, new workflows for interferometric and polarimetric stack processing, a more intuitive and graphically based user interface, and flow control for hybrid computing environments including CPU/GPU clusters, logging and error tracking facilities, and new more efficient computational modules that exploit graphical processor units (GPUs) when available. The ISCE 3.0 framework is designed to work in an operational environment as well as on a single user’s laptop or compute cluster, with services to discover capabilities and scale computations accordingly.
Deep neural networks have gained widespread usage in a number of applications. However, limitations such as lack of explainability and robustness inhibit building trust in their behavior, which is crucial in safety critical applications such as autonomous driving. Therefore, techniques which aid in understanding and providing guarantees for neural network behavior are the need of the hour. In this paper, we present a case study applying a recently proposed technique, Prophecy, to analyze the behavior of a neural network model, provided by our industry partner and used for autonomous guiding of airplanes on taxi runways. This regression model takes as input an image of the runway and produces two outputs, cross-track error and heading error, which represent the position of the plane relative to the center line. We use the Prophecy tool to extract neuron activation patterns for the correctness and safety properties of the model. We show the use of these patterns to identify features of the input that explain correct and incorrect behavior. We also use the patterns to provide guarantees of consistent behavior. We explore a novel idea of using sequences of images (instead of single images) to obtain good explanations and identify regions of consistent behavior.
The Sky-Scanning, Sun-Tracking Airborne Radiometer (3STAR) adapts commercial radiometer technology developed for the ocean color research community to airborne measurement of spectrally resolved solar irradiance and sky radiance. These atmospheric observations are used to derive aerosol optical depth (AOD), supporting localized AOD inputs for atmospheric correction of satellite and airborne data over terrestrial and aquatic (including optically dark) targets. The ability to regionally “tune” atmospheric correction schemes with relevant spatial AOD supports constraining atmospheric correction of remote sensing reflectance. Very wide dynamic range has been achieved for multi-channel band-pass-filter-radiometers originally designed for deployment into the water column. By actively tracking and directly pointing to the Sun, the light attenuation by aerosol particles in the atmospheric column can be quantified. These measurements improve knowledge of atmospheric constituents and the atmospheric corrections required to improve remote sensing capabilities for interpreting reflectance measurements from the Earth surface. 3STAR incorporates a custom Sun-tracking/sky-scanning pointing head, a Sun-tracking camera, and a commercially available, cylindrical, 19-channel radiometer tube assembly. An accurate and responsive mount and tracking system has been developed and certified to NASA and Naval Air Systems Command (NAVAIR) airworthiness standards for deployment into the aircraft slipstream. Ground and flight testing indicate typical tracking errors of less than 0.1 degrees, well within the field of view of the radiometer as required to minimize measurement uncertainty from alignment error. Preliminary AOD measurements compare to within 0.013 with 15 measurements from an Aerosol Robotic Network (AERONET) Cimel instrument at 500 nm wavelength and low solar angle.
Human-scale missions to Mars will likely require multiple landers delivered precisely to designated locations. The current NASA human Mars reference architecture assumes delivery of three 25 t payloads from a 1- or 5-Sol orbit to the surface with a landing precision of 50 m to ensure logistics are located near the habitat. While initial navigation estimates improve with on-orbit ground tracking, errors increase during post-deorbit coast. Likewise, Mars atmospheric variability and forecasting uncertainty means that the entry vehicle guidance, navigation, and control systems must be robust to accommodate landing during any time of day or Mars year, including during dust storms. Precision landing technologies are currently being assessed to determine if onboard navigation sensors are sufficient to enable the landing accuracy required or if additional navigation aids such as surface or orbiting beacons will be needed. This study evaluates the system performance requirements to meet the desired landing accuracy for the reference vehicle design and entry, descent, and landing concept of operations. A detailed six degree-of-freedom integrated performance simulation framework is used to perform the assessment and demonstrate that under current assumptions, onboard navigation sensors are sufficient to support precision landing.
