Search NASA⌕ Search

SEARCH · Search NASA

Results for “climbing”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 343 records · Page 19
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Rotor fragment protection program: Statistics on aircraft gas turbine ngine rotor failures that occurred in U.S. commercial aviation during 1978

This report presents statistical information relating to the number of gas turbine engine rotor failures which occurred in commercial aviation service use. The predominant failure involved blade fragments, 82.4 percent of which were contained. Although fewer rotor rim, disk, and seal failures occurred, 33.3%, 100% and 50% respectively were uncontained. Sixty-five percent of the 166 rotor failures occurred during the takeoff and climb stages of flight.

Delucia, R. A.↗
NASA NTRS1982

Processed-induced defects in EFG ribbons

The defect structure of processed edge defined film-fed growth (EFG) silicon ribbons was studied using a variety of electron microscopic techniques. Comparison between the present results and previous studies on as-grown ribbons has shown that solar cell processing introduces additional defects into the ribbons. The creation of point defects during high temperature phosphorus diffusion induces dislocation climb, resulting in the formation of dislocation helices in the diffused layer.

Cunningham, B.↗
NASA NTRS1982

An experimental study of airfoil icing characteristics

The present investigation is concerned with the icing characteristics of a general aviation wing section, taking into account selected results from icing wind tunnel tests of the wing section. Drag coefficient increases of about 130 percent were measured for a 20 minute glaze icing encounter and cruise aerodynamic conditions. The drag increased by about 40 percent for a 15 minute rime icing encounter and the same aerodynamic conditions. The considered wing section was found to be less sensitive to rime and glaze ice accretions occurring for the climb aerodynamic conditions. The observed aft frost layer growths contributed significantly to the measured increase in section drag coefficient level. Comparisons of measured increases in section drag coefficient due to the primary ice accretion with predictions of NACA drag correlation indicated agreement was as good as that for the original data upon which the correlation was based.

Shaw, R. J.↗
NASA NTRS1982

Analysis of general-aviation accidents using ATC radar records

It is pointed out that general aviation aircraft usually do not carry flight recorders, and in accident investigations the only available data may come from the Air Traffic Control (ATC) records. A description is presented of a technique for deriving time-histories of aircraft motions from ATC radar records. The employed procedure involves a smoothing of the raw radar data. The smoothed results, in combination with other available information (meteorological data and aircraft aerodynamic data) are used to derive the expanded set of motion time-histories. Applications of the considered analytical methods are related to different types of aircraft, such as light piston-props, executive jets, and commuter turboprops, as well as different accident situations, such as takeoff, climb-out, icing, and deep stall.

Wingrove, R. C.↗
NASA NTRS1982

Unsteady rotor aerodynamics using a vortex panel method

The problem of the potential incompressible flow about a helicopter rotor blade is solved using an unsteady vortex-panel method where the mutual interaction between the blade and the distorting free wake is taken into account. The present method alleviates the need to rely upon measured-wake geometries or p5escribed-wake models in order to calculate the airloads. A computer program has been developed which is capable of predicting the geometry of the time-dependent three-dimensional (3-D) wake and the instantaneous loadings for a single blade in hover, climb, and forward flight. The solution is obtained by using a time-accurate step-by-step procedure. The complex-wake geometry at any time is presented graphically with a computer graphics system. Calculated results are compared with published data for a rotor blade in both hover and forward flight. The code has also been applied to the study of the effect of changing blade tip geometry.

Crispin, Y.↗
NASA NTRS1982

Performance characteristics of a buoyant quad-rotor research aircraft

Performance characteristics of a buoyant, quadrotor research aircraft, which represents a hybrid airship concept for heavy lift application, are described. Ceiling altitude and endurance for hovering at typical power levels, including partial power failure, are predicted. Climb performance at various altitude and gross weight conditions have been examined. Forward flight performance of this vehicle is illustrated in terms of typical performance parameters such as maximum speed, maximum range, and endurance, over the full range of its payload capability. Optimum payload weights have been identified which result in maximum range at sea level density altitude and constant endurance at various altitudes, both during hover and cruise flights.

