Search NASA⌕ Search

SEARCH · Search NASA

Results for “correlations”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 343 records · Page 19

A note on correlation description

The paper suggests some modifications to definitions of correlation functions made by Freeman and Bennett (1974) specifically for comparing measured quantities with those predicted by rotor theories, with reference to rotorcraft flight simulation. Special attention is paid to the quality of correlation, determined by a quality factor relating the measured and computed entities. Correlation criteria (mean load and rotor performance, overall amplitude and phase, harmonic altitude and harmonic phase) are examined, along with phase angle correlation criteria (harmonic phase defined by sine-cosine relation and harmonic phase defined by a first positive peak rotor azimuth position)

Mccloud, J. L., III↗

Correlation microphone for measuring airframe noise in large-scale wind tunnels

A correlation microphone arrangement was used in the test section of the Ames 7- by 10-Foot and 40- by 80-Foot Wind Tunnels in an attempt to reject the reverberant and wind noise. The tests in the 7- by 10-foot wind tunnel covered a frequency range from 400 Hz to 8 kHz while the tests in the 40- by 80-foot tunnel covered the range from 31.5 to 800 Hz. Examination of the experimental data plus calculations of cross-correlations due to reflective noise indicate that the correlation microphone is effective in rejecting microphone wind noise and reverberant noise even at low frequencies, and that the low-frequency background noise monitored by the correlation microphone is reflected noise with a preferred direction from the tunnel drive system. Design studies indicate that this tunnel drive noise can be reduced substantially through suitable modification of the drive fans and acoustical treatment of the nacelles that house these fans.

Ahtye, W. F.↗

Correlations by the entrainment theory of thermodynamic effects for developed cavitation in venturis and comparisons with ogive data

A semi-empirical entrainment theory was employed to correlate the measured temperature depression, Delta T, in a developed cavity for a venturi. This theory correlates Delta t in terms of the dimensionless numbers of Nusselt, Reynolds, Froude, Weber and Peclet, and dimensionless cavity length, L/D. These correlations are then compared with similar correlations for zero and quarter caliber ogives. In addition, cavitation number data for both limited and developed cavitation in venturis are presented.

Billet, M. L.↗

CCD correlation techniques

Two CCD techniques were discussed for performing an N-point sampled data correlation between an input signal and an electronically programmable reference function. The design and experimental performance of an implementation of the direct time correlator utilizing two analog CCDs and MOS multipliers on a single IC were evaluated. The performance of a CCD implementation of the chirp z transform was described, and the design of a new CCD integrated circuit for performing correlation by multiplication in the frequency domain was presented. This chip provides a discrete Fourier transform (DFT) or inverse DFT, multipliers, and complete support circuitry for the CCD CZT. The two correlation techniques are compared.

Hewes, C. R.↗

Study of photon correlation techniques for processing of laser velocimeter signals

The objective was to provide the theory and a system design for a new type of photon counting processor for low level dual scatter laser velocimeter (LV) signals which would be capable of both the first order measurements of mean flow and turbulence intensity and also the second order time statistics: cross correlation auto correlation, and related spectra. A general Poisson process model for low level LV signals and noise which is valid from the photon-resolved regime all the way to the limiting case of nonstationary Gaussian noise was used. Computer simulation algorithms and higher order statistical moment analysis of Poisson processes were derived and applied to the analysis of photon correlation techniques. A system design using a unique dual correlate and subtract frequency discriminator technique is postulated and analyzed. Expectation analysis indicates that the objective measurements are feasible.

Mayo, W. T., Jr.↗

Optimum wall impedance for spinning modes: A correlation with mode cut-off ratio

A correlating equation relating the optimum acoustic impedance for the wall lining of a circular duct to the acoustic mode cut-off ratio, is presented. The optimum impedance was correlated with cut-off ratio because the cut-off ratio appears to be the fundamental parameter governing the propagation of sound in the duct. Modes with similar cut-off ratios respond in a similar way to the acoustic liner. The correlation is a semi-empirical expression developed from an empirical modification of an equation originally derived from sound propagation theory in a thin boundary layer. This correlating equation represents a part of a simplified liner design method, based upon modal cut-off ratio, for multimodal noise propagation.