This paper studies the simulated performance of the Deep Space Optical Communication (DSOC) laser downlink pointing control system that has a pointing requirement at the sub-microradian scale. To achieve the required pointing precision, the DSOC Flight Laser Transceiver (FLT) point-ahead mirror (PAM) employs piezoelectric actuators, which are widely used in precision applications due to their high motion resolution, rapid response, and high output forces. However, a piezoelectric actuator's performance is often limited by nonlinearities in their response, most significantly hysteresis. To study the effect of hysteresis on our simulated pointing performance, an invertible hysteresis model is developed using the Classical Prantdl-Ishlinskii (CPI) method. The simulation includes models of DSOC hardware and electronic system components based on key parameters (bias, frequency response, noise), with the hysteresis modeled in the PAM piezo actuator dynamics. A Proportional-Integral controller provides feedback with measurements from two potential sources: strain gauge sensors or a photon-counting camera. To compensate for hysteresis behavior, a feedforward inverse CPI hysteresis model is implemented in the control system. Two CPI models are built using different sampling methods (uniform sampling and cosine spacing) and controller performance is compared. For the maximum command range of ±400 μrad at 1 mHz, results show that the feedforward combined with feedback control reduces output tracking error by 50% or 58% (to 0.20 or 0.38 μrad) compared to feedback control alone (from 0.40 or 0.90 μrad), corresponding to the uniform-sampled and cosine-sampled CPI models, respectively.
This paper presents anL1adaptive control augmentation for a Lift-Plus-Cruise (L+C)vehicle. This class of vehicles operates in three flight modes with different dynamic behavior: vertical, transition, and forward flight. A robust uniform controller is used as a baseline to stabilize the system throughout these flight modes. The uniform controller is a linear control law designed around trim conditions of the aircraft and includes control allocation to achieve the desired forces and moments on the vehicle. TheL1control augmentation is designed for each of these trim conditions to compensate for the nonlinear time- and state-dependent uncertainties in the vehicle dynamics. The augmented control output is then added to the desired force and moment commands on the vehicle. Simulation results demonstrate the effectiveness of control augmentation for reducing the effects of unmodeled dynamics, reduced actuator effectiveness, and time-dependent disturbances. Effectiveness is demonstrated through tracking error metrics.
The role of soil moisture in the evolution of tropical cyclones (TCs) approaching land has long been recognized. Dry land surface conditions can lead to faster dissipation of a TC over land (often associated with changes in precipitation structure), whereas very wet conditions can help sustain or even re-intensify a TC. The ability to forecast post-landfall TC evolution and mitigate the associated socio-economic impact thus hinges on accurate knowledge of land surface conditions prior to landfall. The NASA Soil Moisture Active Passive (SMAP) mission provides accurate observations of soil moisture globally and at high revisit times of 2-3 days. It has been shown that the assimilation of SMAPbrightness temperatures (Tb) significantly improves modeled land surface states and thus has the potential to constrain land surface initial conditions in TC forecasts. In this presentation, we investigate this potential through an extensive set of Observing System Experiments that systematically assess the impact of assimilating SMAP Tbs on TC forecast skill in the Goddard Earth Observing System. Focusing on the case of TC Idai, we show that the assimilation of SMAP generally leads to a drier soil moisture analysis for the land surface underneath much of the storm’s circulation. An exception is the direct TC track, where SMAP assimilation increases soil moisture. These changes are reflected in the surface fluxes, which propagate the land surface state changes to the atmosphere. This results a TC that is overall weaker with lower winds, but with a better-defined eye and a slightly smaller track error than a simulation without SMAP DA. The changes in soil moisture resulting from the assimilation of SMAP also impact the total precipitation amounts as well as the precipitation structure associated with TC Idai.
Human-scale missions to Mars will likely require multiple landers delivered precisely to designated locations. The current NASA human Mars reference architecture assumes delivery of three 25 t payloads from a 1- or 5-Sol orbit to the surface with a landing precision of 50 m to ensure logistics are located near the habitat. While initial navigation estimates improve with on-orbit ground tracking, errors increase during post-deorbit coast. Likewise, Mars atmospheric variability and forecasting uncertainty means that the entry vehicle guidance, navigation, and control systems must be robust to accommodate landing during any time of day or Mars year, including during dust storms. Precision landing technologies are currently being assessed to determine if onboard navigation sensors are sufficient to enable the landing accuracy required or if additional navigation aids such as surface or orbiting beacons will be needed. This study evaluates the system performance requirements to meet the desired landing accuracy for the reference vehicle design and entry, descent, and landing concept of operations. A detailed six degree-of-freedom integrated performance simulation framework is used to perform the assessment and demonstrate that under current assumptions, onboard navigation sensors are sufficient to support precision landing.