Nagabhushan, B. L.↗
NASA NTRS1982

Optimal short-range trajectories for helicopters

An optimal flight path algorithm using a simplified altitude state model and a priori climb cruise descent flight profile was developed and applied to determine minimum fuel and minimum cost trajectories for a helicopter flying a fixed range trajectory. In addition, a method was developed for obtaining a performance model in simplified form which is based on standard flight manual data and which is applicable to the computation of optimal trajectories. The entire performance optimization algorithm is simple enough that on line trajectory optimization is feasible with a relatively small computer. The helicopter model used is the Silorsky S-61N. The results show that for this vehicle the optimal flight path and optimal cruise altitude can represent a 10% fuel saving on a minimum fuel trajectory. The optimal trajectories show considerable variability because of helicopter weight, ambient winds, and the relative cost trade off between time and fuel. In general, reasonable variations from the optimal velocities and cruise altitudes do not significantly degrade the optimal cost. For fuel optimal trajectories, the optimum cruise altitude varies from the maximum (12,000 ft) to the minimum (0 ft) depending on helicopter weight.

Slater, G. L.↗
NASA NTRS1983

Minimum-fuel turning climbout and descent guidance of transport jets

The complete flightpath optimization problem for minimum fuel consumption from takeoff to landing including the initial and final turns from and to the runway heading is solved. However, only the initial and final segments which contain the turns are treated, since the straight-line climbout, cruise, and descent problems have already been solved. The paths are derived by generating fields of extremals, using the necessary conditions of optimal control together with singular arcs and state constraints. Results show that the speed profiles for straight flight and turning flight are essentially identical except for the final horizontal accelerating or decelerating turns. The optimal turns require no abrupt maneuvers, and an approximation of the optimal turns could be easily integrated with present straight-line climb-cruise-descent fuel-optimization algorithms. Climbout at the optimal IAS rather than the 250-knot terminal-area speed limit would save 36 lb of fuel for the 727-100 aircraft.

Neuman, F.↗
NASA NTRS1982

Rotor fragment protection program: Statistics on aircraft gas turbine engine rotor failures that occurred in US commercial aviation during 1979

Statistical information relating to the number of gas turbine engine rotor failures which occurred during 1979 in commercial aviation service use is provided. The predominant failure mode involved blade fragments, 84 percent of which were contained. No uncontained disk failures occurred and although fewer rotor rim and seal failures occurred, 100 percent and 50 percent, respectively, were uncontained. Sixty-eight percent of the 157 rotor failures occurred during the take-off and climb stages of flight.

Delucia, R. A.↗
NASA NTRS1981

Low-speed aerodynamic performance of an aspect-ratio-10 supercritical-wing transport model equipped with a full-span slat and part-span and full-span double-slotted flaps

An investigation was conducted in the Langley 4 by 7 Meter Tunnel to determine the static longitudinal and lateral directional aerodynamic characteristics of an advanced aspect ratio 10 supercritical wing transport model equipped with a full span leading edge slat as well as part span and full span trailing edge flaps. This wide body transport model was also equipped with spoiler and aileron roll control surfaces, flow through nacelles, landing gear, and movable horizontal tails. Six basic wing configurations were tested: (1) cruise (slats and flaps nested), (2) climb (slats deflected and flaps nested), (3) part span flap, (4) full span flap, (5) full span flap with low speed ailerons, and (6) full span flap with high speed ailerons. Each of the four flapped wing configurations was tested with leading edge slat and trailing edge flaps deflected to settings representative of both take off and landing conditions. Tests were conducted at free stream conditions corresponding to Reynolds number of 0.97 to 1.63 x 10 to the 6th power and corresponding Mach numbers of 0.12 to 0.20, through an angle of attack range of 4 to 24, and a sideslip angle range of -10 deg to 5 deg. The part and full span wing configurations were also tested in ground proximity.

Morgan, H. L., Jr.↗
NASA NTRS1983

Supersonic fan engines for military aircraft

Engine performance and mission studies were performed for turbofan engines with supersonic through-flow fans. A Mach 2.4 CTOL aircraft was used in the study. Two missions were considered: a long range penetrator mission and a long range intercept mission. The supersonic fan engine is compared with an augmented mixed flow turbofan in terms of mission radius for a fixed takeoff gross weight of 75,000 lbm. The mission radius of aircraft powered by supersonic fan engines could be 15 percent longer than aircraft powered with conventional turbofan engines at moderate thrust to gross weight ratios. The climb and acceleration performance of the supersonic fan engines is better than that of the conventional turbofan engines.

Franciscus, L. C.↗
NASA NTRS1983

A model for nocturnal frost formation on a wing section: Aircraft takeoff performance penalties

The nocturnal frost formation on a wing section, to explain the hazard associated with frost during takeoff was investigated. A model of nocturnal frost formation on a wing section which predicts when the nocturnal frost will form and also its thickness and density as a function of time was developed. The aerodynamic penalities as related to the nocturnal frost formation properties were analyzed to determine how much the takeoff performance would be degraded by a specific frost layer. With an aircraft takeoff assuming equations representing a steady climbing flight, it is determined that a reduction in the maximum gross weight or a partial frost clearance and a reduction in the takeoff angle of attack is needed to neutralize drag and life penalities which are due to frost. Atmospheric conditions which produce the most hazardous frost buildup are determined.