Rice, E. J.↗

OSO-8 X-ray spectra of clusters of galaxies. 1. Observations of twenty clusters: Physical correlations

OSO-8 X-ray spectra from 2 to 20 keV were analyzed for 26 clusters of galaxies. Temperature, emission integrals, iron abundances, and low energy absorption measurements are given. Eight clusters have positive iron emission line detections at the 90% confidence level, and all twenty cluster spectra are consistent with Fe/H=0.000014 by number with the possible exception of Virgo. Physical correlations between X-ray spectral parameters and other cluster properties are examined. It is found that: (1) the X-ray temperature is approximately proportional to the square of the velocity dispersion of the galaxies; (2) the emission integral and therefore the bolometric X-ray luminosity is a strong function of the X-ray temperature; (3) the X-ray temperature and emission integral are better correlated with cluster central galaxy density than with richness; (4) temperature and emission integral are separately correlated with Rood-Sastry type; and (5) the fraction of galaxies which are spirals is correlated with the observed ram pressure in the cluster core.

Mushotzky, R. F.↗

Application of interferential correlation of spectrum to the detection of atmospheric pollutants

The general correlation principles for spectra and spectra derivatives are studied by using the Fourier transform of the spectral distribution of energy from a source illuminating a double beam interferometer with transverse splitting by dividing luminance. In this correlation technique, the use of such an interferometer has the advantage of greater luminosity as compared with a slit spectrometer. However, the correlation example indicates that it is necessary to adapt the correlator to the particular case considered, in order to obtain the best gain in the signal to noise ratio. In the case of sulfur dioxide detection, a very simple mounting which could be used in some interesting industrial applications was developed. This mounting can be used each time that the substance to be analyzed has a quasi-periodic absorption spectrum: in particular this is often the case with absorption spectra of gases, and a mounting identical to the one described for sulfur dioxide proved to be effective in the detection of nitrogen oxides.

Fortunato, G.↗

An off-design correlation of part span damper losses through transonic axial fan rotors

The experimental performance of 10 transonic fan rotors was used to correlate losses caused by midchord part-span dampers (PSD) during off-design operation between 50 and 100 percent of design speed. The design tip speed for the rotors used varied from 419 to 425 m/s and the design pressure ratios from 1.6 to 2.0. The loss attributable to the damper and the region influenced along the blade height was correlated with relevant aerodynamic and geometric parameters. The losses at the design point were estimated by a previously reported correlation (Roberts, 1978). Using this as a base, the off-design losses were correlated with variation in blade suction surface incidence. A check with independent data showed that the prediction of damper losses and region of influence was fair to good for most of the off-design data examined.

Roberts, W. B.↗

Correlator computer interface and module implementation: Mark 3 processor

Two hardware aspects of the Mark 3 correlator are briefly described. The first area concerns the choice of interface to the controlling minicomputer and the second area concerns the implementation of the correlator module. Multiple computer automated measurement and control (CAMAC) modules and a single large CAMAC module were considered as possible packaging forms for the correlator. The large CAMAC module approach was chosen because of the difficulty in partitioning the correlator with minimum interconnections, the fabrication economy of a single large planar assembly, and the desire to minimize the number of modules.

Nesman, E. F.↗

Thermodynamic equilibrium-air correlations for flowfield applications

Equilibrium-air thermodynamic correlations have been developed for flowfield calculation procedures. A comparison between the postshock results computed by the correlation equations and detailed chemistry calculations is very good. The thermodynamic correlations are incorporated in an approximate inviscid flowfield code with a convective heating capability for the purpose of defining the thermodynamic environment through the shock layer. Comparisons of heating rates computed by the approximate code and a viscous-shock-layer method are good. In addition to presenting the thermodynamic correlations, the impact of several viscosity models on the convective heat transfer is demonstrated.

Zoby, E. V.↗

Wind-Tunnel/Flight Correlation, 1981

Wind-tunnel/flight correlation activities are reviewed to assure maximum effectiveness of the early experimental programs of the National Transonic Facility (NTF). Topics included a status report of the NTF, the role of tunnel-to-tunnel correlation, a review of past flight correlation research and the resulting data base, the correlation potential of future flight vehicles, and an assessment of the role of computational fluid dynamics.