This paper presents simulations of L1 adaptive controller on a multirotor vehicle for compensation of convective winds. There are increasing efforts to utilize unmanned vehicles for fighting wildfires, but such vehicles need to be able to compensate for convective updrafts and other uncertainties (e.g., wind shear and turbulence) caused by the wildfire. Other application domains, such as urban air mobility, also must account for convective or uncertain winds present in urban microclimates. Geometric controllers have great tracking performance properties in environments without uncertainties, but the tracking performance degrades when wind disturbances and external loads are present in the environment. Introducing L1 adaptive control into the controller architecture compensates for these wind disturbances and reduces the tracking error caused by such disturbances. The controller architecture is implemented on a small quadrotor. The simulations demonstrate the advantages of the L1 adaptive augmentation for a sample figure-eight trajectory while encountering unknown variable wind conditions with an external load.
This paper presents simulations of L1 adaptive controller on a multirotor vehicle for compensation of convective winds. There are increasing efforts to utilize unmanned vehicles for fighting wildfires, but such vehicles need to be able to compensate for convective updrafts and other uncertainties (e.g., wind shear and turbulence) caused by the wildfire. Other application domains, such as urban air mobility, also must account for convective or uncertain winds present in urban microclimates. Geometric controllers have great tracking performance properties in environments without uncertainties, but the tracking performance degrades when wind disturbances and external loads are present in the environment. Introducing L1 adaptive control into the controller architecture compensates for these wind disturbances and reduces the tracking error caused by such disturbances. The controller architecture is implemented on a small quadrotor. The simulations demonstrate the advantages of the L1 adaptive augmentation for a sample figure-eight trajectory while encountering unknown variable wind conditions with an external load.
Error sources affecting metric tracking capability of unified S band
Error model for Doppler range rate and phase modulated range tracking system for which data weighting factors can be obtained for use in space vehicle trajectory analysis
This investigation concerns the effects on Ocean Topography Experiment (TOPEX) spacecraft operational orbit determination of ionospheric refraction error affecting tracking measurements from the Tracking and Data Relay Satellite System (TDRSS). Although tracking error from this source is mitigated by the high frequencies (K-band) used for the space-to-ground links and by the high altitudes for the space-to-space links, these effects are of concern for the relatively high-altitude (1334 kilometers) TOPEX mission. This concern is due to the accuracy required for operational orbit-determination by the Goddard Space Flight Center (GSFC) and to the expectation that solar activity will still be relatively high at TOPEX launch in mid-1992. The ionospheric refraction error on S-band space-to-space links was calculated by a prototype observation-correction algorithm using the Bent model of ionosphere electron densities implemented in the context of the Goddard Trajectory Determination System (GTDS). Orbit determination error was evaluated by comparing parallel TOPEX orbit solutions, applying and omitting the correction, using the same simulated TDRSS tracking observations. The tracking scenarios simulated those planned for the observation phase of the TOPEX mission, with a preponderance of one-way return-link Doppler measurements. The results of the analysis showed most TOPEX operational accuracy requirements to be little affected by space-to-space ionospheric error. The determination of along-track velocity changes after ground-track adjustment maneuvers, however, is significantly affected when compared with the stringent 0.1-millimeter-per-second accuracy requirements, assuming uncoupled premaneuver and postmaneuver orbit determination. Space-to-space ionospheric refraction on the 24-hour postmaneuver arc alone causes 0.2 millimeter-per-second errors in along-track delta-v determination using uncoupled solutions. Coupling the premaneuver and postmaneuver solutions, however, appears likely to reduce this figure substantially. Plans and recommendations for response to these findings are presented.
Effects of time, frequency, and tracking station location errors on accuracy of trajectory analysis