Dietenberger, M. A.↗
NASA NTRS1983

Effect of buoyancy and power design parameters on hybrid airship performance

The effects of several design parameters on the performance of hybrid airships having rotors and propellers were examined with a simple mathematical model. The parameters included buoyancy ratio, Froude number, ratio of rotor power to total power, and rotor shaft tilt. Performance variations resulting from changes in these parameters were calculated, and are presented and discussed. Performance quantities included best climb rate, equivalent vehicle L/D, and maximum speed. Performance at all speeds between hover and maximum speed was found to be sensitive to power distribution between rotors and propellers, and to rotor shaft tilt.

Talbot, P. D.↗
NASA NTRS1983

Optimal symmetric flight with an intermediate vehicle model

The present investigation is concerned with an examination of optimal symmetry flight on the basis of the intermediate vehicle model. The analysis is partly based upon an exploration of Euler solutions for the path-angle-as-control model carried out by Kelley (1958). The current analysis takes into account higher-order optimality conditions and 'chattering-control' phenomena. Attention is given to details regarding the intermediate vehicle model, the Legendre-Clebsch necessary condition, the conjugate-point test, and the numerical solution of the time-range problem. It is found that the flight path angle takes on the role of control variable in the model. From physical considerations, it can be seen that when a positive margin of thrust over drag exists, the maximum-range climb trajectory without time or fuel constraints has no proper maximum nor an upper bound.

Kelley, H. J.↗
NASA NTRS1983

Optimal short range trajectories for helicopters

An optimal flight path algorithm using a simplified altitude state model and an apriori climb-cruise-descent flight profile has been developed and applied to determine minimum fuel and minimum cost trajectories for a helicopter flying a fixed range trajectory. The performance model is based on standard flight manual data and is such that on-line trajectory optimization is feasible with a relatively small computer. The results show that the optimal flight path and optimal cruise altitude can represent a 10 percent fuel saving on a minimum fuel trajectory. The optimal trajectories show considerable variability due to helicopter weight, ambient winds and the relative cost trade-off between time and fuel. In general, 'reasonable' variations from the optimal velocities and cruise altitudes do not significantly degrade the optimal cost.

Slater, G. L.↗
NASA NTRS1983

Exploratory low-speed wind-tunnel investigation of advanced commuter configurations including an over-the-wing propeller design

A recent low-speed wind-tunnel investigation of a three-surface regional transport configuration has shown large favorable power effects on longitudinal and lateral stability and marginal engine-out trim characteristics for some aft engine and empennage configurations. The present paper discusses these results in terms of static force test information obtained for power-off and power-on conditions. Also discussed in this paper are wind-tunnel results which indicate that mounting propellers over the wing can introduce large favorable slipstream interference effects which significantly reduce the wing drag at climb power conditions.

Johnson, J. L., Jr.↗
NASA NTRS1983

A flight-test evaluation of a go-around control system for a twin engine powered-lift STOL airplane

An automatic go-around control system was evaluated on the Augmentor Wing Jet Short Takeoff and Landing (STOL) Research Airplane (AWJSRA) as part of a study of an automatic landing system for a powered-lift STOL airplane. The results of the evaluation indicate that the go-around control system can successfully transition the airplane to a climb configuration from any initiation point during the glide-slope track or the flare maneuver prior to touchdown.

Watson, D. M.↗
NASA NTRS1983

Advanced symbology for general aviation approach to landing displays

A set of flight tests designed to evaluate the relative utility of candidate displays with advanced symbology for general aviation terminal area instrument flight rules operations are discussed. The symbology was previously evaluated as part of the NASA Langley Research Center's Terminal Configured Vehicle Program for use in commercial airlines. The advanced symbology included vehicle track angle, flight path angle and a perspective representation of the runway. These symbols were selectively drawn on a cathode ray tube (CRT) display along with the roll attitude, pitch attitude, localizer deviation and glideslope deviation. In addition to the CRT display, the instrument panel contained standard turn and bank, altimeter, rate of climb, airspeed, heading, and engine instruments. The symbology was evaluated using tracking performance and pilot subjective ratings for an instrument landing system capture and tracking task.

Bryant, W. H.↗