Mckinney, L. W.↗

Correlative nature of ozone and carbon monoxide in the troposphere - Implications for the tropospheric ozone budget

The small-scale vertical variability of troposheric O3 and CO is examined using a set of simultaneous measurements obtained in July and August 1974 between 55 deg S and 67 deg N. From this set of vertical profiles, it is found that many of the fluctuations are coincident in both species, and a method is presented that quantifies the correlation between the observed O3 and CO variability. A two-dimensional depiction of the distribution of these O3-CO correlations reveals that there are regions in the troposphere where these trace gases are positively correlated and that, at the same time, there are preferred locations where these two species are primarily anticorrelated. The regions of anticorrelation are found to be consistent with the traditional picture of the tropospheric ozone cycle, suggesting that this gas is chemically unreactive in the troposphere. On the other hand, the location and magnitude of the region in which these two species are positively correlated indicates that there is considerable in situ production of tropospheric ozone.

Fishman, J.↗

Regional correlation between TOMS total ozone from NIMBUS-7 satellite and geopotential height from the GLAS analysis

In order to study the relation between zone and the atmospheric circulation on a global scale the global correlation has been computed between TOMS total ozone measurements from NIMBUS-7 satellite and collocated geopotential heights analysis at all mandatory pressure levels between 1000-50 mb. The heights are obtained from the 4 deg x 5 deg GLAS analysis that uses both conventional (rawinsonde) and the operational TIROS-N satellite soundings but no ozone data. Zonal averages have been substracted to eliminate the correlation due merely to latitudinal dependence, and emphasize the correlation associated with synoptic features. Tables are presented with correlation coefficients for the four synoptic times covering the Pacific Ocean, Asia, Europe and the Atlantic Ocean, and United States regions. These coverages are approximate since NIMBUS-7 does not observe exactly the same region each day.

Munteanu, M. J.↗

Statistical correlation of structural mode shapes from test measurements and NASTRAN analytical values

The software and procedures of a system of programs used to generate a report of the statistical correlation between NASTRAN modal analysis results and physical tests results from modal surveys are described. Topics discussed include: a mathematical description of statistical correlation, a user's guide for generating a statistical correlation report, a programmer's guide describing the organization and functions of individual programs leading to a statistical correlation report, and a set of examples including complete listings of programs, and input and output data.

Purves, L.↗

Ultrasonic velocity measurement using phase-slope cross-correlation methods

Computer implemented phase-slope and cross-correlation methods are introduced for measuring time delays between pairs of broadband ultrasonic pulse-echo signals for determining velocity in engineering materials. The phase-slope and cross-correlation methods are compared with the overlap method which is currently in wide use. Comparison of digital versions of the three methods shows similar results for most materials having low ultrasonic attenuation. However, the cross-correlation method is preferred for highly attenuating materials. An analytical basis for the cross-correlation method is presented. Examples are given for the three methods investigated to measure velocity in representative materials in the megahertz range.

Hull, D. R.↗

Ultraviolet extinction and diffuse band strength correlations

Correlations between UV extinction parameters and diffuse band strengths are south, using a data base of 50 stars with recently measured extinction curves. A novel aspect of this study is that the basic dependence of most interstellar parameters on E(B-V) (or, nearly equivalently, on the total hydrogen column density) has been largely canceled out. After this cancellation, a weak correlation is found between the 4430 A diffuse band and the 2175 A extinction feature. No other correlations are found. These results support a molecular origin for the 5780 A and 6284 A bands. It is speculated that the correlation pattern found for the 4430 A band can be explained if this band originates in reactions on disordered grain surfaces.

Seab, C. G.↗

Pressure-strain correlations in curved wall boundary layers

Pressure-strain correlations, which represent some part of production and dissipation of Reynolds stress in turbulent wall-bounded shear layers, have been determined for the cases of boundary layer flow past a convex, a concave and a flat wall, the latter also in the case when it follows a convex wall (relaxing flow). The Large Eddy Interaction Model utilized for prediction also permits determination of the contribution from different parts of the turbulence spectra to the correlations in different parts across the boundary layer. The relation between the anisotropic nature of the correlations and the spectra in the different flow cases provides a means of testing models for the correlations.

Hong, S. K.↗